• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.5
• /
• pp.239-247
• /
• 2013

In network based on multi-interface, there are needed channel assignment strategy that reduce interference and improve bandwidth efficiency by assigning each interface to available channels in order to utilize effectively multiple wireless interfaces on each node. MCS protocol had been proposed, which improve capacity and throughput of network by using hybrid assignment. MCS uses as the criterion to assign channel the number of node that use the same channel in contention area. but there have an problem that this information exactly does not reflect actually offered channel load. in this paper, we proposes CAMCS protocol to assign channel by that the channel busy degree to indicate the occupancy rate of channel by nodes as well as the number of nodes that use the same channel in inference area is used as criterion for estimation channel load, and conform performance improvement effect by simulation.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.21 no.5
• /
• pp.90-99
• /
• 1984

A onetimensional distribution of the temperature and the heat source in the SOI (silicon-on-insulator) multi-layer structure illuminated by tungsten lamps from both sides was obtained by solving the heat equation in steady state on a finite difference grid using successive over-relaxation method. The heat source distribution was obtained by considering such features as spectral components of the light source, multiple reflection at the internal interfaces, temperature and frequency dependence of the light absorption coefficient, etc. The front and back surface temperatures, which are boundary conditions for the heat equation, were derived from a requirement that they satisfy the radiation conditions. The radiation flux as well as the conduction flux was considered in modelling the thermal behaviour at the internal interfaces. Since the temperature and the heat source profiles are strongly dependent upon each other, the calculation of each profile was iterated using the updated profile of the other until they are consistent with each other. The experimental temperature at the front surface of the wafer as measured by Pyrometer was about 1200$^{\circ}$K, while the simulated temperature was 1120$^{\circ}$K.

• Journal of Information Processing Systems
• /
• v.8 no.4
• /
• pp.603-620
• /
• 2012

Proxy Mobile IPv6 (PMIPv6) is a network-based mobility support protocol and it does not require Mobile Nodes (MNs) to be involved in the mobility support signaling. In the case when multiple interfaces are active in an MN simultaneously, each data flow can be dynamically allocated to and redirected between different access networks to adapt to the dynamically changing network status and to balance the workload. Such a flow redistribution control is called "flow mobility". In the existing PMIPv6-based flow mobility support, although the MN's logical interface can solve the well-known problems of flow mobility in a heterogeneous network, some missing procedures, such as an MN-derived flow handover, make PMIPv6-based flow mobility incomplete. In this paper, an enhanced flow mobility support is proposed for actualizing the flow mobility support in PMIPv6. The proposed scheme is also based on the MN's logical interface, which hides the physical interfaces from the network layer and above. As new functional modules, the flow interface manager is placed at the MN's logical interface and the flow binding manager in the Local Mobility Anchor (LMA) is paired with the MN's flow interface manager. They manage the flow bindings, and select the proper access technology to send packets. In this paper, we provide the complete flow mobility procedures which begin with the following three different triggering cases: the MN's new connection/disconnection, the LMA's decision, and the MN's request. Simulation using the ns-3 network simulator is performed to verify the proposed procedures and we show the network throughput variation caused by the network offload using the proposed procedures.

• Journal of the Korea Computer Industry Society
• /
• v.2 no.7
• /
• pp.945-952
• /
• 2001

In consequence of expansion of internet users, electronic commerce is becoming a new prototype for marketing and sales, arid most of electronic commerce sites or internet shopping malls provide a rich source of information and convenient user interfaces about the organizations customers to maintain their patrons. One of the convenient interfaces for users is service to recommend products. To do this, they must exploit methods to extract and analysis specific patterns from purchasing information, behavior and market basket about customers. The methods are association rules and sequential patterns, which are widely used to extract correlation among products, and in most of on-line electronic commerce sites are executed with users information and purchased history by category-oriented. But these can't represent the diverse correlation among products and also hardly reflect users' buying patterns precisely, since the results are simple set of relations for single purchased pattern. In this paper, we propose an efficient mining technique, which allows for multiple purchased patterns that are category-independent and have relationship among items in the linked structure of single pattern items.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.11A
• /
• pp.870-877
• /
• 2011

IEEE 802.11 devices are widely used, and terminals can be equipped with multiple IEEE 802.11 interfaces as low-cost IEEE 802.11 devices are deployed. The off-the-shelf IEEE 802.11 devices provide multiple channels and multiple data rates. In practical multi-channel networks, since there is channel heterogeneity which indicates that channels have different signal characteristics for the same node, channels should be efficiently assigned to improve network capacity. In addition, in multi-rate networks, low-rate links severely degrade the performance of high-rate links on the same channel, which is known as performance anomaly. Therefore, in this paper, we propose a heterogeneity aware channel assignment (HACA) algorithm that improves network performance by reflecting channel heterogeneity and performance anomaly. Through NS-2 simulations, we validate that the HACA algorithm shows improved performance compared with existing channel assignment algorithms that do not reflect channel heterogeneity.

• The Journal of Engineering Geology
• /
• v.27 no.3
• /
• pp.305-312
• /
• 2017

The most effective way to distinguish subsurface interfaces that produce various geophysical responses is through the integration of multiple geophysical methods, with each method detecting both a complementary and unique set of distinct physical properties relating to the subsurface. In this study, shallow seismic reflection (SSR) and ground penetrating radar (GPR) surveys were conducted at the Cheongju-Gadeok site of the Korea National Groundwater Monitoring Network to map the water table, which was measured at 12 m depth during the geophysical surveys. The water table proved to be a good target reflector in both datasets, as the abrupt transition from the overlying unsaturated weathered rock to the underlying saturated weathered rock yielded large acoustic impedance and dielectric constant contrasts. The two datasets were depth converted and integrated into a single section, with the SSR and GPR surveys conducted to ensure subsurface imaging at approximately the same wavelength. The GPR data provided detailed information on the upper ~15 m of the section, whereas the SSR data imaged structures at depths of 10-45 m. The integrated section thus captured the full depth coverage of the sandy clay, water table, weathered rock, soft rock, and hard rock structures, which correlated well with local drillcore and water table observations. Incorporation of these two geophysical datasets yielded a synthetic section that resembled a simplified aquifer model, with the best-fitting seismic velocity, dielectric constant, and porosity of the saturated weathered layer being $v_{seismic}=1000m/s$, ${\varepsilon}_r=16$, and ${\phi}=0.32$, respectively.

• The Journal of the Korea Contents Association
• /
• v.8 no.3
• /
• pp.25-31
• /
• 2008

We propose a low power level-up/down shifter with single supply that can be used at SoC with multiple supply. The proposed circuit interfaces IPs which are operated on the different supply voltages. The circuit is designed with a single supply that decreases the low power consumption and the complexity of supply routing and layout. The proposed circuit operated at 500MHz for level-up and at 1GHz for level-down. The level-up/down shifter improves noise immunity of the system at I/O circuit. The circuit is evaluated for 1.8V, 2.5V, 3.3V supply with 0.18um CMOS technology, respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.8A
• /
• pp.820-827
• /
• 2010

In these days, video applications for special purposes such as video conference systems among multiple users and video surveillance systems require multiple video connections and QoS guarantee. The video systems employ IEEE 802.11 Wireless LAN devices to support broadband wireless interfaces and easy internet accesses for cheaper prices. However, according to the current IEEE 802.11e HCCA standard, if more than three video sessions are established in WSTA services, some of them must share the TXOP because the available number of TSIDs for video transmission is two. In order to resolve the problem, we devised a method which can establish up to 15 video sessions by slightly modifying the frame structure while maintaining the compatibility with current standard. Our method is implemented on the NCTUns 4.0 network simulator, and evaluated not only numerically in terms of throughput, delay, and PSNR, but also experimentally in the sense of real video clips that are used as input to our simulation. The results showed that our method sufficiently guarantees the transmission bandwidth requested by each video session.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.2
• /
• pp.15-23
• /
• 2013

In this paper, we propose a session management and control architecture for N-Screen services, which enable users to change devices and transfer contents among user's devices during service by session transfer and split. In N-Screen services, users may have multiple devices with different attribute such as screen resolution, CPU capability and access network interfaces. Also, since users may change devices during service, or one user may use multiple stream, N-Screen services need to enable the user to share and transfer contents across N-Screen devices. We introduce the management and control servers to provide session split over user multiple devices and session continuity while changing device. Furthermore, the proposed architecture provides the device capabilities aware session continuity. In addition, the proposed scheme minimizes the session transfer delay and content server processing load. We present results that show the effectiveness and usefulness of proposed architecture.

• Journal of the Korea Society of Computer and Information
• /
• v.16 no.1
• /
• pp.101-115
• /
• 2011

PECOLE (Peer-to-Peer Collaborative Environment) is a P2P-based multimedia distributed collaborative environment supporting a collaborative workspace which is composed of a variety of collaborative applications such as multi-chat, video conferencing, screen sharing and etc. Unfortunately, due to the PECOLE's simple group management, it is impossible to perform collaboration activities while joining multiple groups. In this paper, we present the design and implementation of PECOLE+ which is an extension of PECOLE. PECOLE+ resolves the drawback of PECOLE by providing the Group Management Service and the Workspace Management Service. The Group Management Service provides functionalities such as creating groups, joining multiple groups, and searching groups, and etc. The Workspace Management Service provides each group with an associated workspace, supporting the execution of collaborative applications over the workspace. In addition, any collaborative applications with the provided plug-in interfaces can be executed over the workspace as a PECOLE+ collaborative application.