• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.11
• /
• pp.50-58
• /
• 2000

A Mach-Zehnder type $Ti:LiNbO_3$ optical modulator with a grooved $SiO_2$ buffer layer, was evaluated in terms of an electrode structure. The finite element method was performed to find out the optinum design parameters of electrodes. characteristic impedance ($Z_o$), MW effective index ($N_{eff}$) and attenuation constant ($a_o$)of fabricated traveling-wave electrodes were measured and compared with those obtained by the simulation expectation. For an optical modulator with 11${\mu}m$thick electrodes and a grooved $SiO_2$ buffer layer, the 3dB bandwidth based on the RF measurement results turned out to be 18GHz.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.4
• /
• pp.20-25
• /
• 2010

An integrated Mach-Zehnder interferometric sensor operating at 632.8 nm was designed and fabricated by the technology of planar rib waveguides. Rib waveguide based on silica system ($SiO_2-SiO_xN_y-SiO_2$) was geometrically designed to have single mode operation and high sensitivity. It was structured by semiconductor fabrication processes such as thin film deposition, photolithography, and RIE (Reactive Ion Etching). With the power observation, propagation loss measurement by cut-back method showed about 4.82 dB/cm for rib waveguides. Additionally the chromium mask process for an etch stop was employed to solve the core damaging problem in patterning the sensing zone on the chip. Refractive index measurement of water/ethanol mixture with this device finally showed a sensitivity of about $\pi$/($4.04{\times}10^{-3}$).

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.9 no.5
• /
• pp.598-605
• /
• 1985

Laminar natural convection heat transfer past an outer rectangular corner was experimentally investigated by using Mach-Zehnder interferometer. The present geometry represents the case when the plume from a vertical flat plate and that from a horizontal one merge into a single plume. the temperature distribution and the local heat flux were measured in the range of Grashof number 8 * 10$^{4}$$r_{LH}$ <1.25 * 10$^{6}$ . The effect of the geometric aspect ratio was also considered. Correlation for the average Nusselt number vs. Grashof number was obtained by using a newly determined characteristic length. To determine the interaction of the plumes, the present results were compared with the similarity solutions available from the isolated vertical and isolated horizontal flat plates.

• Korean Journal of Optics and Photonics
• /
• v.15 no.5
• /
• pp.475-482
• /
• 2004

We have fabricated a LiNbO$_3$ travelling-wave optical modulator. The travelling-wave modulator consisted of M-Z(Mach-Zehnder) interferometer and CPW(Coplanar Waveguide) travelling-wave electrodes. Design of CPW electrodes were performed by SOR(Successive Over Relaxation) to obtain the conditions of Microwave effective index and impedance matching. The fabricated modulator had -3.2 dB insertion loss, and S$_{11}$ below -15 dB up to 12 GHz, S$_{21}$ better than -3 dB upto 7 GHz. It turned out that the optical response showed the 3 dB bandwidth of above 12 GHz.

• Journal of Sensor Science and Technology
• /
• v.32 no.4
• /
• pp.223-231
• /
• 2023

An integrated-optical biochemical sensor structure that can perform homogeneous and surface sensing using a 2×2 balanced-bridge Mach-Zehnder interference structure based on the optimized SOI slot optical waveguide was described, and its performance and characteristics were evaluated. Equations for the two output optical powers were derived and examined using the transfer matrices of a 3-dB coupler and phase shifter (channel waveguide). The length of the 3-dB coupler was determined such that the two output optical powers were same using these formulas. In homogeneous sensing, the effect of the refractive index of an analyte in the range of 1.33-1.36 on the two output optical power distributions was numerically derived, and the sensitivity was calculated based on each output and the difference between the two outputs, the former and the latter being 7.5796-19.0305 [au/RIU] and 15.2601-38.1351 [au/RIU], respectively. In the case of surface sensing, the sensitivity range of the refractive index of 1.337 based on each of the two outputs was calculated as -2.2490--3.5854 [au/RIU] and 1.2194-3.8012 [au/RIU], and the sensitivity range of 4.8048-7.0694 [au/RIU] was confirmed based on the difference between the two outputs.

• ETRI Journal
• /
• v.26 no.4
• /
• pp.344-350
• /
• 2004

We propose a filter-free wavelength conversion using a Mach-Zehnder interferometer with monolithically integrated $2{\times}2$ multimode interference semiconductor optical amplifiers (MMI-SOAs). The device has been optimized by considering a non-homogeneous carrier distribution due to the self-imaging properties of the MMI-SOA. Static measurements show an extinction ratio of up to 18 dB and an input signal rejection ratio of up to 20 dB.

• Journal of IKEEE
• /
• v.20 no.4
• /
• pp.385-391
• /
• 2016

We demonstrated experimentally a variable optical frequency comb source using a cascaded dual parallel Mach Zehnder modulator (DPMZM) and a phase modulator (PM). With this simple configuration and applying low drive voltages, we generated variable comb source composed of spectral lines 3, 5, 7, 9 and 11 with 10-GHz frequency spacing, also generated 2 and 3 spectral lines with 20 GHz frequency spacing. The generated comb source maintains high spectral coherence across the entire bandwidth with good spectral flatness (within 1-dB for 2, 3, 5, 7 comb lines, within 2-dB for 9-comb lines and within 3-dB for 11 comb lines). The flat and variable comb source is mainly achieved by manipulating 6 operating parameters of DPMZM, setting RF amplifier gain, connected at phase modulator and phase shifters. Hence the method is simple and offers great flexibility in achieving flat and variable comb spectrum, which is experimentally demonstrated. This brings advantages of power efficiency due to low driving voltages, simplicity and cost effectiveness to the system.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.5
• /
• pp.119-123
• /
• 2015

This paper presents a theoretical study of transmission performance for an optical NRZ (nonreturn-to-zero) transmitter employed a Mach-Zehnder modulator. Especially, we have investigated the effects of the ${\alpha}$-parameters that represents the chirps and the driving voltage ratios(=driving voltage/switching voltage) of Mach-Zehnder modulators for transmitting 25Gbps optical NRZ signals at a wavelength of 1550nm without any dispersion compensation methods over single mode fiber. By optimizing the negative values of ${\alpha}$-parameters for the dispersion tolerance with the change of driving voltage ratios, it has been tested whether the transmission performance has improved. We have verified the improvement by the BERs and the optical eye diagrams.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.3
• /
• pp.10-18
• /
• 2003

In this paper, we propose an optical encryption system based on the encryption of information using the phase component of a wavefront and orthogonal polarization in a Mach-Zehnder interferometer. Since the incoherence of the two perpendicularly polarized lights removes interference component, the decrypted image is stable. In encryption process, the original image is converted into an image having random polarization state by the relative phase difference of horizontal polarization and vertical polarization, so we cannot obtain the original information from the random polarization distribution. To decrypt an Image, the random polarization distribution of encrypted image is divided into two orthogonal components, then key image must be placed on vertical path of Mach-Zehnder interferometer. The decrypted image is obtained In the form of intensity by use of an analyzer.

• Journal of Advanced Marine Engineering and Technology
• /
• v.21 no.4
• /
• pp.437-442
• /
• 1997

An experimental study was carried out in a channel cavity with square heat surface by visual¬ization equipment with Mach - Zehnder interferometer and laser apparatus. The image processing system consists of one commercial image board slit into a personal computer and 2-dimensional sheet light by Argon-Ion Laser with cylindrical lens and flow picture recording system. Instant simultaneous velocity vectors at whole field were measured by 2-D PIV system which adopted two¬frame grey-level cross correlation algorithm. Heat source was uniform heat flux(o.4W/cm$^2$, , O.8W/cm$^2$, 1.2W/cm$^2$). Obtained result showed various flow patterns such as kinetic energy distribution. Severe unsteady flow fluctuation within the cavity are remarkable and sheared mixing layer phenomena are also found at the region where inlet flow is collided with the counter-clockwise rotating main primary vortex. Photographs of Mach ~ Zehnder are also compared in terms of constant heat flux.