• Carbon letters
• /
• 제12권3호
• /
• pp.180-183
• /
• 2011

Li metal is accepted as a good counter electrode for electrochemical impedance spectroscopy (EIS) as the active material in Li-ion and Li-ion polymer batteries. We examined the existence of signal noise from a Li-metal counter quantitatively as a preliminary study. We suggest an electrochemical cell with one switchable electrode to obtain the exact impedance signal of active materials. To verify the effectiveness of the switchable electrode, EIS measurements of the solid electrolyte interphase (SEI) before severe $Li^+$ intercalation to SFG6 graphite (at > ca. 0.25 V vs. Li/$Li^+$) were taken. As a result, the EIS spectra without the signal of Li metal were obtained and analyzed successfully for the following parameters i) $Li^+$ conduction in the electrolyte, ii) the geometric resistance and constant phase element of the electrode (insensitive to the voltage), iii) the interfacial behavior of the SEI related to the $Li^+$ transfer and residence throughout the near-surface (sensitive to voltage), and iv) the term reflecting the differential limiting capacitance of $Li^+$ in the graphite lattice.

• 한국세라믹학회지
• /
• 제35권9호
• /
• pp.995-1001
• /
• 1998

As a basic study for cathode materials of {{{{ { {LiMn }_{2 }O }_{4 } }}-based lithium-ion secondary batteries Li({{{{ { { { {Mn }_{1-$\delta$ }Nb }_{$\delta$} )}_{2 }O }_{4 } }} ($\delta$=0.05, 0.1, 0.2) materials which Nb is substituted for Mn were synthesized by the solid state reaction at 80$0^{\circ}C$ and 110$0^{\circ}C$ respectively. The second phase {{{{ { LiNbO}_{3 } }} appeared above $\delta$=0.1 As the result of im-pedance analysis as the amount of substituted Nb increased the resistivity of grain boundary increased greatly. Compared to undoped-{{{{ { {LiMn }_{2 }O }_{4 } }} the electrical conductivity of Li({{{{ { { { {Mn }_{1-$\delta$ }Nb }_{$\delta$} )}_{2 }O }_{4 } }} decreased slightly but is charging capacity and potential plateau increased.

• 전기화학회지
• /
• 제10권1호
• /
• pp.31-35
• /
• 2007

이 리뷰를 통하여, 휴대폰용 리튬이차전지의 최근 기술동향을 설명하였다. 휴대폰용 이차전지로는 니카드, 니켈-금속수소, 리튬이온 혹은 리튬이온폴리머의 세 가지 형태의 전지가 있으며, 리튬 이차전지가 에너지밀도 측면에서 가장 성능이 우수하다. 즉, 동일한 용량을 갖는 이차전지 가운데 가장 작고 가벼운 것은 리튬이차전지이다. 이러한 리튬이차전지의 시장은 매년 약 15%의 높은 성장을 기록하고 있다. 연구개발은 $LiFePO_4$를 포함하는 새로운 양극, $Li_4Ti_5O_{10}$, Si, 주석 등의 새로운 음극소재, 새로운 전해질과 안정성 확보에 관한 것을 중심으로 진행되고 있다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 C
• /
• pp.1054-1057
• /
• 1995

The pollution-free secondary Li ion battery has been developed recently. However due to short history of Li ion battery, the standards for characterized assessments and standardized testing methods have not been prepared and established yet. Also, the researches have not been done systematically regarding the operating methods of these new type of batteries. Such limited knowledge of new batteries emphasizes the importance of development of characterized assessment and the operating methods.

• 한국인터넷방송통신학회논문지
• /
• 제23권4호
• /
• pp.171-176
• /
• 2023

21세기 현대사회에 있어서 이차전지 배터리(Battery)를 이용한 휴대용 전자제품은 계속해서 경량, 소형화되어가는 추세 속에서 있다. 그리고 이러한 추세와 더불어 우리는 몸에 착용할 수 있는 전자 장비를 이용하여 하루 일상생활에서 정보를 수집, 공유하는 4차 산업혁명 시대에 활동하고 있다. 따라서 소형 가전제품 및 디지털 기기를 사용하면서 재충전할 수 있는 이차전지 배터리의 역할은 점점 더 중요하게 증가하고 있다. 이러한 증가와 더불어 이차전지 배터리 성능시험은 특성, 수명, 고장진단, 재활용 등의 다양한 시험방법을 요구하고 있으며 있다. 또한 배터리의 안전과 적절한 기능을 보장하기 위한 배터리 테스트 시스템 구축과 이에 따른 지침 및 올바른 기본지식이 고려되고 있다. 따라서 본 논문에서는 배터리의 성능과 직접으로 연결된 시나리오별 충방전에 따른 이차전지 리튬이온(Li-ion) 배터리의 특성에 대해 살펴보고자 한다.

• 한국세라믹학회지
• /
• 제37권5호
• /
• pp.466-472
• /
• 2000

As cathode materials of LiMn2O4-based lithium-ion secondary batteries, Li(Mn1-$\delta$M$\delta$)2O4 (M=Ni and Co, $\delta$=0, 0.05, 0.1 and 0.2) materials which Co and Ni are substituted for Mn, were syntehsized by the solid state reaction at 80$0^{\circ}C$ for 48 hours. No second phases were formed in Li(Mn1-$\delta$M$\delta$)2O4 system with substitution of Co. However, substitution of Ni caued to form a second phase of NiO when its composition exceeded over 0.2 of $\delta$ in Li(Mn1-$\delta$M$\delta$)2O4. As the results of charging-discharging test, the maximum capacity of Li(Mn1-$\delta$M$\delta$)2O4 appeared in $\delta$=0.1 for both Co and Ni. Also, Li(Mn1-$\delta$M$\delta$)2O4 electrode showed higher capacity and better cycle performance than LiMn2O4.

• 한국재료학회지
• /
• 제12권9호
• /
• pp.712-717
• /
• 2002

New wet chemical method so called precipitation-evaporation method was suggested for preparing spinel structure lithium manganese oxide ($LiMn_2$$O_4$) for Li ion secondary battery. Using precipitation-evaporation method, $LiMn_2$$O_4$ cathode materials suitable for Li ion secondary batteries can be synthesized. Single spinel phase $LiMn_2$$O_4$ powder was synthesized at lower temperature compared to that of prepared by solid-state method. $LiMn_2$$O_4$ powder prepared by precipitation-evaporation method showed uniform, small size and well defined crystallinity particles. Li ion secondary battery using $LiMn_2$$O_4$ as cathode materials prepared by precipitation-evaporation method and calcined at $800^{\circ}C$ showed discharge capacity of 106.03mAh/g and discharge capacity of 95.60mAh/g at 10th cycle. Although Li ion secondary battery showed somewhat smaller initial capacity but good cyclic ability. It is suggested that electro-chemical properties can be improved by controlling particle characteristics by particle morphology modification during calcination and optimizing Li ion secondary battery assembly conditions.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 춘계학술대회 논문집 센서 박막재료 반도체 세라믹
• /
• pp.299-305
• /
• 2003

The battery industries have been developed to the implementation of lithium ion secondary cell from the cell of Ni/Cd and Ni/MH in the past to be asked of an age of high technology from low technology. Also in resent the polymeric cell to get a good high function with an age of new advanced information system is changed from the 21 century to the secondary batteries society. The properties of lithium secondary batteries have the high energy density, the long cycle time, the low self discharge area and the high active voltage. The wanted properties of secondary batteries for the motion of an apparatuses of industries of an high skill age have a small type trend of the energy density and it is become with a strong asking of the industrial society market about the storable medium of the convenience and new power energy. The electrochemical properties is researched for the cell to be synthesised and crystallized the positive active material LiMnO2 of the secondary cell at 9250C to get a new improved data of the electric discharge for that the capacitance of the LiMnO2 thin film that is improving and researching with the properties and a merit and demerit in the this kind of asking.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.627-628
• /
• 2005

In recent years, the rapid growth of portable electronic device market requires higher density characteristics of batteries. The speed at which portability and mobility is advancing hinges much on the battery. What is important is this energy source that engineers design handled devices around the battery, rather than the other way around. Much improvement has been made in reducing the power consumption of portable devices. Currently, the most popular secondary battery is Li-ion battery. Li-ion has won the limelight and become the most prominent battery. This paper reviews the prospect and future of the Li-ion battery.

• 전기화학회지
• /
• 제8권4호
• /
• pp.168-171
• /
• 2005

The electrochemical properties of $LiFePO_4$ as a cathode for Li-ion batteries were improved by incorporating conductive carbon into the $LiFePO_4$. X-ray diffraction analysis and SEM observations revealed that the carbon-coated $LiFePO_4$ consisted of fine single crystalline particles, which were smaller than the bare $LiFePO_4$. The electrochemical performance of the carbon-coated $LiFePO_4$ was tested under various conditions. The carbon-coated $LiFePO_4$ showed much better performance in terms of the discharge capacity and cycling stability than the bare $LiFePO_4$. The improved electrochemical performances were found to be attributed to the reduced particle size and enhanced electrical conductivity of the $LiFePO_4$ by the carbon.