• 환경위생공학
• /
• 제15권4호
• /
• pp.78-83
• /
• 2000

The emission factor of nitrogen oxides(NOx) was evaluate to clarify the characteristics of NOx emitted from seven large combustion facilities in seoul area. The emission factors of NOx at A-1 and A-2 facilities of internal combustion engine were 66.957kgNOx/ton and 20.913kgNOx/ton, respectively. The emission factor of A-1 facility was higher than that of A-2 facility even same internal combustion engine, because A-1 facility adopted SCR(selective catalystic reactor) for reduction of NOx emission factor of A-2, A-4, and A-7 power generation boiler facilities were 4.300kgNOx/ton, 2.460kgNOx/ton and 1.796kgNOx/ton, respectively. The capacity of A-2 facility was about two times than that of A-4 and A-7. These emission factors were lower than those at facilities in other areas of korea, because of using low NOx burner of power generation boiler. The emission factors of NOx at A-3 and A-6 incinerator facilities were 0.147kgNOx/ton and 0.221kgNOx/ton which were lower than other facilities, respectively, because these facilities incinerate municipal solid waste of low heating value and uwe SCR for reducing NOx concentration.

• 한국해양환경ㆍ에너지학회지
• /
• 제6권3호
• /
• pp.16-25
• /
• 2003

본 논문에서는 RORO선을 이용한 연안운송에 따른 CO₂가스 배출량과 NOx가스 배출량의 삭감 효과에 대하여 고찰한다. 먼저 국내 CO₂가스 배출량과 수출입 컨테이너화물의 물동량에 대하여 고찰한다. 다음에 RORO선의 특성, CO₂가스 배출량 기준과 NOx가스 배출량 기준에 대하여 고찰한다. 또한 경인지역과 부산항 사이의 수출입 컨테이너 화물의 운송에 있어서 도로운송을 연안운송으로 전환한 경우의 CO₂가스 배출량과 NOx가스 배출량 삭감 효과에 대하여 계산한다. 마지막으로 RORO선의 적재율과 연안운송 분담율 변화에 따른 CO₂가스 배출량과 NOx가스 배출량 변화에 대하여 조사한다. 본 논문의 결과를 통하여 수출입컨테이너 화물의 운송을 도로운송으로부터 RORO선을 이용한 연안운송으로 전환하는 것이 CO₂가스 배출량 삭감에는 효과적이나 NOx가스 배출량 삭감에는 큰 효과가 없는 것을 확인하였다.

• 한국연소학회지
• /
• 제13권4호
• /
• pp.1-7
• /
• 2008

Strict pollutant regulations of NOx emission and increasing awareness of the environmental damage stimulated interest in research to obtain useful information regarding CO and NOx reductions at the same time. In this study, $CH_4$/air premixed flame was examined numerically to reduce CO and NOx emission level simultaneously in the post-flame region by the heat loss models in which radiative and combined conductive and convective heat losses were included. To reduce the NOx emission, first heat exchanger location was decided near the flame. After first heat exchanger was decided for the optimal NOx emission(about 30 ppm), in order to decide the optimal CO emission(about 30ppm), seocond heat exchanger location was tested and decided for several cases. Finally, the optimal location of heat exchanger for minimal CO and NOx emission simultaneously were determined and suggested.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2005년도 전기학술대회논문집
• /
• pp.74-80
• /
• 2005

It becomes necessary for engine manufactures to verify whether lots of engines on test bed during shop test are in compliance with NOx Technical Code for marine diesel engines more efficiently on the basis of engine group test concept which contains parent engine and member engines since all the engines are not needed to take NOx measurement. In addition, it becomes more obliged to consider parameters which affect NOx emission level and describe these parameters in NOx technical file as engine information and settings to define engine operation range with tolerance to make sure the engines are still in compliance with NOx emission limit on board after shop test. During preparation of engine group test for 4-stroke marine diesel engines, we evaluated NOx emission value under different engine operating conditions and found that there are certain parameters, for example, Charge air temperature and Max. cylinder pressure which have influence on NOx emission level. The NOx emission shall be satisfied with NOx technical code by means of controlling such parameters.

• International Journal of Automotive Technology
• /
• 제7권3호
• /
• pp.269-276
• /
• 2006

Running tests on roads were conducted to clarify the influences of road infrastructure, traffic condition and vehicle's emission level to the amount of emission at local roadsides, and to reveal the operation patterns which can reduce the emission peaks. NOx emission peaks of two light duty freight diesel vehicles which have different emission levels were evaluated by using an on-board measurement system. Tests were carried out with various payload conditions and road conditions. As a result many NOx emission peaks were observed when the vehicles were starting or accelerating at intersections. The test vehicle which has higher emission level caused higher frequency and level of NOx emission peaks. Shifting up at lower engine speed in combination with lower acceleration brought out not only reduction of NOx emission peaks level but also of $CO_2$ mass emission.

• 한국해양환경ㆍ에너지학회지
• /
• 제7권2호
• /
• pp.57-63
• /
• 2004

본 논문에서는 국내 선박 디젤엔진의 NOx 배출 현황과 그 저감기술에 대해서 살펴보고자 하였다. 우선, 국내 선박 디젤엔진의 생산현황에 대해서 살펴보고, 다음으로 NOx 배출현황에 대해서 조사를 하였다. 마지막으로 NOx 배출 저감기술의 현황을 조사해 보았다. 본 연구를 통하여 국내에서 생산되는 선박용 디젤엔진이 IMO의 현재 NOx 배출 규제안을 만족하고 있는 것으로 파악이 되었다. 그러나 향후 더욱 엄격해질 IMO의 NOx 배출 규제안에 대응하기 위해서는 보다 더 고도화된 NOx저감기술의 개발이 필요할 것으로 예상된다.

• 한국자동차공학회논문집
• /
• 제10권3호
• /
• pp.77-84
• /
• 2002

Measurements of NO and NOx emission of laminar partially premixed LPG/air flames with and without acoustic excitation are reported. The NOx emission at the tailpipe of a combustion chamber is determined by chemiluminescent analyser. The NOx measurements are taken in flames with several different center tube equivalance ratio( ø$\sub$o/), and overall equivalace ratio(ø$\sub$o/) for a fixed fuel flowrate. The NOx emission decrease to reach a minimum value at an optimum ø$\sub$c/ 2. Theø$\sub$c/ 2 flame gives a compromise of thermal NO and prompt NO mechanism. In the case of excitation. the visual shape of the flame is changed from laminar flame to turbulent-like flame. With increasing levels of excitation amplitude, an optimum value of the NO and NOx emission exists. A shorter flame caused by the enhanced upstream mixing due to acoustic excitation results in the reduction of NO and NOx emission in the present flames. The reduction of flame length affects the shorter residence time of center tube mixture, and significantly influences the NOx reduction.

• 한국연소학회지
• /
• 제14권3호
• /
• pp.37-44
• /
• 2009

An experimental study was conducted to reduce NOx emission in RT(radiant tube)burner by using oscillating combustion processes in RIST. A solenoid valve gives the various oscillating conditions, such as oscillation frequency, duty ratio of fuel flow. In this study, we used commercial software, CFD-ACE+ to predict combustion and NOx emission characteristics for various experimental oscillation conditions. The effect of oscillation frequency and duty ratio on NOx emission will be discussed in terms of flow field, temperature and equivalence ratio distributions in detail.

• 한국분무공학회지
• /
• 제21권4호
• /
• pp.207-213
• /
• 2016

To protect air pollution of urban area from motor vehicles, emission limits for diesel vehicles have been dramatically lowered in short period. But recent studies have shown that on-road NOx emissions of light-duty diesel vehicles are considerably higher than the values measured with laboratory test procedures used for emission certification. To tackle with this issue, Ministry of Environment have a plan to introduce EU RDE-LDV (Real-driving Emission-Light-duty Vehicle) regulation. In this study, 4 Euro 6 diesel vehicles have been tested with the new test procedures published by EU to estimate on-road NOx emissions using PEMS (Portable Emission Measurement System). The results have shown that the requirements of EU RDE-LDV could be met in driving condition of metropolitan area for constitution of test routes and validity of test results. In analysing with Moving Averaging Window method the completeness and normality of test data were validated with the requirement. On-road NOx emissions were quite deviated as test vehicles and higher than the new limit of on-road NOx emission enforced from Sept. 2017, which means that RDE-LDV can effectively reduce NOx emission of diesel vehicles in real driving conditions of Korea.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2000년도 제21회 KOSCO SYMPOSIUM 논문집
• /
• pp.67-76
• /
• 2000

Experimental and numerical investigation on NOx emission characteristics with equivalence ratios, fuel flow rates and nozzle diameters were studied in CH4 Jet flames. Emission indices of NOx were measured by chemiluminescent method with carbon converter. Numerical analyses were carried out with GRl-2.11 mechanism that includes C2-chemistry and all of NO reaction mechanisims. The roles of thermal NO and prompt NO mechanism on each flame's NOx emission index were investigated. The results of this study show that the numerical results represent well the trends of ElNOx experimentally observed. The numerical analyses clarified the trends of EINOx with equivalence ratios, fuel flow rates and nozzle diameters.