• Toxicological Research
• /
• 제17권1호
• /
• pp.7-9
• /
• 2001

The quantitative assessment of the penetration of organic solvents through skin is necessary for the evaluation of health hazards in occupational environments. We investigated the rate of dermal penetration when mixed or single forms of organic solvents were placed into a diffusion cell in vitro or into an experimental animal in vivo. The diffusion rates of methanol. toluene, and styrene were 6.07, 0.129, and 0.046 mg/$cm^2$/h, respectively. When skin was exposed to the mixed solvent of methanol and toluene, the penetration rate of toluene did not change significantly (0.110 mg/$cm^2$/h). However, the rate of methanol penetration increased to 43.90 mg/$\textrm{cm}^2$/h. The penetration rate of methanol also increased significantly to 54.69 mg/$cm^2$/h by mixing it with styrene. The concentration of methanol in the blood was monitored during the epicutaneous exposure in rats. The blood concentration of methanol was increased by mixing methanol with toluene as seen in the in vitro experiments. These results showed that the penetration rate of organic solvents would be enhanced by mixing them with other solvents.

• Proceedings of the SAREK Conference
• /
• 대한설비공학회 2008년도 동계학술발표대회 논문집
• /
• pp.3-8
• /
• 2008

Effect of external heating rate on the conversion efficiency for the steam reforming of methanol is investigated numerically considering both heat and mass transfer of the species in a packed bed microreactor. In a results from the numerical simulation, the conversion efficiency of methanol has been obtained for the external heating rate. The axial variation of mole fraction of methanol has been additionally presented for several cases of external heating rates. The results show that for the constant inlet temperature condition the conversion efficiency of methanol increases with external heating rate over the range of operating conditions.

• Korean Journal of Microbiology
• /
• 제21권3호
• /
• pp.163-169
• /
• 1983

Effects of temperature on the gorwth characteristics and the chemical composition of pseudomonas cells grown under glucose-or methanol-utilizing continuous culture were studied. In a glucose-utilizing continuous culture, optimum dilution rate, agitation, pH, and temperature, for the higher biomass yield were $0.45hr^-$, 7000rpm, pH 7.5, and $30^{\circ}C$, respectively. But in a methanol-utilizing continuous culture, they were $0.125hr^-$, 600rpm, pH 8, and $30^{\circ}C$, respectively. In methanol-utilizing continuous culture, the maximum production rate of the cells was 1.48g, dry wt./1/hr at a dilution rate of $0.45hr^-$, and the cell yield was 0.46g. dry wt./g. glucose. In the methanol-utilizaing continuous culture, the maximum production rate of the cells was 0.33 7g. dry wt./1/hr. at a dilution rate of $0.125hr^-$ and the cell yield was 0.44g dry cell/g. methanol. The contents of protein of the cells increase with the increase ingrowing temperature (from 15 to $30^{\circ}C$), more or less, while the contents of RNA nad carbohydrate of the cells decreased. However, DNA contents of cells growth under the various temperature ranges didn't change. As the temeprature of cultivation rises at a constant dilution rate, the efficiency of RNA in protein synthesis was increased, showing the decreases in the ratio of RNA to protein.

• Journal of the Korean Applied Science and Technology
• /
• 제26권4호
• /
• pp.394-399
• /
• 2009

The esterification of palmitic acid in Jatropha Oil using 8wt% p-TSA catalyst was done at the 1:8 molar ratio of oil to methanol and $65^{\circ}C$. The conversion of palmitic acid appeared to be 95.3% in 60min. After that, the continuous transesterification of the oil using 0.5wt% KOH, 0.8wt% TMAH mixed catalyst[40vol% KOH(0.5wt%) + 60vol% TMAH(0.8wt%)] and 1.1wt% TMAH was conducted with the flow rates and the molar ratios at $65^{\circ}C$. The overall conversion of Jatropha Oil increased with the decrease of flow rate and showed 95.6% with 9ml/min of flow rate at the 1:8 molar ratio of oil to methanol and $65^{\circ}C$. But it showed 87% with 15ml/min of flow rate at the same conditions. The recovery of methanol(%) appeared to be 86% at the 1:8 molar ratio of oil to methanol, mixed catalyst and $65^{\circ}C$.

• Korean Journal of Chemical Engineering
• /
• 제35권11호
• /
• pp.2145-2149
• /
• 2018

The formation of methanol directly from methane and steam was observed over Cu ion-exchanged mordenite. Furthermore, the continuous production of methanol was achieved by co-feeding methane and steam over Cumordenite. The methanol production rate was comparable to that reported in the stepwise process in which activation, methane reaction, and extraction of methanol were carried out separately.

• Journal of the Korean Chemical Society
• /
• 제29권5호
• /
• pp.465-471
• /
• 1985

The rate constants for the solvolysis of anthraquinone-2-carbonyl chloride in binary solvent mixtures, methanol-acetonitrile, methanol-acetone, ethanol-acetonitrile and ethanol-acetone, have been studied by means of conductometry. Maximum rate phenomena were observed at the methanol mole fraction, $X_{MeOH}$ = 0.73~0.81 for methanol-acetonitrile and at $X_{MeOH}$ = 0.83 for methanol-acetone mixtures. The Kivinen and Grunwald-Winstein plots indicated that the reaction proceeds via $S_N2$ type mechanism. Application of Taft's solvatochromic correlation on the solvolysis rate revealed that both $\alpha$ and ${\pi}^*$ are important for reactions in methanol-acetonitrile and methanol-acetone mixtures, while only ${\alpha}$ influences significantly on the rate in ethanol-acetonitrile and ethanol-acetone mixtures.

• Journal of ILASS-Korea
• /
• 제4권3호
• /
• pp.24-31
• /
• 1999

The engine performance and combustion characteristics of methanol blended fuel of spark ignition engine were discussed on the basics of experimental investigation. The effects of methanol blending fuel on combustion in cylinder were investigated under various conditions of engine cycle and blending fuel on combustion in cylinder were investigated tinder various conditions of engine cycle and blending ratios. The results showed thai the engine performance was influenced by the methanol blending ratio and the variations of operating conditions test engine. The increase of fuel temperature brought on the improvement of combustion characteristics such as cylinder pressure. the rate of pressure rise and heat release in an engine. The burning rate of fuel-air mixture, the exhaust emissions and the other characteristics of performance were discussed also.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• 제20권10호
• /
• pp.3381-3386
• /
• 1996

The engine performance and combustion characteristics of methanol blended fuel in spark ignition engine were discussed on the basis of experimental investigation. The effects of methanol blending fuel on combustion in cylinder were investigated under various conditions of engine cycle and blending ratio. The results showed that the engine performance was influenced by the methanol blending ratio and the variations of operating conditions of test engine. The increase of fuel temperature brought on the improvement of combustion characteristics such as cylinder pressure, the rate of pressure rise and heat release in an engine. The burning rate of fuel-air mixture, the exhaust emissions and the other characteristics of performance were discussed also.

• Bulletin of the Korean Chemical Society
• /
• 제6권1호
• /
• pp.19-23
• /
• 1985

Solvolysis of 1-adamantyl chloride, -bromide and -tosylate have been studied in methanol-acetonitrile mixtures. Rate maxima were found for 1-adamantyl bromide and tosylate at 80-90 % methanol mixtures. The rate maximum observed was interpreted as a result of cooperative enhancement of cation and anion solvation. 1-Adamantyl tosylate had small cation solvation but had extensive anion solvation. It was concluded that the Y scale based on adamantyl tosylate is superior to others since it varies in a wide range especially for weakly ionizing medium.

• Bulletin of the Korean Chemical Society
• /
• 제18권9호
• /
• pp.1017-1021
• /
• 1997

Solvolyses of p-methoxyphenyl chloroformate in water, D2O, CH3OD, 50% D2O-CH3OD, and in aqueous binary mixtures of acetone, ethanol and methanol are investigated at 25.0 ℃. Product selectivities are reported at 25 ℃ for a wide range of ethanol-water and methanol-water solvent compositions. The Grunwald-Winstein plots of first-order rate constants for p-methoxyphenyl chloroformate with YCl (based on 1-adamantyl chloride) show marked dispersions into three separate curves for the three aqueous mixtures with a small m value and a rate maximum for aqueous alcohol solvents. Third-order rate constants, kww, kaw, kwa and kaa were calculated from the observed kww and kaa values together with kaw and kwa calculated from the intercept and slope of the plot of 1/S vs. [alcohol]/[water]. The calculated rate constants, kcalc and mol % of ester agree satisfactorily with those of the observed rate constants, kobs and mol % of ester, supporting the stoichiometric solvation effect analysis. The kinetic solvent isotope effects determined in water and methanol are consistent with the proposed mechanism of the general base catalyzed carbonyl addition-elimination.