• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.9C
• /
• pp.879-885
• /
• 2002

The performance of communication systems should be tested against a set of requirements. To this end, noise generation systems are used to generate noise signals with specified characteristics. In this paper, we propose the area & power-efficient noise generation system based on DCT method. It is shown that the proposed structure results in area reduction of non-DCT block by 44∼47%. Moreover, since the proposed structure does not use high-speed internal clock, it achieves power reduction by 74∼77%.

• Current Optics and Photonics
• /
• v.2 no.1
• /
• pp.96-100
• /
• 2018

A tunable low-phase-noise microwave generation structure that utilizes an optoelectronic oscillator (OEO) and a fiber Bragg grating (FBG) is proposed and experimentally demonstrated in this article. This structure has no particular requirement for the band width of the laser, and its tunability is realized through adjusting the central frequency of the tunable FBG. A detailed theoretical analysis is established and confirmed via an experiment. A high-purity microwave signal with a frequency tunable from 6 to 12 GHz is generated. The single-sideband phase noise of the generated signal at 10.2 GHz is -117.2 dBc/Hz, at a frequency offset of 10 kHz.

• Proceedings of the IEEK Conference
• /
• 1999.06a
• /
• pp.841-844
• /
• 1999

VDSL noises should be used for testing and evaluation of VDSL systems. In DMT systems for ADSL, noises are generated using IIR filters obtained from the Yule-Walker equations. However, this method cannot be directly applied to VDSL environments. In this paper, an DCT-based VDSL noise generation algorithm is proposed.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.19 no.8
• /
• pp.809-815
• /
• 2009

The previous work(Cheong et al., 2006) where the characteristics of acoustic emissions of wind turbines has been investigated according to the methods of power regulation, has showed that the acoustic power of wind turbine using the stall control for power regulation is more correlated with the wind speed than that using the pitch control. In this paper, basically extending this work, the noise generation characteristics of large modern upwind wind turbines are experimentally indentified according to the power regulation methods. To investigate the noise generation mechanisms, the distribution of noise sources in the rotor plane is measured by using the beam-forming measurement system(B&K 7768, 7752, WA0890) consisting of 48 microphones. The array results for the 660 kW wind turbine show that all noise is produced during the downward movement of the blades. This result show good agreement with the theoretical result using the empirical formula with the parameters: the convective amplification; trailing edge noise directivity; flow-speed dependence. This agreement implies that the trailing edge noise is dominant over the whole frequency range of the noise from the 660 kW wind turbine using the pitch control for power regulation.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2009.04a
• /
• pp.63-67
• /
• 2009

The previous work (Cheong et al., 2006) where the characteristics of acoustic emissions of wind turbines has been investigated according to the methods of power regulation, has showed that the acoustic power of wind turbine using the stall control for power regulation is more correlated with the wind speed than that using the pitch control. In this paper, basically extending this work, the noise generation characteristics of large modern upwind wind turbines are experimentally indentified according to the power regulation methods. To investigate the noise generation mechanisms, the distribution of noise sources in the rotor plane is measured by using the Beam-forming measurement system (B&K 7768, 7752, WA0890) consisting of 48 microphones. The array results for the 660 kW wind turbine show that all noise is produced during the downward movement of the blades. This result show good agreement with the theoretical result using the empirical formula with the parameters: the convective amplification; trailing edge noise directivity; flow-speed dependence. This agreement implies that the trailing edge noise is dominant over the whole frequency range of the noise from the 660 kW wind turbine using the pitch control for power regulation.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2007.11a
• /
• pp.133-137
• /
• 2007

As the waterpower generation plant, the subject of this Study, is a facility that produces plenty of electricity corresponds to $196{\sim}240GWh$ annually, and in its generation process it creates a loud noise when the turbine related to the hydraulic turbine dynamo revolves, and since such loud noise must be transmitted to the dynamo room and amplified, it is effecting a lot of influences to the adjacent office and space. In such viewpoint, this Research, based on the soundproof measure presented at the preceding research, has attempted to evaluate about the effect of noise-reduction countermeasure against the hydraulic turbine dynamo using Auralizational Technique through Psycho-Acoustics Experiment. It deems that such result could be applied hereafter as the useful material when setting up a soundproof countermeasure for the hydraulic turbine dynamo room in dam.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.10
• /
• pp.181-189
• /
• 2007

This paper presents a experimental evidence of the generation of the earth potential and communication line noise from the electric railway. There is a critical measurement err in case of measuring the electrical power induced noise voltage and degree of cable balance in the field of earth potential generated. As a results, it has been found that the conventional cable has more noise immunity than shielded cable near the railway where the earth current flows through the sheath layer.

• Journal of the Korean Vacuum Society
• /
• v.5 no.1
• /
• pp.48-53
• /
• 1996

We present a microscopic description for generation of 1/f noise in interfaces between cobalt thin film and silicon substrate. Along with surface resistance measurements and transmission electron diffraction observations. 1/f noise power spectral density has been measured for the interfacial structures at the liquid nitrogen temperature . The cobalt films have been deposited by the electron-beam evaporation technique onto p-type (100) silicon in the high vacuum condition. The measured noise power spectral density shows highest magnitude near the structural transition and metallization transition region. The noise magnitude rapidly decreased after the cobalt silicide nucleation. The noise parameter is concluded to be originated form the structural fluctuations.

• Journal of Institute of Convergence Technology
• /
• v.12 no.1
• /
• pp.1-5
• /
• 2022

This paper describes an algorithm for generating a terrain using a noise function and a height map as one of the procedural terrain generation methods. The polygon mesh data structure to represent the generated terrain concisely and render it is also described. The Perlin noise function is used as the noise technique for terrain mesh, and the height data of the terrain is generated by combining the four noise waves. In addition, the terrain height information can be also obtained from actual image data taken from the satellite. The algorithm presented in this paper generates the geometry part of the polygon topography from the height data obtained, and generated a material for texture mapping with two textures, that is, a diffuse texture and a normal texture. The validity of the terrain method proposed in this paper is verified through application examples, and its possibility can be confirmed through performance verification.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2000.06a
• /
• pp.1829-1835
• /
• 2000

The experimental results of sodium-water reaction noise measurement in frequency range $1{/sim}200kHz$ are presented. The experiments of noise generation under the condition of sodium test facility, water leak rate $0.01{\sim}1.2g/s$ and temperature of sodium $250{\sim}500^{\circ}C$, were carried out. From theoretical study it is noted that the noise resonant attenuation on hydrogen bubbles in liquid sodium plays the significant role for leak noise spectra formation. Interaction of leak noise and hydrogen bubbles in sodium being accompanied by thermal, emission and viscosity energy dissipation was studied. Acoustic noise spectra were investigated from point of view of water leak detection in sodium/water steam generator. The results of sodium-water reaction noise absorption on hydrogen bubbles in liquid sodium by temperature $250{\sim}500^{\circ}C$ are presented. The theoretical model of noise absorption using the coefficients of attenuation was developed. From calculation the coefficients of attenuation were estimated.