• Journal of Biosystems Engineering
• /
• v.29 no.4
• /
• pp.323-328
• /
• 2004

A surface plasmon resonance (SPR) sensing system, which belonged to a family of thin film refractometry-based sensors, was fabricated to measure the alcohol contents in alcoholic beverages. In this study, a SPR owe was obtained by a photodiode array with 128 pixels and transformed into a refractive index which was calculated by means of the first moment of values below a baseline of 0.85. When the sensing system was applied to Soju, Cheonju, Igwaduju and Tacju highly linear relationships between the refractive index by SPR and the contents of alcohol were obtained. That is, the coefficients of determination in their linear models were 0.992, 0.933, 0.918 and 0.954, respectively. Meanwhile, the effect of sample preparations on the accuracy of measurement was analyzed. As for Soju and Tacju, the best calibration equations were obtained when no sample preparation was applied. The best calibration models for measurement of Cheonju and Igwaduju were obtained through the samples filtered by $C_{18}$ disks.

• Advances in Traditional Medicine
• /
• v.4 no.2
• /
• pp.77-81
• /
• 2004

Petroleum ether, benzene and alcohol extracts of seeds of C. juncea administered orally at the dose level of 25mg/100g body weight to adult female mice for 30 days, resulted in irregular estrous cycle with prolonged estrus and metaestrus and reduced diestrus and proestrus during the experimental period. Histological studies of the ovary indicate increases in the number of atretic follicles but decreases in the number of developing follicles, Graafian follicles and corpora lutea. The total cholesterol content of the ovary is increased, whereas ascorbic acid content is decreased. The weight of the uterus and its micrometric measurement in all experimental mice are increased significantly. The alcoholic extracts showed estrogenic activity in immature mice by early opening of the vagina, premature cornification of the vaginal epithilium and increases in uterine weight. However, alcohol extract of seeds of C. juncea was more effective in causing these changes compared to other extracts. After subjecting to preliminary phytochemical screenings alcohol extract showed positive; test for alkaloids, steroids, glycosides, flavones, phenols and tannins.

• Analytical Science and Technology
• /
• v.11 no.3
• /
• pp.222-228
• /
• 1998

Five kinds of packed column and two kinds of capillary column were used to get optimum condition for ethanol analysis by using fifteen different volatile, low molecular weight organic substances. Only two columns, Gaskuropack 54 and DB-1, showed good separation efficiency. In the adding salt-effect experiment 0.6N - perchloric acid, 1M - meta-phosphoric acid and saturated NaCl solution were used for alcohol concentration measurement of biological fluids and tissue specimens. Among adding salt experiment, adding saturated NaCl solution showed the most stable value of alcohol concentration. This fact might be due to the increased vaporization of alcohol in the saturated NaCl solution. In the time-course of blood alcohol concentration, the alcohol level was lineary decreased to the diameter of vessel containing specimens. This result was interpreted in view of ethanol level, weight, water content, and hematocrit value. The ethanol distribution levels were measured from samples of blood and tissue obtained from 25 postmortems cases investigated by NISI. This study showed that the distribution level was decreased in order of brain, blood, kidney, spleen, liver, and lung.

• Membrane Journal
• /
• v.20 no.4
• /
• pp.335-341
• /
• 2010

This study focuses on the investigation of the anion exchange membrane through blending poly(ethylenimine) (PEI) and poly(vinyl alcohol) (PVA) varying the mixing ratio. To characterize the resulting membranes, the water content, contact angle, FT-IR, thermal gravimetric analysis, ion exchange capacity, ion conductivity and elastic modulus were measured. The PVA / PEI = 90 / 10 membrane showed the ion conductivity, $5.16{\times}10^{-2}S/cm$ and simultaneously the contact angle, $78.3^{\circ}$. According to TGA measurement, the resulting membranes seemed durable at room temperature. Through the modulus test, the mechanical properties increased with increasing PVA content and apparently the membranes looked very robust.

• Korean journal of food and cookery science
• /
• v.7 no.2
• /
• pp.89-95
• /
• 1991

The effects of lactic acid bacteria on the chemical and microbial changes of fermented kimchi at various temperatures were studied. Kimchi was homogenized and was sterilized by ultra violet (UV), then Lactobacillus plantarum, Leuconostoc mesenteroides, Pediococous acidilactici, Lactobacillus brevis and the mixture of these bacteria inoculated on sterilized kimchi, respectively. The measurement of alcohol by gas chromatography, and changes of sugar content and total viable count were investigated and palatability test was carried while inoculated kimchi was fermented at $30^{\circ}C$, $21^{\circ}C$ and $7^{\circ}C$. Ethyl alcohol was detected by GC in sample I (original Kimchi homogenate), III(inoculated Leu. mesenteroides), V(inoculated with Lac. brevis), then especially, more content were detected at $14^{\circ}C$. Sugar content reduced in accordance with fermentation proceeding. Total viable count increased at early fermentation stage, but thereafter decreased slowly. In the result of palatability test, sample I was the highest at all temperatures, sample III and IV (inoculated with mixed lactic acid bacteria) was the following in that kimchi odor and taste and the temperature.

• Polymer(Korea)
• /
• v.35 no.4
• /
• pp.296-301
• /
• 2011

This study focuses on the investigation of the impregnation of poly (vinyl alcohol) (PVA) crosslinked with poly(styrene sulfonic acid-co-maleic acid) (PSSA-MA) to porous polyethylene membrane for the fuel cell application. The membranes were characterized by the measurements of the water content, contact angle, FTIR spectra, thermal gravimetric analysis, ion exchange capacity, proton conductivity, methanol permeability and elastic modulus. The existence of hydrophilic moieties in the impregnated membranes was confirmed by contact angle and FTIR measurements. The impregnated PVA/PSSAMA(90:10) membrane exhibited a higher ion exchange capacity (1.2 meq./g dry membrane) than Nafion membrane (0.91 meq./g dry membrane). Through the elastic modulus measurement, the dimensional stability of the resulting membranes was expected to increase higher than the polyethylene membranes. The methanol crossover and water content decreased even if the PSSA-MA content increased due to the reduction of the free volume.

• The Journal of Internal Korean Medicine
• /
• v.40 no.3
• /
• pp.331-342
• /
• 2019

Objectives: Samul-tang is commonly used to alleviate the side effects of chemotherapy. This study aimed to establish an efficient method of extracting ACTS002 based on Samul-tang using the yield, high-performance liquid chromatography (HPLC), and antioxidant assay. Methods: ACTS002 was extracted from each extraction solvent, and the contents of 5-hydroxymethyl-2-furaldehyde (5-HMF), paeoniflorin, and ferulic acid were quantitatively analyzed and compared using HPLC. Moreover, the antioxidant activities of ACTS002 were measured using total flavonoids, total phenolic compounds, 1,1-diphenyl-2-picrylhydrazyl (DPPH), 2,2'-azino-bis (3-ethylbenzothiazoline-6-sulphonic acid) (ABTS), and Ferric reducing/antioxidant power (FRAP). Results: All of the components were set as the index contents because they were easy to process. The antioxidant activity of total flavonoids was the highest in 70% ethyl alcohol extracts, and total phenolic compounds were the highest in 50% ethyl alcohol extracts. In DPPH, 50% ethyl alcohol extracts showed the highest activity, and in ABTS 70% ethyl alcohol extracts were the highest. In FRAP, 70% ethyl alcohol extracts showed the highest activity. Conclusions: ACTS002 can control quality by setting 5-HMF, paeoniflorin, and ferulic acid as the index contents. The antioxidant activity measurement was relatively high in the 50% and 70% ethyl alcohol extracts. Our results can predict the possibility of a pharmacological activity and the standardization of ACTS002.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.3
• /
• pp.456-464
• /
• 1997

The effect of the additives on the Zn-Ni alloy electrocrystallization from a chloride bath was investigated by means of electrochemical methodes, scanning electron microscopy and measurement of surface appearance, X-ray diffraction patterns. The additives tested were the surfactant of naphtalene-derivative, saccharin and aliphatic alcohol. The resistance of electrodeposit increased by adding the additives, whereas the effect of additives on resistance was different with current density. The nickel content of alloy deposit was increased by the addition of alcohol, while decreased by the surfactant. The surface roughness, appearance and morphology of deposit were also influenced by the type of additive. The fine, compact grains and good surface roughness could be obtained from the surfactant or alcohol -added bath, and the surfactant or saccharin improved the surface appearance.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.6
• /
• pp.592-597
• /
• 2004

Porous silicon(PS) has received much attention as a sensitive material of chemical sensors because of its large internal surface area. In this work, we fabricated gas-sensing devices based on the porous silicon layer which could be applicable to the measurement of blood alcohol content(BAC), and estimated their electrical properties. The structure of the sensor is similar to an MIS (metal-insulator-semiconductor) diode and consists of thin Au/oxidized PS/PS/p-Si/Al, where the p-Si substrate is etched anisotropically to reduce the thickness. We measured C-V curves from two types of the samples with the PS layer treated by the different anodization current density of 60 or 100 mA/cm$^2$, in order to compare the sensitivity. As a result, the magnitude and variation of capacitances from the devices with the PS formed under the current density of 100 mA/cm$^2$ were found to be more detectable due to the larger internal surface.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.12 no.2
• /
• pp.103-111
• /
• 1979

For the effective utilization of the coastal fish resources in Korea, an investigation on the optimum processing conditions and the quality of a textured fish protein concentrate similar to the texture of animal meat has been carried out with the fish meat of Alaska pollack and mackerel. A noodle shaped product was prepared with the fish meat paste after the adjustment of pH and salt content. The product was soaked in $96\%$ ethyl alcohol to produce textured fish protein concentrate and then dried. The processing conditions were estimated with the rehydration capacity of the textured fish protein concentrate(FFC). The quality of the final product was evaluated with chemical composition, sensory test and texture measurement. The optimum pH and salt content of the fish meat for the processing of meaty textured FPC were 7.5 and $1.0\%$ respectively. The most effective soaking conditions were as follows:soaking time, 40 min. ; temperature of alcohol, 5 to $20^{\circ}C$;amount of alcohol, 4 times the weight of tile fish meat paste, number of soaking in alcohol, 4 times. The alcohol remaining in meaty textured FPC could be removed effectively by forced air drying. The yield and the contents of protein and lipid in the meaty textured FPC from Alaska pollack were $19.9\%\;84.3\%\;and\;0.5\%$ and those from mackerel were $29.8\%,\;78.1\%\;and\;3.6\%$ respectively. The content of essential amino acid in the meaty textured FPC from Alaska pollack and mackerel was not inferior to that of beef, textured soybean protein and FAO pattern. Beef meat can be substituted with the meaty textured FPC up to $50\%$ in processing meat balls withoutanysignificantlossinthetaste, ordor and texture.