• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.4
• /
• pp.335-344
• /
• 2004

A low phase noise EQM(Engineering Qualified Model) LO(Local Oscillator) has been developed for Ka-band satellite transponder. A VCDRO(Voltage Controlled Dielectric Resonator Oscillator) is also designed using a high impedance inverter coupled with dielectric resonator to improve the phase noise performances out of the loop bandwidth. The mechanical analysis fur housing and the thermal analysis fur circuit board are achieved. This EQM LO is applied to Ka-band satellite transponder of EQM level after environmental experiments for space application. The LO has the harmonic suppression characteristics above 52 ㏈c and requires low power consumption under 1.3 watts. The phase noise characteristics are exhibited as -101.33 ㏈c/㎐ at 10 ㎑ offset frequency and -114.33 ㏈c/㎐ at 100 ㎑ offset frequency, with the output power of 14.0 ㏈m${\pm}$0.17 ㏈ over the temperature range of -15∼＋65$^{\circ}C$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.2
• /
• pp.152-160
• /
• 2008

In this paper, we analyze the performance of a direct-conversion UHF RFID reader with the range correlation effects of the phase noise. Since a UHF RFIB system uses the same oscillator to generate the transmitted carrier and the local oscillation, the periodic interference and phase noise reduction effects occur due to time delay between two signals. Through exact theory and simulation, we verify how to cancel the periodic interference phenomena using I/Q diversity combining technique. And, we analyze phase noise reduction effects due to range correlation as a function of the tag-reader distance and the offset frequency Using these results, we simulate the symbol-error-rate performance with respect to phase noise with and without range correation effects. We show that the phase noise of the local oscillator has little effect on the symbol-error-rate performance because of phase noise reduction by range correlation.

• Journal of Astronomy and Space Sciences
• /
• v.17 no.2
• /
• pp.221-232
• /
• 2000

A Gunn waveguide-oscillator, mechanically tunable from 60 to 70 GHz, has been developed for use as a local oscillator(LO) is millimeter radio telescope. Disc size, post size and characteristics of Gunn diode have an effect on the frequency tuning characteristics of Gunn oscillator. In this paper we report experimental results and design criteria for a wideband tunable Gunn oscillator. The developed Gunn oscillator has been used in the 100/150 GHz band dual channel receiver for the Taeduk Radio Astronomy Observatory.

• Proceedings of the KIEE Conference
• /
• 2002.07d
• /
• pp.2589-2591
• /
• 2002

송수신기의 방식에는 직접변환 방식과 기저대역 신호와 LO(Local Oscillator)를 혼합하여 interpolation 기법을 사용하여 중간 주파수 단계까지 up conversion을 하고 두 번째 LO와 IF신호를 혼합하여 RF신호로 변환하여 송신하는 헤테로다인 방식이 존재한다. 본 논문에서는 이런 송수신기 방식 중에서 헤테로다인 방식을 적용하여 QPSK에서의 digital up /down converter를 Simulink 환경에서 설계 및 구현하였다. Up converter는 4배의 interpolation 필터와 4단짜리 cascaded integrate-comb(CIC)필터를 사용하여 입력데이터의 샘플 레이트를 클럭 레이트까지 증가시켰으며, numerically controlled oscillator (NCO)와 mixer를 사용하여 신호를 변조하였다. Down converter의 구조는 up converter와 동일하며 단지 up converter의 반대순서로 구성되어있다. 이런 모든 과정을 Simulink를 이용한 시뮬레이션과 스펙트럼 분석기를 사용하여 검증해 보았다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.5A
• /
• pp.341-346
• /
• 2009

M-WiMAX (Mobile-Worldwide Interoperability for Microwave Access) system, which uses OFDM (Orthogonal Frequency Division Multiplexing) technique, is known to be proper for mobile high-speed data transmission system. Nevertheless, M-WiMAX is seriously sensitive to IQ imbalance caused by the LO (Local Oscillator) at the receiver. In this paper, we analyze the effect of IQ imbalance on the system, and then propose a joint optimization scheme that can optimize DFE (Digital Front-end) of mobile modem by combining operation duplicated between AGC (Automatic Gain Control) and the estimation and compensation of IQ imbalance. Simulation results show that the proposed scheme achieves the same performance of the conventional scheme while reducing the complexity of the H/W implementation.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.19 no.3
• /
• pp.379-386
• /
• 2016

In this paper, phase noise analysis result for 2.4 GHz PLL(phase locked loop) using SPD(sample phase detector) is proposed. It can be used for high performance frequency synthesizer's LO(local oscillator) to extend output frequency range or for LO of offset PLL to reduce a division rate or for clock signal of DDS(direct digital synthesizer). Before manufacturing, theoretical estimation of PLL's phase noise performance should be performed. In order to calculate phase noise of PLL using SPD, Leeson model is used for modeling phase noise of VCO(voltage controlled oscillator) and OCXO(ovened crystal oscillator). After theoretically analyzing phase noise of PLL, optimized loop filter bandwidth was determined. And then, phase noise of designed loop filter was calculated to find suitable OP-Amp. Also, the calculated result of phase noise was compared with the measured one. The measured phase noise of PLL was -130 dBc/Hz @ 10 kHz.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.4C no.6
• /
• pp.272-275
• /
• 2004

A balanced single side-band (SSB) mixer employing a sub-harmonic configuration is designed for up and down conversions in K-band. The designed mixer uses anti-parallel diode (APD) pairs to effectively eliminate even harmonics of the local oscillator (LO) spurious signal. To reduce the odd harmonics of LO at the RF port, we employ a balanced configuration for LO. The fabricated chip shows 12$\pm$2dB of conversion loss and image-rejection ratio of about 20dB for down conversion at RF frequencies of 24-27.5GHz. As an up-conversion mode, the designed chip shows 12dB of conversion loss and image-rejection ratio of 20 ～ 25 dB at RF frequencies of 25 to 27GHz. The odd harmonics of the LO are measured below -37dBc.

• Current Optics and Photonics
• /
• v.6 no.1
• /
• pp.23-31
• /
• 2022

Heterodyne efficiency is an indicator to evaluate the performance of space coherent laser communication systems. It is affected by signal light and local oscillator (LO) light amplitude, phase and polarization state. In this paper, based on the common heterodyne efficiency, a heterodyne efficiency model that can reflect polarization aberration of optical system is proposed. The heterodyne efficiency is analyzed when the signal light and the LO light are linearly polarized or circularly polarized. For a coherent communication optical system, when the incident signal light is right-circularly polarized light and the incident LO light is 45° linear polarized light. Based on the three-dimensional ray tracing theory and the heterodyne efficiency proposed in this paper, the change of polarization states and the distribution of heterodyne efficiency of the signal light and LO light influenced by the optical system's polarization aberration are analyzed. Analysis shows that the heterodyne efficiency model proposed in this paper can be used to evaluate coherent communication systems and reflect the influence of optical system polarization aberration.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.1
• /
• pp.93-97
• /
• 2007

In this paper a new clock generation scheme for TDM-CDM converter in the Gap Filler for satellite DMB systems has been proposed. The scheme uses the frame sync signal from the Ku band TDM receiver to lock the VCXO which provides the system clock for the TDM-CDM converter. The locking algorithm can be easily implemented in the FPGA, so that no separate circuitry is needed as in conventional PLL. With a stable OCXO, The scheme can be used to generate the reference clock to the local oscillator for RF parts.

• ETRI Journal
• /
• v.27 no.5
• /
• pp.569-578
• /
• 2005

The purpose of this paper is to describe the implementation of monolithically matching circuits, interface circuits, and RF core circuits to the same substrate. We designed and fabricated on-chip 1 to 6 GHz up-conversion and 1 to 8 GHz down-conversion mixers using a 0.8 mm SiGe hetero-junction bipolar transistor (HBT) process technology. To fabricate a SiGe HBT, we used a reduced pressure chemical vapor deposition (RPCVD) system to grow a base epitaxial layer, and we adopted local oxidation of silicon (LOCOS) isolation to separate the device terminals. An up-conversion mixer was implemented on-chip using an intermediate frequency (IF) matching circuit, local oscillator (LO)/radio frequency (RF) wideband matching circuits, LO/IF input balun circuits, and an RF output balun circuit. The measured results of the fabricated up-conversion mixer show a positive power conversion gain from 1 to 6 GHz and a bandwidth of about 4.5 GHz. Also, the down-conversion mixer was implemented on-chip using LO/RF wideband matching circuits, LO/RF input balun circuits, and an IF output balun circuit. The measured results of the fabricated down-conversion mixer show a positive power conversion gain from 1 to 8 GHz and a bandwidth of about 4.5 GHz.