• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.7
• /
• pp.1326-1331
• /
• 2001

This paper has been studied about design of a transceiver for data transmission. The transceiver has bandwidth of 424.7~424.95 MHz and uses half duplex communication method, PLL synthesized, 20 channel, 12.5 KHz channel bandwidth and FSK modulation/demodulation method. The transmission set is designed using low noise amplifier and power amplifier Also, it consists of low pass filter and resonation circuit for decrease of spurious signal. The receiver set is designed using dual conversion method. Finally, the transceiver set achieves the following characteristics 9.71dbm output power, 47dbc spurious property and $\pm$12.3 Jitter at sensitivity of -1134dbm.

• Journal of IKEEE
• /
• v.22 no.3
• /
• pp.742-746
• /
• 2018

In this paper, we implemented a VLC(Visible Light Communication) system capable of transmitting/receiving data on a 30MHz clock based on On/Off keying modulation/demodulation. The data rate of the implemented system can be verified by functional verification of VLC channel composed of LED/photodiode driver and VLC transmitting/receiving signal of Tx/Rx platform. But, In the experimental results with the VLC transmitting/receiving for combined module, the maximum transmission rate was measured at 15 MHz. Therefore, we describe the problems that can occur when implement the VLC system using the LED module with output power of 15W or more and propose ways to improve it.

• The Journal of the Acoustical Society of Korea
• /
• v.13 no.1
• /
• pp.63-70
• /
• 1994

In this paper, we Investigate the $Q^2PSK$ modulation and demodulation system and analyze the BER performance of the receiver system under 2-way Rayleigh fading and Gaussian noisy channel environment. The TDL equalizer with the adaptive LMS algorithm is used to improve the receiver performance since the received signal is distorted through that channel and the recovered carrier from the noncoherent demodulation has much phase deviation error. From the results of computer simulation, It is shown that at 12dB SNR, the reception performance is improved by $83.7\%$ in the fading case, $89.3\%$ in the carrier phase error case and $60.4\%$ in the case of the fading and carrier phase error.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.1
• /
• pp.1-11
• /
• 2004

This paper presents an implementation of smart antenna system channel card that executes modulation/demodulation. Operations and performances of modules of implemented channel card is confirmed and field test of channel card shows the performance of smart antenna systems. Based on the analysis obtained from the field test in cdma2000 1x environments which contains multipath lading, it is confirmed that smart antenna system channel card provide exact beampattern to the DOA and performance of proposed channel card has better FER by 5∼8 times, compared to 2 antenna diversity system.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.1
• /
• pp.17-22
• /
• 2016

In relay networks, relay nodes amplify or demodulate/remodulate the received signal from the transmitter, and transmit that signal to the receiver. The received signals from several relays are combined and used for demodulation at the receiver, which enhances the performance of the overall system. Partially differential modulation scheme which uses coherent modulation at the relay and non-coherent modulation scheme at the receiver is adopted for modulation scheme. We analyze the performance of systems depending on various energy allocations of source and relays given the total energy in relay networks.

• ETRI Journal
• /
• v.37 no.1
• /
• pp.1-10
• /
• 2015

A blind hopping phase estimator is proposed for the demodulation of received signals in frequency-hopping spread spectrum systems. The received signals are assumed to be bandwidth limited with a shaping filter, modulated as frequency modulation (FM) or binary frequency shift keying (BFSK), and hopped by predetermined random frequency sequences. In the demodulation procedure in this paper, the hopping frequency tracking is accomplished by choosing a frequency component with maximum amplitude after taking a discrete Fourier transform, and the hopping phase estimator performs the conjugated product of two consecutive signals and moving-average filtering. The probability density function and Cramer-Rao low bound (CRLB) of the proposed estimator are evaluated. The proposed scheme not only is very simple to implement but also performs close to the CRLB in demodulating hopped FM/BFSK signals.

• The Bulletin of The Korean Astronomical Society
• /
• v.38 no.2
• /
• pp.91.2-91.2
• /
• 2013

The Korean Solar Radio Burst Locator (KSRBL) is a solar radio spectrograph observing the frequency range between 0.245-18 GHz with the capability of locating the wideband gyrosynchrotron bursts. Its calibration process consists of antenna calibration, flux calibration, and demodulation. Antenna calibration is to determine the position, the width, and the peak value of the beam, flux calibration is to determine the conversion factor between the measured unit to the Solar Flux Unit (SFU), and demodulation is to determine the burst position and remove the modulation pattern. We introduce the current calibration software and some information that potential users may concern.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.11
• /
• pp.1095-1102
• /
• 1991

In this paper, we proposed the differential demodulation technique of 2-h CPM and analyzed its error performances. We derived the sets of modulation indices of 2-h phase codes adequate to the differential detection. The power spectra of 2-h CPM signals with various sets of mudulation indices are illustrated and compared, Besides, the error performances for the differential detectors are calculated and detectors using Viterbi algorithm are compared and analyzed by computer simulations.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.1
• /
• pp.179-193
• /
• 2016

In power quality monitoring, voltage fluctuation is one of the power quality problems, which cause light flickers. To determine the flicker severity, the flicker meter concept was developed in an IEC 61000-4-15 standard. Generally, voltage fluctuations are described as an amplitude modulation(AM). The flicker meter of IEC 61000-4-15 as an international standard for flicker measurement recommends square demodulation method to detect flicker signals from voltage fluctuation signals. This paper suggests a new effective method using filter bank to detect and estimate flicker signals, which do not need square demodulation. For the accurate detection of flicker signals, the filter bank is designed with a full consideration of the spectrum characteristics of voltage fluctuation signals described as AM. The frequency and magnitude of the detected flicker signals are estimated using recursive method. Computer simulations were performed on synthesized signals to prove validity of the proposed method.

• Journal of the Korea Computer Industry Society
• /
• v.3 no.1
• /
• pp.67-76
• /
• 2002

This thesis aims at the study of the receiving part of wireless modem for Mobitex, which are designed for two way massage services by using the network of wireless packet. This receiving part has the features of GMSK demodulation by using Gaussian filter, which has the co-amplitude in a better condition and narrowness bandwidth and high performance in BER, compared with existing MSK modulation. In case of BT=0.3, we designed this receiving part to reduce RF output power spectrum at received data of symbol demodulation and avoid inter symbol interference(ISI) so that we can apply this part to Mobitex network which are currently in service for wireless modem in domestic.