• Journal of electromagnetic engineering and science
• /
• v.10 no.3
• /
• pp.104-116
• /
• 2010

With several advantages such as flexible downlink-to-uplink(DL-to-UL) ratio and flexible spectrum usage, Time Division Duplexing(TDD) is emerging as an alternate to Frequency Division Duplexing(FDD), especially in wireless broadband systems. We already have at least four different TDD systems in the industry: Time Division-Synchronous Code Division Multiple Access(TD-SCDMA), IEEE 802.16e-TDD, IEEE 802.16m-TDD, and Time Division-Long Term Evolution(TD-LTE). A disadvantage of TDD is that tight coordination such as time synchronization between adjacent operators is required to prevent interference between the adjacent TDD systems. In this paper, we investigate coexistence scenarios among the above four well-known TDD systems and calculate spectral efficiency(SE) loss in each scenario. Our findings are that SE loss can be significant if TDD ratios of the adjacent operators are considerably different. However, as long as the TDD ratios of the adjacent operators are similar, configurations in the systems permit perfect time synchronization between the two heterogeneous TDD systems, and the resulting SE loss is zero or reasonably low. We believe that the above findings and the configurations of the TDD systems recommended tominimize SE loss will be helpful for operators who deploy TDD systems in system parameter determination and cross-operator coordination.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.10 no.5
• /
• pp.501-507
• /
• 2005

This paper proposes a Hybrid Random PWM(HRPWM) technique using a LF2407 DSP board in order to spread the power spectra of an induction motor. The proposed method is composed to the PRBS (Pseudo-Random Binary Sequence) with the Lead-Lag random bit and the random triangular carrier for the logical comparison. Also, a DSP generates the random number, the PRBS and the three-phase reference signal, a MAX038 chip operating as frequency modulator generates the random triangular carrier. For verification of the proposed method, the experiments were conducted with a three-phase adjustable speed a.c drives, and the results of simulations and experiments are presented.

• Phonetics and Speech Sciences
• /
• v.7 no.4
• /
• pp.77-83
• /
• 2015

Voice complication without the laryngeal nerve injury can occur after thyroidectomy. The purpose of this study is to investigate voice changes according to extent of thyroidectomy with acoustic analysis. Thirty-five female patients with papillary thyroid carcinoma took voice evaluation at before and 1 month, and 3 months after thyroidectomy. Acoustic analysis parameters were speaking fundamental frequency(SFF), min $F_0$, max $F_0$, dynamic range $F_0$, jitter, shimmer, noise-to-harmonic ratio(NHR), and Cepstral prominence peak(CPP). Repeated-measured analysis of variance was applied. Time-related voice changes showed significant differences in all parameters except NHR. At 1 month after surgery, voice quality was worse and pitch was decreasing, but voice quality and pitch were improving at 3-month follow-up. Voice changes according to the extent of surgery were in SFF, max $F_0$, and dynamic range $F_0$. Time by surgery-related voice change existed only in min $F_0$. The result showed that the severity of voice complication depended on the extend of thyroidectomy which had a negative impact on $F_0$-related parameters. The deterioration of voice quality at 1 month after thyroidectomy may be affected by the loss of thyroid hormone in the blood. The descent of $F_0$-related parameters may be impacted by laryngeal fixation of surgical site adhesion.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.3
• /
• pp.267-279
• /
• 1998

A numerical study was made of flow behind a circular cylinder in a uniform flow, where the cylinder was rotationally oscillated in time. The temporal behavior of vortex formation was scrutinized over broad ranges of the two externally specified parameters, i.e., the dimensionless rotary oscillating frequency (.110.leq. $S_{f}$.leq..220) and the maximum angular amplitude of rotation (.theta.$_{max}$=15 deg., 30 deg. and 60 deg.). The Reynolds number (Re= $U_{{\inf}D}$.nu.) was fixed at Re=110. A fractional-step method was utilized to solve the Navier-Stokes equations with a generalized coordinate system. The main emphasis was placed on the initial vortex formations by varying $S_{f}$ and .theta.$_{max}$. Instantaneous streamlines and pressure distributions were displayed to show the vortex formation patterns. The vortex formation modes and relevant phase changes were characterized by measuring the lift coefficient ( $C_{L}$) and the time of negative maximum $C_{L}$( $t_{-C}$$_{Lmax}$) with variable forcing conditions.s.tions.s.s.s.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.947-950
• /
• 2005

For revolving and elevating a turret of a tank, we substitute an existing oil pressure system with an electric system using a motor and applied the vector control method to this system. A switching method of an inverter for providing desired sinusoidal current to each phase of a motor, we adopted min-max pulse width modulation method which takes less computation time, rather than space vector pulse width modulation method. We designed a digital filter and applied it to the control system. Developed current controller is verified it's performance through a current control test, speed control test, frequency response and tracking a profile of speed test.

• Journal of Advanced Navigation Technology
• /
• v.21 no.2
• /
• pp.193-199
• /
• 2017

In the paper, a dual band-notched monopole antenna is proposed for 2.4 GHz WLAN (2.4 ~ 2.484 GHz) and UWB (3.1 ~ 10.6 GHz) applications. The 3.5 GHz WiMAX band notched characteristic is achived by a pair of L-shaped slots instead of the previous U-shaped slot on the center of the radiating patch, whereas the 7.5 GHz band notched characteristic is achived by C-shaped strip resonator placed near to the microstrip feed line. The measured impedance bandwidth (${\mid}S_{11}{\mid}{\leq}-10dB$) is 8.62 GHz (2.38 ~ 11 GHz) which is sufficient to cover 2.4 GHz WLAN and UWB band, while measured band-notched bandwidths for 3.5 GHz WiMAX and 7.5 GHz bnad are 1.13 GHz (3.15 ~ 4.28 GHz) and 800 MHz (7.2 ~ 8 GHz) respectively. In particular, it has been observed that antenna has a good omnidirectional radiation patterns and higher gain of 2.51 ~ 6.81 dBi over the entire frequency band of interest.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.11
• /
• pp.1101-1110
• /
• 2011

This paper presents a printed, wideband folded monopole antenna for laptop and tablet computer applications. The proposed antenna is designed to cover bandwidth(2.3~10.6 GHz) of Bluetooth, WiMAX, and UWB system by using the printed folded monopole antenna having asymmetrical line width coupling with a parasitic inverted- L element. Also, wireless LAN band(5.15~5.85 GHz) which interferes with UWB system is rejected by inserting half-wavelength open stub in the folded monopole antenna. -10 dB bandwidth of the fabricated wideband antenna is 2.27~10.6 GHz (4.7:1) and -10 dB band-rejected bandwidth is measured as 700 MHz(5.15~5.85 GHz, 12.72 %). The gain and efficiency of the antenna except for the rejected band are higher than 3.93 dBi and 91.89 % and are measured as -2 dBi and 14.65 % at 5.5 GHz which is band-rejected frequency. The size of the antenna is suitable to install for small space of tablet and laptop computers as 12.75(1 ${\lambda}$/10)${\times}$12(1 ${\lambda}$/11) $mm^2$(${\lambda}$ is free space wavelength at 2.3 GHz). Therefore, we verified that the designed antenna is appropriate for wideband antenna of tablet and laptop PC applications.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.5
• /
• pp.944-949
• /
• 2015

This study proposed a patch antenna with a MIMO structure which is applicable for wireless communication equipment by combining a single patch antenna with a multi port. The proposed MIMO patch antenna was designed through the TRF-45 substrate with a relative permittivity of 4.5, loss tangent equal to 0.0035 and dielectric high of 1.6 mm, and the center frequency of the antenna was 2.45 GHz in the ISM (Industrial Scientific and Medical) band. The proposed MIMO patch antenna had a 500 MHz bandwidth from 2.16 ~ 2.66 GHz and 24.1% fractional bandwidth. The return loss and VSWR were -62.05 dB, 1.01 at the ISM bandwidth of 2.45 GHz. The Wibro band of 2.3 GHz was -17.43 dB, 1.33, the WiFi band of 2.4 GHz was -31.89 dB, 1.05, and the WiMax band of 2.5 GHz was -36.47 dB, 1.03. The radiation patterns included in the bandwidth were directional, and the WiBro band of 2.3 GHzhad a gain of 4.22 dBi, the WiFi band of 2.4 GHz had a gain of 4.12 dBi, the ISM band of 2.45 GHz had a gain of 4.06dBi, and the WiMax band of 2.5 GHz had a gain of 3.9 6dBi.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.36 no.4
• /
• pp.232-241
• /
• 2020

Purpose: This study investigated the complications and patterns of implants that confronted with the extruded natural teeth. Materials and Methods: Among patients who received implant treatment between 2006 and 2018 at Chosun University Dental Hospital, only implants that had a maintenance period of at least 5 years and that both implants and confronting natural teeth could be measured and compared on a radiograph were selected. They were divided into two groups. Group 1, experimental group consisted of Implants confronting the extruded natural posterior teeth (n = 167: maxilla (Group 1max) = 92, mandible (Group 1man) = 75) and Group 2, control group consisted of Implants confronting the normal natural posterior teeth (n = 656: maxilla (Group 2max) = 272, mandible (Group 2man) = 384). Results: The incidence of complications between Group 1 and Group 2 was statistically significant. In particular, there was a statistically significant difference between the frequency of marginal bone loss and the amount of marginal bone loss. Conclusion: The extruded natural tooth may cause more frequent complications including bone resorption in the opposing implant.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.1151-1156
• /
• 2003

The dynamic properties of short-fiber reinforced Chloroprene rubber for vibration isolators have been studied as functions of interphase conditions and fiber content. The loss factor showed the maximum at strain amplitude 2%, and increased 0.09 for matrix, 0.05 for reinforced rubber with increasing frequency respectively. The dynamic ratio rapidly decreased with increasing strain amplitude, and some increased with increasing frequency. The better interphase condition showed the lower dynamic ratio. Therefore, the short-fiber reinforced rubber could have the better isolation in frequency ratio(${\sqrt{2}}min$.) compared to frequency ratio(${\sqrt{2}}max$.). And we have investigate the possibility of applying short-fiber reinforced rubber to automotive engine mount.