• 천문학회보
• /
• 제43권1호
• /
• pp.32.4-33
• /
• 2018

We study the kinematical properties of the Seyfert galaxy, NGC 4051 and Mrk 79. The data used in this study had been observed with OASIS spectrometer at CFHT 3.6m telescope using O300 grism, MR1. The wavelength coverage is $4760{\AA}$ $-5558{\AA}$, which includes emission lines, $H{\beta}4861{\AA}$, $[OIII]4959{\AA}$, and $[OIII]5007{\AA}$. We observe that forbidden lines have both narrow and broad components. Radial velocity of NGC 4051 is blue-shifted, perhaps due to the z value derived by the earlier studies, 0.002336. We use the revised z, 0.002099, according to the radial velocity of the central spectrum. NGC 4051 is face-on galaxy without rotation observed. Radial velocity of Mrk 79 shows a rotation characteristic in narrow components, relative to $PA=60^{\circ}$, red-shifted to north-west, and blue-shifted to south-east. In the [OIII] broad components, blue-shifted points are observed at the place at 2 arcsec apart from the center of Mrk 79 to north-west, which are likely to be gas outflow.

• ETRI Journal
• /
• 제36권2호
• /
• pp.317-320
• /
• 2014

A balanced RF duplexer with low interference in an extremely narrow bandgap is proposed. The Long-Term Evolution band-7 duplexer should be designed to prevent the co-existence problem with the WiFi band, whose fractional bandgap corresponds to only 0.7%. By implementing a hybrid bulk acoustic wave (BAW) structure, the temperature coefficient of frequency (TCF) value of the duplexer is successfully reduced and the suppressed interference for the narrow bandgap is performed. To achieve an RF duplexer with balanced Rx output topology, we also propose a novel balanced BAW Rx topology and RF circuit block. The novel balanced Rx filter is designed with both lattice- and ladder-type configurations to ensure excellent attenuation. The RF circuit block, which is located between the antenna and the Rx filter, is developed to simultaneously function as a balance-tounbalance transformer and a phase shift network. The size of the fabricated duplexer is as small as $2.0mm{\times}1.6mm$. The maximum insertion loss of the duplexer is as low as 2.4 dB in the Tx band, and the minimum attenuation in the WiFi band is as high as 36.8 dB. The TCF value is considerably lowered to $-16.9ppm/^{\circ}C$.

• 대한전자공학회논문지SD
• /
• 제45권9호
• /
• pp.21-25
• /
• 2008

본 연구에서는 MOSFET의 RF 성능을 극대화하기 위해 단위 게이트 finger 폭($W_u$)에 대한 $f_T$ 및 $f_{max}$의 종속데이터를 측정하고 이 결과를 소신호 모델 파라미터들을 추출함으로써 새롭게 분석하였다. 이러한 물리적 분석결과로 $f_T$의 최대값이 존재하는 원인은 좁은 $W_u$에서 $W_u$에 무관한 parasitic gate-bulk capacitance와 넓은 $W_u$에서 트랜스컨덕턴스의 증가율이 감소하는 wide width effect에 의한 것임을 알 수 있다. 또한, $f_{max}$의 최대값은 게이트저항이 좁은 $W_u$에서 크게 줄어들고 넓은 $W_u$에서 점점 일정하게 되는 non-quasi-static effect에 의해 발생된다는 사실이 밝혀졌다.

• 한국연초학회지
• /
• 제21권1호
• /
• pp.82-88
• /
• 1999

The present study was conducted to compare the relative efficiency of two different haploid breeding methods in tobacco varietal development. A single FI hybrid plant from cross of two flue-cured cultivars of Nicotiana tabacum L., Bright Yellow4(BY4) and NC95, was used to develop the 30 anther derived dihaploid (ADH) lines and maternally-derived dihaploid (MDH) lines utilizing Nicotiana africana, respectively. As compared with mid-parent, mean of ADH lines showed increase in number of leaves, delay in days to flower and narrow in width of leaf. However, no significant differences in the other investigated characters were recognized. MDH lines also showed narrow width of leaf, while no significant differences in the other characters were observed. The variations of the investigated characters were generally greater in ADH than MDH lines. MDH lines had higher height of plant and shorter days to flower than ADH lines, while the other characters did not show remarkable differences. The degree of heritability for each of the characters observed between ADH and MDH was almost the same. The characters showing high heritability value were height of plant, number of leaves, days to flower, and yield, while those showing relatively low value were length of leaf, width of leaf, and total alkaloid content. Predicted gains from selection for increased yield were calculated for both populations(ADH, MDH) and correlated responses associated with selection for yield were estimated. Height of plant, width of leaf, days to flower, and concentration of reduceing sugar would be expected to improve with selection for yield much faster in the MDH population than in the ADH.

• 동력기계공학회지
• /
• 제5권2호
• /
• pp.22-29
• /
• 2001

This paper represents axial mean velocity, turbulent kinetic energy and swirl number based on momentum flux measured in the X-Y plane and Y-Z plane respectively of a cone type gas swirl burner by using X-probe from the hot-wire anemometer system. This experiment is carried out at flow rates 350 and $450{\ell}/min$ respectively, which are equivalent to the combustion air flow rate necessary for heat release 15,000 kcal/hr in gas furnace, in the test section of a subsonic wind tunnel. Axial mean velocities and turbulent kinetic energies show that their maximum values exist centering around narrow slits situated radially on the edge of and in the forefront of a burner until $X/R{\fallingdotseq}1.5$, but they have a peculiar shape like a starfish diffusing and developing into inward and outward of a burner by means of the mixing between flows ejected from narrow slits, an inclination baffle plate and swirl vanes respectively according to downstream regions. Moreover, they show a relatively large value in the inner region of 0.5$S_m$ obtained by integration of velocity profiles shows a characteristic that has an inflection point composing of the maximum and minimum value until X/R<3, but shows close agreement with the geometric swirl number after a distance of X/R=3.

• 한국전기전자재료학회논문지
• /
• 제13권9호
• /
• pp.729-734
• /
• 2000

Recently, Very Large Scale Integrated (VLSI) circuit & deep-submicron bulk Complementary Metal Oxide Semiconductor(CMOS) devices require gate electrode materials such as metal-silicide, Titanium-silicide for gate oxides. Many previous authors have researched the improvement sub-micron gate oxide quality. However, few have reported on the electrical quality and reliability on the ultra thin gate oxide. In this paper, at first, I recommand a novel shallow trench isolation structure to suppress the corner metal-oxide semiconductor field-effect transistor(MOSFET) inherent to shallow trench isolation for sub 0.1${\mu}{\textrm}{m}$ gate oxide. Different from using normal LOCOS technology deep-submicron CMOS devices using novel Shallow Trench Isolation(STI) technology have a unique"inverse narrow-channel effects"-when the channel width of the devices is scaled down, their threshold voltage is shrunk instead of increased as for the contribution of the channel edge current to the total channel current as the channel width is reduced. Secondly, Titanium silicide process clarified that fluorine contamination caused by the gate sidewall etching inhibits the silicidation reaction and accelerates agglomeration. To overcome these problems, a novel Two-step Deposited silicide(TDS) process has been developed. The key point of this process is the deposition and subsequent removal of titanium before silicidation. Based on the research, It is found that novel STI structure by the SEM, in addition to thermally stable silicide process was achieved. We also obtained the decrease threshold voltage value of the channel edge. resulting in the better improvement of the narrow channel effect. low sheet resistance and stress, and high threshold voltage. Besides, sheet resistance and stress value, rms(root mean square) by AFM were observed. On the electrical characteristics, low leakage current and trap density at the Si/SiO$_2$were confirmed by the high threshold voltage sub 0.1${\mu}{\textrm}{m}$ gate oxide.

• 한국의류학회지
• /
• 제14권4호
• /
• pp.274-280
• /
• 1990

This paper is intended to grasp the characteristics of many bodices patterns which have been shown so far. The way is by selecting four characteristic kinds of patterns, making blouses offer the patterns and measuring ease. In measuring the degree of ease, $Scheff\`{e}'s$ paired comparison is made use of. In analysis, variation ratio has come out of analysis of variance, and significance is tested by producing estimated values between patterns. The Result is summed up as follows. 1. After wearing blouses made ofter different basic patterns and measuring ease, the analysis of variance is made about the sensory value of ease. The result is as follows. 1) In the ease of different patterns, all the areas are significant at the level of $1\%$ , regard- less of movements. 2) Under the influence of movements, the back area of arm hole is significant at the level of $5\%$ in narrow movements, and the front and the back area of arm hole are each significant at the level of $1\%$ in wide movements. 3) In the interaction of patterns and movements, bust and the under area of arm hole are each significant at the level of $1\%$ in narrow movements, and bust is significant at the level of $1\%$ in wide movements. 2. When comparing estimated values between patterns, the value of c is the largest and in the order of b,4, a. And in the other movements, the order changes into c,d, b and a. Thus the ease of blouses is different according to patterns. The reason for this is that the amount of ease of bust, the amount and location of darts, and sleeve cap height have complicate influences on the ease of blouses. Both sleeve cap height and the depth of arm hole have influences on the ease of sleeve. Consequently, in making clothes, it would be better to select and use proper patterns which go with the purposes and desings of clothes rather than to apply one pattern to various clothes.

• 한국화재소방학회논문지
• /
• 제28권6호
• /
• pp.35-40
• /
• 2014

병목현상은 많은 피난인들이 출구나 복도를 지나가려하게 되면 생기는 현상이다. 병목현상으로 인해 시간의 지연이 생기게 되며, 이는 건물 화재 시의 피난 예측에서 매우 중요한 요소가 된다. 피난시간 분석에서 병목현상은 유동률이라는 요소로 반영된다. 이는 시간당 단위 폭 당 통과되는 사람의 수를 나타낸다. 피난모델링에서 계산되는 유동률은 피난실험의 결과에 근접해야하며, 이에 대한 확인은 필수적인 사항이다. 본 연구에서는 유동률에 대한 피난실험의 결과와 피난모델 Pathfinder의 적용결과를 비교하여 보았다. 그 결과 피난실험과 모델링의 결과 값은 차이를 보여주고 있다. 실험의 평균값은 $4.25N/m{\cdot}s$이고 시뮬레이션의 최대 값은 $1.55N/m{\cdot}s$로 나타났다.

• 대한원격탐사학회지
• /
• 제27권3호
• /
• pp.303-314
• /
• 2011

Surface albedo is an important parameter of the surface energy budget, and its accurate quantification is of major interest to the global climate modeling community. Therefore, in this paper, we consider the direct solution of kernel based bidirectional reflectance distribution function (BRDF) models for retrieval of normalized reflectance of high resolution satellite. The BRD effects can be seen in satellite data having a wide swath such as SPOT/VGT (VEGETATION) have sufficient angular sampling, but high resolution satellites are impossible to obtain sufficient angular sampling over a pixel during short period because of their narrow swath scanning when applying semi-empirical model. This gives a difficulty to run BRDF model inferring the reflectance normalization of high resolution satellites. The principal purpose of the study is to estimate normalized reflectance of high resolution satellite (RapidEye) through BRDF components from SPOT/VGT. We use semi-empirical BRDF model to estimated BRDF components from SPOT/VGT and reflectance normalization of RapidEye. This study used SPOT/VGT satellite data acquired in the S1 (daily) data, and within this study is the multispectral sensor RapidEye. Isotropic value such as the normalized reflectance was closely related to the BRDF parameters and the kernels. Also, we show scatter plot of the SPOT/VGT and RapidEye isotropic value relationship. The linear relationship between the two linear regression analysis is performed by using the parameters of SPOTNGT like as isotropic value, geometric value and volumetric scattering value, and the kernel values of RapidEye like as geometric and volumetric scattering kernel Because BRDF parameters are difficult to directly calculate from high resolution satellites, we use to BRDF parameter of SPOT/VGT. Also, we make a decision of weighting for geometric value, volumetric scattering value and error through regression models. As a result, the weighting through linear regression analysis produced good agreement. For all sites, the SPOT/VGT isotropic and RapidEye isotropic values had the high correlation (RMSE, bias), and generally are very consistent.

• 한국환경과학회지
• /
• 제23권10호
• /
• pp.1755-1762
• /
• 2014

Water quality of the Koejong-reservoir was estimated by using the ecological model to evaluate the effects of industrial sewage discharge. State variables consist of POC, DOC, phytoplankton, DIP, DIN, DO and COD. Initial conditions for the compartment are applied to the model based on the observed results. The reproducibility was found to be satisfactory with the relative error ranging between the calculated value and the observed value. Water quality simulation was conducted by applying additional industrial sewage discharge into the Koejong-reservoir. The concentrations of COD, Chl.a, DIP and COD showed fluctuations of a narrow range. The increment percentages of Chl.a, COD and DIP were 26.6%, 20.2% and 18.2%, respectively. In the case of DO, the concentration decreased 4.8%.