• Journal of the Korean Data and Information Science Society
• /
• v.17 no.2
• /
• pp.543-557
• /
• 2006

This paper is concerned with the applicability of the chi-square approximation to the six disparity statistics: the Pearson chi-square, the generalized likelihood ratio, the power divergence, the blended weight chi-square, the blended weight Hellinger distance, and the negative exponential disparity statistic. Three dimensional contingency tables of small and moderate sample sizes are generated to be fitted to all possible hierarchical log-linear models: the completely independent model, the conditionally independent model, the partial association models, and the model with one variable independent of the other two. For models with direct solutions of expected cell counts, point estimates and confidence intervals of the 90 and 95 percentage points of six statistics are explored. For model without direct solutions, the empirical significant levels and the empirical powers of six statistics to test the significance of the three factor interaction are computed and compared.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.11a
• /
• pp.15-20
• /
• 1996

We present the result of physical studies for three integral-type burnable absorbers of gadolinia, erbia and IFBA, in the hexagonal fuel assembly. The analysis of nuclear characteristics for gadolinia and IFBA cases shows that the spectrum hardening of hexagonal fuel assembly compared to rectangular one leads to smaller reactivity hold-down worth(RHW) and less change of MTC in the negative direction per insertion of one burnable absorber rod. Erbia case, on the other hand, exhibits reversed trend in RHW and MTC due to the enhanced absorption of large resonance of Erbium at 0.5 eV It turns out to be that Erbia performs best in terms of minimizing the peak pin power and maintaining as more negative MTC as practically attainable during the entire operational phase, and IFBA provides the least residual reactivity penalty at EOC. Therefore, we take Erbium as the suitable burnable absorber and provide optimal designs of 60, 120, 180, 240 and 300 erbia-shimmed hexagonal fuel assemblies with regard to minimizing the peak pin power.

• Plant Journal
• /
• v.7 no.2
• /
• pp.30-38
• /
• 2011

The purpose of this paper is to review the understanding of pollution causes in the excitation system and how to solve the problem. The cause of the problem was in-leakage of bearing lubricant oil through the gap between rotor and outer in the air deflector, which was triggered by a negative pressure with respect to the operation of a collector ring fan in the collector house. In order to prevent exciting current transmission equipment pollutant, the reduction of the negative gage pressure of the inside of collector house is required. The protection in-leakage of bearing lubricant oil through the gap between rotor and outer of the air deflector are necessary. The reduction of the inside diameter of air deflector and the expansion of inlet filter of collector house are inevitable.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.17 no.2
• /
• pp.15-22
• /
• 1980

For efficient coding of graphic image data, the statistical characteristics for both Korean lettered images and English lettered images are measurpd and co mpared. Also, the measured run length distribution is compared with the run length distribution hased on Markov model. It is shown that the measured white run length distribution is more Bike a negative - power distribution than an exponential distribution . This fact is stronger in the Korean lettered images than is the English lettered images, The performances of four typical run length codes are compared for the same set of graphic data files,, and it is shown that the codes perform better in the Korean ]entered images :hart In Eng]isle lettered images.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.37 no.3
• /
• pp.424-438
• /
• 2013

This study examines the value, knowledge and sustainable consumption behavior of fashion consumers. The study shows that universalism/harmony, security/benevolence, power, and tradition/faith have positive effects on buying/usage behavior; however, hedonism/wealth has a negative effect. Stimulation/self-direction and universalism/harmony positively influence boycott behavior; however, power has a negative influence. Universalism/harmony and politeness have positive impacts on care/disposing behavior. Consumer knowledge about fashion related environmental problems, labor practices, ethical issues and sustainable environment knowledge influence sustainable buying/usage behavior; in addition, knowledge about ethical issues and sustainable environmental problems positively influence boycott and care/disposing behavior. Moreover, there were significant differences in values, knowledge, and consumption behavior by age.

• Journal of Power Electronics
• /
• v.13 no.1
• /
• pp.86-93
• /
• 2013

A half-cycle-waveform inversion based three reference modulations seven-level SPWM (TRM-SPWM) scheme with one carrier is proposed in this paper. To keep the same comparison logics for the modulations and carrier during the negative half cycle and the positive one for the modulations, in the negative half cycle of the modulations, the DC offsets related to the amplitude of the carrier are set on the three modulations, respectively. The seven-level SPWM waveform with dead time thereby is implemented with only one Digital Signal Processor (DSP) without any other attached logic circuit. The basis principle of the proposed TRM-SPWM is analyzed in detail, and the frequency spectrums of the conventional and the proposed schemes are derived and compared with each other through simulation. The DSP based implementation is presented and detailed experimental waveforms verify the accuracy and feasibility of the proposed TRM-SPWM scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.7
• /
• pp.1726-1733
• /
• 1996

A 3V-50MHz analog CMOS continuous-time current-mode filter with a negative resistance load(NRL) is proposed. In order to design a current-mode current integrator, a modified basic current mirror with a NRL to increase the output resistance is employed. the inherent circuit structure of the designed NRL current integrator, which minimizes the internal circuit nodes and enhances the gain bandwidth product, is capable of making the filter operate at the high frequency. The third order Butterworth low pass filter utilizing the designed NRL current integrator is synthesized and simulated with a 1.5.mu.m CMOS n-well proess. Simulation result shows the cutoff frequency of 50MHz and power consumption of 2.4mW/pole with a 3V power supply.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.183-186
• /
• 1999

A 900 71Hz RF band-pass amplifier for wireless communication systems is designed and fabricated. HSPICE simulation results show that the amplifier can achieve a tunable center frequency between 880 MHz and 920 MHz. The gain of designed amplifier is 19 dB at Q=88, and the power dissipation is about 61 mW under 3 V power supply by using the spiral inductor with negative-7m circuit and center frequency tunning circuit. The designed band-pass amplifier is implemented by using 0.6 um 2-poly-3-metal standard CMOS process.

• Journal of Power Electronics
• /
• v.10 no.6
• /
• pp.724-732
• /
• 2010

This paper presents an effective rotor current controller for variable-speed stand-alone doubly fed induction generator (DFIG) systems feeding an unbalanced three-phase load. The proposed current controller is developed based on proportional plus two resonant regulators, which are tuned at the positive and negative slip frequencies and implemented in the rotor reference frame without decomposing the positive and negative sequence components of the measured rotor current. In addition, the behavior of the proposed controller is examined in terms of control performance and stability with respect to rotor speed variations, i.e., slip frequency variations. Simulations and experimental results are shown to validate the robustness and effectiveness of the proposed control method.

• Journal of Power Electronics
• /
• v.13 no.6
• /
• pp.928-938
• /
• 2013

This paper proposes a novel control method for a multi-output switched-resonant converter. Output voltage can be regulated against variations in the supply voltage and load by controlling the voltage of the resonant capacitor (pulse amplitude control). Precise control is possible when pulse amplitude control is combined with pulse number control. The converter is analyzed, and design considerations are explained by using examples. Control implementation is described and load regulation and ripples are analyzed by simulation and hardware results. The topology is modified to obtain an additional negative output without any additional hardware other than a diode. The analysis of such a triple output converter with two positive outputs and one negative output is conducted and confirmed. The topology and control scheme are scalable to any number of outputs.