• Journal of the Korean Geotechnical Society
• /
• v.37 no.11
• /
• pp.7-22
• /
• 2021

In this study, inverse analysis was performed on the bi-directional axial compressive load test conducted on drilled shafts. And the bearing capacities were analyzed by numerical analysis of various pile tip ground conditions of silt clay, silt sand, sand silt, sand gravel, weathered rock, and soft rock. The bearing capacities were analyzed using the P-S method, the Davisson method, and the allowable sttlement of 25.4 mm. The minimum allowable bearing capacities analyzed by three methods were found to be 19.64 MN ~ 24.96 MN. At this time, the base resistances were sharing a 2% ~ 12% of a head load, shaft resistance were shared 88% ~ 98% of the head load. The greater the strength of pile tip was found to increase the allowable bearing capacity. However, the difference between the maximum allowable bearing capacity and the minimum allowable bearing capacity was 5.32 MN, and the increase in the allowable bearing capacity was only 27% depending on the pile tip.

• Microbiology and Biotechnology Letters
• /
• v.6 no.1
• /
• pp.27-31
• /
• 1978

The malo-alcoholic fermentation characteristics of Schiozaccharomyces japonicus var. japonicus which was freshly isolated from strawberry were studied. A good assimilation of malic acid by the strain was observed under the following conditions：pH 4.2∼4.8, alcohol content less than 12％, sulfur dioxide concentration less, than 150 ppm, and less than 0.01％ of Mn$\^$2＋/ as MnSO$_4$. The strain could remove 0.3％ of malic acid completely in 6 days under stationary culture at 30$^{\circ}C$. Shaking the culture could promote growth of the strain but did not affect on the malo-alcoholic fermentation.

• Korean Journal of Materials Research
• /
• v.12 no.6
• /
• pp.436-441
• /
• 2002

Effect of Sn addition on the stress corrosion cracking(SCC) resistance of the Al-Cu-Mn cast alley was investigated by C-ring teat and electrical conductivity measurement, The electrical conductivity and SCC resistance increased by Sn addition. The alley containing 0,10%Sn showed maximum electrical conductivity and the best SCC resistance. At the same composition, the electrical conductivity and SCC resistance increased from peak aged condition to ever aged condition. The PFZ and coarse precipitates along the grain boundary were observed from TEM micrographs. The fracture mode of the alloy was confirmed as intergranular type and showed brittle fracture surface. The SCC mechanism of the alloy was concluded as the anodic dissolution model, The maximum hardness was increased from 130Hv in the Sn-free alloy to 156Hv in the 0.10%Sn added alloy.

• Korean Journal of Materials Research
• /
• v.12 no.3
• /
• pp.195-199
• /
• 2002

Planar Hall effect of ferromagnetic GaMnAs thin films was investigated for the first time. The films were grown in an optimized growth condition via molecular beam epitaxy at low temperatures. For the optimization of the growth conditions, we used reflection high-energy electron diffraction, electrical conductivity, double crystal x-ray diffraction, and superconducting quantum interference device measurements techniques. We observed that the difference between the longitudinal resistance and the transverse resistance matches the planar Hall resistance. The ratio of the planar Hall resistance at saturation magnetic field to that at zero reached above 500%.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.15 no.1
• /
• pp.1-8
• /
• 1986

Authors investigatigated the analysis heavy metals in corps at the Mankyung river area. Samples were digested with Cone. nitric acid and Cone. hydroc hrorico acid and analyzed by Varian 875 Atomic Absorption Atomic Absorption Spectrophotometer in 1984. The results were as follows: The contents of heavy metals in rice were in the range of $0.41{\sim}5.15,\;1.12{\sim}5.18,\;10.65{\sim}14.54,\;24.15{\sim}35.41ppm$ for Pb, Cu, Mn, Zn respectively. Those in barley were in the range of $0.48{\sim}0.8,\;1.39{\sim}2.81,\;9.69{\sim}14.89,\;30.14{\sim}34.84ppm$ for Pb, Cu, Mn, Zn respectively. Those in kidney bean were in the range of $0.06{\sim}0.13,\;3.65{\sim}6.25,\;.65{\sim}12.15,\;51.25{\sim}65.69\;ppm$ for Pb, Cu, Mn, Zn respectively. Those in corn were in the range of $0.59{\sim}0.89,\;2.15{\sim}2.83,\;6.01{\sim}10.15,\;29.31{\sim}36.15ppm$for Pb, Cu, Mn, Zn respectively. We might be concluded that the above values of heavy metals contained in crop at the sites near to Mankyung river were serious partially.

• Current Optics and Photonics
• /
• v.2 no.6
• /
• pp.589-594
• /
• 2018

We have investigated the dimensional nature of center-of-mass exciton confinement states in a CdMnTe/CdTe/CdMnTe heterostructure, where the CdTe well is too wide (144 nm) to confine both electrons and holes but able to confine whole excitons in the center-of-mass coordinate. Fine multiple photoluminescence spectra with a few meV separation were observed at 6 K. From the thickness dependence of the transition rate, they were attributed to even numbered center-of-mass exciton confinement states (N = 2, 4, 6, ${\cdots}$, 18). Dimensionality of the center-of-mass exciton confinement states was also investigated in terms of temperature dependence of radiative decay time. At low temperatures (${\leq}12K$), we found that the ground state excitons are likely localized possibly due to the barrier interface fluctuation, resulting in a constant decay time (~350 ps). With increased temperature (${\geq}12K$), localized excitons are thermally released, giving rise to a linear temperature dependence of radiative decay time as an evidence of two-dimensional nature.

• Transactions of the Korean hydrogen and new energy society
• /
• v.12 no.1
• /
• pp.29-38
• /
• 2001

The alloys $ZrMn_2Ni_x$ (x=0.0, 0.3, 0.6, 0.9 and 1.2) as the alloys of Zr-Mn-Ni three component system were prepared and their hydrogen-storage properties and their electrochemical properties were investigated. The C14 Laves phase formed in all the alloys $ZrMn_2Ni_x$. Among these alloys $ZrMn_2Ni_{0.6}$ was activated relatively easily(after about 11 charge-discharge cycles), and had the largest discharge capacity(max. 45mAh/g). For all the alloys Zr was dissolved most easily into the 6M KOH solution. More Mn and Ni were dissolved from the $ZrMn_2Ni_{0.6}$ alloy than from the other alloys. Due to the active charge and discharge of the $ZrMn_2Ni_{0.6}$ alloys, related to the easier activation and the larger discharge capacity, Zr, Mn and Ni in this alloy were considered to be dissolved more easily into the 6M KOH solution, compared with the other alloys.

• Nutrition Research and Practice
• /
• v.5 no.6
• /
• pp.548-552
• /
• 2011

The purpose of this study was to estimate the daily manganese (Mn) intake of Korean children. This study was done using a three-day dietary intake survey of 257 Korean children (boys 123; girls 134). The Mn intake values were calculated based on a database that provides the Mn content of the frequently consumed Korean foods, alongside the food composition table provided by the Korean National Rural Living Science Institute. The average age, height, weight and body mass index of our subjects were 11.9 years, 155.4 cm, 48.9 kg and 20.2 kg/$m^2$ in boys and 11.9 years, 154.1 cm, 43.5 kg and 18.3 kg/$m^2$ in girls. The average daily energy intakes were 2,249.2 kcal in boys and 2,044.5 kcal in girls. Boys consumed significantly more Mn than girls, based on intake estimates of $4,585.3{\mu}g$ (117.6% of adequate intake) and $4,029.3{\mu}g$ (117.1% of adequate intake), respectively (P < 0.001). Boys had a Mn intake of $2,041.1{\mu}g$ per 1,000 kcal of energy consumption, whereas for girls this was at $1,983.9{\mu}g$ per 1,000 kcal. Neither group exceeded the tolerable upper intake level for Mn. The major food groups which contributed to Mn intake in our subjects were cereals (50.8%), vegetables (21.0%), seasonings (8.9%), and pulses (7.7%). Notably, boys derived a higher Mn intake through cereals and vegetable than did girls (P < 0.001, P < 0.05). The key food sources of Mn, in descending order, were rice, soybean curd, kimchi, black rice and cereals. We propose that the results of our study may be used as a basis for follow-up studies that examine the Mn intake of children.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.8
• /
• pp.2295-2298
• /
• 2014

To effectively destruct 2-chlorophenol, a representative sterile preservative, nanometer-sized Mn (0.5, 1.0, 3.0 mol %)-incorporated $TiO_2$ powders were synthesized by a solvothermal method. XRD result demonstrated that the Mn ingredients were perfectly inserted into $TiO_2$ framework. The Mn-$TiO_2$ particles exhibited an anatase structure with a particle size of below 20 nm. The absorbance was shifted to the higher wavelength on Mn-$TiO_2$ compared to that of $TiO_2$. Otherwise, the PL intensities which has a close relationship for recombination between holes and electrons significantly decreased on Mn-$TiO_2$. The photodecomposition for 2-chlorophenol in a liquid system was enhanced over Mn-doped $TiO_2$ compared with pure $TiO_2$: 2-chlorophenol of 50 ppm was completely decomposed after 12 h when 1.0 mol % Mn-$TiO_2$ was used. Consequently, the core of this paper is as follows. introducing Mn into $TiO_2$ framework reduced the band-gap, moreover, it played as an electron capture resulted to lower recombination between electrons and holes during photocatalytic reaction for removal of 2-cholophenol.

• Resources Recycling
• /
• v.9 no.6
• /
• pp.31-35
• /
• 2000

The complex permeability, the complex permittivity and the reflection loss are investigated in the composite microwave absorbers which are mixed with the wasted Mn-Zn ferrite and the industrial cement. The cement has larger the complex permittivity than that of the rubber. The complex permittivity is decreasing with the increment of the mixing ratio of Mn-Zn ferrite to cement (F/C in weight) and the complex permeability is increasing with the increment of F/C. The maximum reflection loss is above -40 dB at all samples. The matching frequency is in the range of 1.3 GHz to 2.9 GHz and is decreasing with the increment of F/C from 1 to 3. The matching thickness is increasing with the increment of F/C. The wasted Mn-Zn ferrite and the cement is very useful material for the composite microwave absorber.