• Journal of the Korea Society of Computer and Information
• /
• v.12 no.5
• /
• pp.131-137
• /
• 2007

Recently, Ant Colony Optimization (ACO) is emerged as a simple yet powerful optimization algorithm for routing and load-balancing of both wired and wireless networks. However, there are few researches trying to adopt ACO to enhance routing performance in WSN owing to difficulties in applying ACO to WSN because of stagnation effect. In this paper, we propose an energy-efficient path selection algorithm based on ACO for WSN. The algorithm is not by simply applying ACO to routing algorithm but by introducing a mechanism to alleviate the influence of stagnation. By the simulation result, the proposed algorithm shows better performance in data propagation delay and energy efficiency over Directed Diffusion which is one of the outstanding schemes in multi-hop flat routing protocols for WSN. Moreover, we checked that the proposed algorithm is able to mitigate stagnation effect than simple ACO adoption to WSN.

• Journal of Broadcast Engineering
• /
• v.19 no.3
• /
• pp.372-384
• /
• 2014

DTV field tests have been performed to measure field strength and to check reception ratio on indoor and outdoor sites. They use an antenna of 9m to measure DTV signal in case of outdoor measurement on the road. Modern skyscrapers require the analysis of vertical-directional wave propagation by measuring vertical-directional DTV signal. Even if the field strength is above the reception threshold of $43dB{\mu}V/m$, the reception is impossible in case of strong multi-path or high impulse noise. So, vertical-directional field measurement is essential in environment of tall buildings. In this paper, we developed an octo type multi-copter to measure vertical-directional DTV signal level. A compact and portable DTV signal level meter, an antenna, a microwave transmitter for data transmission, and a recording equipment are equipped in the multi-copter. Three different sites are selected to test the measurement system. Developed measurement system using the multi-copter is very useful in measuring vertical-directional DTV signal, especially in apartments, non-accessible area by vehicles, and forbidden areas.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.4
• /
• pp.428-435
• /
• 2004

With the rapid and wide-spread use of cellular telephones much attention has been focussed on propagation in the urban area crowed with buildings and houses. It is often surrounded by hills, forests, and mountains. The importance of surface scattering intereference between transmitters and receivers on the rough surfaces has been interested and investigated. Therefore, a prediction method is necessary to estimate the influence of rough surfaces on microwave radio propagation. Moreover, most of the mobile communications are performed based on the digital communication system rather than the analog one. In this case, we must pay more careful attention to the signal delay caused by the phase delay due to the multi-path propagation. In this paper we have analyzed numerically scattering of electromagnetic waves from building walls by using FVTD(Finite Volume Time Domain) method. We consider three different types of rough surfaces such as periodic, random, and composite structures. We calculate the bistatic normalized radar cross section (NRCS) for horizontal and vertical polarization, and we take account of the conventional optical reflection which corresponds to the n-th Bragg reflection for periodic structures. In addition, we investigated what conditions are needed in order to be able to ignore the higher order Bragg reflection for the periodic structures.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.4
• /
• pp.97-107
• /
• 2013

Underwater wireless communication systems can be useful for underwater environment observation, catastrophe prevention, ocean resources exploration, ocean organism research, vessel sinking exploration, and so on. However, unlike terrestrial wireless communication, underwater wireless communication should consider factors such as long propagation delay, limited transmission capacity, high bit-error rate due to potential loss in power, ambient noise, man-made noise, multi-path, etc., because of the inherent characteristics of water. Thus, in this paper, we propose a suitable media access control(MAC) protocol that applies a combination of the ALOHA MAC protocol and the CSMA/CA MAC protocol to underwater environment. We further propose a mathematical analysis model to evaluate performance. We also verify performance improvement in the proposed scheme in comparison with existing MAC protocols.

• Journal of Advanced Marine Engineering and Technology
• /
• v.40 no.1
• /
• pp.45-49
• /
• 2016

The performance of underwater acoustic communication systems is sensitive to inter-symbol interference caused by delay spread developed from multipath signal propagation. The multipath nature of underwater channels causes signal distortion and error floor. In order to improve the performance, it is necessary to employ an iterative coding scheme. Of the various iterative coding schemes, turbo code and convolutional code based on the BCJR algorithm have recently dominated this application. In this study, the performance of iterative codes based on turbo equalizers with equivalent coding rates and similar code word lengths were analyzed. Underwater acoustic communication system experiments using these two coding techniques were conducted on Kyeong-chun Lake in Munkyeong City. The distance between the transmitter and receiver was 400 m, and the data transfer rate was 1 Kbps. The experimental results revealed that the performance of turbo codes is better for channeling than that of convolutional codes that use a BCJR decoding algorithm.

• Journal of Satellite, Information and Communications
• /
• v.2 no.2
• /
• pp.1-9
• /
• 2007

In this paper, we describe the performance degradation of satellite Wibro system and compensation method in the high-speed railroad channel environment. High-speed railroad channel environment is divided into LOS channel and tunnel. In the LOS channel, signal blocking caused by railroad power feeder structures can be a critical problem which is can be solved with antenna diversity. On the other hand, multi path interference phenomenon, representable by propagation model of Optic Fiber, occurred in the tunnel may be another obstacle. These satellite Wibro system performance degradations in railroad channel environment are addressed and adequate compensation methods are proposed and verified through computer simulation. In addition, the ICI caused by Doppler shift in OFDM system is analyzed with its compensation method.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.3
• /
• pp.74-82
• /
• 2011

This paper describes a control system for positioning the real-time locations of the autonomous warfare vehicles and infantry, and for avoiding collisions between them. The control system utilizes the low-cost RSSI (Received Signal Strength Indication) for positioning the locations of the wireless devices. The mathematical mean filtering processes are applied to the calculation of the RSS matrix to improve the performance for positioning the wireless devices in the multi-path propagation environment. A fuzzy rule is proposed to recover and replace the broken packets occurring in the wireless communication. The gradient and geometric triangulation algorithms are proposed to trace the real-time locations of wireless devices, based on the distances between them. The estimated location results of the geometric triangulation algorithm are compared with the results of the GPS and the gradient algorithm.

• The Journal of Information Technology
• /
• v.5 no.4
• /
• pp.1-8
• /
• 2002

This thesis is about power line communication(PLC) over the low voltage grid. The main advantage with power line communication is the use of an existing infrastructure. The PLC channel can be modeled as having multi-path propagation with frequency-selective fading, typical power lines exhibit signal attenuation increasing with length and frequency. OFDM(Orthogonal Frequency Division Multiplexing) is a modulation technique where multiple low data rate carriers are combined by a transmitter to form a composite high data rate transmission. To implement the multiple carrier scheme using a bank of parallel modulators would not be very efficient in analog hardware. Each carrier in an OFDM is a sinusoid with a frequency that is an integer multiple of a base or fundamental sinusoid frequency. Therefore, each carrier is a like a Fourier series component of the composite signal. In fact, it will be shown later that an OFDM signal is created in the frequency domain, and then transformed into the time domain via the Discrete Fourier Transform(DFT).

• Journal of the Korea Society for Simulation
• /
• v.20 no.4
• /
• pp.157-166
• /
• 2011

As underwater environment monitoring system's interest has increased, the research is proceeding about underwater acoustic sensor network. Underwater sensor network can be applicable to many fields, such as underwater environment monitoring, underwater resource exploration, oceanic data collection, military purposes, etc. It is essential to define the PHY-MAC protocol for revitalization of the underwater acoustic sensor network which is available utilization in a variety of fields. However, underwater acoustic sensor network has to implement by consideration of underwater environmental characteristics, such as limited bandwidth, multi-path, fading, long propagation delay caused by low acoustic speed. In this paper, we define frequency of adjusted PHY protocol, network topology, MAC protocol, PHY-MAC interface, data frame format by consideration of underwater environmental characteristics. We also present system configuration of our implementation and evaluate performance based on our implementation with test in real underwater field.

• The Journal of Information Technology
• /
• v.6 no.2
• /
• pp.1-8
• /
• 2003

This paper is about power line communication(PLC) over the low power voltage grid. The main advantage with power line communication is the use of an existing infrastructure. The PLC channel can be modeled as having multi-path propagation with frequency-selective fading, typical power lines exhibit signal attenuation increasing with length and frequency. OFDM(Orthogonal Frequency Division Multiplexing) is a modulation technique where multiple low data rate carriers are combined by a transmitter to form a composite high data rate transmission. To implement the multiple carrier scheme using a bank of parallel modulators would not be very efficient in analog hardware. Each carrier in an OFDM is a sinusoid with a frequency that is an integer multiple of a base or fundamental sinusoid frequency. Therefore, each carrier is a like a Fourier series component of the composite signal. In fact, it will be shown later that an OFDM signal is created in the frequency domain, and then transformed into the time domain via the Discrete Fourier Transform(DFT).