• Journal of the Korean Wood Science and Technology
• /
• v.21 no.1
• /
• pp.39-50
• /
• 1993

The purpose of this study was to describe the micromorphological changes in Korean red pine (Pinus densiflora S. et Z.) wood decayed by a major brown-rot fungus, Lentinus lepideus, using scanning electron microscope and transmission electron microscope. At the end of the 12-week exposure to the fungus in soil block procedure(ASTM 1971), test blocks sustained 5.02% weight loss. The formation of bore hole by hyphae and penetration of hyphae through bordered pit were not observed. Instead, fungal hyphae appeared to penetrate axially tracheid luminar from the the ray cells via cross field pits. Hyphae were mainly found in lignin rich cell corner regions of tracheids, and also extensive degradation of tracheid wall occurred in this region. Extensive degradation of $S_2$ layer occurred without noticeable alteration of the $S_3$ layer, but warty layer and compound middle lamella remained relatively intact. Localized erosion, the characteristic of white rot, was observed in some cell wall and wall components including lignin were found to be decomposed.

• Tuberculosis and Respiratory Diseases
• /
• v.45 no.3
• /
• pp.619-623
• /
• 1998

Neurilemmoma, also called schwanomma, neurinoma, and perineural fibroblastoma is a rare benign tumor originated from the schwann cell of nerve sheath. They occur commonly at 20-50 aged person and involved the head and neck and flexor surface of the extremity. Histologically, they are characterized by Antoni A and Antoni B tissue composed of high and low cellularity. Primary neurilemmoma involved in the bronchial wall is extremely rare and few cases have been reported previously. We experienced neurilemmoma of the bronchial wall in a 72 year old woman. The pulmonary radiology showed the right middle lobe collapse with single lymphadenopathy, and bronchoscopic biopsy was performed to confirm the neurilemmoma.

• Journal of Institute of Control, Robotics and Systems
• /
• v.15 no.12
• /
• pp.1232-1239
• /
• 2009

This paper proposes an exploration strategy to efficiently find a specific place in large unknown environments with wall-following based path planning. Many exploration methods proposed so far showed good performance but they focused only on efficient planning for modeling unknown environments. Therefore, to successfully accomplish the room finding task, two additional requirements should be considered. First, suitable path-planning is needed to recognize the room number. Most conventional exploration schemes used the gradient method to extract the optimal path. In these schemes, the paths are extracted in the middle of the free space which is usually far from the wall. If the robot follows such a path, it is not likely to recognize the room number written on the wall because room numbers are usually too small to be recognized by camera image from a distance. Second, the behavior which re-explores the explored area is needed. Even though the robot completes exploration, it is possible that some rooms are not registered in the constructed map for some reasons such as poor recognition performance, occlusion by a human and so on. With this scheme, the robot does not have to visit and model the whole environment. This proposed method is very simple but it guarantees that the robot can find a specific room in most cases. The proposed exploration strategy was verified by various experiments.

• Journal of the Korean Solar Energy Society
• /
• v.25 no.4
• /
• pp.93-100
• /
• 2005

Character and illuminance distribution of daylighting is very important for the architectural plan in museum. Those data show bases for exhibition space design with daylighting and play a decisive role in visual perception of articles and space aesthetic. The goal of this paper was therefore to analyze the illuminance distribution in fine art museum with 3 typical girdle skylight types which are devided according to the art of protection from glare. This Experiment proved that they had a striking contrast with regard to the ratio of daylight illumination and illuminance distribution in spite of the same purpose of those development. The girdle skylight with a translucent glass showed the strongest value of the ratio of daylight illumination, but inequable illuminance distribution in space, excepting the area of the wall. However, the latticed reflector of light refracted daylight in the direction of wall and made illuminance distribution very equable in whole space. The ratio of daylight illumination at the girdle skylight which was located at the verge of the ceiling, was highest at the upper part of the wall and was reduced gradually from there, by way of the middle and under part of the wall, to the center of space.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.11
• /
• pp.107-118
• /
• 2013

Geosynthetic reinforced soil (GRS) walls have been increasingly applied recently due to its numerous geotechnical engineering applications. However failure occurs in some cases of constructed GRS walls. These GRS wall failures are mostly due to the unpredictable characteristics of intensive rainfall. Hence, the need for new and innovative ideas for rehabilitation methods has been getting attention. This paper introduces a case study for the design and restoration method of collapsed GRS wall using Limit equilibrium and Numerical Analyses. Restoration method includes: (1) soil nailing without backfill excavation and (2) reconstruction with GRS wall after collapsed backfill excavation. Analyses results show minimal horizontal displacements and shear strain on the reinforced concrete facing for the restoration case with soil nailing. On the other hand, horizontal displacements are developed in the middle of the mortar block facing and shear strains are developed at the bottom facing with spiral curves for the reconstructed GRS wall after collapsed backfill excavation. Therefore, the collapsed GRS wall was restored with the soil nailing without backfill excavation and its construction procedures are discussed in this paper.

• Journal of the Korean Geotechnical Society
• /
• v.25 no.5
• /
• pp.39-46
• /
• 2009

In this study, behavior of a rigid continuous wall, earth pressure distribution with construction stage, and axial force of earth anchors were evaluated based on field monitoring data and numerical analysis results. For this purpose, a construction site excavated using the diaphragm wall was selected and full instrumentation system was introduced. From monitoring results, it was found that the values of horizontal displacement of the wall measured from the inclinometers, which were installed within the diaphragm wall were similar to analytical value. The earth pressure increased with excavation progress due to jacking force of the ground anchors installed in previous excavation stages. When the excavation depth reached 60% of the final depth, observed earth pressure distribution was similar to that estimated from Peck's apparent earth pressure distribution. When the excavation depth was around 90% of the final depth, values of observed earth pressure showed middle values between those of Peck's and Tschebotarioffs apparent earth pressures. It was also observed that, when excavation depth is deep, values of the earth pressures from the rigid wall were similar to those estimated from conventional earth pressure distribution shape proposed for flexible walls.

• International conference on construction engineering and project management
• /
• 2024.07a
• /
• pp.85-92
• /
• 2024

Reinforced concrete modular integrated construction (MiC) has been widely used in Hong Kong nowadays, but the solutions for temporary tying of the side walls during the construction of the composite wall have still shortcomings. Based on a MiC project in Hong Kong, this paper proposes a new inner tie system for composite wall. The system components are installed on the side walls of precast modules without penetrating through the side walls. After the loop is rotated to contact the hook, the tying effect can be generated when the concrete is poured on site between the middle gap of two modules. This system replaces tie bolts penetrating through precast side walls, so that the modules' interior fitting-out can be fully completed in factory and the on-site construction has no adverse effects on the internal decoration. This paper mainly describes the mechanism of the system, FEA simulation and optimization of the member size, as well as tensile and punching shear tests to verify the reliability, safety and to get more information about failure mode of the system. The system will be further examined by assembling 1:1 mockup modules, and finally applied to a real MiC project soon. The system can also act as permanent tie bars for the composite wall to reduce the total wall thickness, save the structural cost and increase the usable area. Compared with other existing tying methods in the industry, the system is easy to install, reliable to take loads, adaptable to large construction errors, and has the potential to be widely used in future practical projects.

• The Journal of Korean Physical Therapy
• /
• v.30 no.3
• /
• pp.84-89
• /
• 2018

Purpose: Therapeutic climbing has become very popular today, with it being reported as a new method for preventing and treating orthopedic trauma to the shoulder joint. However, objective studies on its effects on the musculoskeletal system are still lacking. The objective of the present study was to investigate the effects of wall inclination during therapeutic climbing on the muscle activity around the shoulder joint. Methods: In this study, the participants performed movements at three different inclination angles of $0^{\circ}$, $+15^{\circ}$, and $-15^{\circ}$. sEMG was performed to measure the activities of five different muscles around the shoulder joint (biceps brachii, serratus anterior, upper trapezius, middle trapezius, and lower trapezius muscles). Results: Biceps brachii muscle showed a significant increase at $-15^{\circ}$, as compared to $0^{\circ}$ (p<0.01), and the serratus anterior also showed a significant increase at $-15^{\circ}$, as compared to $0^{\circ}$ (p<0.05). Moreover, the middle and lower trapezius muscles also showed a significant increase at $-15^{\circ}$, as compared to $0^{\circ}$ (p<0.001). Compared to $0^{\circ}$, all muscles showed decreased values at $15^{\circ}$, but the differences were not statistically significant (p>0.05). Conclusion: Therapeutic climbing may be a new therapeutic approach that can increase muscle strength and coordination in the sensory nervous system, since it can be used as a tool that promotes active movement by altering wall inclination and causing the user to generate movements according to the existing situation.

• Journal of the Korean Society of Safety
• /
• v.35 no.5
• /
• pp.128-136
• /
• 2020

In the present experimental study, the effect of water-based iron(III) oxide nanofluid on the MFB(Minimum Film Boiling) point during quenching was investigated. As the highly heated test specimen, the cylindrical stainless steel rod was used, and as the test fluids, the water-based iron(III) oxide nanofluids of 0.001 and 0.01 vol% concentrations were prepared with the pure water. To examine the effect of location in the test specimen, the thermocouples were installed at the bottom and middle of wall, and center in the test specimen. Through a series of experiments, the experimental data about the influences of nanofluid concentrations, the number of repeated experiments, and locations in the test specimen on the reaching time to MFB point, MFBT(Minimum Film Boiling Temperature), and MHF(Minimum Heat Flux) were obtained. As a result, with increasing the concentration of nanofluid and the number of repeated experiments, the reaching time to MFB point was reduced, but the MFBT and MHF were increased. In addition, it was found that the effect of water-based iron(III) oxide nanofluid on the MFB point at the bottom of wall in the test specimen was observed to be greater than that at the middle of wall and center. In the present experimental ranges, as compared with the pure water, the water-based iron(III) oxide nanofluid showed that the maximum reduction of reaching time to MFB point was about 53.6%, and the maximum enhancements of MFBT and MHF were about 31.1% and 73.4%, respectively.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.49 no.5
• /
• pp.262-269
• /
• 2023

Objectives: Anterior maxillary sinus wall fractures are common in all types of maxillofacial trauma. They can result in various complications, including injury to the surrounding nerves. Owing to its anatomy, trauma to the maxillary antrum can result in injury to the middle superior alveolar nerve (MSAN) and the anterior superior alveolar nerve (ASAN). The purpose of this study is to evaluate neurosensory deficits (NSD) present in maxillary gingiva, incisors, and premolars after injury to the anterior wall of the maxillary antrum. Materials and Methods: This prospective study was conducted among 39 patients sustaining unilateral fractures of the anterior maxillary sinus wall. Clinical neurosensory tests including two-point discrimination and fine touch discrimination were performed to classify the extent of nerve injuries as mild, moderate, severe, or anesthetic. Additional temperature discrimination and pulpal sensibility tests (electric pulp testing and cold testing) were carried out. A comparison of radiographic fracture patterns and severity of nerve injury was done. Testing was carried out immediately after trauma and at 2-month follow-up. Results: More than half of the patients assessed in the study group presented with NSD of the teeth and gingiva after trauma. The incidence of deficits varied with the type of test used to measure them. Most frequently, patients presented with both loss of two point as well as fine touch discrimination thresholds. Severe nerve injuries were associated with loss of temperature discrimination clinically and displaced fractures radiographically. There was no significant relationship between the recovery of pulpal and gingival sensation. The patterns of injury and recovery in ASAN and MSAN were similar. Conclusion: NSD after trauma to the maxillary antrum is relatively common. Clinical loss of temperature discrimination and radiographic signs of fracture lines passing through the canalis sinuosus are predictors of persistent and severe oral NSD.