• 보건의료생명과학 논문지
• /
• 제9권2호
• /
• pp.345-354
• /
• 2021

본 연구는 건강한 대학생을 대상으로 가상현실과 인지압박 과제를 통해 스트레스를 유발 후 magnetic pellets 이압자극 시 스트레스 감소에 어떠한 영향을 미치는지 알아보고자 하였다. 대조군(n=6)은 이압자극 적용군(sham), 실험군(n=8)은 magnetic pellets 이압자극 적용군으로 하였다. 그 결과, 각 측정항목(시각 아날로그척도, 뇌파, 심박변이 변화)에서 대조군에 비해 실험군이 각 기준값(T_O)으로 회귀하는데 더 효과적임을 확인할 수 있었다. 따라서 magnetic pellets 이압자극은 여러 스트레스 상황에서 쉽고 간편하게 적용할 수 있는 중재방안이라고 생각된다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 하계학술대회 논문집
• /
• pp.349-350
• /
• 2009

Superconducting magnetic bearing and rotating system were developed by utilizing the high magnetization YBaCuO superconductor. The pellets prepared by quasi-melt process had a high magnetic levitation force and a high magnetic attractive force. The shaft also could be moves its position and orientation of the rotating axis freely. Is is essential to enhance the materials properties and to improve the system design for the application of the system to industrial purpose.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 C
• /
• pp.1777-1779
• /
• 2001

In this experiment, an attempt to use the sludge pellets as catalyst for NO removal from simulated gas is experimentally investigated by using cylinder type reactor. An experimental investigation has been conducted for NO concentration of 50[ppm], 100[ppm], 200[ppm] balanced with air. a gas flow rate of 5[1/min]. Cylinder type reactor is at upstream of system for corona discharge and packed bed type reactor filled with sludge pellets ate put at downstream of Cylinder type reactor for catalystic effect. And AC voltage to discharge the gases was supplied. In the result, NO removal with magnetic field is higher than that without magnetic field, when packed-bed reactor with sludge pellet is installed at downstream of cylinder reactor NO, $NO_2$ removal rate increased and $O_3$ is not generated.

• Korean Chemical Engineering Research
• /
• 제43권1호
• /
• pp.71-75
• /
• 2005

초거대 자기 저항 물질인 $La_{0.5}Ca_{0.5}MnO_3$의 분말과 pellet을 졸-겔 법으로 제조하였다. 열처리 온도를 변화시켜 얻은 시료에 대해 FT-IR과 CP/MAS $^{13}C$ solid state NMR spectroscopy 그리고 XRD 등을 이용해 구조변화를 관찰하였다. 양이온 조성 비율을 알아보기 위해 ICP-AES를 이용하였으며, 입자크기와 균일도를 FE-SEM/EDS로, 미세구조와 격자 패턴은 TEM으로 관찰하였다. VSM을 이용하여 자기적 특성을 살펴보았으며 큐리온도($T_c$)는 236 K에서 측정되었다.

• 한국자기학회지
• /
• 제3권1호
• /
• pp.34-40
• /
• 1993

급속냉각기술로 제조된 $Nd_{10.5}Fe_{79}Co_{2}Zr_{1.5}B_{7}$ 합금분말을 사용하여 사출성형용 자성 펠렛을 제조하였다. 입도분포가 다른 두 종류의 분말($38~75\;\mu\textrm{m}$ 및 $75~50\;\mu\textrm{m}$)을 사용하여 열가소성(Nylon 6) 펠렛을 제조한 후 자성분말의 임계분율(critical volume fraction) 을 결정하고 수지자석의 성형밀도에 따른 자기특성을 고찰하였다. Nylon 6 수지를 사용한 Nd-Fe-Co-Zr-B계 펠렛은 분말입도가 $38~75\;\mu\textrm{m}$인 경우 임계 부피분율은 70%로 나타났고, 그때의 성형밀도는 이론밀도 의 90%를 상회 했으나 $75~150\;\mu\textrm{m}$ 분말의 경우는 같은 분율에서 이론밀도의 87% 수준에 머물렀다. 최적의 자기특성은 분말에 윤활제로서 silicone oil만을 0.5wt.% 첨가한 경우이며 이때의 자기특성으로, $(BH)_{max}=5.2\;MGOe,\;B_{r}=5.1\;kG$ 그리고 $_{i}H_{c}=8.8\;kOe$의 높은 수준을 보였다. Nylon 6수지자석의 성형밀도를 예측할 수 있는 경험식으로서, ${\rho}(g/cm^{3})=1.1+K.V_{s}$을 얻었으며 K(5.3~5.6)는 자성분말 입도에 따른 기울기 상수이고 $V_{s}$는 분말의 부피분율이다.

• 한국초전도ㆍ저온공학회논문지
• /
• 제18권1호
• /
• pp.14-18
• /
• 2016

Organic compounds have a problem that the separation of structural isomer in the preparation process requires high energy consumption. This study proposes a new separation method of structural isomer using Magneto- Archimedes method. Firstly, the levitation height of 1, 6-DDA and 1, 10-DDA was respectively calculated by simulation of the forces acting on the particles under magnetic field, and it was indicated that they could be separated by the difference of levitation height. To confirm the phenomenon experimentally, white powders of 1, 6-DDA and 1, 10-DDA were formed into pellets, and were soaked in manganese chloride solution. Then the solution was put on the center of the cryostat of HTS bulk magnet (maximum magnetic flux density is 3T). As a result, it was confirmed that the separation of structural isomer by difference of levitation height could be possible.

• 한국초전도ㆍ저온공학회논문지
• /
• 제16권2호
• /
• pp.36-41
• /
• 2014

Temperature dependence of magnetic moment (m-T) and the magnetization (M-H) at 5 K and 20 K of the in situ processed $MgB_2$ bulk pellets with/without carbon (C) doping were examined. The superconducting critical temperature ($T_c$), the superconducting transition width (${\delta}T$) and the critical current density ($J_c$) were estimated for ten test samples taken from the $MgB_2$ bulk pellets. The reliable m-T characteristics associated with the uniform $MgB_2$ formation were obtained for both $MgB_2$ pellets. The $T_cs$ and ${\delta}Ts$ of all test samples of the undoped $MgB_2$ were the same each other as 37.5 K and 1.5 K, respectively. The $T_cs$ and ${\delta}Ts$ of the C-doped $MgB_2$ were 36.5 K and 2.5 K, respectively. Unlike the m-T characteristics, there existed the difference among the M-H curves of the test samples, which might be caused by the microstructure variation. In spite of the slight $T_c$ decrease, the C doping was effective in enhancing the $J_c$ at 5 K.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2003년도 춘계학술발표강연 및 논문개요집
• /
• pp.239-239
• /
• 2003

As a result of the recent miniaturization and enhancement in the performance of thin film inductors and thin film transformers, there are increased demands for the thin films with a high magnetic permeability in the high frequency range, a high saturation magnetization, a high electrical resistivity, and a low coercive force. In order to improve high frequency properties, we will investigate anisotropy field by shape and size of pattern. The Fe-Al-O thin films of 16mm diameter and 1$\mu\textrm{m}$ thickness were deposited on Si wafer, using RE magnetron reactive sputtering technique with the mixture of argon and oxygen gases. The fabricating conditions are obtained in the working partial pressure of 2m Torr, O$_2$ partial Pressure of 5%, Input power of 400w, and Al pellets on an Fe disk with purity of 99.9%. For continuous thin film is the 4Ms of 19.4kG, H$\sub$c/ of 0.6Oe, H$\sub$k/ of 6.0Oe and effective permeability of 2500 up to 100MHz. In this work, we expect to enhanced effect of magnetic anisotropy on patterned of Fe-Al-O thin films.

• Bulletin of the Korean Chemical Society
• /
• 제15권6호
• /
• pp.465-468
• /
• 1994

The charge transfer compounds $(TTF)_4FeCl_3{\cdot}CH_3OH,\;(TTF)_4SbCl_4\;and\;(TTF)_5(SbBr_4)_2{\cdot}CH_3COCH_3$ were prepared from reactions of the TTF (tetrathiafulvalene) and metal halides. The compounds were characterized by spectroscopic (UV,IR, EPR and XPS) methods, magnetic susceptibility and electrical conductivity measurements. The d.c electrical conductivities of the pressed pellets are in the order of $10^{-1}-10^{-3} Scm^{-1}$, which lies in the range of semiconductor region at room temperature. It means that the partially ionized TTF has stacked in low-dimensional chain in each compound. Spectroscopic properties also indicate that TTF molecules are partially ionized and charge transfer has occurred from (TTF)n to Fe(III) center in $(TTF)_4FeCl_3{\cdot}CH_3OH$ whereas to the $-SbX_4^-$ entity in $(TTF)_4SbCl_4\;and\;(TTF)_5(SbBr_4)_2{\cdot}CH_3COCH_3$. The EPR g values are consistent with TTF radical formation and EPR linewidths suggest the delocalization of unpaired electrons along TTF stacks. A signal arised from metal (Fe and Sb) ions were not detected in EPR spectra, indicating that metal ion is in the diamagnetic state in each compound. The diamagnetic state was also examined by the magnetic susceptibility measurement. The magnetic properties reveal the significant interaction between the $TTF^+$ radical cations in the stacks. The oxidation state of metal ions was also investigated by XPS spectra.

• 대한금속재료학회지
• /
• 제49권1호
• /
• pp.52-57
• /
• 2011

Nickel ferrite ($NiFe_2O_4$) powder was prepared through the ceramic route by calcination of a stoichiometric mixture of nickel oxide (NiO) and iron oxide ($Fe_2O_3$). The pressed pellets of $NiFe_2O_4$ were isothermally reduced in pure hydrogen at 800, 900, 1000 and $1100^{\circ}C$. Based on thermogravimetric analysis, the reduction behavior and the kinetic reaction mechanisms of the synthesized ferrite were studied. The initial ferrite powder and various reduction products were characterized by XRD, SEM, reflected light microscope and VSM to reveal the effect of hydrogen reduction on the composition, microstructure, magnetic properties and reaction kinetics of the produced Fe-Ni alloy. Complete reduction of the $NiFe_2O_4$ was achieved with synthesis of homogeneous nanocrystalline Fe-Ni alloys. Arrhenius equation with the approved mathematical formulations for a gas-solid reaction was applied for calculating the activation energy ($E_a$) values and detecting the controlling reaction mechanism.