• Advances in concrete construction
• /
• v.10 no.2
• /
• pp.171-183
• /
• 2020

The main objective of this study is the assessment of the ability of limestone mortars to resist to different chemical attacks. The ability of polypropylene (PP) fibres waste used as reinforcement of these concrete materials to enhance their durability is also studied. Crushed sand 0/2 mm which is a fine limestone residue obtained by the crushing of natural rocks in aggregates industry is used for the fabrication of the mortar. The fibres used, which are obtained from the waste of domestic plastic sweeps' fabrication, have a length of 20 mm and a diameter ranging between 0.38 and 0.51 mm. Two weight fibres contents are used, 0.5 and 1%. The durability tests carried out in this investigation included the water absorption by capillarity, the mass variation, the flexural and the compressive strengths of the mortar specimens immersed for 366 days in 5% sodium chloride, 5% magnesium sulphate and 5% sulphuric acid solutions. A mineralogical analysis by X-ray diffraction (XRD) and a visual inspection are used for a better examination of the quality of tested mortars and for better interpretation of their behaviour in different solutions. The results indicate that the reinforcement of limestone mortar by PP fibres waste is an excellent solution to improve its chemical resistance and durability. Moreover, the presence of PP fibres waste does not affect significantly the water absorption by capillarity of mortar nether its mass variation, when exposed to chloride and sulphate solutions. While in sulphuric acid, the mass loss is higher with the presence of PP fibres waste, especially after an exposure of 180 days. The results reveal that these fibres have a considerable effect of the flexural and the compressive behaviour of mortar especially in acid solution, where a reduction of strength loss is observed. The mineralogical analysis confirms the good behaviour of mortar immersed in sulphate and chloride solutions; and shows that more gypsum is formed in mortar exposed to acid environment causing its rapid degradation. The visual observation reveals that only samples exposed to acid attack during 366 days have showed a surface damage extending over a depth of approximately 300 ㎛.

• Resources Recycling
• /
• v.29 no.4
• /
• pp.51-57
• /
• 2020

Separation of Co and Ni over Mg from the sulfuric acid solutions using Cyanex272, PC88A and Versatic acid 10 as an extractant was carried out. From the comparative studies about the extraction behavior of Co, Ni and Mg, Versatic acid 10 was superior to Cyanex272 and PC88A for the selective extraction of cobalt and nickel from the mixed solutions. About 98% of Ni and Co were extracted at equilibrium pH 7.0 and less than 5% of Mg was co-extracted by Versatic acid 10. McCabe-Thiele diagram indicated two stages requirement for Co and Ni extraction by 10% Versatic acid 10 at pH 7.0 and phase ratio (A/O) of 2.0. The loaded Co and Ni in organic phase was stripped effectively the sulfuric acid concentration above 70 g/L. 99.78% of cobalt and 98.42% of nickel were stripped.

• Journal of Environmental Health Sciences
• /
• v.14 no.1
• /
• pp.33-38
• /
• 1988

Natural mineral water is generally quite different from ordinary drinking water due to its original nature and various properties. The complexity of natural mineral water requires, therefore, not only to identify its nature and proper characteristics, but also to classify them by a reasonable scientific basis of comparison. The study was concentrated on a possible classification technique to natural mineral waters by their constitutions and physico-ehemical properties. The classification was carried out by the computation of such numerical parameters as ionic equivalent percentage, electrolytic conductance or mobility, ionic molecular weight, molecular concentration, equivalent conductivity and degree of ionization in consideration of the determinative criteria as follows -particular single element or molecule -major components of natural waters as bicarbonate, sulphate, chloride,caloride, calcium, magnesium, and sodium -moleculat concentration related to blood osmotic pressure -water temperature at emergence from spring -contents of free carbon dioxide (CO2) -pH value of water -total dissolved solids or salts (NaCl) The results obtained proved out to be clearly distinguhhable from ordinary drinking water as far as concern natural mineral water as an example on the subject -simple water -bicarbonate-predominating water -cold spring -carbonated-non gaseous water -weak alkaline water -non saline water Putting these various results together, the sample turned out to be a kind of natural mineral water that can be used as a drinking water if microbiologically safe.

• Membrane and Water Treatment
• /
• v.14 no.2
• /
• pp.85-93
• /
• 2023

Membrane separation is widely used for several applications such as water treatment, membrane reactors and climate change. Cross-linked organic-inorganic hybrid polyvinylidene fluoride (PVDF) / Tetraethyl orthosilicate (TEOS) was adopted for the preparation of optimized hollow membrane (HFM) for membrane distillation or other low pressure separators for mechanical properties and permeability under varying pretreatment schemes. HFMs were prepared on semi-pilot membrane fabrication system. Novel adopted post-treatment schemes involved soaking in glycerol, magnesium sulphate (MgSO₄), sodium hypochlorite (NaOCl), and isopropanol for different durations. All fibers were characterized for morphology using a scanning electron microscope (SEM), surface roughness using atomic force microscope (AFM), elemental composition by examining Energy Dispersive Spectroscopy (EDS), water contact angle (CA°) and porosity. The performance of the fibers was evaluated for pure water permeation flux (PWF). Post-treatment with MgSO₄ gave the highest both tensile modulus and flux. Assessment of properties and performance revealed comparable results with other organic-inorganic separators, HF or flat. In spite of few reported data on post treatment using MgSO₄ in presence of TEOS, this proves the potential of low cost treatment without negative impact on other membrane properties. The flux is also comparable with hypochlorite which manifests substantial precaution requirements in actual industrial use.The relatively high values of flux/bar for sample treated with TEOS, post treated with MgSO₄ and hypochlorite are 88 and 82 LMH/bar respectively.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.9
• /
• pp.590-596
• /
• 2012

Enhanced coagulation is best available technologies to treat NOM in water to produce clean drinking water. In this research, the comparison experiments between conventional coagulation (CC) and enhanced coagulation (EC) using 4 type coagulants i.e., ferric chloride, aluminium sulphate (alum), poly aluminium sulphate organic magnesium (PSOM) and poly aluminium chloride (PACl) were performed in terms of surrogate parameters such as dissolved organic carbon (DOC), trihalomethane formation potential (THMFP), haloacetic acid formation potential (HAAFP) and zeta potential variation in order to find out the most effective coagulant and conditions to fit Nakdong River water. When applied to EC process, the turbidity removal efficiency did not increased gradually compared to the CC process when adding coagulants. Furthermore, the removal efficiency of turbidity became decreased much more as coagulants were added increasingly whereas the removal efficiency of DOC, THMFP and HAAFP became increased by 13~18%, 9~18% and 9~18% respectively compared to the CC process. The characteristics of turbidity removal showed relatively high removal efficiency considering the pH variation in entire pH range when using $FeCl_3$ and PACl. Additionally, in case of alum and PSOM steady removal efficiency was shown between pH 5 and pH 8. In terms of DOC surrogate the coagulants including 4 type coagulants indicated high removal efficiency between pH 5 and pH 7. The removal efficiency of dissolved organic matter (DOM) in EC between less than 1 kDa and more than 10 kDa augmented by 11~21% and 16% respectively compared to the CC process. The removal efficiency of hydrophobic and hydrophilic organic matter proved to be increased by 27~38% and 11~15% respectively. In conclusion, the most effective coagulant relating to EC for Nakdong River water was proved to be $FeCl_3$ followed by PSOM, PAC and alum in order.