DOI QR코드

DOI QR Code

Simultaneous Reduction of CH4 and NOx of NGOC/LNT Catalysts for CNG buses

CNG 버스용 NGOC/LNT 촉매의 CH4와 NOx의 동시 저감

  • Seo, Choong-Kil (Department of Automotive & Mechanical Engineering, Howon University)
  • 서충길 (호원대학교 자동차기계공학과)
  • Received : 2018.03.30
  • Accepted : 2018.06.01
  • Published : 2018.06.30

Abstract

Natural gas is a clean fuel that discharges almost no air-contaminating substances. This study examined the simultaneous reduction of $CH_4$ and NOx of NGOC/LNT catalysts for CNG buses related to the improvement of the $de-CH_4/NOx$ performance, focusing mainly on identifying the additive catalysts, loading of the washcoat, stirring time, and types of substrates. The 3wt. % Ni-loaded NGOC generally exhibited superior $CH_4$ reduction performance through $CH_4$ conversion, because Ni is an alkaline, toxic oxide, and exerts a reducing effect on $CH_4$. A excessively small loading resulted in insufficient adsorption capacity of harmful gases, whereasa too high loading of washcoat caused clogging of the substrate cells. In addition, with the economic feasibility of catalysts considered, the appropriate amount of catalyst washcoat loading was estimated to be 124g/L. The NOx conversion rate of the NGOC/LNT catalysts stirred from $200^{\circ}C$ to $550^{\circ}C$ for 5 hours showed 10-15% better performance than the NGOC/LNT catalysts mixed for 2 hours over the entire temperature range. The NGOC/LNT catalysts exhibitedapproximately 20% higher $de-CH_4$ performance on the ceramic substrates than on the metal substrates.

천연 가스는 공기 오염 물질을 거의 배출하지 않는 깨끗한 연료입니다. 이 연구의 목적은 CNG 버스용 NGOC/LNT(천연가스산화촉매/질소산화물흡장)촉매의 메탄과 질소산화물 동시 저감에 관한 연구로 메탄과 질소산화물 저감 성능 개선과 관련하여 조촉매, washcoat 담지량, 교반 시간 및 담체 종류에 대해 주로 초점을 두었다. 더구나, 니켈은 알칼리성의 독성 산화물이고 메탄에 영향을 미치는 효과가 있기 때문에, 3 wt% 니켈이 담지된 천연가스산화촉매는 일반적으로 메탄 전환율을 통해 우수한 메탄 감소 성능을 나타낸다. 담체에 담지량이 적으면 유해 가스의 흡장량이 충분치 않고 워시 코트가 너무 많이 담지되면 담체의 셀이 막히게 되었다. 촉매의 경제적을 고려할 때 촉매에 담지되는 양은 124g/L가 적절하다. 물질마다 5시간 동안 교반된 NGOC/LNT 촉매의 200에서 550도 까지 NOx 전환율은 2시간 동안 교반된 NGOC/LNT 촉매보다 전체 온도 범위에서 10-15% 우수한 성능을 보였다. 세라믹 담체의 NGOC/LNT 촉매는 메탈 담체보다 약 20% 수준의 높은 메탄 저감 성능을 나타냈다.

Keywords

References

  1. K. C. Oh, C. K. Seo, S. C. Go, "Commercialization Research of a Metal DOC based on Fe-Cr-Ni Substrate", Chem. Eng. J., vol. 254, no. 10, pp. 426-433, 2014. DOI: https://doi.org/10.1016/j.cej.2014.05.125
  2. T. V. Johnson, "Review of Diesel Emission and Control", SAE no. 2010-01-0301. DOI: https://doi.org/10.4271/2010-01-0301
  3. J. H. Hong, H. J. Ha, J. D. Han, "The Promotion Effects on Partial Oxidation of Methane for Hydrogen Production over Co/Al2O3 and Ni/Al2O3 Catalysts", Clean Tech., vol. 18, no. 1, pp. 95-101, 2012. DOI: http://dx.doi.org/10.7464/ksct.2012.18.1.095
  4. P. Forzatti, L. Lietti, I. Nova, E. Tronconi, "Diesel NOx Aftertreatment Catalytic Technologie: Analogies in LNT and SCR Catalytic Chemistry", Catal. Today, vol. 151, no. 3-4, pp. 202-211, 2010. DOI: https://doi.org/10.1016/j.cattod.2010.02.025
  5. A. Lundstrom, B. Andersson, L. Olsson, "Urea Thermolysis studied under Flow Reactor Conditions using DSC and FT-IR", Chem. Eng. J., vol. 150, no. 2-3, pp. 544-550, 2009. DOI: https://doi.org/10.1016/j.cej.2009.03.044
  6. L. Xu, W. Watkins, R. Snow, G. Graham, R. McCabe, "Laboratory and Engine Study of Urea-related Deposits in Diesel Urea-SCR After-treatment System", SAE no. 2007-01-1582. DOI: https://doi.org/10.4271/2007-01-1582
  7. A. Schuler, M. Vostmeier, P. Kiwic, J. Gieshoff, W. Hautpmann, A. Drochner, H. Vogel, "$NH_3$-SCR on Fe Zeolite Catalysts-From Model Setup to $NH_3$ dosing", Chem. Eng. J., vol. 154, no. 1-3, pp. 333-340, 2009. DOI: https://doi.org/10.1016/j.cej.2009.02.037
  8. A. Grossale, I. Nova, E. Tronconi, "Study of a Fe-zeolited-based System as NH3-SCR catalyst for Diesel Aftertreatment", Catal. Today, Vol. 136, no. 1, pp. 18-23, 2008. DOI: https://doi.org/10.1016/j.cattod.2007.10.117
  9. A. Sultana, M. Sasaki, K. Suzuki, H. Hamada, "Tuning the NOx conversion of Cu-Fe/ZSM-5 Catalyst in $NH_3$-SCR", Catal. Commun., vol. 41. no. 11, pp 21-25, 2013. DOI: https://doi.org/10.1016/j.catcom.2013.06.028
  10. C. K. Seo, H. N. Kim, B. C. Choi, M. T. Lim, "The Optimal Volume of a Combined System of LNT and SCR catalysts" J. Ind. Eng. Chem., vol. 17, no. 3, pp. 382-385, 2011. DOI: https://doi.org/10.1016/j.jiec.2010.10.033
  11. J. R. Sohn, S. G. Ryu, Y. I. Pae, "Structure and Thermal Properties of Chromium Oxide Supported on Zirconia", Journal of the Korean Institute of Chemical Engineers, vol. 30, no. 5, pp. 586-593, 1992.
  12. S. H. Zhang, M. F. Wu, T. T. Tang, Q. J. Xing, C. Q. Peng, F. Li, H. Lid, X. B. Luo, J. P. Zou, X. B. Min, J. M. Luo, "Mechanism Investigation of Anoxic Cr(VI) Removal by nano-valent iron based on XPS Analysis in time Scale", Chem. Eng. J., vol. 335, no. 3, pp. 945-953, 2018. DOI: https://doi.org/10.1016/j.cej.2017.10.182
  13. M. Long, C. Zhou, S. Xia, A. Guadiea, "Concomitant Cr(VI) Reduction and Cr(III) Precipitation with Nitrate in a Methane/Oxygen-based Membrane Biofilm Reactor", Chem. Eng. J., vol. 315, no. 5, pp. 58-66, 2017. DOI: https://doi.org/10.1016/j.cej.2017.01.018
  14. S. Hesamedini, A. Bund, "Formation of Cr(VI) in Cobalt containing Cr(III)-baded Treatment Solution", Surface Cating Tech., vol. 334, no. 1, pp. 444-449, 2018. DOI: https://doi.org/10.1016/j.surfcoat.2017.12.006
  15. D. Wang, Y. Ye, H. Liu, H. Ma, W. Zhang, "Effect of Alkaline Precipatation on Cr Species of Cr(III)-bearing Complexes typically used in the tannery industry", Chemosphere, vol. 193, no. 2, pp. 42-49, 2018. DOI: http://doi.org/10.1016/j.chemosphere.2017.11.006
  16. T. Wang, X. Jin, Z. Chen, M. Megharaj, "Simultaneous Removal of Pb(II) and Cr(III) by magnetite nanoparticle usging various synthesis conditions", J. Ind. Eng. Chem., vol. 20, no. 9, pp. 3543-3549, 2014. DOI: https://doi.org/10.1016/j.jiec.2013.12.047
  17. K. H. Hong, J. H. Kim, K. Chang, J. Kwon, "The Role of Cr on oxide formation in Ni-Cr alloys: A theoretical study", Computational Mater. Sci., vol. 142, no. 2, pp. 185-191, 2018. DOI: https://doi.org/10.1016/j.commatsci.2017.09.056
  18. G. Y. Jung, W. C. Jeon, S. Lee, S. H. Jung, S. G. Cho, "Reaction Characteristics of Ni-Al nanolayers by molecular dynamics simulation", J. Ind. Eng. Chem., vol. 57, no. 1, pp. 290-296, 2018. DOI: https://doi.org/10.1016/j.jiec.2017.08.035
  19. A. K. Thakur, G. M. Nisola, L. A. Limjuco, K. J. Parohing, R. E. C. Torrejos, V. K. Shahi, W. J. Chung, "Polyethylenimine-modified mesoporous silica adsorbent for simultaneous removal of Cd(II) and Ni(II) from aqueous solution", J. Ind. Eng. Chem., vol. 49, no.5, pp. 133-144, 2017. DOI: https://doi.org/10.1016/j.jiec.2017.01.019