• Journal of Power Electronics
• /
• v.6 no.3
• /
• pp.187-194
• /
• 2006

A new asymmetrical pulse width modulation (PWM) half bridge converter with improved ZVS performance is proposed. The ZVS operation of the proposed converter can be maintained from no load to full load conditions since the magnetizing current of the transformer contributes to the ZVS operation at light loads without considerable conduction loss of the transformer and switch. Synchronous rectification is employed to reduce the rectification loss. Operational principles, large signal modeling, ZVS analysis and design equations are presented. Experimental results demonstrate that the proposed converter can achieve a large ZVS range and significant improvement in efficiency for a 100W (5V, 20A) prototype converter.

• ETRI Journal
• /
• v.6 no.4
• /
• pp.21-30
• /
• 1984

A new control strategy for a PWM inverter with instantaneous feedback is suggested, theoretically analyzed and verified through simulations. This control gives excellent results under various load conditions.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.6
• /
• pp.506-513
• /
• 2016

In general, LLC converters show great promise in applications that require high efficiency, especially under light load conditions. In particular, LLC converters feature wide gain capability with pulse-frequency modulation and zero voltage switching over entire load conditions. However, output voltage increases in light load conditions. In this study, Bode plot and impedance asymptotes analyses were conducted to obtain insights into the regulation characteristics of LLC converters under light load conditions. To improve the regulation characteristic of LLC converters, a new resonant tank with an additional capacitor is proposed. The design guideline for the proposed LLC converter is determined by the Bode plot and impedance asymptotes analyses. Therefore, the proposed LLC converter achieves the light load regulation while maintaining the advantages of typical LLC converters.

• Proceedings of the KIEE Conference
• /
• 2006.04b
• /
• pp.278-280
• /
• 2006

In this paper, a novel type of auxiliary active snubbingcircuit assisted quasi-resonant soft-switching pulse width modulation inverter is proposed for consumer induction heating equipments. The operation principle of this high frequency inverter is described using switching modes and equivalent circuits. This newly developed series resonant high frequency inverter can regulate its high frequency output AC power under a principle of constant frequency active edge resonant soft- switching commutation by asymmetrical PWM control system. The high frequency power regulation and actual power conversion efficiency characteristics of consumer induction heating (IH) products using the proposed soft-switching pulse width modulation (PWM) series load resonant high frequency inverter evaluated. The practical effectiveness and operating performance of high frequency inverter are discussion on the basis of simulation and experimental results as compared with the conventional soft-switching high frequency inverter.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.2 s.344
• /
• pp.88-93
• /
• 2006

In this paper, smaller load has been used compared with the conventional Doherty amplifier and PBG structure have been employed to suppress IMD (Inter-modulation Distortion) and improve PAE (Power Added Efficiency). And The PBG structure has been employed on the output macthing network of Doherty amplifier. The proposed power amplifier has been improved more the IMD3 by 5.5 dBc, and the average PAE by $5\%,$ at peak output power, $18\%$ at 8dB back-off point respectively than the conventional Doherty power amplifier.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.12A
• /
• pp.1189-1197
• /
• 2006

Ultra-wideband(UWB) is a killer technology for short-range wireless communications. In the past, most of the UWB research focused on physical layer but the unique characteristics of UWB make it different to design the upper layer protocols than conventional narrow band systems. Cross-layer protocols have received high attention for UWB networks. In this paper, we investigate the performance of two physical layer schemes: Time Hopping Binary Pulse Position Modulation(TH-BPPM) and Time Hopping Binary Pulse Amplitude Modulation (TH-BPAM) with proposed private MAC protocol for UWB ad-hoc networks. From pulse level to packet level simulation is done in network simulator ns-2 with realistic network environments for varying traffic load, mobility and network density. Our simulation result shows TH-BPAM outperforms TH-BPPM in high traffic load, mobility and dense network cases but in a low traffic load case identical performance is achieved.

• Proceedings of the KIPE Conference
• /
• 2006.06a
• /
• pp.200-202
• /
• 2006

In this paper, a novel type of auxiliary active snubbing circuit assisted quasi-resonant soft-switching pulse width modulation inverter is proposed for consumer induction heating equipments. The operation principle of this high frequency inverter is described using switching modes and equivalent circuits. This newly developed series resonant high frequency inverter can regulate its high frequency output AC power under a principle of constant frequency active edge resonant soft-switching commutation by asymmetrical PWM control system. The high frequency power regulation and actual power conversion efficiency characteristics of consumer induction heating (IH) products using the proposed soft-switching pulse width modulation (PWM) series load resonant high frequency inverter evaluated. The practical effectiveness and operating performance of high frequency inverter are discussion on the basis of simulation and experimental results as compared with the conventional soft-switching high frequency inverter.

• Journal of Power Electronics
• /
• v.16 no.2
• /
• pp.675-684
• /
• 2016

This paper presents a new stand-alone wind-based induction generator system with constant frequency and adjustable output voltage. The proposed generator consists of a six-phase cage-rotor induction machine with two separate three-phase balanced stator windings and a three-phase space vector pulse width modulation inverter that operates as a static synchronous compensator (STATCOM). The first stator winding is fed by the STATCOM and used to excite the machine while the second stator winding is connected to the generator external load. The main frequency of the STATCOM is determined to be constant and equal to the load-requested frequency. The generator output frequency is independent of the load power demand and its prime mover speed because the frequency of the induced emf in the second stator winding is the same as this constant frequency. A sliding mode control (SMC) is developed to regulate the generator output voltage. A second SMC is used to force the zero active power exchanged between the machine and the STATCOM. Some simulation and experimental results are presented to prove the validity and effectiveness of the proposed generator system.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.3
• /
• pp.20-27
• /
• 2006

Power line for digital home appliances has own property that transmitting power connected to loads. Especially, power line communication(PLC) for the home network which has characteristics of load fluctuation makes variable noise characteristics. It becomes serious problems to maintain efficient communication performance. Thus, in this paper, we present an optimal modulation and demodulation method through mathematical analysis of each measured load fluctuation based on PLC for home appliances. To analyze and compare various modem methods presented in this paper, we analyzed them normally via computer simulation under various noise channel environments according to various load fluctuations. In addition, we certified its availability through hardware implementation.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.9
• /
• pp.67-74
• /
• 2016

This paper presents a novel multiple orthogonal subcarrier modulation based UHF band RFID communication system. In tag-to-reader communication, the demonstration system can deliver 1.6 Mbps through four subcarriers. To improve data rate while suppressing increase in circuit complexity, tag employs square-waves as the subcarriers and uses individual load modulators for each subcarrier. By using multiple orthogonal subcarrier based modulation, proposed communication system can be operated under existing UHF band RFID regulation. In reader, an OFDM demodulator is used. Since the tag backscatters the reader's CW carrier, carrier frequency offset compensation is not necessary in reader demodulator. Experimental results show that the demonstration system achieves a bit error rate of 10-5 at an Eb/N0 of 10.8 dB.