• Analytical Science and Technology
• /
• v.8 no.4
• /
• pp.799-806
• /
• 1995

In industrial field, a large volume of regenerants (acid and caustic soda) and their washing effluents are regularly disposed off from the water demineralization plant during regeneration of the ion-exchanger units. Of these waste effluents, a part of the wash water discharged from the single bed Anion and Mixed Bed units can be utilized at a certain stage of their washing cycles when its conductivity is fallen down and becomes considerably less than that of the input raw water. The main aim of this specific waste effluent utilization is to dilute the TDS concentration of the input raw water (fed into the single bed ion-exchanger units) by blending. The achievement is the increase of the longevity of the production cycles of the I.E. units along with the improvement of the production quality and decrease of the regeneration frequencies. As a result, regenerant consumption would be saved because of the reduction of ionic load in feed water which will ultimately reduce the water purification cost. At the same time, the environment pollution will also be protected to a considerable extent. This operational measure is quite effective and useful specially where high TDS water is demineralized only by single bed ion-exchangers. In such case, the water treatment plant is very often found to suffer from both production quality and quantity in addition to carrying out of random and restless regenerations. Proper reuses of the aforesaid wash water effluents of the Anion and MB units excellently minimizes the difficulties experienced in practice. This paper contains the utilities and techniques of reuses of the different kinds of waste effluents of the industrial water treatment plant in addition to the specific reuses of the post-regeneration wash waters of the Anion and MB ion-exchanger units.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.10
• /
• pp.105-111
• /
• 2008

To improve the stability of levee structure, it is required to use good quality fill materials, intensive management, appropriate hydraulic structure and construction of cut-off wall. In particular, the most important factor of levee construction technology is to use bed sediment for its safety. In this study, seepage model test and numerical analysis were performed based on a standard section of levee recommended in the river design standard of korea (2005). The results of test and analysis show that most of the bed soil is a sand (SP in USCS), which does not satisfy the permeability criteria for levee materials ($< k=10^{-3}cm/sec$), thus for the safety of levee it is required to adopt a stabilizing method such as good quality soil mixing, water content control.

• Proceedings of the Korean Nuclear Society Conference
• /
• 2005.10a
• /
• pp.233-234
• /
• 2005

• Preventive Nutrition and Food Science
• /
• v.18 no.1
• /
• pp.60-66
• /
• 2013

The whole saltwort plant (Salicornia herbacea) was micronized to develop the table salt substitute. The micronized powder was mixed with distilled water and made into a spherical granule by using the fluid-bed coater (SGMPDW). The SGMPDW had superior flowability to powder; however, it had low dispersibility. To increase the dispersibility of SGMPDW, the micronized powder was mixed with the solution, which contained various soluble solid contents of saltwort aqueous extract (SAE), and made into a spherical granule (SGMPSAE). The SGMPSAE prepared with the higher percentages of solid content of SAE showed improved dispersibility in water and an increase in salty taste. The SGMPSAE prepared with 10% SAE was shown to possess the best physicochemical properties and its relative saltiness compared to NaCl (0.39). In conclusion, SGMPSAEs can be used as a table salt substitute and a functional food material with enhanced absorptivity and convenience.

• Journal of the Korean Applied Science and Technology
• /
• v.23 no.1
• /
• pp.63-69
• /
• 2006

Methanol and formaldehyde were produced directly by the partial oxidation of methane. The catalysts used were mixed oxides of late-transition metals, such as Mn, Fe, Co, Ni and Cu. The reaction was carried out at $450^{\circ}C$, 50 bar in a fixed-bed differential reactor. The prepared catalysts were characterized by XRD, TPD and BET apparatus. Of the catalysts, A-Mn0.2-6, which contains 0.2 mole of Mn and calcined at $600^{\circ}C$, showed the best catalytic activity: 3.7% methane conversion, and 30 and 28% methanol and formaldehyde selectivities, respectively. The catalytic activity was changed with the content of Mn and the calcination temperature. Catalytic activity increased with the specific surface areas of the catalysts. With XRD, it was found that the structure of the catalysts are changed with calcination temperature. Through $O_2-TPD$ experiment, it was found that the catalysts showing good catalytic activity showed $O_2$ desorption peak around $800^{\circ}C$.

• Journal of Environmental Health Sciences
• /
• v.33 no.6
• /
• pp.488-492
• /
• 2007

The influence of additive materials including saw dust and cow manure in the ripening of leather sludge for the efficient vermisabilization was studied. The ripening characteristics of the leather sludge, the growth of earthworms in the growth bed and the by-products like cast were observed according to the mixing ratio of additive materials. When the mixed leather sludge of which the additive materials contents were over 20% were ripened for 50 days, the values of ORP and alkalinity were changed to the favorable ranges for earthworms, the positive (+) and below 1,000 mg/l as $CaCO_3$, respectively. The velocity of ripening improving the characteristics of the leather sludge was faster in the sludge mixed with cow manure than saw dust. This results could also be verified from the monitoring of the states of earthworm growth using the survival rate, the increase rate of lifeweight and the hatching rate of earthworm cocoon in the their growth bed packed with the ripened sludge. The values of CEC in cast, the vermi-stabilized sludge, were increased with the mixing ratio of additive materials, but the content of heavy metals was drcreased by the dilution effect and accumulation in the earthworm body. Above results show that the leather sludge might be efficiently stabilized by earthworms through the ripening for 50 days using additive materials. Cow manure can be used as a good additive materials for leather sludge as much as saw dust, and the optimum content of additive materials in the well-ripened leather sludge was about 30%.

• Nuclear Engineering and Technology
• /
• v.46 no.6
• /
• pp.847-856
• /
• 2014

Spent resin waste containing a high concentration of $^{14}C$ radionuclide cannot be disposed of directly. A fundamental study on selective $^{14}C$ stripping, especially from the IRN-150 mixed bed resin, was carried out. In single ion-exchange equilibrium isotherm experiments, the ion adsorption capacity of the fresh resin for non-radioactive $HCO_3{^-}$ ion, as the chemical form of $^{14}C$, was evaluated as 11mg-C/g-resin. Adsorption affinity of anions to the resin was derived in order of $NO_3{^-}$ > $HCO_3{^-}{\geq}H_2PO_4{^-}$. Thus the competitive adsorption affinity of $NO_3{^-}$ ion in binary systems appeared far higher than that of $HCO_3{^-}$ or $H_2PO_4{^-}$, and the selective desorption of $HCO_3{^-}$ from the resin was very effective. On one hand, the affinity of $Co^{2+}$ and $Cs^+$ for the resin remained relatively higher than that of other cations in the same stripping solution. Desorption of $Cs^+$ was minimized when the summation of the metal ions in the spent resin and the other cations in solution was near saturation and the pH value was maintained above 4.5. Among the various solutions tested, from the view-point of the simple second waste process, $NH_4H_2PO_4$ solution was preferable for the stripping of $^{14}C$ from the spent resin.

• Nuclear Engineering and Technology
• /
• v.54 no.2
• /
• pp.589-600
• /
• 2022

Investigations on the molten-pool sloshing behavior are of essential value for improving nuclear safety evaluation of Core Disruptive Accidents (CDA) that would be possibly encountered for Sodium-cooled Fast Reactors (SFR). This paper is aimed at synthesizing the knowledge from our recent studies on molten-pool sloshing behavior with solid particles conducted at the Sun Yat-sen University. To better visualize and clarify the mechanism and characteristics of sloshing induced by local Fuel-Coolant Interaction (FCI), experiments were performed with various parameters by injecting nitrogen gas into a 2-dimensional liquid pool with accumulated solid particles. It was confirmed that under different particle-bed conditions, three representative flow regimes (i.e. the bubble-impulsion dominant, transitional and bed-inertia dominant regimes) are identifiable. Aimed at predicting the regime transitions during sloshing process, a predictive empirical model along with a regime map was proposed on the basis of experiments using single-sized spherical solid particles, and then was extended for covering more complex particle conditions (e.g. non-spherical, mixed-sized and mixed-density spherical particle conditions). To obtain more comprehensive understandings and verify the applicability and reliability of the predictive model under more realistic conditions (e.g. large-scale 3-dimensional condition), further experimental and modeling studies are also being prepared under other more complicated actual conditions.

• Journal of Animal Environmental Science
• /
• v.3 no.1
• /
• pp.13-18
• /
• 1997

This study was conducted to investigate the physicochemical changes during the aerobic composting of swine manure mixed with bulking agent, sawdust(v/v, 1:1), in a full-scale composting plant using rectangular escalator-aginated bed composting system. Physical and chemical properties were analyzed on the samples which were collected at 5, 15, and 25 day of composting, curing and final step. The results of this study were summarized as follows; 1. Moisture and K2O content, and pH of final step were higher than those of 5th day of composting (p＜0.05). 2. Ammonium nitrogen, total organic corbon and organic matter content, and electrical conductivity(EC) were significantly decreased (p＜0.05) but nitrate nitrogen, ash and P2O5 content increased(p＜0.05) throughout the aerobic composting process. 3. Total organic carbon per total nitrogen(C/N) and total organic matter per total nitrogen(OM/N) ratio were significantly decreased throughout the aerobic composting process(p＜0.05). 4. Physical and chemical properties of swine manure were varied by aerobic fermentation using rectangular escalor-aginated bed composting system.

• Korean Journal of Plant Resources
• /
• v.32 no.6
• /
• pp.735-742
• /
• 2019

This study investigated a suitable method that could be applied for Asian chain fern [Woodwardia japonica (L. f.) Sm.] to propagate gametophytes and promote sporophyte formation. The gametophytes used in all experiments were obtained from germinated spores in vitro and were subcultured at 8-week intervals. The most appropriate media for gametophyte propagation was identified by culturing 300 mg of gametophyte in Murashige and Skoog (MS) basal medium (1/8, 1/4, 1/2, 1, 2), and Knop medium for 8 weeks. As a result, fresh weight of the gametophyte was increased by 56.7-fold on MS medium. Moreover, antheridium formation as well as gametophyte growth was improved on MS medium, especially. To improve the sporophyte formation ex vitro, 1.0 g of gametophyte was ground with distilled water and spread on eight combinations onto four different culture mediums, such as bed soil, peat moss, perlite and decomposed granite. Then generation and growth of sporophytes were investigated after cultivation for 10 weeks. As a result of this experiment, peat moss had a promotive effect of sporophyte formation at single-use and mixed culture soils. In particular, a mixture of bed soil, peat moss and perlite in a 1:1:1 ratio (v/v/v) led to the accelerated formation (782.5 ea/pot) and the frond growth of sporophytes. This included increases in length and width of fronds. However, promotive effect of gametophyte growth and sporophyte formation was not found at single-use and treatment with high ratio of bed soil.