• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.6
• /
• pp.167-175
• /
• 2018

Natural gas is a clean fuel that discharges almost no air-contaminating substances. This study examined the simultaneous reduction of $CH_4$ and NOx of NGOC/LNT catalysts for CNG buses related to the improvement of the $de-CH_4/NOx$ performance, focusing mainly on identifying the additive catalysts, loading of the washcoat, stirring time, and types of substrates. The 3wt. % Ni-loaded NGOC generally exhibited superior $CH_4$ reduction performance through $CH_4$ conversion, because Ni is an alkaline, toxic oxide, and exerts a reducing effect on $CH_4$. A excessively small loading resulted in insufficient adsorption capacity of harmful gases, whereasa too high loading of washcoat caused clogging of the substrate cells. In addition, with the economic feasibility of catalysts considered, the appropriate amount of catalyst washcoat loading was estimated to be 124g/L. The NOx conversion rate of the NGOC/LNT catalysts stirred from $200^{\circ}C$ to $550^{\circ}C$ for 5 hours showed 10-15% better performance than the NGOC/LNT catalysts mixed for 2 hours over the entire temperature range. The NGOC/LNT catalysts exhibitedapproximately 20% higher $de-CH_4$ performance on the ceramic substrates than on the metal substrates.

• Membrane Journal
• /
• v.21 no.3
• /
• pp.256-262
• /
• 2011

This study describes the performance of PSF and PC membranes for separation and recovery of $SF_6$ from gas mixtures (10% $SF_6$/70% $N_2$/19% $O_2$/1% $CF_4$) containing low concentration of $SF_6$. The $SF_6$ concentration in retentate, recovery efficiency and selectivity of mixed gases were measured as a function of retentate flow rate and temperature. The concentration of $SF_6$ in the gas recovered from PSF and PC membrane respectively decreased with increase of retentate flow rate and increased with increase of temperature. The values of $SF_6$ concentration in retentate of PSF membrane were higher than those of PC membrane at constant experimental conditions. The maximum value of recovery efficiency of PSF and PC membranes are 95.9% and 67.8%, respectively, under 298.15 K and 150 cc/min of retentate flow rate. With the exception of $CF_4/SF_6$, the real selectivities of $N_2/SF_6$ and $O_2/SF_6$ at PSF membrane were higher than those of PC membrane.

• Membrane Journal
• /
• v.23 no.1
• /
• pp.1-11
• /
• 2013

Poly(ether imide) (PEI)-poly(dimethylsioxane) (PDMS) composite membranes and their modules were prepared, which are capable of selective $CO_2$ separation from the mixture gas. The gas flow rate, concentration, recovery ratio of $H_2$ and removal ratio of $CO_2$ outflowing by stage-cut were characterized at $25^{\circ}C$ and the constant pressure. In addition, to increase the recovery ratio of $H_2$, one stage, two stage series connection, and three stages series + parallel connection tests were carried out. When the stage-cut was 0.32 for the three stages connection operation, the concentration $H_2$ of the produced gas and the recovery ratio of $H_2$ was 97% and 85%, respectively. And also the removal ratio of $CO_2$ was 90% was obtained and the recycled gas concentration was similar with that of the feed gases.

• Membrane Journal
• /
• v.27 no.2
• /
• pp.147-153
• /
• 2017

In this study, we investigated permeation properties of single gas ($N_2$, $O_2$, $CO_2$) through membranes composed of poly(ethylene oxide) (PEO) and poly(ethylene-co-vinyl acetate) (EVA) blend. The prepared membranes showed no new absorbance peaks, which indicate the physical blending of PEO and EVA by FT-IR analysis. SEM observation showed that the crystalline phase of PEO decreased with increasing EVA content in the PEO/EVA mixed matrix. DSC analysis showed that the crystallinity of the PEO/EVA blend membrane decreased with increasing EVA content. Gas permeation experiment was performed with various feed pressure (4~8 bar). The permeability increased in the following order: $N_2$ < $O_2$ < $CO_2$. The permeability of $CO_2$ in PEO/EVA blend membranes were increased with increasing feed pressure, However, the permeability of $N_2$ and $O_2$ were independent of feed pressure. On the other hand, the permeability of all the gases in PEO/EVA blend membranes increased with increasing amorphous EVA content in semi-crystalline PEO. In particular, the blend membrane with 40 wt% EVA showed $CO_2$ permeability of 64 Barrer and $CO_2/N_2$ ideal selectivity of 61.5. The high $CO_2$ permeability and $CO_2/N_2$ ideal selectivity are attributed to strong affinity between the polar ether groups of PEO or the polar ester groups of EVA and polar $CO_2$.

• Journal of Energy Engineering
• /
• v.17 no.4
• /
• pp.241-246
• /
• 2008

Increase of $CO_2$ by using fossil fuels makes mainly global warming and the international efforts to reduce the $CO_2$ emission is being promoted. Absorption process using aqueous alkanolamine solution to remove acid components in the mixed gases has been used commercially. This method was used to remove $CO_2$ in the flue gas in recent years. $CO_2$ Absorption characteristics of several aqueous alkanolamine solutions such as MEA, DEA and AMP was studied by measuring vapor-liquid-equilibrium(VLE) and absorption velocity in this study. VLE measuring equipment, shell and reactor type, was used to acquire VLE data, equilibrium $CO_2$ pressure(${P_{CO_2}}^*$) and time at each pulse gas input. We also acquired the $CO_2$ absorption velocity by measuring the time to arrive the VLE at $40{\sim}80^{\circ}C$ and first gas input. The $CO_2$ absorption capacity of MEA 10wt% solution was higher than two alkanolamine solutions at $40^{\circ}C$ and the equilibrium $CO_2$ loading was 0.5. Absorption capacity was excellent as follows; AMP>DEA>MEA. But absorption velocity was fast as follows; MEA>AMP>DEA. Though good absorbent was considered by many variables, absorption velocity and capacity was more important factor.

• Journal of the Korean Geosynthetics Society
• /
• v.19 no.2
• /
• pp.13-21
• /
• 2020

In Korea, small reservoirs have been constructed for the supply of agricultural water, but most of them have been over 50 years from the year of construction. Aging agricultural reservoirs are being investigated for serious defects such as leaks and movements in slope, which are very vulnerable to safety. Accordingly, grouting methods are used to reinforce aging agricultural reservoirs in Korea. However, cement used as a grouting injection material consumes natural resources and generates a large amount of greenhouse gases during production. In addition, there is a problem that sufficient reinforcement is not made due to various factors such as the injection amount, the compounding ratio, the injection pressure, and etc. Therefore, due to these problems, the development of new materials and methods that can replace the grouting method and cement is required. In order to solve these problems, this study conducted an laboratory test on the surface stabilizer used to secure the stability of road and rail slopes. In addition, the program was analyzed and the reinforcing effect was examined when the surface stabilizer was used as reinforcement material for aging agricultural reservoir. As a result of the laboratory test, when the surface stabilizer is mixed, the increase of cohesion is possible up to 9% and there is no change in the friction angle. The results of the program analysis showed that the 1.0m reinforcement of slopes increased the factor of safety by 1.4 times, making it possible to reinforce the aging agricultural reservoir using surface stabilizers. And as a reinforcement method, it was analyzed that it is most appropriate to reinforce the slope and the bottom of slope simultaneously.

• Journal of the Korean Magnetics Society
• /
• v.22 no.3
• /
• pp.79-84
• /
• 2012

Nano-magnetic materials such as iron-nitrides have been actively studied as an alternative to the application of high density, high performance needs for next generation information storage and also alternative to the rare earth and neodymium magnet. $Fe_4N$ is the basic materials for magnetic storage media and is one of the important magnetic materials in focus because of its higher magnetic recording density and chemical stability. Single phase ${\gamma}^{\prime}-Fe_4N$ nanoparticles have been prepared by a PAD (Plasma Arc Discharge) method and nitriding in a $NH_3-H_2$ mixed gases at temperature, $400^{\circ}C$ for 4 hrs. Also $Fe_{17}Sm_2N_x$ powders were synthesized by nitriding after reduction/diffusion of $Fe_{17}Sm_2$ to compare the magnetic properties with nano-sized $Fe_4N$ particles. The saturation magnetization of $Fe_4N$ and $Fe_{17}Sm_2N_x$ were 149 and 117 emu/g, respectively, but the coercive force was considerably smaller than that of bulk or acicular $Fe_4N$.

• Korean Journal of Food Science and Technology
• /
• v.37 no.6
• /
• pp.933-938
• /
• 2005

To investigate pertinent packaging treatment of fresh-cut potatoes (Solanum tuberosum L.), potato cubes were subjected to passive, gas exchange, and vacuum packaging conditions. Low density polyethylene film (LDPE), polypropylene film (PP), anti-fogging film (AP), and perforated film (PF) were used as passive packaging treatments. Mixed gases of 5% $CO_2/5%\;O_2$ (MA1) and 10% $CO_2/5%\;O_2$ (MA2) were applied as gas exchange packaging. Packs filled with cubes were kept at $5^{\circ}C$, and changes in weight loss, surface color, vitamin C content and sensory quality of cubes were analyzed during storage. Respiration rate of cubes was 2.11 times higher than that of intact raw potatoes at $5^{\circ}C$. Gas concentrations in passive packaging was maintained at 1-2% $O_2$ and 4-14% $CO_2$ after 7 days. Gas levels changed depending on films used. Cubes packed in PP and MA2 showed lowest weight loss and browning during storage. Firmness of cubes was not affected by packaging treatment. Vitamin C content was highest in cubes packed with AF. Cubes packed in MA2 showed highest quality upto 10days storage, followed by those packed in PP and AF.

• Journal of Conservation Science
• /
• v.26 no.4
• /
• pp.429-436
• /
• 2010

Dyestuffs extracted from fifteen kinds of natural dyeing materials were researched on their antimicrobial performance against 3 kinds of bacteria and 2 kinds of fungi in order to develop conservation/storage materials of traditional and natural dyed papers. The three types of mordants were evaluated by using the same method and then mixed with the dyestuffs to research their antimicrobial performance. With those results, dyed paper was made by mixing mordants with 9 kinds of dyestuffs with excellent antimicrobial performance. Among the dyed papers, Cotinus coggygria, Coptis chinensis, Phellodendri amurense, Rhus javanica and Acer ginnala multiple mordant papers were found to have an antibacterial quality against fungi, while, in the insect repellent experiment using termites, Coptis chinensis and Phellodendri amurense dyed papers were found to have insect repellent qualities. Also, with regard to the research result about the affect of dyeing paper on other materials like metal, Coptis chinensis have relatively stable qualities. Also, the three types of dyeed paper by Cotinus coggygria, Coptis chinensis and Phellodendri amurense, were found to have a tendency to remove harmful gases. Not only can these dyed papers be used for making storage box for cultural properties to prevent various organic artifacts from bio-damaging, but they can also be utilized as functional finishing materials in various spaces.

• Journal of the Korean Vacuum Society
• /
• v.19 no.3
• /
• pp.224-229
• /
• 2010

Indium oxide $(In_2O_3)$ thin films have been prepared on glass substrate by using radio-frequency reactive magnetron sputtering with changing the oxygen flow ratio. The substrate temperature was kept at a fixed value of $400^{\circ}C$, and the sputtering gas and reactive gas were supplied with argon and oxygen, respectively. The oxygen partial flow ratio was varied by controlling the amount of oxygen with respect to the total mixed gases, 10%, 20%, 30%, 40%, and 50%. The optical, electrical, and structural properties of the deposited thin films were investigated by using ultraviolet-visible-near infrared spectrophotometer, Hall measurement, and X-ray diffractometer and scanning electron microscopy. The $In_2O_3$ thin film deposited at 20% of oxygen flow ratio showed an average transmittance of 86% in the wavelength range of 430~1,100 nm, an electrical resistivity of $1.1{\times}10^{-1}{\Omega}cm$. The results show that the transparent conducting films with optimum conditions can be achieved by controlling the oxygen flow ratio.