• Journal of the Korean Society of Clothing and Textiles
• /
• v.26 no.8
• /
• pp.1248-1253
• /
• 2002

Coocus laccae(Laccifer lacca Kerr), usually known as Lac, is a kind of cocoon which is parasitic on the tree around India and China. It contains the laconic acid of red colored dyes and has been used for cosmetic or natural dyeing prior to the introduction of New World cochineal. Nevertheless, the characterization of lac has not been studied, very little informed. The purpose of this study is to examine the effects of dyeing conditions fur Lac extract, such as pH of dye bath, concentration of Lac exact dyeing temperature and time, to find out the optimum conditions. The results were as follow. 1. The highest K/S values of the silk and wool was shown at PH 3 and PH 4. 2. K/S values of the silk came to nearly the adsorption equilibrium state at 40$^{\circ}C$ and the curve of wool showed a dramatic increase with the increase of temperature. 3. Dyed silk and wool fabrics showed good light fastness without using mordants.

• Restorative Dentistry and Endodontics
• /
• v.17 no.1
• /
• pp.166-180
• /
• 1992

One disadvantage of Glass Ionomer Cement Restoration is the difficulty in polishing. To find the appropriate polishing method, we polished the surface of Glass Ionomer Cement Restorations by 11 combination methods serially using disks shared with large-small particles and evaluated the polishing process in terms of surface roughness, surface roughness curve, and SEM findings. In addition, a visible light curing type bonding material was applied to evaluate the possible improvement in surface properties. The following results were obtained. 1. The disk surface of Glass Ionomer Cement was polished serially by disks with superfine particles, but it didn't become smooth. 2. The surface of Microfilled Composite resin became smoother as using a disk with finer particles. 3. When a visible light curing type bonding material was applied in finishing process, the surface of Glass Ionomer Cement became smooth as much as the applied matrix.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.9-10
• /
• 2007

In this paper, we investigated the effect of solar cell breakage on maximum output power of PV module. The test result using artificial light source didn't give any change in output power in case of crack near electrical ribbon. Also, there was a reduction in output power in case of increasing of crack area far from electrical ribbon. But, this experiment is under artificial light source test method. So, when such a PV module is outdoor for a long time, there would be problems on electrical output power and durability because of thermal aging phenomenon of solar cell breakage.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.11a
• /
• pp.451-456
• /
• 2004

In this study, evaluation was carried out for reduction method of floor impact noise through field test and the effective methods for heavy impact noise were proposed. As a field test, impact noise reduction materials such as EPP, EEPS, EVA, PE and so on, did not satisfied the recommandation value at the condition of 150mm thickness concrete slab. The evaluation results for those materials by 'inverse A curve' showed $53\sim55dB$ at heavy impact noise and $53\sim58dB$ at light impact noise. But, two methods proposed by authors were evaluated $47\sim50dB$ at heavy Impact noise and $54\sim58dB$ at light Impact noise on the similar concrete slab thickness.

• Bulletin of the Korean Chemical Society
• /
• v.21 no.4
• /
• pp.389-392
• /
• 2000

A simple and inexpensive colorimetric spectrometer for determining total cholesterol has been developed,comprising a diode laser as the light sourcoptical fibers for the light guide and a photodiode as the detector.The stabilty and performance of the new system was investigated by obtaining the calibration curve for stan-dard cholesterol solutions. The total cholesterol in humanserum was also measured by the analyzer and com-pared with the value obtained by a conventional spectrometer. The results showed that the developed spectrometer was useful for the determination of cholesterol levels. The visible diodelaser used in the study exhibited good spectroscopic and operational properties for colorimetric absorption spectrometry and could be a key component for the development of a simple and economical analyzer.

• Membrane Journal
• /
• v.8 no.3
• /
• pp.157-169
• /
• 1998

The effects of solvents (DMAc, NMP, 1,4-dioxane) and nonsolvents ($H_2O$, Methanol, n-hexane) on the morphology of 6FDA-p-TeMPD polyimide membrane, prepared by the wet phase inversion method, were studied. In the polymer/solvent/nonsolvent ternary system, the binodal curve, the coagulation value and the relative light transmission were measured, and the solubility parameter difference was calculated. The onset state and rate of liquid-liquid alemixing were predicted and the morphology of membrane was analyzed. It is found that the finger-like pores are formed within discontinuous polymer nodules when the binoclal curve is close to the polymer-solvent (P-S) axis, the coagulation value is small, the reduction of light transmission is easy to occur and the order of solubility parameter difference ($\Delta \delta_{i-j}$) is $\Delta \delta_{S-NS} > \Delta \delta_{P-NS} > \Delta \delta_{P-S}$. The dense skin with small nodules and the sponge type sublayer with macrovoid are formed in the case that the binodal curve is distant from the P-S axis, the onset time of liquid-liquid demixing is long and the order of $\Delta \delta_{i-j}$ is $\Delta \delta_{P-NS} >(\Delta \delta_{S-NS} < > \Delta \delta_{P-S})$. The thick layer of fine nodule coagulation and loosely grown sublayer of nodules appear when the binodal curve is distant from the P-S axis, the onset time of liquid-liquid demixing is very long and the order of $\Delta \delta_{i-j}$가 $\Delta \delta_{S-NS} > (\Delta \delta_{P-NS}$\lessgtr$ > (\Delta \delta_{P-NS} < >)\Delta \delta_{P-S}$ ).

• Journal of Astronomy and Space Sciences
• /
• v.30 no.3
• /
• pp.145-152
• /
• 2013

Rotation-powered pulsars are excellent laboratories for studying particle acceleration as well as fundamental physics of strong gravity, strong magnetic fields and relativity. Particle acceleration and high-energy emission from the polar caps is expected to occur in connection with electron-positron pair cascades. I will review acceleration and gamma-ray emission from the pulsar polar cap and associated slot gap. Predictions of these models can be tested with the data set on pulsars collected by the Large Area Telescope on the Fermi Gamma-Ray Telescope over the last four years, using both detailed light curve fitting, population synthesis and phase-resolved spectroscopy.

• Bulletin of the Korean Space Science Society
• /
• 1993.04a
• /
• pp.14.1-14
• /
• 1993

BV observation of AW Cam (BD.69'0389, HD48049, Bv412) have been carried outusing a CCD Camera attached to 61-cm telescope, at Sobaek mountain Astronomical Observatory. BD 159'0385 were employed for the comparison. A total of 350obserrations were obtained during 3 nights between Jan. 28 and Feb. 19 1993. The light curve have been analyzed by the method of Wilson and Devinney different ialcorrection. The results were compared with the previous solutions.

• Proceedings of the KIEE Conference
• /
• 1989.07a
• /
• pp.370-373
• /
• 1989

It has been reported that the formation of conductive carbon path is mainly affected by scintillation. In this paper, mechanisms of tracking deterioration are reviewed by counting light pulse with IR photodiode. The influence of applied voltage and molecular composition of materials in the tracking breakdown is also reviewed by the Number of Pulse curve.

• The Pure and Applied Mathematics
• /
• v.16 no.1
• /
• pp.31-46
• /
• 2009

In this paper we study the geometry of Einstein half light like submanifolds M of a Lorentz manifold ($\bar{M}$(c), $\bar{g}$) of constant curvature c, equipped with an integrable screen distribution on M such that the induced connection ${\nabla}$ is a metric connection and the operator $A_u$ is a screen shape operator.