• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.2
• /
• pp.61-66
• /
• 2011

A new via structure on printed circuit board has been proposed for differential signaling in applications of high-speed interconnection. In new structure, the via is physically separated and then divided into two electrically-isolated sections using mechanical drill routing process. These cutted vias are connected respectively to the traces of the differential pair. New via structure makes possible to rout the differential pair using only one via, while conventional via structure needs two vias for interconnection. Because the spacing even in via region keeps almost constant, new via structure can alleviate an impedance discontinuity and then enhance its signal transmission characteristics such as reflection loss and insertion loss. It is expected that new via structure is effective in differential signaling for high-speed interconnection.

• Korean Journal of Optics and Photonics
• /
• v.17 no.5
• /
• pp.430-436
• /
• 2006

Polarization-independent $Ti:LiNbO_3\;2{\times}2$ optical add/drop multiplexer for the 1550nm wavelength region is fabricated. The device consists of two input waveguides, two polarization beam splitters. two polarization conversion/electrooptic tuning waveguide sections, and two output waveguides. The single mode channel waveguides for both TE and TM polarizations are fabricated on a x-cut $Ti:LiNbO_3$substrate by Ti diffusion. Spectral section is based on phase-matched polarization conversion due to shear strain induced by a thick $SiO_2$ grating overlay film. An applied voltage tunes the device by changing the waveguide birefringence, hence the optical wavelength at which most efficient polarization conversion occurs. Tuning rate of 0.094nm/V with a maximum range of 17nm has been obtained. The nearest side-lobe is about 8.2dB. The FWHM is 3.72nm.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.5D
• /
• pp.869-876
• /
• 2006

In the case of earthenware cultural heritages that are found in the form of fragments, the major task is quick and precise restoration. The existing method, which follows the rule of trial and error, is not only greatly time consuming but also lacked precision. If this job could be done by three dimensional scanning, matching up pieces could be done with remarkable efficiency. In this study, the original earthenware was modeled through three-dimensional pattern scanning and photogrammetry, and each of the fragments were scanned and modeled. In order to obtain images from the photogrammetry, we calibrated and used a Canon EOS 1DS real size camera. We analyzed the relationship among the sections of the formed model, efficiently compounded them, and analyzed the errors through residual and color error map. Also, we built a web-based three-dimensional simulation environment centering around the users, for the virtual museum.

• Journal of the Korean Society of Radiology
• /
• v.14 no.2
• /
• pp.121-127
• /
• 2020

The era of the Fourth Industrial Revolution is increasingly demanding mathematical competencies for virtual reality (VR), artificial intelligence (AI) and the like. In this context, this study intended to identify the basic mathematical competency levels of university freshman students in radiology department and to provide basic data thereon. For this, the diagnostic assessment of basic learning competencies for the domain of mathematics was conducted from June 17, 2019 to June 28, 2019 among 78 freshman students of radiology department at S university and D university. As a result, the university students' overall basic mathematical competency levels were diagnosed to be excellent. However, their levels in the sectors of the geometry and vector and the probability and statistics were diagnosed to be moderate, with the mean scores of 2.61 points and 2.64 points, respectively, which were found to be lower than those of the other sections. As for basic mathematical competency levels according to genders, the levels of male students and female students were diagnosed to be excellent, with the mean scores of 17.48 points and 16.29 points, respectively, showing no statistically significant difference (p>0.05). Given the small number of subjects and regional restriction, there might be some limitations in the generalization of the findings of the present study to all university freshman students and all departments. The above results suggest that it is necessary to implement various programs such as student level-based special lectures for enhancing basic mathematical competencies relating to major in order to improve the basic mathematical competencies of freshman students in radiology department, and that it is necessary to increase the students' mathematical competencies by offering major math courses in the curriculum and applying teaching-learning methods matching students' levels.

• Journal of Gastric Cancer
• /
• v.12 no.2
• /
• pp.113-119
• /
• 2012

Purpose: The aim of this study is to compare the characteristics of tumor and prognosis, depending on the status of resection margin involvement, on the frozen section diagnosis in gastric cancer. Materials and Methods: This study was conducted retrospectively, in 83 margin-positive patients on the frozen section diagnosis, who underwent gastrectomy from July 1995 to September 2006. The control group was selected by matching the age, gender, TNM stage and status of adjuvant chemoradiotherapy, among those who had shown clear resection margins. The characteristics of tumor and patient survival are investigated, and they were analyzed between the two groups. Results: The tumor size was significantly larger in the study group than that of the control group (P=0.037). There was significant difference between the two groups in location of the tumors (P=0.003). Multivariate analysis indicated that only the location and Lauren's classification are independent factors, which affected the resection margin involvement. Median survival was $41.0{\pm}11.5$ months in the study group and $93.0{\pm}30.3$ months in the control group (P=0.049). In the survival analysis, it was investigated that TNM stage and the resection margin involvement of the frozen section diagnosis were the critical variables. Conclusions: When the tumor is located at the middle or the upper third, or the Lauren's indeterminate type, they are highly likely to show the resection margin involvement on the frozen section diagnosis, and it can, therefore, have negative effects on the prognosis. It is considered as good to perform more extensive resection as possible, during the initial resection.

• Journal of Korean Society of Transportation
• /
• v.23 no.2
• /
• pp.107-116
• /
• 2005

The information on travel time in providing the information of traffic to drivers is one of the most important data to control a traffic congestion efficiently. Especially, this information is the major element of route choice of drivers, and based on the premise that it has the high degree of confidence in real situation. This study developed a vehicle arrival time prediction algorithm called as "VAT-DV" for 6 corridors in total 6.1Km of "Nam-san area trffic information system" in order to give an information of congestion to drivers using VMS, ARS, and WEB. The spatial scope of this study is 2.5km~3km sections of each corridor, but there are various situations of traffic flow in a short period because they have signalized intersections in a departure point and an arrival point of each corridor, so they have almost characteristics of interrupted and uninterrupted traffic flow. The algorithm uses the information on a demand volume and a queue length. The demand volume is estimated from density of each points based on the Greenburg model, and the queue length is from the density and speed of each point. In order to settle the variation of the unit time, the result of this algorithm is strategically regulated by importing the AVI(Automatic Vehicle Identification), one of the number plate matching methods. In this study, the AVI travel time information is composed by Hybrid Model in order to use it as the basic parameter to make one travel time in a day using ILD to classify the characteristics of the traffic flow along the queue length. According to the result of this study, in congestion situation, this algorithm has about more than 84% degree of accuracy. Specially, the result of providing the information of "Nam-san area traffic information system" shows that 72.6% of drivers are available.

• Journal of Aerospace System Engineering
• /
• v.15 no.3
• /
• pp.71-78
• /
• 2021

Since most functions of modern aircraft are controlled by software, software errors are directly related to aircraft safety. The criterion in Chapter 15 of the MIL-HDBK-516C addresses safe development and verification of military aircraft software. As the U.S. Air Force repeatedly experienced non-compliance with Chapter 15 criterion of the MIL-HDBK-516C, it published an Airworthiness Circular (AC-17-01) as a guide to meeting the criterion. In this paper, Chapter 15 of MIL-HDBK-516C, AC-17-01 and the SW Qualification Guideline (DO-178C) as applied by the Federal Aviation Administration are compared and analyzed. For the analysis, a matching ratio formula between the MIL-HDBK-516C criteria specified in AC-17-01 and the DO-178C specified in MIL-HDBK-516C criteria is defined. The sections that satisfy MIL-HDBK-516C criterion are derived when AC-17-01 or DO-178C matches. Based on the analysis results, the aircraft software development process is established and examples of application of Chapter 15 of MIL-HDBK-516C are addressed.

• Journal of the Korean Institute of Traditional Landscape Architecture
• /
• v.37 no.3
• /
• pp.134-147
• /
• 2019

The purpose of this study was to analyze the functional unit system of NCS landscape field for correction and supplementation of NCS landscape field and the contents of the four-year college landscape course subject. First, 24 unconsolidated four-year universities were selected, and FGI was conducted and verified for 816 courses in 24 universities. The results of the study are summarized as follows, with three sections three, nine divisions and 65 sub-category. First, landscape design subjects accounted for 40.0% of the subjects organized by four-year universities. In addition, the ratio of 12.9% for ecological landscape, 11.3% for landscape construction, 10.2% for others, 10.0% for landscape information, 6.6% for landscape culture and 3.7% for landscape management was surveyed. Balanced and efficient modification and reinforcement of NCS is required in the future. Second, 10(18.9%) units with matching NCS performance criteria and educational objectives were found to be capable of different units(18.9%), 15(28.3%), and 37subjects with inconsistent NCS unit capability (56.9%). Third, looking at the criteria for the reference of each unit of capability presented by the NCS, it is deemed that one unit of capability should be organized separately to improve the practical ability, since it includes the contents of basic knowledge learning. Fourth, the objectives pursued on the basis of the contents of the NCS capability unit and four-year college curriculum were developed by focusing on the development of unit capabilities in the field of landscape construction and landscape management compared to the field of landscape design. It has been shown that a balance is needed for future development. This study is intended to put forward further research that re-examine specific curriculum assessment criteria that have not been classified in the course of classifications based on the curriculum handbook, which excludes interferences from each school.