• 한국분무공학회지
• /
• 제18권1호
• /
• pp.21-26
• /
• 2013

Diesel low temperature combustion (LTC) is the concept where fuel is burned at a low temperature oxidation regime so that $NO_x$ and particulate matters (PM) can simultaneously be reduced. There are two ways to realize low temperature combustion in compression ignition engines. One is to supply a large amount of EGR gas combined with advanced fuel injection timing. The other is to use a moderate level of EGR with fuel injection at near TDC which is generally called Modulated kinetics (MK) method. In this study, the effects of fuel injection pressure on performance and emissions of a single cylinder engine were evaluated using the latter approach. The engine test results show that MK operations were successfully achieved over a range of with 950 to 1050 bar in injection pressure with 16% $O_2$ concentration, and $NO_x$ and PM were significantly suppressed at the same time. In addition, with an increase in fuel injection pressure, the levels of smoke, THC and CO were decreased while $NO_x$ emissions were increased. Moreover, as fuel injection timing retarded to TDC, more THC and CO emissions were generated, but smoke and $NO_x$ were decreased.

• Composites Research
• /
• 제28권3호
• /
• pp.99-103
• /
• 2015

본 논문에서는 복합재료 제조공정 중 온도에 따른 경화 반응을 이해하고 열분석을 수행하였으며, 이 결과를 바탕으로 온도에 따른 수지의 경화도 및 비열의 변화를 수식화하였다. 온도에 따른 경화도와 비열은 DSC와 MDSC (Modulated DSC)를 활용하여 측정하였다. DSC와 MDSC 분석은 Isothermal과 Dynamic 조건으로 수행하여 Cure Kinetics, 유리전이온도 및 비열을 측정하고, 회기 분석 방법을 이용하여 물성거동을 수학적으로 모델링하였다.

• Journal of the Korean Wood Science and Technology
• /
• 제40권2호
• /
• pp.110-122
• /
• 2012

This study investigated the effects of layered clay on the thermal curing behavior and tensile properties of resole phenol-formaldehyde (PF) resin/clay/cellulose nanocomposites. The thermal curing behavior of the nanocomposite was characterized using conventional differential scanning calorimetry (DSC) and temperature modulated (TMDSC). The addition of clay was found to accelerate resin curing, as measured by peak temperature ($T_p$) and heat of reaction (${\Delta}H$) of the nanocomposite’ curing reaction increasing clay addition decreased $T_p$ with a minimum at 3~5% clay. However, the reversing heat flow and heat capacity showed that the clay addition up to 3% delayed the vitrification process of the resole PF resin in the nanocomposite, indicating an inhibition effect of the clay on curing in the later stages of the reaction. Three different methods were employed to determineactivation energies for the curing reaction of the nanocomposite. Both the Ozawa and Kissinger methods showed the lowest activation energy (E) at 3% clay content. Using the isoconversional method, the activation energy ($E_{\alpha}$) as a function of the degree of conversion was measured and showed that as the degree of cure increased, the $E_{\alpha}$ showed a gradual decrease, and gave the lowest value at 3% nanoclay. The addition of clay improved the tensile strengths of the nanocomposites, although a slight decrease in the elongation at break was observed as the clay content increased. These results demonstrated that the addition of clay to resole PF resins accelerate the curing behavior of the nanocomposites with an optimum level of 3% clay based on the balance between the cure kinetics and tensile properties.

• Composites Research
• /
• 제37권4호
• /
• pp.296-300
• /
• 2024

The rational synthesis of efficient transitional metal phosphides (TMPs) could revolutionize green hydrogen production via water splitting. Hydrogen, with the highest energy density among fuels, stands out as an excellent alternative to address environmental issues and ensure sustainable future energy generation. However, the limited availability of state-of-the-art electrocatalysts like Pt/C and RuO₂, used for the hydrogen evolution reaction (HER) and oxygen evolution reaction (OER), respectively, necessitates the development of cost-effective and non-noble electrocatalysts for green hydrogen production. In this context, we present a novel heterointerface-modulated heterostructure design comprising ultrathin nanosheets of a 3D Co₂P/VP heterostructure on a conductive nickel foam substrate. This heterostructure demonstrates remarkably low overpotentials of 96 mV for HER and 237 mV for OER at 10 mA cm^-2. The material's robust electrochemical kinetics are further evidenced by low Tafel slopes of 68.28 mV dec^-1 and 116.54 mV dec^-1, respectively.

• BMB Reports
• /
• 제32권3호
• /
• pp.294-298
• /
• 1999

Myo-inositol monophosphate phosphatase is a key enzyme in the phosphoinositide cell-signaling system. Incubation of myo-inositol monophosphate phosphatase from porcine brain with N-bromosuccinimide (NBS) resulted in a time-dependent loss of enzyme activity. The inactivation followed pseudo-first-order kinetics with the second-order rate constant of $3.8{\times}10^3\;M^{-1}min^{-1}$. The time course of the reaction was significantly affected by the substrate myo-inositol-1-phosphate, which afforded complete protection against the loss of catalytic activity. Spectrophotometric studies indicated that about one oxindole group per molecule of enzyme was formed following complete loss of enzymatic activity. It is suggested that the catalytic function of myo-inositol monophosphate phosphatase is modulated by the binding of NBS to a specific tryptophan residue at or near the substrate binding site of the enzyme.

• Animal cells and systems
• /
• 제1권4호
• /
• pp.583-587
• /
• 1997

Incubation of an NADPH-dependent succinic semialdehyde reductase from bovine brain with N-bromosuccinimide (NBS) resulted in a time-dependent loss of enzyme activity. The inactivation followed pseudo-first-order kinetics with the second-order rate constant of $6.8\times{10}^3$ $M^-1$ $min^{-1}$. The inactivation was prevented by preincubation of the enzyme with substrate succinic semialdehyde, but not with coenzyme NADPH. There was a linear relation-ship between oxindole formation and the loss of enzyme activity. Spectro-photometric studies indicated that about one oxindole group per molecule of the enzyme was formed following complete loss of enzymatic activity. It is suggested that the catalytic function of succinic semialdehyde reductase is modulated by binding of NBS to a specific tryptophan residue at or near the substrate binding site of the enzyme.

• BMB Reports
• /
• 제30권5호
• /
• pp.370-377
• /
• 1997

A novel assay method is described for rapid quantitation of reaction rate of sterol ${\Delta}^7$-reductase (${\Delta}^7$-SR) which catalyzes reduction of the ${\Delta}^7$-double bond of sterols. Of six different organ tissues-liver, small intestine, brain, lung, kidney, and testis-. ${\Delta}^7$-SR activity was detected only in liver (2.30 nmol/min/mg protein) and testis (0.11 nmol/min/mg protein). Using a newly developed method which employs diet-induced enzyme proteins and ergosterol as substrate, we assessed both kinetics ($K_m=210\;{\mu}M$, $V_{max}=1.93\;nmol/min/mg$) and inhibition of the rat hepatic ${\Delta}^7$-SR against well-studied cholesterol lowering agents such as triparanol ($IC_{50}=16\;{\mu}M$). 3-$\beta$-[2-(diethylamino)ethoxy]androst-5-en-17-one (U18666A) ($IC_{50}=5.2\;{\mu}M$), and trans-1.4-bis(2-chlorobenzylaminomethyl)cyclohexane dihydrochloride (AY-9944) ($IC_{50}=0.25\;{\mu}M$). Of the three well-known AY-9944-sensitive cholesterogenic enzymes (i.e., ${\Delta}^7$-SR, sterol ${\Delta}^8$-isomerase, and sterol ${\Delta}^14$-reductase). ${\Delta}^7$-SR was found to be the most sensitive enzyme with a noncompetitive inhibition of this compound ($K_i=0.109\;{\mu}M$). Substrate specificity studies of the microsomal ${\Delta}^7$-SR indicate that the relative reaction rate for 7-dehydrocholesterol and ergosterol are 5.6-fold and 1.6-fold higher than that for lathosterol. ${\Delta}^7$-SR activity was also modulated by feeding rats a diet supplemented with 0.5% ergosterol (>2.6-fold) in addition to 5.0% cholestyramine plus 0.1% lovastatin ($\simeq$5.0-fold). Finally, microsomal ${\Delta}^7$-SR was solubilized by 1.5% 3-[3-(cholamidopropyl)-dimethylammonio]-1-propanesulfonate (CHAPS) and enriched on PEG (0~10%) precipitation, which should be suitable for further purification of the enzyme.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제2권4호
• /
• pp.259-267
• /
• 2002

We present a novel 3D fabrication method with single X-ray process utilizing an X-ray mask in which a micro-actuator is integrated. An X-ray absorber is electroplated on the shuttle mass driven by the integrated micro-actuator during deep X-ray exposures. 3D microstructures are revealed by development kinetics and modulated in-depth dose distribution in resist, usually PMMA. Fabrication of X-ray masks with integrated electrothermal xy-stage and electrostatic actuator is presented along with discussions on PMMA development characteristics. Both devices use $20-\mu\textrm{m}$-thick overhanging single crystal Si as a structural material and fabricated using deep reactive ion etching of silicon-on-insulator wafer, phosphorous diffusion, gold electroplating, and bulk micromachining process. In electrostatic devices, $10-\mu\textrm{m}-thick$ gold absorber on $1mm{\times}1mm$ Si shuttle mass is supported by $10-\mu\textrm{m}-wide$, 1-mm-long suspension beams and oscillated by comb electrodes during X-ray exposures. In electrothermal devices, gold absorber on 1.42 mm diameter shuttle mass is oscillated in x and y directions sequentially by thermal expansion caused by joule heating of the corresponding bent beam actuators. The fundamental frequency and amplitude of the electrostatic devices are around 3.6 kHz and $20\mu\textrm{m}$, respectively, for a dc bias of 100 V and an ac bias of 20 VP-P (peak-peak). Displacements in x and y directions of the electrothermal devices are both around $20{\;}\mu\textrm{m}$at 742 mW input power. S-shaped and conical shaped PMMA microstructures are demonstrated through X-ray experiments with the fabricated devices.

• 한국전문물리치료학회지
• /
• 제13권4호
• /
• pp.79-86
• /
• 2006

The purpose of the current experiment was to describe interlimb coordination when swing limb conditions are being manipulated by constraining step length or by adding a 5 or 10 pound weight to the swing limb distally. Subjects were asked to begin walking with the right limb to land on the primary target (normal step length) that is 10 cm in diameter. However, if, during movement, the light was illuminated, then the subject had to step on one of the secondary targets (long and short step length). These three step length conditions were repeated while wearing a 5 pound ankle weight and then when wearing a 10 pound ankle weight. Ground reaction force (GRF) data indicated that there were changes in the forces and slopes of the swing and stance Fx GRFs. Long stepping subjects had to increase the propulsive force required to increase step length. Consequently, swing and stance toe-off greatly increased in the long step length condition. Short step length subjects had to adequately adjust step length, which decreased the speed of gait initiation. Loading the swing limb decreased the force and slope of the swing limb. Swing and stance toe-off was longest for the long step length condition, but there was a small difference of temporal events between no weight and weight condition. It appears that subjects modulated GRFs and temporal events differently to achieve the peak acceleration force of the swing and stance limb in response to different tasks. The findings from the current study provide preliminary data, which can be used to further investigate how we modulate forces during voluntary movement from a quiet stance. This information may be important if we are to use this or a similar task to evaluate gait patterns of the elderly and patient populations.

• 한국약용작물학회지
• /
• 제26권1호
• /
• pp.72-81
• /
• 2018

Background: Polysaccharides are the most important functional constituent in Astragalus membranaceus. The purpose of the present study was to evaluate the effect of polysaccharides isolated from the aboveground parts of A. membranaceus (AMA) and polysaccharides isolated from the roots of A. membranaceus (AMR) immune function by modulated cytotoxic T cell and Th1- and Th2-related cytokines kinetics. Methods and Results: Sprague-Dawley rats were randomly divided into exhaustive exercise case groups and non-exercise case, AMA and AMR samples were administered orally for 30 days (500 mg/kg/day and 10 mg/kg/day, respectively) and were compared to those rats in the groups fed commercial sports drink (SPD) and vehicle. Both exhaustive exercise groups and non-exercise groups had a lower ratio of $CD4^+$ and $CD8^+$ cells in the spleens of the rat fed AMA and AMR compared to those in the rats fed SPD and vehicle group. These results suggested that AMA and AMR promote an increase in the proportion of cytotoxic T cells. The IL-4-producing T lymphocytes decreased significantly in the AMR (10 mg/kg/day) group compared to SPD and vehicle, whereas the AMA group increased the IL-4 concentration more than the SPD and vehicle in exhaustive exercise group. However, the populations of IFN-${\gamma}$-producing T lymphocytes of AMR and AMA increased. AMA decreased the concentration of IFN-${\gamma}$ to inhibit the Th1 response and thereby increased the concentration of IL-4 to induce a Th2 response that was related to humoral immunity in the non-exercise group. Conclusions: These results showed that, in addition to Th1/Th2 regulation, AMR and AMA played an important immuno-modulatory role after exhaustive exercise-induced Th1/Th2 lymphocyte imbalance, which might be correlated with cytokine producing immunoregulatory cells.