• Applied Chemistry for Engineering
• /
• v.8 no.6
• /
• pp.967-972
• /
• 1997

Recovery of aromatics in extract phase which was obtained by batch equilibrium extraction between light cycle oil(LCO) and dimethylsulfoxide(DMSO) solution as solvent was investigated by re-extraction. To select the most suitable re-extraction solvent for recovery of aromatics in extract phase, distribution equilibrium was measured between extract phase and solvents. The solvents used were benzene(B), toluene(T), m-Xylene(mX), n-hexane(Hx) and n-hexane(Hx) and n-Octane(Ot). From the distribution coefficients and yields of aromatics, Hx seemed to be the most suitable. Furthermore, effects of operation parameters for re-extraction of aromatics in the extract phase were studied by batch equilibrium re-extracion with Hx as solvent. Yields of aromatics were found to increase with increasing solvent/feed (extract phase) mass ratio(S/F), while distribution coefficients of aromatics were fixed irrespective of S/F used. Operating temperature did not affect distribution coefficients and yields of aromatics. Distibution coefficients and yields of naphthalene group(carbon numer : 10~12) increased with increasing cabon number. Mass transfer rates of aromatics were also measured with a batch stirred vessel.

• Development and Reproduction
• /
• v.25 no.1
• /
• pp.55-57
• /
• 2021

Samples were collected from the subtidal region of Jumunjin on the eastern coast of Korea in July 2020. A total of 338 mussels of shell height (SH) 20.8-149.8 mm were used for sex ratio analysis. The sex ratio (F:M) in the same population of mussel Mytilus coruscus was approximately 1:0.7. The sex ratio according to the class of SH was different. The sex reversal pattern of M. coruscus appears to go from male → female → male → female, and as such is determined to be sequential hermaphrodites.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.6
• /
• pp.91-98
• /
• 2013

Magnetic sensor chip for measuring bio-magnetism is implemented in $0.18{\mu}m$ CMOS technology. The magnetic sensor chip consists of a small-sized high inductance coil sensor and an instrumentation amplifier (IA). High inductance coil sensor with suitable sensitivity and bandwidth for measurement of bio-magnetic signal is designed using electromagnetic field simulation. Low gm operational transconductance amplifier (OTA) using transconductance reduction techniques is designed for on-chip solution. Output signal sensitivity of magnetic sensor chip is $3.25fT/{\mu}V$ and reference noise of 21.1fT/${\surd}$Hz. Proposed IA is designed along with band pass filters(BPF) to reduce magnetic signal noise by using current feedback techniques. Proposed IA achieves a common mode rejection ratio of 117.5dB while the input noise referred is kept below $0.87{\mu}V$.

• Journal of Adhesion and Interface
• /
• v.1 no.1
• /
• pp.15-22
• /
• 2000

To prepare acrylic type pressure-sensitive adhesive, quarter polymers were synthesized from butylacrylate (BA), 2-ethylhexylacrylate (2-EHA), methyl methacrylate (MMA), 2-hydroxyethylmethacrylate (2-HEMA). The quarter polymer was identified by FT-IR. Molecular weight was measured by Gel Pearmeation Chromatograhy. Also, viscosity, solid content and peel strength were investigated. The peel strength was $160g_f/25mm$ when the volume ratio of feed monomer to solvent was 1.3:1 and the ratio was relevant to commercial usage. The pot life of adhesive was 30 s at the 50 m/min of heat treatment rate, and it indicated that the minimum drying time was 30 s. Not only weathering resistance keep up peel strength $160{\sim}180g_f/25mm$ after 1000 h, but also no residual remains.

• Korean journal of applied entomology
• /
• v.63 no.1
• /
• pp.33-42
• /
• 2024

The green peach aphid, Myzus persicae is a representative agricultural insect pest that is polyphagous and causes serious damage to tobacco, potatoes, peppers, cabbage, and peaches. In this study, we analyzed the level of development of insecticide resistance to λ-cyhalothrin, imidacloprid, and flupyradifurone and the point mutations (R81T, L1014F, M918L) in 12 field populations of M. persicae. In addition, the expression level of CYP6CY3, a cytochrome P450 gene, was analyzed through qRT-PCR. As a result, λ-cyhalothrin showed high resistance ratio (RR) of > 200 in all 12 populations. Imidacloprid and flupyradifurone showed high RR of >200 in YS, UR, HY, and WJ populations. The R81T was detected in approximately 50%, L1014F in approximately 33.3%, and M918L in 100% of the 12 populations. Additionally, the expression level of subunit CYP6CY3 was highest in imidacloprid-resistant population (YS). These results suggest that M918L point mutation can be used as λ-cyhalothrin-resistance molecular diagnostic and R81T point mutation and the high expression of CYP6CY3 can be used as imidacloprid-resistance molecular diagnostic markers.

• Proceedings of the Korean Magnestics Society Conference
• /
• 1991.05a
• /
• pp.73-74
• /
• 1991

The films with ferromagnetic fine particles dispersed in nonmagnetic matrix, such as $Fe-Al_2O_3$ and Fe-Cu have been studied for use of magnetic recording medium, optically device and sensor. Their magnetic properties depend strongly on structural parameter such as size and volume fraction of ferromagnetic particles. Fe-Cr-Ni alloy sputtered films also have microstructure with ferromagnetic -- b.c.c phase and nonmagnetic f.c.c phase grains. Magnetic properties of these films depend strongly on such a unique structure. These are depend on the ratio in volume of ferromagnetic particles to nonmagnetic ones $V_F/V_N$, the saturation magnetization Ms increased with increase of $V_F/V_N$. The coercivity Hc of the as-deposited films took maximum value of about 200 Oe at adequate $V_F/V_N$ and then Ms and Squareness S were 500 emu/cc and 0.5, respectively.(omitted)

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.4
• /
• pp.121-128
• /
• 1998

In this study, when tension and bending stress act on plate simultaneously, stress intensity factor is analyzed at crack tip with using BEM(Boundary Element Method). In this analysis, stress intensity factors(S.I.F) are defined for variable ligament, aspect and stress ratio($\sigma$T/$\sigma$B). Consequently, predicted that crack grow to depth direction at low aspect and ligament ratio in tension stress and to surface direction in bending stress. Tension and bending stress act on plate same time, effect of tension stress in the first stage and effect of bending stress in the after stage was to observed. The outbreak of secondary crack in backside is under the control of stress amplitude and predict that the point of outbreak is mear backside.

• Journal of the Korean Applied Science and Technology
• /
• v.18 no.4
• /
• pp.316-324
• /
• 2001

To prepare an acrylic type pressure-sensitive adhesive, quarternary polymers were synthesized from butyl acrylate (BA), 2-ethyl hexyl acrylate (2-EHA), methyl methacrylate (MMA), and 2-hydroxy ethyl methacrylate (2-HEMA). The quarternary polymers were identified by FT-IR and Molecular weight was measured by Gel Pearmeation Chromatography. Also, viscosity, solid content and peel strength were examined. The peel strength was 160 $g_{f}/25$ mm when the volume ratio of feed monomer to solvent was 1.3:1, and the ratio was relevant to commercial usage. The pot life of adhesive was 30 sec at the 50 m/min of heat treatment rate at, and it indicated that the minimum drying time was 30 sec. In weathering resistance test, peel strength of $160{\sim}180$ $g_{f}/25$ mm after 1000 h, with no residual remains on the adhesive surface.

• Macromolecular Research
• /
• v.13 no.3
• /
• pp.218-222
• /
• 2005

Transferrin-conjugated liposomes ($T_f$-liposomes) were made and formulated with pCMVluc DNA to form a lipoplex. Among the various formulations studied, the $T_f$-liposome: pCMVluc DNA complex at a ratio of 5: 1 (wt/wt) showed the highest transfection efficiency, which was twice that of $Lipofectin^{TM}$ on HeLa cells. The maxi-mum tolerated dose (MTD) of this lipoplex formulation from a single intravenous injection was over 10 mg/kg in healthy ICR mice. The RT-PCR results showed that the highest level of luciferase mRNA was detected in the lungs, followed by the liver, spleen, heart and kidneys, after an intravenous injection into mice. Two weeks after the injection, the levels of luciferase mRNA decreased gradually in the liver, spleen, heart, and kidney, but not in the lungs. The micro-array study showed that the cancer-related genes, including the bcl 6 gene, were highly up-regulated by the treatment with $T_f$-liposome/ pCMVluc DNA complex on HeLa cells, indicating that there were possible interactions between the host chromosomal DNA and the $T_f$-liposome within the cells. The results obtained from this study are expected to be useful for designing a safe and efficient gene delivery system using transferrin-conjugated liposomes.

• Structural Engineering and Mechanics
• /
• v.15 no.1
• /
• pp.21-38
• /
• 2003

The formulation of a new bridge-vehicle system using shell with eccentric beam elements has been introduced in a companion paper (Part I). The new system takes into account of the contribution of the twisting and pitching modes of vehicles to the bridge responses. It can also be used to study the dynamic transverse load distribution of a bridge. This paper presents a parametric study on the impact induced by one vehicle or multi-vehicle running across a bridge using the proposed model. Several parameters were considered as variables including the mass ratio, the speed parameter, the frequency ratio and the axle spacing parameter to investigate their effects on the impact factor. A total number of 189 cases were carried out in this parametric study. Within the realistic range of vehicle considered, the maximum impact factors could be 2.24, 1.78 and 1.49 for bridges with spans 10 m, 20 m and 30 m respectively.