• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.16 no.5
• /
• pp.1540-1560
• /
• 2022

Latest technological innovation in the development of compact lower power radios has led to the explosion of Internet of Things. With Wi-Fi, Zigbee and other physical layer protocols offering short coverage area there was a need for a RF protocol that had a larger coverage area with low power consumption. LoRa offers Long Range with lower power consumption. LoRa offers point to point and point to multipoint connections. with Single hop communication in place the need for routing protocols are eliminated. LoRa Wide Area Network stack can accommodate thousands of nodes under a single LoRa gateway with a single hop communication between the end nodes and LoRaWAN gateway. This paper takes an experimental approach to analyze the basic physical layer parameters of LoRa and the practical coverage offered by a LoRaWAN under highly dense urban conditions with variable topography. The insights gained from the practical deployment of the LoRaWAN network, and the subsequent performance analysis is used to design a novel public utility monitoring platform. The second half of the papers is designing a robust platform to integrate both existing wired sensor water meters, current and future generation wireless water meters. The Common Automated Metering Platform is designed to integrate both wired sensors and wireless (LoRaWAN and Wi-Fi) supported water meters. This integrated platform reduces the number of nodes under each LoRaWAN gateway and thus improves the scalability of the network. This architecture is currently designed to accommodate one utility application but can be modified to integrate multi-utility applications.

• Journal of Korea Multimedia Society
• /
• v.16 no.10
• /
• pp.1196-1203
• /
• 2013

In general, the cost of transceiver for wireless network configuration is more expensive than that for wired network. However, in case of environmental management system in a tunnel, the cost can be minimized by adopting low rate tranceiver because the amount of the exchanged data for tunnel monitoring is very small. When the obtained data from sensor node is sent directly to the corresponding command node, there is no need to consider routing problem of the data transfer. However in this case, sensor nodes are required to be implemented with high power transmitter and experience high energy consumption. To tackle this problem, relay nodes can be used to transfer the data of tunnel monitoring, and suitable routing protocols for selecting optimum path are needed. Therefore, in this paper, we propose a routing algorithm and a self-configuration protocol for environment management system in tunnel.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.9
• /
• pp.1696-1702
• /
• 2008

A MANET(Mobile Ad-hoc Network) is a multi-hop routing protocol formed by a collection without the intervention of infrastructure. So the MANET also depended on the property as like variable energy, high degree of mobility, location environments of nodes etc. Generally the various clustering technique and routing algorithm would have proposed for improving the energy efficiency. One of the popular approach methods is a cluster-based routing algorithm using in MANET. In this paper, we propose an algorithm techniques which is TICC (Time Interval Clustering Control) based on energy value in property of each node for solving cluster problem. It provides improving cluster energy efficiency how can being node manage to order each node's energy level. TICC could be able to manage the clustering, re-configuration, maintenance and detection of Node in MANET. Furthermore, the results of modeling shown that Node's energy efficiency and lifetime are improved in MANET.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.3
• /
• pp.664-674
• /
• 1996

In high speed multi-wavelength networks, retransmission overhead due to desination conflict or control packet collision is one factor of performance degration because signal prpagation delay is much larger than the transmission time of data packet. In this paper, an efficient WDMA protocol with a collision avoidance mechanism is proposed for high speed WDM single-hop network with a passive star topology. In proposed protocol, each node has cource queues and routing table to store souting informatio. This architecture makes is possible to avoid any kind of collision when a node reserves the channel to transmit a data packet. High system thoughput and channel utilization can be achieved by proposed protocol since there are no discarded packets caused by any collision at transmission time. The performance of proposed protocol is evaluated in term of throughput and delay with variations in offered load. Simulation results show that the proposed protocol has superior performance to convertional protocols under nonuniform traffic as well as uniform traffic.

• KIPS Transactions on Computer and Communication Systems
• /
• v.4 no.1
• /
• pp.11-14
• /
• 2015

WSN (Wireless Sensor Network) based on low-power is one of the core technologies in the ubiquitous society. In this paper, we present a border surveillance and control system in WSN environment. The system consists of static sensor node, mobile sensor node, static gateway, mobile gateway, server and mobile application. Mobile applications are divided into user mode and manager mode. So users monitor border surveillance through mobile phone and get information of border network environment without time and space constraints. In manager mode, for the flexible operation of nodes, manager can update to the software remotely and adjust the position of the mobile node. And also we implement a suitable multi-hop routing protocol for scalable low-power sensor nodes and confirm that the system operates well in WSN environment.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.5
• /
• pp.1215-1223
• /
• 2014

In multi-hop wireless networks, a message transmission path is set up on demand by a route discovery step, where a shortest path is used in general. The shortest path, however, normally uses the nodes near the center area, which causes a high traffic load in that area and reduces the message transmission reliability. We propose a stable routing protocol considering the remaining energy of nodes. Our protocol uses ETX as a link performance estimator and tries to avoid the nodes with smaller energy. By doing this, we can reduce the route failure probability and packet loss. We have evaluated the performance of the proposed protocol using QualNet and compared with AODV and MRFR protocols. The simulation result shows that our protocol has a similar performance as MRFR in terms of end-to-end message reception ratio, average message delay and delay jitter, but outperforms MRFR in terms of traffic load distribution.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.7
• /
• pp.37-48
• /
• 2014

Wireless mesh networks have emerged as a key technology in environment that needs wireless multi-hop communication without infrastructure and IEEE 802.11s mesh network standard have currently been established. One of big differences between this standard and the legacy IEEE 802.11 is that MCCA MAC is included to support QoS. MCCA supports bandwidth reservations between neighbors, so it can satisfy the QoS of bandwidth guarantee. However, MCCA has dis-advantages as follow; 1) it can not guarantee end-to-end bandwidth, 2) in multi-interface multi-channel wireless environments, the IEEE 802.11s does not provide a bandwidth reservation protocol and a wireless channel assignment etc. In this paper, we have proposed MIMC R-HWMP, which expands R-HWMP that was proposed in our previous work[3], to support multi-interface multi-channel. By simulation, we showed end-to-end bandwidth guarantee and the increase in the available bandwidth in multi-interface multi-channel wireless mesh networks.

• Journal of KIISE:Information Networking
• /
• v.32 no.1
• /
• pp.100-109
• /
• 2005

A Mobile Ad-Hoc Network (MANET) supports a multi-hop wireless network without any prepared base station (BS). The MANET is capable of building a mobile network automatically without any help from DHCP servers for address allocation or routers to forward or route messages. Many routing protocols have been proposed for the MANET, but these specify the most optimized or shortest path from a source to a destination, and they assume that nodes are pre-configured before communication. To make up for this, address allocation algorithms, such as MANETConf [1] and prophet address allocation algorithm [2], have been proposed. Especially, MANETConf proposes address allocation algorithm with duplication address check. In this paper, we present a dynamic node configuration protocol based on 2-tierd hierarchical network architecture for mobile ad-hoc network, modified from [1]. Especially, it reduces the number of broadcast message exchange between nodes when a new node somes into a network, which lessens network overhead, remarkably. This protocol is based on two-tired structure, and it ensures address allocation with simple duplication address defection mechanism.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.16 no.6
• /
• pp.153-158
• /
• 2016

Broadcasting in multi-hop wireless sensor networks is a basic operation that supports many applications such as route search, setting up addresses and sending messages from the sink to sensor nodes. The broadcasting using flooding causes problems that can be mentioned as a broadcasting storm such as redundancy, contention and collision. A variety of broadcasting schemes using wireless sensor networks have been proposed to achieve superior performance rather than simple flooding scheme. Broadcasting algorithms in wireless sensor networks can be classified into six subcategories: flooding scheme, probabilistic scheme, counter-based scheme, distance-based scheme, location-based schemes, and neighbor knowledge-based scheme. This study analyzes a simple flooding scheme, probabilistic scheme, counter-based scheme, distance-based scheme, and neighbor knowledge-based scheme, and compares the performance and efficiency of each scheme through network simulation.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.5 no.6
• /
• pp.588-594
• /
• 2010

In a multi-hop wireless sensor network, broadcasting is an elementary operation to support command message sending, route discovery and other application tasks. Broadcasting by flooding may cause serious redundancy, contention, and collision in the network, which is referred to as the broadcast storm problem. Many broadcasting schemes have been proposed to give better performance than simple flooding in wireless sensor network. How to decide whether re-broadcast or not also poses a dilemma between reach ability and efficiency under different host densities. In this paper, we present popular broadcasting schemes, which can reduce re-broadcast packets and improve SRB(Saved ReBroadcast). Simulation results show different levels of improvement over the simple flooding scheme.