• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.12
• /
• pp.1825-1832
• /
• 2013

Since domestic terrestrial DTV transition introduces the need for a multi-channel service as raised again to multi-channel service is being promoted. Current terrestrial broadcasters to realize multi-channel services are provided jointly countermeasures. Multi-channel services also active in policy-making of Korea Communications Commission. Therefore, in this article, terrestrial technical issues that arise in multi-channel services and services for the implementation of policy measures were proposed. Therefore, in this article terrestrial technical issues that arise in multi-channel services and services for the implementation of policy measures by looking at the future terrestrial multi-channel service to pursue the direction and policies of regulatory agencies aims to help.

• Journal of Sensor Science and Technology
• /
• v.9 no.6
• /
• pp.448-454
• /
• 2000

This paper describes the implementation of a multi-subject, multi-channel optical telemetry system for the short range measurement of electrocardiograms (EKGs) a system which receives command signals and transmits physiological signals to the external system using LED (Light Emitting Diode) and PD (Photodiode). This system decreases the dependency of power supply voltage to the CMOS IC chips and a new enforced synchronization technique using infrared bi-directional communication has also been proposed. The telemetry IC with the size of $5.1{\times}5.1mm^2$ has the following functions: receiving of command signal, initialization of internal state of all functional blocks, decoding of subject selection signal, time division multiplexing of 4-channel modulated physiological signals, transmission of modulated signals to external system, and auto power down control.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.8
• /
• pp.19-23
• /
• 2001

DSP-based implementation is pervasive in wireless communication parts for systems and handsets according to developing high-speed and low-power programmable Digital Signal Processor (DSP). In this paper, we present a real-time implementation of multi-channel Adaptive Multi-rate (AMR) speech coder. The real-time implementation of an AMR algorithm is achieved using 32-bit fixed-point TMS320C6202 DSP chip that operates at 250 MHz. We performed cross compile, linear assembly optimization and TMS320C62xx assembly optimization for real-time implementation. Furthermore, speech data input/output function and communication function with external CPU is included in an AMR speech coder. The AMR Speech coder developed using DSP EVM board was evaluated in ETRI IMT-2000 Test-bed system.

• Journal of the Korea Society of Computer and Information
• /
• v.22 no.6
• /
• pp.17-24
• /
• 2017

In recent digital broadcasting, up to 250 channels are multiplexed and transmitted. The channel transmission is made in the form of MPEG-2 Transport Stream (TS) and transmits one channel (Video, Audio). In order to check if many broadcast channels are transmitted normally, in multi-channel multi-view system, ability of real-time monitoring is required. In order to monitor efficient multi-channel, a distributed system in which functions and load are distributed should be implemented. In the past, we used an inefficient system that gave all of the functionality to a piece of hardware, which limited the channel acceptance and required a lot of resources. In this paper, we implemented a distributed multi-view system which can reduce resources and monitor them economically through efficient function and load balancing. It is able to implement efficient system by taking charge of decoding, resizing and encoding function in specific server and viewer function in separate server. Through this system, the system was stabilized, the investment cost was reduced by 19.7%, and the wall monitor area was reduced by 52.6%. Experimental results show that efficient real-time channel monitoring for multi-channel digital broadcasting is possible.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.4
• /
• pp.276-285
• /
• 2003

In this paper, we present real-time implementation of a R2MFC/DTMF (R2 Multi Frequency Combinations/Dual Tone Multiple Frequency) tone receiver/sender using a high performance DSP (Digital Signal Processor) and apply it to a carrier class VoIP (Voice over Internet Protocol) gateway system. The Receiver utilizes the Goertzel filter and the sender adopts the harmonic resonant filter. We describe, in detail, the techniques of multi-channel real-time implementation on a Texas Instruments TMS320C62x DSP such as effective PCM (Pulse Code Modulation) in/out by means of DMA (Direct Memory Access) and McBSP (Multi Channel Buffered Serial Port) and message communication via HPI (Host Port Interface), etc. From experimental results, we confirmed that the optimized code provided 780 channel capacity at 250㎒ C6202, and the our R2MFC/DTMF receiver/sender met ITU-T (International Telecommunication Union-Telecommunication) specifications.

• The Journal of the Acoustical Society of Korea
• /
• v.19 no.4
• /
• pp.45-51
• /
• 2000

This paper describes real-time implementation of a multi-channel G.729A speech coder using a 16 bit fixed-point Digital Signal Processor (DSP) and its application to a Voice Mailing Service (VMS) system. TMS320C549 by Texas Instruments was used as a fixed point DSP chip and a 4 channel G.729A coder was implemented on the chip. The implemented coder required 14.5 MIPS for the encoder and 3.6 MIPS for the decoder at each channel. In addition, memories required by the coder were 9.88K words and 1.69K words for code and data sections, respectively. As a result, the developed VMS system that accommodates two DSP chips was able to support totally 8 channels. Experimental results showed that the our multi-channel coder passes all of test vectors provided by ITU-T.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.565-568
• /
• 2005

Even though there has been a great deal of research and development for the compression techniques such as H.263, MPEG-1, and MPEG-2 in DVR systems, an efficient scheme for storing, accessing, and managing the huge amount of video data from multi-channel cameras needs to be developed. In this paper, we describe an implementation of MPEG-4 encoder for PC-based real-time multi-channel DVR systems.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.5
• /
• pp.1039-1044
• /
• 2005

A Multi-channel serial device using the embedded Linux system is designed for a remote controlling and monitoring system. The proposed device consists of a FIFO, a state machine, and an interrupter. The device program written in embedded Linux enables the effective programming of device. While the conventional multi-channel serial devices accesses every individual serial devices, the proposed device accesses the multi-channel serial device as if it is a single serial device. The device efficiently performs the multi-channel serial input/output operation and has fast access time than the conventional multi-channel serial device.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.11 no.3
• /
• pp.233-238
• /
• 2006

In order to solve power disturbances, power components measurement for both supply and demand side of power system must be implemented. This paper proposed a DSP (Digital Signal Processor)-based multi-channel (voltage 8-channel and current 10-channel) power components measurement system that simultaneously can measure and analyze power components for both supply md demand side. After voltage and current measurement accuracy revision using YOKOGAWA 2558, the developed system was tested in the field.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.11 no.3
• /
• pp.217-226
• /
• 1986

A method on the hardware implementation of the Multi-channel FIR digital filter using Digital Quarter Square Multiplication(DQSM) algorithm is proposed. This paper describes that ROM requirement can be reduced by using the double precision algorithm and the absolute value circuit, and also execution speed can be improved by reducing logic level steps of absolute value circuit. The frequency response of the four channel FIR digital filter implemented by the above method is quite agreeable with the frequency response simulated by Remez excahange algorithm.