• International Journal of Contents
• /
• v.2 no.1
• /
• pp.29-33
• /
• 2006

The common-source low noise amplifier(LNA) with inductive degeneration using a genetic algorithm is designed and tested for a down converter in an industrial, scientific and medical (ISM) band application and a wireless broadband internet service (WiBro). The genetic algorithm optimizes the reflection coefficients to be well matched the input and output ports between multistage transistor amplifiers, and it generates low voltage standing wave ratio as well as gain flatness of the amplifier. The stability and the gain flatness of the LNA have been improved by combining the matching circuits and the series feedback microstrip lines with inductive degeneration at common-source port. In the frequency range of ISM band and WiBro application operating at $2.3GHz{\sim}2.5GHz$, the measured power gain and maximum voltage standing wave ratio (VSWR) of the LNA are $41{\pm}0.5dB$ and 1.3, and the noise figure of the LNA is lower than 0.85dB. The above results are agreed well with the theoretical values of the amplifiers.

• Journal of the Semiconductor & Display Technology
• /
• v.15 no.2
• /
• pp.6-10
• /
• 2016

In RF plasma processing, when the plasma is generated, there is the difference of impedance between RF generator and plasma source. Its difference is normally reduced by using the matcher and the RF power is transferred efficiently from the power generator to the plasma source. The generated plasma has source impedance that it can be changed during processing by pressure, frequency, density and so on. If the range of source impedance excesses the matching range of the matcher, it cannot match all value of the impedance. In this research, we studied the elevation mechanism of the RF power delivery efficiency between RF generator to the plasma source by using the transmission line and impedance tuning of the plasma source. We focus on two plasma sources (capacitive coupled plasma (CCP), inductive coupled plasma (ICP)) which is most widely used in industry recently.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.9
• /
• pp.915-921
• /
• 2013

This work presents a 77 GHz low noise amplifier(LNA) for automotive radar systems using 65 nm RF CMOS process. The LNA is composed of three stage common source amplifiers and includes transmission line matching networks. To reduce the time for three dimensional EM simulation, we optimize the transmission line impedance matching network using a pre-built EM library. The proposed compact simulation technique is confirmed by measurement results. The peak gain of the LNA is 10 dB at 77 GHz and input/output return losses are below -10 dB around the design frequency.

• Korea Journal of Hospital Management
• /
• v.21 no.4
• /
• pp.45-54
• /
• 2016

The purpose of this study is to identify patient and hospital characteristics with pulmonary tuberculosis and to analyze factors which were influencing length of stay and treatment. The Korean National Hospital Discharge In-depth Injury Survey database from 2006 to 2012 was used for analysis. Study subjects were 4,704 patients and analyzed by using frequency, chi-square and logistic regression through using STATA 12.0. To avoid selection bias, we used propensity score matching. Analysis results show that the length of stay and treatment of pulmonary tuberculosis was different between insurance types. Patients characteristic(female, comorbidity, admission by outpatient department, medical insurance type) and hospital characteristic(500-999 beds, over 1000 beds) significantly influence length of stay. Admission by outpatient department and over 1000 beds are significantly influence treatment. Based on these findings, it is necessary to clarify between length of stay and treatment outcome by medical aids beneficiaries and audit hospitals follow discharge guidelines in pulmonary tuberculosis patients.

• Journal of Institute of Control, Robotics and Systems
• /
• v.12 no.9
• /
• pp.876-882
• /
• 2006

This study presents an ultrasonic location awareness system for the ubiquitous computing with absolute position. The flight time of ultrasonic waves is determined by a period detecting technique which is able to extend the sensing range compared with traditional methods. For location awareness, ultrasonic waves are sent successively from each ultrasonic transmitter and synchronized by radio frequency (RF) signal, where the transmitting part is fixed and the receiving part is movable. To expand the recognizing range, cell matching technique and coded ultrasonic technique are introduced. The experimentation for various distances is accomplished to verify the used period detecting technique of U-SAT system. The positioning accuracy by using cell matching is also verified by finding the locations of settled points and the usability of coded ultrasonic technique is verified. As a result, the possibility of ultrasonic location awareness system for the ubiquitous computing can be discussed as a pseudo-satellite system with low cost, a high update rate, and relatively high precision, in the places where CPS is not available.

• Korean Journal of Optics and Photonics
• /
• v.16 no.1
• /
• pp.103-108
• /
• 2005

Second harmonic generation(SHG) by guided phase matching is observed in waveguide structure using the anomalous dispersion of a poled polymer. The second harmonic TM$_{0}$ guided mode could be generated from the fundamental TM$_{0}$ guided mode and then the second harmonic power was higher than any other phase matchable mode because the overlap integral between the fundamental and the second harmonic wave was the largest in the theoretical analysis. Near UV SHG(370 nm) was obtained from the fundamental wavelength of Ti-sapphire laser(740 nm).

• Journal of electromagnetic engineering and science
• /
• v.14 no.3
• /
• pp.299-305
• /
• 2014

A wideband circularly polarized (CP) antenna with a single feed is proposed for use in global navigation satellite systems. Its primary radiation elements are composed of two orthogonal bowtie dipoles, which are equipped with double-printed vacant-quarter rings to allow direct matching of the antenna to a single $50-{\Omega}$ coaxial line and to produce CP radiation. The crossed bowtie dipole is appropriately incorporated with a planar metallic reflector to produce the desired unidirectional radiation pattern as well as to achieve a wideband characteristic in terms of impedance matching and axial ratio (AR) bandwidths. The designed antenna was fabricated and measured. The prototype antenna with an overall 1.2-GHz frequency size of $0.48{\lambda}_o{\times}0.48{\lambda}_o{\times}0.25{\lambda}_o$ produced a measured ${\mid}S_{11}{\mid}$<-10 dB bandwidth of 1.05-1.79 GHz and a measured 3-dB AR bandwidth of 1.12-1.64 GHz. It also showed right-hand CP radiation with a small gain variation (${\pm}0.3dB$) and high radiation efficiency (>93%) over the operational bandwidth.

• Proceedings of the KIPE Conference
• /
• 2014.07a
• /
• pp.47-48
• /
• 2014

기본적으로 전력전송개념에서 최대의 전력이 전달하기 위해서는 전력전송단과 부하단사이의 임피던스를 맞추어 주어야 최대의 전력이 전달된다. 무선전력전송 역시 RF Source와 송수신 코일간의 임피던스를 맞추어야 최대의 전력전달과 효율을 기대할 수 있다. 따라서 송수신 코일과 부하간에 임피던스 매칭은 필수적으로 필요하다. 매칭이 원할하지 않을 경우 RF Source에 반사전력이 반사되어 심각한 손실을 발생할 수 있으며, 수신부의 부하단에 최대로 전력이 전달되지 않으며 전체 시스템 효율이 나빠지게 된다. 임피던스 매칭회로 타입에는 여러가지 타입이 사용되는데 대표적으로 L type, T Type, ${\pi}$ type이 일반적으로 사용된다. 본 연구에서는 L type, T type, ${\pi}$ type 방식을 이용하여 각 타입별 매칭범위와 매칭특성에 대한 기초실험을 수행하였다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07b
• /
• pp.1188-1191
• /
• 2003

In this paper, we focus our attention on the improvement of locking time and jitter parameter and propose the new structure of PLL which combined with the FVC, FOVI Matcher(FVC-Output and VCO-input Matching Circuit), Control Circuit and the conventional charge pump PLL. Using fast operation characteristics of the FVC, the circuit matching FVC-Output and VCO-input (FOVI Matcher) made to synchronize very fast. Fast locking time is usually required for application where the PLL has to settle rapidly if they switch from an idle mode to a normal mode and to track high-frequency data bit rate in data recovery systems. After a fast acqusition is achieved by the using the FVC, the conventional PLL operates for removing the phase error between the reference signal and the feedback signal. Therefore this structure can improve the trade-off between acquisition behavior and locked behavior.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.54 no.5
• /
• pp.798-807
• /
• 2021

The directivity characteristics of acoustic transducers for conventional single-beam echo sounders considerably limit the detection of fish-size information in acoustic field surveys. To overcome this limitation, using the split-aperture technique to estimate the direction of arrival of single-echo signals from individual fish distributed within the sound beam represents the most reliable method for fish-size classification. For this purpose, we design and develop a split-beam data acquisition and processing system to obtain fish-size information in conjunction with a 50-kHz single-beam echo sounder. This split-beam data acquisition and processing system consists of a notebook PC, a field-programmable gate array board, an external single-transmitter module with a matching network, and four-channel receiver modules operating at a frequency of 50-kHz. The functionality of the developed split-beam data processor is tested and evaluated. Acoustic measurements in an experimental water tank showed that the developed data acquisition and processing system can be used as a fish-sizing echo sounder to estimate the size distribution of individual fish, although an external single-transmitter module with a matching network is required.