• Analytical Science and Technology
• /
• v.23 no.6
• /
• pp.551-559
• /
• 2010

This study was conducted to establish an analytical method for the determination of seven nitrosamines in chlorinated tap water by precolumn derivatization followed by high performance liquid chromatography coupled with fluorescence detection. The derivatization procedure was optimized for denitrosation and dansylation, and then two extraction methods, liquid-liquid extraction (LLE) with dichloromethane and solid phase extraction (SPE), were compared. The SPE method employing the optimized derivation procedure showed higher extraction recovery (54.4-88.7%) and reproducibility (1.9-19.4%) than the LLE method (51.4-87.7% and 4.2-33.3%, respectively). The method detection limits were between 0.5 and 4.4 ng/L. When chlorinated water samples were collected from two treatment plants and ten household taps, and analyzed for nitrosamines, Nnitrosodimethylamine (NDMA) was the major compound found between 26.1 and 112 ng/L.

• Korean Chemical Engineering Research
• /
• v.56 no.5
• /
• pp.687-693
• /
• 2018

The selective removal and recovery of fermentation inhibitors during purification of sugars from biomass hydrolysates can increase the economic efficiency of the entire process to produce bioalcohol from lignocellulosic biomass. This study investigated the effect of furans in phenols-free biomass hydrolysate on acetic acid extraction in an emulsion liquid membrane system. Under specific operating conditions, more than 99% of acetic acid could be extracted within 5 minutes, and the degrees of extraction of furfural and 5-hydroxymethylfurfural were about 10% and 4%, respectively. The extraction rate of acetic acid was also lower at a higher initial concentration of furfural in the feed phase, which was greater for furfural than 5-hydroxymethylfurfural. Thus, if furfural is first removed from the hydrolysate prior to acetic acid extraction, emulsion liquid membrane would be a more economically efficient way of removing acetic acid.

• Journal of the Korean Society of Safety
• /
• v.8 no.2
• /
• pp.44-50
• /
• 1993

The objective of this study was to investigate the extraction of chromium(Vl) ion in waste water through the liquid surfactant membrane with open-type Perforated Reciprocating-Plate Column. Extraction experiments were conducted to measure the effect of flow characteristics of continuous and dispersed phase and stroke velocity, sodium hydroxide concentraction in internal aqueous phase, sulfuric acid concentraction in outer phase, and residence time distribution and measured extraction velocity. The result of experiments showed that extraction velocity of chromium ion was maximum when stroke velocity was 180 1/min and dispersion phase velocity was 30m11min, continuous phase velocity was 20m1/min. Extraction velocity of chromium ion increased with increasing difference of hydrogen ion concentraction of dispersion and continuous phase and column stage decreased.

• Proceedings of the PSK Conference
• /
• 2002.10a
• /
• pp.423.1-423.1
• /
• 2002

A simple. specific and sensitive method for the determination of cyclosporine A (CsA) in human serum has been developed by a high performance liquid chromatography/diode array detector (DAD) and applied to pharmacokinetic study of CsA. This method involves the use of solid phase extraction procedure following rapid protein precipitation with zinc sulphate from 1 $m\ell$ of human serum, using a disposable $C_{18}$ extraction cartridge. (omitted)

• Korean Journal of Environmental Agriculture
• /
• v.26 no.3
• /
• pp.246-253
• /
• 2007

This study was performed to enhance the cleanup efficiency of methoxyfenozide and bentazone by pH adjustment in the course of liquid-liquid partition and to develop an optimum analytical conditions using HPLC coupled with DAD for two matrices, brown rice and rice straw. Preparation procedure of brown rice sample was "extraction${\rightarrow}$coagulation${\rightarrow}$liquid-liquid partition$\rightarrow$-florisil C.C", and this procedure was samely applied to two compounds. In rice straw, preparation procedure of methoxyfenozide sample was "extraction$\rightarrow$-alkalization$\rightarrow$liquid-liquid extraction$\rightarrow$coagulation$\rightarrow$florisil C.C", and in the case of bentazone, "extraction$\rightarrow$alkalization$\rightarrow$liquid-liquid partition$\rightarrow$acidification$\rightarrow$liquid-liquid extraction$\rightarrow$florisil C.C". All these purified samples were redissolved in the mobile phases, acetonitile : 20 mM sodium acetate (75:25, v/v) for methoxyfenozide and acetonitrile : 75 mM sodium acetate, pH 6.0 (40:60, v/v) for bentazone. Recoveries of methoxyfenozide analysis in brown rice and rice straw were 83.5-97.4 and 86.4-97.3%, and detection limits were 0.02 and 0.04 mg/kg, respectively. Recoveries of bentazone in brown rice and rice straw were 86.8-101.9 and 88.3-94.5% and detection limits were 0.005 and 0.01 mg/kg, respectively. This methods seem to be usefully applied to the residue analysis of two compounds in the view of producing stable analytical condition and fair reproducibility.

• Journal of Applied Biological Chemistry
• /
• v.57 no.4
• /
• pp.301-305
• /
• 2014

The Antioxidant activity screening identification of five kind compounds in Artemisiae annuae herba with the on-line screening high performance liquid chromatography (HPLC) $ABTS^+$ assay. The various experimental variables such as the extraction time (h) and extraction solvent composition (%) of dipping method were investigated efficiently extraction at the room temperature $25^{\circ}C$. The results, the highest yield of total extract amount (0.458 g, 15.250%) was obtained by dipping method with 100% water and extraction time to 3 h. And the on-line screening HPLC-$ABTS^+$ assay method was rapid and efficient to search for bioactivity from natural products.

• Archives of Metallurgy and Materials
• /
• v.66 no.4
• /
• pp.1001-1005
• /
• 2021

Liquid Metal Extraction process using molten Mg was carried out to obtain Nd-Mg alloys from Nd based permanent magnets at 900℃ for 24 h. with a magnet to magnesium mass ratio of 1:10. Nd was successfully extracted from magnet into Mg resulting in ~4 wt.% Nd-Mg alloy. Nd was recovered from the obtained Nd-Mg alloys based on the difference in their vapor pressures using vacuum distillation. Vacuum distillation experiments were carried out at 800℃ under vacuum of 2.67 Pa at various times for the recovery of high purity Nd. Nd having a purity of more than 99% was recovered at distillation time of 120 min and above. The phase transformations of the Nd-Mg alloy during the process, from Mg₁₂Nd to α-Nd, were confirmed as per the phase diagram at different distillation times. Pure Nd was recovered as a result of two step recycling process; Liquid Metal Extraction followed by Vacuum Distillation.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.4
• /
• pp.1011-1015
• /
• 2014

Octadecyl-modified graphene (graphene-C18) was fabricated and used as adsorbent in hollow fiber liquid phase microextraction (HF-LPME) for the first time. The extraction performance of graphene-C18 reinforced HF-LPME was evaluated using chlorophenols as model analytes. The factors affecting the extraction efficiency, such as extraction time, pH of the sample solution, agitation rate, the concentration of graphene-C18 and salt addition were optimized. After the graphene-C18 reinforced HF-LPME of the chlorophenols from honey sample, the analytes were separated and determined by high-performance liquid chromatography. The linearity was observed in the range of 5.0-200.0 ng $g^{-1}$ for 2-chlorophenol and 3-chlorophenol, and 2.0-200.0 ng $g^{-1}$ for 2,3-dichlorophenol and 3,4-dichlorophenol, respectively. The limits of detection (S/N = 3) of the method were lower than 1.5 ng $g^{-1}$. The recoveries of the method were between 88% and 108%. The method is simple, sensitive and has been resoundingly applied to analysis of chlorophenols in honey samples.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.8
• /
• pp.403-409
• /
• 2018

Inconel 713C which of a commercial Ni super alloy have the composition of 70 % Ni, 12 % Cr, 6 % Al and 4 % Mo. Mo is very expensive and have some economic value to recover in the alloy. In this study, liquid-liquid exraction(solvent extraction and stripping) has been performed to separate Mo from the synthetic leaching solution of spent Inconel 713C alloy and prepare to Mo powder by dying, evaporation and heat treatment. The experiments were conducted by using synthetic leaching solution which was prepared $NaMoO_4$ $2H_2O$ by dissolved in distilled water. Alamine336 and Cyanex272 dissolved in kerosene were used as extractants. The extraction percentage of Mo by Alamine336 is 99 % in the condition of the range of pH 1 to 4 and 1 % of concentration of Alamine336. The stripping solutions are used by HCl, $H_2SO_4$ and $HNO_3$ solutions and the concentrations were controlled by distilled water. The concentrations of HCl, $H_2SO_4$ and $HNO_3$ as stripping solutions are increased, the stripping percentages of Mo are increased and the stripping percentage of Mo by $HNO_3$ is higher than other stripping solutions. After liquid-liquid extraction and heat treatment, $MoO_3$ powder which of the purity of 97.5 % was prepared.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.9 no.6
• /
• pp.454-458
• /
• 2004

A study of the POSE (predispersed solvent extraction) for succinic acid by colloidalliq­uid aphrons was conducted. The organic phase contaning TOA (tri-n-octylamine) and 1-octanol permits a selective extraction of succinic acid from its aqueous solution. There was no difference of the extractability of POSE and that of conventional mixer-settler type extraction. Taking into account the no mechanical mixing in POSE, it was concluded that the POSE process is more adaptive than the conventional mixer-settler type extraction process. From mass transfer analysis at the various concentration of TOA in counter-current continuous operation, the concentration of TOA had no influence on the mass transfer coefficient. The loading values in continuous POSE were almost same as those in batch operation.