• 콘크리트학회논문집
• /
• 제16권3호
• /
• pp.433-440
• /
• 2004

In order to improve the performance of concrete, generally, modern cements often incorporate several mineral admixtures. In this study, the experimental included the flow value, air content of mortar containing limestone powder and length change and compressive strength of mortar specimen immersed in sulfate solutions. From the experimental results, the limestone powder cement matrices improved the physical properties and sulfate resistance of cement matrices at $10\%$ replacement ratio of limestone powder. The $30\%$ replacement ratio of limestone powder was significantly deteriorated in sodium sulfate solution. Irrespective of fineness levels of limestone powder, length change and SDF of mortar specimens with only $10\%$ replacement was much superior to the other replacements.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2004년도 춘계 학술발표회 제16권1호
• /
• pp.336-339
• /
• 2004

This paper presents an experimental investigation examining water-cement ratio effects on fiber-matrix interface properties and on matrix fracture properties, which are used for designing mix proportion suitable for achieving strain-hardening behavior at a composite level. A single fiber pullout test and a wedge splitting test were employed to measure the bond properties in a matrix and the fracture toughness of mortar matrix, respectively. Test results showed that the properties tended to increase with decreasing water-cement ratio. Composite design using these test results will be discussed in the follow-up paper.

• Advances in concrete construction
• /
• 제2권4호
• /
• pp.249-259
• /
• 2014

Mortar is a masonry product which is matrix of concrete. It consists of binder and fine aggregate and moreover, it is an essential associate in any reinforced structural construction. The strength of mortar is a special concern to the engineer because mortar is responsible to give protection in the outer part of the structure as well as at a brick joint in masonry wall system. The purpose of this research is to investigate the compressive strength and tensile strength of mortar, which are important mechanical properties, by replacing the cement and sand by stone dust. Moreover, to minimize the increasing demand of cement and sand, checking of appropriateness of stone dust as a construction material is necessary to ensure both solid waste minimization and recovery by exchanging stone dust with cement and sand. Stone dust passing by No. 200 sieve, is used as cement replacing material and retained by No. 100 sieve is used for sand replacement. Sand was replaced by stone dust of 15%, 20%, 25%, 30%, 35%, 40%, 45% and 50% by weight of sand while cement was replaced by stone dust of 3%, 5%, and 7% by weight of cement. Test result indicates that, compressive strength of specimen mix with 35% of sand replacing stone dust and 3% of cement replacing stone dust increases 21.33% and 22.76% respectively than the normal mortar specimen at 7 and 28 days while for tensile it increases up to 13.47%. At the end, optimum dose was selected and crack analysis as well as discussion also included.

• 폴리머
• /
• 제32권6호
• /
• pp.555-560
• /
• 2008

폴리머를 혼입한 폴리머 시멘트 모르타르 및 콘크리트는 인장강도, 휨강도, 접착성, 수밀성, 내마모성 그리고 내약품성 등을 개선시키는데 우수한 효과가 있어 고성능이 요구되어지는 건축 구조물의 외장재, 바닥 마감재, 포장재, 방수재, 장식 코팅재, 그리고 보수재 등의 용도로 많이 사용되고 있다. 또한, 기존의 시멘트 콘크리트의 취약성을 보완하는 측면뿐만 아니라 보다 내구적이고 안정적인 구조재료의 역할을 할 수 있어 다양한 용도의 개발이 이루어지고 있다. 본 연구에서는 폴리머를 건축재료인 시멘트 콘크리트에 적용하기 위한 기초적 실험으로써 폴리머 시멘트 모르타르를 제작하여 그 특성을 파악하고 건축재료로서의 폴리머 이용 가능성을 확인하고자 하였다. 폴리머를 시멘트 모르타르에 혼입하여 적용해 본 결과, 보통 시멘트 모르타르에 비해 폴리머 시멘트 모르타르의 강도와 내구성 증진효과가 높게 나타나는 것을 알 수 있었다.

• Advances in concrete construction
• /
• 제15권3호
• /
• pp.149-159
• /
• 2023

Water glass (WG) and sodium sulfate (SS) were used to prepare polymeric aluminum chloride residue cement mortar (PACRM) by single and compound blending with polymeric aluminum chloride waste residue, respectively. The structural strength and textural characteristics examinations showed that PACRM consistency increased by incorporating WG, but decreased by incorporating SS. When WG and SS were compounded, the mortar consistency initially rose before falling. The compressive strength of PACRM increased and then decreased as WG was increased. The mechanical properties of PACRM were better enhanced by SS than WG, showing no strength deterioration. The main reason for the improved mechanical properties of polymeric aluminum chloride waste residue in the presence of activators is the increased precipitation of reactive substances, such as C-S-H gels, calcium silica, and Ca(OH)₂. The density of the specimens with PACRM and the degree of aggregation of hydration products were significantly enhanced by generating more hydration products in the mortar. Further, the cracks and pores were significantly reduced, and the matrix structure was continuous and dense at 5% SS doping and 3% compound doping.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계 학술발표회 논문집(II)
• /
• pp.553-556
• /
• 2006

Generally, concrete is one of the most widely used construction materials, because of its good durability to cost ratio. However, when subjected to severe environments its durability can significantly decline due to various harmful conditions. In this article, we would like to investigate a chloride ion diffusion of cement matrix with inert filler, which ground calcium carbonate(GCC). For the experimental results of the chloride ion diffusion, as the addition of GCC makes decreasing the permeability by micro-filler effect, the matrix of 5-15% ratio of replacement are superior to the GCC0 mortar matrix with respect to durability of cement matrix in this scope.

• 한국건축시공학회지
• /
• 제15권4호
• /
• pp.359-365
• /
• 2015

본 연구에서는 바닥 모르타르에 발생하는 균열을 방지하기 위해, 팽창성이 있는 재료인 알파반수석고를 활용한 비소성결합재 기반 바닥 모르타르의 경화특성 및 건조수축 특성을 평가하고, 건설현장에 적용하여 외기환경에 노출된 조건에서 바닥 모르타르의 수축변형 거동 및 균열 발생여부를 검토하였다. 그 결과, 슬래그계 바닥 모르타르의 경우 시멘트계 모르타르에 비해 초결 및 종결시간이 급격히 단축되었고 압축강도는 관련기준을 만족하는 것으로 확인되었으며, 초기에 팽창 변형 이후의 수축변형 거동은 시멘트계 모르타르와 유사한 경향을 나타내었다. 슬래그계 바닥 모르타르의 현장 적용 결과 균열이 발생하지 않았으며, 외기환경 조건에 의한 변형률의 차이가 크지 않아 시멘트계 바닥 모르타르에 비해 치수안정성이 큰 것으로 판단된다.

• 한국건축시공학회지
• /
• 제14권6호
• /
• pp.523-529
• /
• 2014

국내에서는 많은 양의 패류가 생산되고 있으나, 이로 인해 발생하는 대량의 패각을 처리하는데 많은 어려움을 겪고 있다. 따라서 본 연구에서는 이러한 패각을 대량으로 처리하기 위하여 건설재료로서의 가능성을 평가하고자 한다. 모르터의 잔골재를 패각으로 치환하여 흡수율, 압축강도를 측정하고 계면결합 형태를 관찰하였다. 대체적으로 패각의 치환율이 증가함에 따라 흡수율은 증가하였으며, 압축강도는 감소하였다. 예외적으로 꼬막 패각을 치환한 모르터는 치환율이 증가함에 따라 압축강도가 증가하였다. 패각 치환율의 증가에 따른 흡수율의 증가 및 압축강도의 감소는 패각 주위에 발생한 다공성 때문인 것으로 파악되었으며, 꼬막 패각을 치환한 모르터는 패각과 시멘트 입자간의 계면결합 형태가 양호하였기 때문에, 오히려 강도가 상승한 것으로 판단된다.

• 한국건축시공학회지
• /
• 제12권2호
• /
• pp.194-202
• /
• 2012

This paper predicts the cementing efficiency of fly-ash(FA) based on mortar test considering binder-water ratio and FA replacement ratio as experimental variables. The cementing efficiency prediction model proposed by statistical analysis enables us to estimate the value according to the binder-water ratio and FA replacement ratio of matrix. When FA replacement ratio is the same, the lower the binder-water ratio, the higher the estimated cementing efficiency. There are significant differences in the values according to binder-water ratio at FA replacement ratios of 15% or less, but there are almost no differences when FA replacement ratio is more than 15%. As the binder-water ratio increases, the variations in the values according to FA replacement ratio are great at FA replacement ratios of 15% or less. As the FA replacement ratios increase, the values increase for FA replacement ratios of 15% or less, but decrease for more than 15%. The values range from -0.71 to 1.24 at binder-water ratio of 1.67-2.86 and FA replacement ratio of 0-70%. The RMSE of the 28-day compressive strength predicted by modified water-cement ratio is 2.2 MPa. The values can be trusted, as there is good agreement between predicted strength and experimental strength.

• Interaction and multiscale mechanics
• /
• 제3권1호
• /
• pp.23-37
• /
• 2010

Concrete is a heterogeneous material consisting of coarse aggregate, mortar matrix and interfacial zones at the meso level. Though studies have been done to interpret the fracture process in concrete using meso level models, not much work has been done for simulating the macroscopic behaviour of reinforced concrete structures using the meso level models. This paper presents a procedure for the mesoscopic analysis of reinforced concrete beams using a modified micro truss model. The micro truss model is derived based on the framework method and uses the lattice meshes for representing the coarse aggregate (CA), mortar matrix, interfacial zones and reinforcement bars. A simple procedure for generating a random aggregate structure is developed using the constitutive model at meso level. The study reveals the potential of the mesoscopic numerical simulation using a modified micro truss model to predict the nonlinear response of reinforced concrete structures. The modified micro truss model correctly predicts the load-deflection behaviour, crack pattern and ultimate load of reinforced concrete beams failing under different failure modes.