• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.2
• /
• pp.183-192
• /
• 2009

SAR(Synthetic Aperture Radar) is an all-weather imaging radar and is widely used in military and civil application. Especially high-resolution SAR images are very important in military purpose because it can be used at target recognition application. LIG Nex1 developed a SAR system called NexSAR with bandwidth of 600 MHz and resolution of 30 cm to obtain technologies required for high-resolution SAR. To achieve 600 MHz bandwidth of waveform generator, two DDSs are used and its output signals are SSB modulated. And deramp technique is used to reduce the sampling rate of ADC at high resolution mode. NexSAR has stripmap and spotlight modes and its functionality and performances are evaluated through ground and flight tests.

• Journal of Advanced Navigation Technology
• /
• v.28 no.3
• /
• pp.309-314
• /
• 2024

Avionics Intercom performs communication between pilot, co-pilot and crews in aircraft. In the case of developing intercom in the aircraft modification development project, additional communication equipment or avionics equipment is configured to link the existing intercom with the headsets. Newly designed intercom needs a configuration that receives an aircraft headset microphone and transmits a microphone signal to the existing intercom, and these signals are required to perform signal quality above a certain level. To satisfy these requirements, microphone transmitter circuit has designed and tested, but quality factors of signal were not suitable. In order to avoid the issue, eliminate transmitter and apply signal bridge circuit considered with load effect, and it meets requirements. In this paper, the test results for the signal quality for each configuration are reviewed.

• Journal of the Korean Society of Radiology
• /
• v.15 no.1
• /
• pp.9-14
• /
• 2021

Recently, magnetic resonance imaging (MRI), which can acquire images with good contrast without exposure to radiation, has been widely used for diagnosis. However, noise that reduces the accuracy of diagnosis is essentially generated when acquiring the MR images, and by adjusting the parameters, the noise problem can be solved to obtain an image with excellent characteristics. Among the parameters, the number of excitation (NEX) can acquire images with excellent characteristics without additional degradation of image characteristics. In contrast, appropriate NEX setting is required since the scan time increases and motion artifacts may occur. Therefore, in this study, after fixing all MRI parameters through the MRiLab simulation program, we tried to evaluate the tendency of image characteristics according to changing NEX through quantitative evaluation of brain T2 weighted images acquired by adjusting only NEX. To evaluate the noise level and similarity of the acquired image, signal to noise ratio (SNR), contrast to noise ratio (CNR), root mean square error (RMSE) and peak signal to noise ratio (PSNR) were calculated. As a result, both noise level and similarity evaluation factors showed improved values as NEX increased, while the increasing width gradually decreased. In conclusion, we demonstrated that an appropriate NEX setting is important because an excessively large NEX does not affect image characteristics improvement and cause motion artifacts due to a long scan.

• Journal of Positioning, Navigation, and Timing
• /
• v.10 no.2
• /
• pp.121-130
• /
• 2021

In this paper, we propose a method to improve the positioning accuracy of TOA based indoor positioning system in NLOS environments. TOA based indoor positioning systems have been studied mostly considering LOS environments. However, it is almost impossible to maintain the LOS environments due to obstacles such as people, furniture, walls, and so on. The proposed method in this study compensates the range error caused by the NLOS environments. We confirmed that positioning accuracy of a proposed method is improved than conventional algorithms through simulation and field test.

• Journal of the Korean Society of Systems Engineering
• /
• v.6 no.2
• /
• pp.1-6
• /
• 2010

본 논문은 시스템 엔지니어링 프로세스 및 방법론에 입각하여 조직의 시스템 엔지니어링 전산지원도구 인프라를 구축한 사례에 대해 제시한다. SE 표준 프로세스인 EIA-632를 기준으로 시스템 설계의 요구사항 정의 프로세스, 해결방안 정의 프로세스, 제품구현의 구현 프로세스, 기술평가의 시스템 분석 프로세스를 효율적으로 수행할 수 있도록 전산지원도구 인프라를 IBM 사의 Rational 제품들로 구축한 것을 보여주고, 각 프로세스 별 구축된 전산지원도구의 활용법을 보여준다.

• International journal of advanced smart convergence
• /
• v.9 no.2
• /
• pp.114-122
• /
• 2020

When replacing hardware due to obsolescence, discontinuation, and expansion of software-equipped electronic equipment, software changes are required in the past, but if virtualization technology is applied, it can be applied without software changes. In this regard, we studied in order to apply virtualization technology in the development of naval multi-function radar signal processing, we studied hardware and OS independency for Docker and performance comparison between Docker and virtual machine. As a result, it was confirmed that hardware and OS independence exist when using Docker and that high-speed processing is possible compared to the virtual machine.

• The Journal of the Korea Contents Association
• /
• v.18 no.8
• /
• pp.338-344
• /
• 2018

The purpose of this study was to determine the optimal number of excitations(NEX) of diffusion weighted imaging(DWI) which is clinically useful in patients with musculoskeletal diseases while the scan time is relatively long. In this study, 30 patients underwent knee MRI using diffusion weighted image sequence using b values targeted on the bone and muscle. The NEX were varied from 1 to 5 and the ADC values were measured and analyzed. As a result of the study, 4 NEX and 2 NEX showed an statistically identical effect with the existing NEX on the bone and muscle diffusion weighted images, respectively. Also, it proved that the scan time could be significantly reduced by 21.2 % and 59.6 % compared to the established NEX which meant the optimal NEX could replace the existing NEX. In conclusion, applying the optimal NEX on the musculoskeletal bone and soft tissue DWI could improve the problems caused by the long scan time.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.12 no.5
• /
• pp.601-608
• /
• 2009

Interoperability is the key issue in NCW. However, old-fashioned weapon systems have low level interoperability. The representative example is BTCS. Therefore, we apply KVMF R1 to BTCS in order to improve interoperability and testify the effectiveness of how to apply without any changes in existing software. In this paper, we have proposed a message and software architecture design method for applying KVMF to developed weapon system. Finally, it is confirmed that the proposed method is superior to apply KVMF to existing weapon system in a point of verifying how to highly efficiently apply KVMF on existing weapon system.

• Journal of Magnetics
• /
• v.18 no.4
• /
• pp.422-427
• /
• 2013

The aim of this study was to investigate effects of the number of acquisitions (NEX) on signal-to-noise (SNR) and artifacts in SENSE parallel imaging of magnetic resonance imaging (MRI). 3.0T MR System, 8 Channel sensitivity encoding (SENSE) head coils were used along with an in-vivo phantom. Reference sequence of 3D fast field echo (FFE) was consisted of NEX values of 2, 4, 6, 8, 10 and 12. The T2 turbo spin echo (TSE) sequence used for exams achieved SENSE factors of 1.2, 1.5, 1.8, 2.0, 2.2, 2.5, 2.8, 3.0, 3.2, 3.5, 3.8 and 4.0. Exams were conducted five times for each SENSE factor to measure signal intensity of the object, the posterior phase-encode direction and frequency direction. And SNR was calculated using mean values. SENSE artifacts were identified as background signal intensity in the phase-encoded direction using MRIcro. It was found that SNR increased but SENSE artifacts reduced with NEX of 4, 8 and 12 when the NEX increased in reference scan. It is therefore concluded that image quality can be improved with NEX of 4, 8 and 12 for reference scanning.

• International Journal of Internet, Broadcasting and Communication
• /
• v.16 no.1
• /
• pp.330-338
• /
• 2024

In this paper, a Ka-band high-output active phased array antenna device applicable to small radars and seekers was designed, and the improved performance was studied. The radiation device assembly consists of 1x8 arrangements, and the step flared notch antenna type. It shows low active reflection loss characteristics in broadband, and low loss characteristics by applying the air-strip feeding structure, and is designed to enable beam steering up to 45 degrees. The TRM(transmit receive module) output power is more than 2.0W per channel using GaN HPA in the transmitting path, and satisfies more than 25.0 dB gain and less than 6.0 dB noise figure in the receiving path. Accordingly, the Effective Isotropically Radiated Power(EIRP) of the antenna unit shows the performance of 0.00 dB or more and the receive gain-to-noise temperature ratio(G/T) of 0.00 dB/k or more. For demonstration, we have designed aforementioned planar array antenna which consists of 64 radiating elements having a size within 130 mm x 130 mm x 300 mm and weight of less than 4.9 kg..