• Journal of the Korean Society for Railway
• /
• v.7 no.4
• /
• pp.339-344
• /
• 2004

This paper proposes transformerless power conversion system consisting of a single-phase diode rectifier and a shunt hybrid filter for the electric-railway system. The hybrid filter consists of a single tuned LC filter per a phase and a low-rated NPC type multi-level inverter. Compared with conventional active filters. transformers are not used. Also, LC filter works as not only a harmonic filter tuned at the 3rd harmonic frequency but also a switching-ripple filter. The rating of the active filter can be decreased by using a NPC type multi-level inverter. The simulation results confirm the validity of the system.

• Journal of Power Electronics
• /
• v.15 no.2
• /
• pp.319-326
• /
• 2015

In this paper, a cost-effective single switch multi-channel LED (light emitting diode) driver is proposed. While conventional LED drivers require as many non-isolated DC/DC converters as the number of LED channels, the proposed LED driver needs only one power switch and several balancing capacitors instead of expensive non-isolated DC/DC converters. Therefore, the proposed driver features a simpler structure, with a lower cost and a higher efficiency. Because its power switch can be turned off under the zero current switching condition, it has very desirable advantages such as improved electromagnetic interference characteristics and high efficiency. Moreover, it uses only a small number of DC blocking capacitors with no additional active devices for the current balancing of multi-channel LEDs. As a result, the proposed driver exhibits high reliability and is cost effective. To confirm the validity of the proposed driver, a theoretical analysis is performed, and design considerations and experimental results obtained from a prototype that is applicable to a 46" LED-TV are presented.

• Proceedings of the KIPE Conference
• /
• 2001.10a
• /
• pp.529-533
• /
• 2001

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.04a
• /
• pp.262-263
• /
• 2011

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.12B
• /
• pp.1050-1057
• /
• 2008

Wireless Mesh Networks (WMNs) have recently become a hot issue to support high link capacity in wireless access networks. The IEEE 802. I 1 standard which is mainly used for the network interface technology in WMNs supports up to 3 or 12 multiple channels according to the IEEE 802.11 specification. However, two important problems must be addressed when we design a channel assigmnent algorithm: channel dependency problem and channel scanning delay. The former occurs when the dynamic channel switching of an interface leads to the channel switching of other interfaces to maintain node connectivity. The latter happens per channel switching of the interface, and affects the network performance. Therefore, in this paper, we propose the Distance-Based Channel Assigmnent (DB-CA) scheme for multi-channel WMNs to solve such problems. In DB-CA, nodes just perform channel switching without channel scanning to communicate with neighboring nodes that operate on different channels. Furthermore, DB-CA minimizes the interference of channels being used by nodes near the gateway in WMNs. Our simulation results show that DB-CA achieves improved performance in WMNs.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.8
• /
• pp.2930-2947
• /
• 2014

With the rapid growth of the communication technology, intelligent terminals (i.e. PDAs and smartphones) are widely used in many mobile applications. To provide secure communication in mobile environment, in recent years, many user authentication schemes have been proposed. However, most of these authentication schemes suffer from various attacks and cannot provide provable security. In this paper, we propose a novel remote user mutual authentication scheme for multi-server environments using elliptic curve cryptography (ECC). Unlike other ECC-based schemes, the proposed scheme uses ECC in combination with a secure hash function to protect the secure communication among the users, the servers and the registration center (RC). Through this method, the proposed scheme requires less ECC-based operations than the related schemes, and makes it possible to significantly reduce the computational cost. Security and performance analyses demonstrate that the proposed scheme can solve various types of security problems and can meet the requirements of computational complexity for low-power mobile devices.

• ETRI Journal
• /
• v.32 no.2
• /
• pp.184-194
• /
• 2010

Ethernet ring protection (ERP) technology, which is defined in ITU-T Recommendation G.8032, has been developed to provide carrier grade recovery for Ethernet ring networks. However, the filtering database (FDB) flush method adopted in the current ERP standard has the drawback of introducing a large amount of transient traffic overshoot caused by flooded Ethernet frames right after protection switching. This traffic overshooting is especially critical when a ring provides services to a large number of clients. According to our experimental results, the traditional FDB flush requires a link capacity about sixteen times greater than the steady state traffic bandwidth. This paper introduces four flush optimization schemes to resolve this issue and investigates how the proposed schemes deal with the transient traffic overshoot on a multi-ring network under failure conditions. With a network simulator, we evaluate the performance of the proposed schemes and compare them to the conventional FDB flush scheme. Among the proposed methods, the extended FDB advertisement method shows the fastest and most stable protection switching performance.

• Journal of Communications and Networks
• /
• v.7 no.3
• /
• pp.377-384
• /
• 2005

The purpose of this research is to develop and evaluate a traffic engineering architecture that uses local state information. This architecture is applied to an Internet protocol radio access network (RAN) that uses multi-protocol label switching (MPLS) and differentiated services to support mobile hosts. We assume mobility support is provided by a protocol such as the hierarchical mobile Internet protocol. The traffic engineering architecture is router based-meaning that routers on the edges of the network make the decisions onto which paths to place admitted traffic. We propose an algorithm that supports the architecture and uses local network state in order to function. The goal of the architecture is to provide an inexpensive and fast method to reduce network congestion while increasing the quality of service (QoS) level when compared to traditional routing and traffic engineering techniques. We use a number of different mobility scenarios and a mix of different types of traffic to evaluate our architecture and algorithm. We use the network simulator ns-2 as the core of our simulation environment. Around this core we built a system of pre-simulation, during simulation, and post-processing software that enabled us to simulate our traffic engineering architecture with only very minimal changes to the core ns-2 software. Our simulation environment supports a number of different mobility scenarios and a mix of different types of traffic to evaluate our architecture and algorithm.

• ETRI Journal
• /
• v.18 no.4
• /
• pp.315-338
• /
• 1997

We extend our previous theoretical analysis of electronic and optical properties of p-type quantum well structures based on the two heavy- and light-hole system to include all the three valence bands. These theories are then used to clarify the origin of the normal incidence absorption and photo current at photon wavelengths of 2 - 3 ${\mu}m$, which was observed in addition to the absorption around 8 ${\mu}m$ by a recent experimental investigation with heavily doped p-type GaAs/AlGaAs multi-quantum well (MQW) structures. In the theoretical analysis, the Hartree and exchange-correlation many-body interactions are taken into account within one-particle local density approximation, and it is shown that normal incidence absorption occurs in two wavelength regions over the transition energy range higher than barrier height for p-type GaAs/AlGaAs superlattices with well doping of $2{\times}10^{19}\;cm^{-3}$; one region has broad absorption peaks with coefficients of about 5000 $cm^{-1}$ around 8 ${\mu}m$, and the other has two rather sharp peaks at 2.7 ${\mu}m$ and 3.4 ${\mu}m$ with 1800 $cm^{-1}$ and 1300 $cm^{-1}$, respectively. The result indicates that the theory explains the experimental observation well, as the theoretical and experimental results are in close agreement in general absorption features.

• Journal of Internet Computing and Services
• /
• v.7 no.4
• /
• pp.57-66
• /
• 2006

In this paper, I propose a new method of Multi-Pulse Speech Coding(FBD-MPC: Frequency Band Division MPC) by using TSIUVC(Transition Segment Including UnVoiced Consonant) searching, extraction and approximation-synthesis method in a frequency domain. As, a result. the extraction rates of TSIUVC are 84.8%(plosive), 94.9%(fricative) and 92.3%(affricative) in female voice, 88%(plosive), 94.9%(fricative) and 92.3%(affricative) in male voice respectively. Also, I obtain a high quality approximation-synthesis waveforms within TSIUVC by using frequency information of 0.547kHz below and 2.813kHz above. I evaluate MPC by using switching information of voiced/unvoiced and FBD-MPC by using switching information of voiced/Silence/TSIUVC. As, a result, I knew that synthesis speech of FBD-MPC was better in speech quality than synthesis speech of the MPC.