• Journal of the Korean Physical Society
• /
• v.73 no.10
• /
• pp.1479-1485
• /
• 2018

A number of experiments have been performed on light slowing and stopping in the electromagnetically induced transparency (EIT) media of hot atomic gases where the Doppler-shift may add detunings to the field frequencies in an inhomogeneous fashion. We provide here a theoretical analysis as to the effect of such a Doppler-broadened environment on the dynamics of the system in comparison to a cold atomic medium. We will show that one of the most critical factors in the formation of a stationary light pulse is the enhancement of the excited-state decay rate caused by the collisions between the atoms of the medium and the molecules of the buffer gas.

• Journal of Auto-vehicle Safety Association
• /
• v.15 no.3
• /
• pp.43-52
• /
• 2023

When a children's school bus stops on the road, the operator enables an amber flashing light (indicating stopping or slowing) or a red flashing light (indicating that children are getting on and off). Drivers of vehicles passing by the stopped school bus, as well as vehicles in adjacent lanes to the school bus must stop temporarily. However, many drivers are not aware of the laws and do not comply with them, so children are exposed to an increased risk of being hit, especially at night as the color recognition of the vehicle is significantly lower than during the day. In our experiments, messages and shapes using light were projected to the front and rear of a parked school bus, in addition to its red lights flashing.

• Nuclear Engineering and Technology
• /
• v.49 no.6
• /
• pp.1287-1300
• /
• 2017

Based on the observation that ignoring the angle dependency of multigroup resonance cross sections within a fuel pellet would result in nontrivial underestimation of the spatial self-shielding of flux, a parametrized spectral superhomogenization (SPH) factor library (PSSL) method is developed as a practical means of resolving the problem. Region-wise spectral SPH factors are calculated by the normal and transport corrected SPH iterations after ultrafine group slowing down calculations over various light water reactor pin-cell configurations. The parametrization is done with fuel temperature, U-238 number density, fuel radius, moderator source represented by ${\Sigma}_{mod}V_{mod}$, and the number density ratio of resonance nuclides to that of U-238 in a form of resonance interference correction factors. The parametrization is successful in that the root mean square errors of the interpolated SPH factors over the fuel regions of various pin-cells are within 0.1%. The improvement in reactivity error of the PSSL method is shown to be superior to that by the original SPH method in that the reactivity bias of -200 pcm to -300 pcm vanishes almost completely. It is demonstrated that the environment effect takes only about 4% in the reactivity improvement so that the pin-cell based PSSL method is effective in the assembly problems.

• Tribology and Lubricants
• /
• v.38 no.2
• /
• pp.70-72
• /
• 2022

In this study, we report on a power system developed as a decelerator for a driving module in an electric vehicle. The system is to be mounted in a limited space. The research focus was on development of miniaturization, light weight, and high power density. In particular, we aimed to minimize the layout of existing external components as integrated or built-in, and to maximize the power density by applying optimal cooling technology to increased requirements for developing modular power systems applicable to various OEM models. South Korean automakers ranked fourth in global electric-vehicle sales in 2020, but domestic sales are relatively slow. Despite government's expansion in subsidies for eco-friendly cars, consumers are delaying purchases after 2021 considering the cost-effectiveness of electric vehicles. In major European markets, the demand for electric vehicles exceeded the demand for diesel cars, and sales of hybrid cars, which used to represent eco-friendly cars, are slowing down as Toyota, started selling electric vehicles. In this study, the internal lubrication characteristics of a decelerator installed in an electric vehicle were analyzed in terms of the deceleration time while driving. By selecting the proper oil and oil viscosity, it was confirmed that there is no problem in lubricating the bearings and gears of the decelerator.

• Journal of Magnetics
• /
• v.11 no.4
• /
• pp.195-207
• /
• 2006

The recently published and new results on design and fabrication of magnetophotonic crystals of different dimensionality are surveyed. Coupling of polarized light to 3D photonic crystals based on synthetic opals was studied in the case of low dielectric contrast. Transmissivity of opals was demonstrated to strongly depend on the propagation direction of light and its polarization. It was shown that in a vicinity of the frequency of a single Bragg resonance in a 3D photonic crystal the incident linearly polarized light excites inside the crystal the TE- and TM-eigen modes which passing through the crystal is influenced by Brags diffraction of electromagnetic field from different (hkl) sets of crystallographic planes. We also measured the faraday effect of opals immersed in a magneto-optically active liquid. It was shown that the behavior of the faraday rotation spectrum of the system of the opal sample and magneto-optically active liquid directly interrelates with transmittance anisotropy of the opal sample. The photonic band structure, transmittance and Faraday rotation of the light in three-dimensional magnetophotonic crystals of simple cubic and face centered cubic lattices formed from magneto-optically active spheres where studied by the layer Korringa-Kohn-Rostoker method. We found that a photonic band structure is most significantly altered by the magneto-optical activity of spheres for the high-symmetry directions where the degeneracies between TE and TM polarized modes for the corresponding non-magnetic photonic crystals exist. The significant enhancement of the Faraday rotation appears for these directions in the proximity of the band edges, because of the slowing down of the light. New approaches for one-dimensional magnetophotonic crystals fabrication optimized for the magneto-optical Faraday effect enhancement are proposed and realized. One-dimensional magnetophotonic crystals utilizing the second and the third photonic band gaps optimized for the Faraday effect enhancement have been successfully fabricated. Additionally, magnetophotonic crystals consist of a stack of ferrimagnetic Bi-substituted yttrium-iron garnet layers alternated with dielectric silicon oxide layers of the same optical thickness. High refractive index difference provides the strong spatial localization of the electromagnetic field with the wavelength corresponding to the long-wavelength edge of the photonic band gap.

• Korean Journal of Optics and Photonics
• /
• v.17 no.1
• /
• pp.94-98
• /
• 2006

An optical microphone based on a dual-core fiber collimator and a membrane type micromirror serving as an optical head and a reflective diaphragm respectively was implemented. The micromirror diaphragm is suspended by a thin silicon bar linked with a frame, thus it is subject to a displacement induced by acoustic waves. The optical head incorporating two collimators integrated in a single housing gives light to and receives it from the diaphragm, rendering the optical microphone structure simple and compact. This dual-core collimator having a slowing varying beam profile facilitates the initial alignment of the optical head with the diaphragm, especially the distance between them. For the assembled microphone, the static characteristics were investigated tofind the operation point defined as the optimum distance between the head and the diaphragm, and a frequency response with a variation of about $\pm$5 dB for the range of up to 3kHz was achieved.

• Journal of Korean Society of Forest Science
• /
• v.108 no.1
• /
• pp.40-49
• /
• 2019

Coarse woody debris (CWD), which is a component of the forest ecosystem, plays a major role in forest energy flow and nutrient cycling. In particular, CWD isolates carbon for a long time and is important in terms of slowing the rate of carbon released from the forest to the atmosphere. Therefore, this study measured the physiochemical characteristics and respiration rate ($R_{CWD}$) of CWD for Larix kaempferi and Pinus rigida in temperate forests in central Korea. In summer 2018, CWD samples from decay class (DC) I to IV were collected in the 14 forest stands. $R_{CWD}$ and physiochemical characteristics were measured using a closed chamber with a portable carbon dioxide sensor in the laboratory. In both species, as CWD decomposition progressed, the density ($D_{CWD}$) of the CWD decreased while the water content ($WC_{CWD}$) increased. Furthermore, the carbon concentrations did not significantly differ by DC, whereas the nitrogen concentration significantly increased and the C/N ratio decreased. The respiration rate of L. kaempferi CWD increased significantly up to DC IV, but for P. rigida it increased to DC II and then unchanged for DC II-IV. Accordingly, except for carbon concentration, all the measured characteristics showed a significant correlation with $R_{CWD}$. Multiple linear regression showed that $WC_{CWD}$ was the most influential factor on $R_{CWD}$. $WC_{CWD}$ affects $R_{CWD}$ by increasing microbial activity and is closely related to complex environmental factors such as temperature and light conditions. Therefore, it is necessary to study their correlation and estimate the time-series pattern of CWD moisture.