• 소음진동
• /
• 제2권2호
• /
• pp.125-134
• /
• 1992

In this study, ti identify the dynamic characteristics of automobile steering system which consists of many components and joints, each component combined structure was analyzed using commercial structural package, ANSYS. And, the finite element method for each component and modeling method of several joints universal joint, bolt joint, bearing, etc. were studied. On the other hand, the experimental modal analysis was performed to compare with the results of the finite element analysis and joint modeling. The result shows very close agreement between two analysis. Also, it was found that the steeing column used in this experiment does not effect the low frequency mode of entire system. In addition, we found that constraint equations need to be considered in modeling universal joint. Since the stiffness effect of Urethane around wheel could be ignored, it can be modeled only with mass effect. In the end, it was found that dynamic characteristics of the entire steerintg system depends mainly upon the wheel characteristics.

• 한국막학회:학술대회논문집
• /
• 한국막학회 1999년도 심포지움시리즈 Jan-99 막분리공정을 이용한 재활용 기술
• /
• pp.1-12
• /
• 1999

In Kimchi (a salt-pickled and fermented food) manufacturing industry, the process of brining and rinsing the raw vegetable produces a vast amount of wastewater of high salinity. Instead of expensive and low-efficient conventional treatment system, brining wastewater reuse system was developed using hybrid chemical precipitation / microfiltration. In the microfiltration of chemically treated brining wastewater, comparison of flux, backwashing frequency and energy consumption was made between dead-end and crossflow filtration mode. The optimum location of neutralization step in this system was also discussed in connection with the micro filtration performance. The quality test of Kimchi prepared by the reuse system conformed the new approach was successful in terms of water/raw material (salt) savings and wastewater reduction.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 C
• /
• pp.1646-1648
• /
• 1994

In the system of underground transmission line, the rate of electrical failure is very low, but, if once occuring, the failure evolves into a paralysis of the system, the time of restoration is very long, the damage from stopping of power supply is very serious, and the cost of restoration is very great. Because of these problems, you must try to protect the system and equipment from every electrical failure by contributing much carefulness to the design and operation of the underground system. This study summerizes the results of simmulation tests about the effect of installing this protection device on the insulated joint box and the terminal end box.

• 전기학회논문지
• /
• 제60권2호
• /
• pp.435-440
• /
• 2011

A touchless user interface system is proposed for real-time mobile devices in this work. The proposed system first recognizes the position of pattern to interact various applications based on the scene taken from mobile camera. Then, the proposed system traces the route of the pattern, which estimates the motion of pattern based on the mean-shift method. Based on this information, we control menu and keypad for the various applications. Differ from other user interface systems, the proposed system provides the new experience to even for the user of low-end mobile without additional hardware. Simulation results demonstrate that the proposed algorithm provides better interaction performances than the conventional method, while achieving real-time user interacting for mobile devices.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2004년도 춘계학술대회 논문집
• /
• pp.412-418
• /
• 2004

In this paper, a new distributed intelligent control module based on LonWorks fieldbus for air handling unit(AHU) of heating, ventilating and air-conditioning(HVAC) is proposed to replace with a conventional direct digital control(DDC) with 32 bit microprocessor. This article also addresses an Internet-based HVAC system architecture that combines Web technology and networking. The proposed control architecture has a excellent features such as highly compact and flexible function design, a low priced smart front-end and reliable performance with various functions. This also addresses issues in control network configuration, logical design of field devices by S/W tool, Internet networking and electronic element installation. Experimental results showing the system performance are also included in this paper.

• Journal of Information Processing Systems
• /
• 제16권3호
• /
• pp.648-662
• /
• 2020

Bluetooth low energy (BLE) beacon is an actively push-to-broadcast electronic signal and can be used for object identification. This paper uses such beacon-based identification and Internet of Things (IoT) technologies for the elder health management service system to simplify the user interfaces and steps for preventive elder care. In the proposed system, an elder's family member, caregiver, or medical worker can conveniently and quickly record daily health management information. Besides, through the statistics and analysis of the data on the back end of the system, it is helpful for the elderly to refer to the data of daily care management and future management trends. Similarly, it is also an essential reference data for system maintenance and the new preventive health care services development.

• 한국안전학회지
• /
• 제31권5호
• /
• pp.1-6
• /
• 2016

The performance of a set of low-cost optical components used for measuring the optical density of PM particles was evaluated in the present study. To this end, the set of low-cost optical components was replaced with that of general optical components used to measure the PM optical density under identical experimental conditions. The optical densities measured from the set of general optical components were then compared to those obtained from the set of low-cost optical components. While the optical density is measured, another key parameter, the dimensionless extinction constant of PM particles (which is needed to optically measure the PM concentration) was also determined in the present study. The experimental results indicate that the optical density and PM concentration measurements performed by low-cost optical components are feasible, producing trackable variations in the OD and concentrations compared to values obtained from the set of general optical components.

• 한국농공학회논문집
• /
• 제59권2호
• /
• pp.29-36
• /
• 2017

The objective of this study was to analyze the temporal and spatial characteristics of agricultural drought by tracking the daily reservoir storage in Chungnam province. All daily records of the percent of reservoir storage from 2000 to 2015 were collected for 130 irrigation reservoirs from the RIMS (Rural Infrastructure Management System). The temporal change of province-wide average reservoir storage and the statistics showed that the annual average and minimum percent of reservoir storage in 2015 were extremely low like as those in the historical drought years of 2001 and 2012. The minimum reservoir storage on record was a 41 % at the end of September and remained far less than its historical average even until the end of the year. Furthermore, the annual average reservoir storage (68.3 %) recorded the lowest on record since 2000. In addition, about half of 130 major irrigation reservoirs in Chungnam fell into the risk of water shortage below 30 % full, and, in terms of annual minimum reservoir storage, the 79 reservoirs yielded lower storage in 2015 comparing with the measured in another drought year, 2001. On the other hand, irrigation reservoirs of comparatively worse storage condition revealed to be mostly located on the inside, such as Cheongyang-gun and Hongsung-gun. Conclusively, the low reservoir storage, still far below average even on December 2015, induced a serious concern about that more extreme drought would happen in the next spring.

• Journal of Magnetics
• /
• 제18권2호
• /
• pp.173-177
• /
• 2013

Cantilever-detected high-frequency electron spin resonance (ESR) is a powerful method of sub-terahertz and terahertz ESR spectroscopy for a tiny magnetic sample at low temperature. In this technique, a small magnetization change associated with ESR transition is detected as deflection of a sample-mounted cantilever. So far, we have succeeded in ESR detection at 370 GHz using a commercial piezoresistive microcantilever. The spin sensitivity was estimated to ${\sim}10^{12}$ spins/gauss. In order to further increase the sensitivity, we adopt a fiber-optic-based detection system using a Fabry-Perot interferometer in place of piezoresistive system. Fabry-Perot cavity is formed between an optical-fiber end and microcantilever surface, and a change in the interference signal, corresponding to the cantilever deflection, is sensitively detected. This system is suitable for low-temperature and high-magnetic-field experiments because of its compact setup and less heat dissipation. In this study, performance of Fabry-Perot interferometer is evaluated, and its application to cantilever-detected ESR measurement is described.

• 한국산학기술학회논문지
• /
• 제16권9호
• /
• pp.6254-6259
• /
• 2015

광시스템상에는 외부로부터의 잡음과 시스템 자체의 잡음이 항상 존재하는데, 이러한 잡음은 광시스템의 성능을 저하시키는 요인으로 작용하게 되어 결국에는 시스템의 에러확율을 변화시키게 된다. 이에 본 논문에서는 광시스템의 특성변수인 m 값을 도입하여 다양한 m값의 변화에 따라 광시스템의 에러확률을 ${\kappa}$-자승법을 이용하여 계산하였다. 계산 결과 m값에 따라 광시스템의 에러확률이 변화함을 확인하였고, 광시스템의 표준에럭확률인 $10^{-9}$을 유지하는 경우 m값을 400정도로 유지하면 됨을 확인하였다. 이는 m값이 큰 경우는 광시스템이 저출력임을 의미하므로 보다 작은 출력의 광원을 사용해도 광시스템의 에러확율을 유지하는데 문제가 없음을 알 수 있었다. 이는 일반적인 경우 저출력의 광원을 사용하는 경우 광시스템의 수신단에서 신호를 증폭하는 전치증폭기를 사용하지 않아도 됨을 의미하므로 보다 효율적이며 저렴하게 광시스템을 구현할 수 있음을 의미한다.