• Textile Coloration and Finishing
• /
• v.34 no.3
• /
• pp.157-164
• /
• 2022

This study tried to analyze the heat resistance properties by blending epoxy and phenolic resin in a certain ratio, and to analyze the adhesive properties at the time of metal-polymer hetero-adhesion by applying Epoxy-phenolic resin between a silicon steel sheet and m-aramid sheet, the viscosity, adhesive peel strength, and adhesive cross section were measured using a rotational rheometer, a tensile tester(UTM), and a field emission scanning electron microscopy(FE-SEM). The thermal stability and heat resistance were confirmed by measuring the mass loss according to the temperature increase using Thermogravimetric analysis(TGA). After blending with epoxy and Phenolic resin(1:0.25 ratio) curing at 110℃ for 10 min, high adhesive strength was improved more than 40% compared to the adhesive strength using epoxy alone. When the space between the silicon steel sheet and m-aramid sheet, which is created during curing of the E-P blend, is cured with a slight weight, it is possible to control the empty space and improve adhesion.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.33 no.6
• /
• pp.210-215
• /
• 2023

Raw mix burnability is an especially crucial factor in cement manufacturing technology, and it depends on the physical, chemical and mineralogical properties of each raw material. In this article, we compared the difference of burnability between the domestic and Japanese fly ash as cement raw materials by using Lafarge and Polysius evaluation method. Regardless of the type or amount of fly ash used, it was found to be more combustible when using fly ash. In both case, burnability improves as the amount of fly ash increases, especially the improvement in bunarbility is remarkable up to 3%. In conclusion, as the amount of fly ash increases within the range allowed by cement quality, burnability of raw materials improves, and thus the fuel cost required for the firing of clinker can also be expected to be reduced.

• Korean Journal of Food Science and Technology
• /
• v.8 no.1
• /
• pp.53-60
• /
• 1976

This study was undertaken to investigate the toxic effect of AF-2, 2-(2-furyl)-3-(5-nitro-2-furyl) acrylamide, in the diet of rats (Splague Dowley) for 4 weeks. Comparisons were made of weight gains, organ weights and the cholesterol, phospholipid and triglyceride content of the blood serum and liver tissue. Rats were divided into three groups, a control group which was fed on a standard diet and two groups were fed with 0.04% (group I) and 0.2% (group II) of AF-2. Male rats weighing 370-410 g, female rats weighing 240-250 g were used in this experiment and each group was composed of 24 Albino rats. The results were as follows. 1. Comparisons of weight gains, control and experimental groups did not show significant differences. 2. An examination of organ weights, liver weights of experimental groups showed higher than that of the control group. 3. In the lipid content of blood serum, phospholipid contents of experimental groups were lower than that of the control, while cholesterol and triglyceride content of experimental groups were higher than that of the control. 4. In the lipid content of liver tissue, phospholipid and triglyceride content of experimental groups did not show considerable changes, but cholesterol content was increased in proportion to AF-2 content. From these results, the authors could observe the significant changes in weight gains of liver and cholesterol content after feeding. It is concluded that the toxic effect of group II showed higher than that of group I and AF-2 had a toxic effect on rat liver to a certain extent.

• Journal of Korean Academy of Oral and Maxillofacial Radiology
• /
• v.29 no.2
• /
• pp.533-547
• /
• 1999

Malignant fibrous histiocytoma is one of the most common soft tissue sarcomas in late adult life. but its incidence in oral and maxillofacial region is extremely rare. We report a case of malignant fibrous histiocytoma which occurred in the infratemporal fossa. Conventional radiograph of this case showed an ill-defined radiolucent lesion in the alveolar bone of the right maxillary first molar area. the lateral wall of the maxillary sinus. and the ascending ramus of mandible. MRI demonstrated a well defined mass of intermediate signal intensitiy in Tl weighted images but T2 weighted images showed two distinctive regions of different characteristics. Upper portion of the lesion was of hyperintense signal but (at) lower portion, the signal intensity decreased clearly, which might mean that this lesion(mass) is composed of two different subtypes though it couldn't be confirmed by histopathological examination. Biopsy was taken the lesion as only in the soft tissue of the maxillary posterior alveolar region and confirmed the storiform-pleomorphic type of malignant fibrous histiocytoma. Histopathological subtype was well consistent with the relatively aggressive imaging findings of that region. We expect more detailed analysis of the nature of malignant fibrous histiocytoma with improvement of the imaging modality and the identification of the relationship between diagnostic imaging and histopathologic findings.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.5 no.2
• /
• pp.195-199
• /
• 2002

In order to find potential anticancer agents, we extracted pheophytin in the silkworm feces from various larval stages by water, chloroform and methanol extraction. The cytotoxicity of the pheophytin extracts of various silkworm feces was measured in the CT-26 cells originated from murine metastatic colon cancer, by dye uptake assay. The cytotoxicity of those pheophytins in 2nd, 3rd and 4th instars was better than remaining larval stages. The in vitro anticoagulant and fibyinolytic activities of ethanol extract from varietal mulberry leaves, mulberry branches and silkworm feces and pheophytin extracts from silkworm feces obtained at various larval stages were evaluated in order to find effective therapeutic drugs for the treatment of myocardial and cerebral thrombosis. The fibrinolytic activity was tested using the activated partial thromboplastin time (APTT) and thrombin time (TT) was measured for blood clotting activity. With regards to the fibrinolytic system, ethanol extracts of silkworm feces were better than varietal mulberry leaves and mulberry branches. The pheophytin extracts from 7th days of 5th instar contained the highest percentage of pheophytin and good fibrinolytic activity.

• International Journal of Control, Automation, and Systems
• /
• v.5 no.4
• /
• pp.388-396
• /
• 2007

This paper describes a multipath estimation method for Global Positioning System (GPS) dual frequency carrier phase measurements. Multipath is a major error source in high precision GPS applications, i.e., carrier phase measurements for precise positioning and attitude determinations. In order to estimate and remove multipath at carrier phase measurements, an array GPS antenna system has been used. The known geometry between the antennas is used to estimate multipath parameters. Dual frequency carrier phase measurements increase the redundancy of measurements, so it can reduce the number of antennas. The unscented Kalman filter (UKF) is recently applied to many areas to overcome some of the limitations of the extended Kalman filter (EKF) such as weakness to severe nonlinearity. This paper uses the UKF for estimating multipath parameters. A series of simulations were performed with GPS antenna arrays located on a straight line with one reflector. The geometry information of the antenna array reduces the number of estimated multipath parameters from four to three. Both the EKF and the UKF are used as estimation algorithms and the results of the EKF and the UKF are compared. When the initial parameters are far from true parameters, the UKF shows better performance than the EKF.

• Imaging Science in Dentistry
• /
• v.30 no.2
• /
• pp.127-131
• /
• 2000

A 19-year-old man was referred to Seoul National University Dental Hospital for evaluation of a large painless swelling of the left mandibular angle area in August, 1999. The growth had been first noted 6 years ago. He had visited other hospital in 1997. In spite of the treatment given at the hospital, the mass continued to grow rapidly. Conventional radiographs in 1999 showed an expansile, lobulated, and destructive lesion of the left mandibular body. CT scan demonstrated an expansile mass with a corticated margin. Bony septa were seen within the lesion. Internal calcification noted on the bone-setting CT image, and corresponded to the hypointense area in T1-weighted MRI image. MRI clearly delineated the extent of the lesion which had heterogenous intermediate signal intensity in T1-weighted images and heterogenous hyperintense signal intensity in T2-weighted images. The lesion was well-enhanced. Histopathologically, the lesion was well demarcated. Multinucleated giant cells were presented in a fibrous background, demonstrating a storiform pattern. Areas of osteoid rimmed by a few osteoblasts were scattered throughout the lesion. Inflammatory cells, blood vessels, and hemosiderin deposition were also shown. CGCG may show lots of internal calcification foci on the CT, and varied signal intensity in MRI. More cases will be needed to understand the features of the CT & MR finding of CGCG.

• Journal of Environmental Health Sciences
• /
• v.23 no.2
• /
• pp.12-23
• /
• 1997

The biosynthesis of galactolipid, galactose and the fatty acid composition in E. cdi and B. subtills treated with potassium dichromate(PD, 500 ppm, 500 ppm), potassium chromate(PC, 500 ppm, 500 ppm), cobalt chloride(CC, 100 ppm, 10 ppm) and methylmercuric chloride(MC, 100 ppm, 10 ppm) during the culture were analyzed to compare with the control. The growth rate of cells, the contents of monogalactosyldiglyceride(MGDG), digalactosyldiglyceride(DGDG) and total lipid in the metal compound treatments were lower as compared with the control. And too, the contents of galactose utilized for the biosynthesis of galactolipids in these strains in the various metal compounds treatments were inhibited. The fatty acids used for the MGDG and DGDG formation in E. coli and B. subtills treated with each metal compounds during the culture were showed to the variant compositional change.

• Journal of the Korean Solar Energy Society
• /
• v.32 no.spc3
• /
• pp.275-281
• /
• 2012

Proton Exchange Membrane Fuel Cells (PEMFC) are the most appropriate for energy source of small robot applications. PEMFC has superior in power density and thermodynamic efficiency as compared with the Direct Methaol Fuel Cell (DMFC). Furthermore, PEMFC has lighter weight and smaller size than DMFC which are very important factors as small robot power system. The most significant factor of mobile robots is weight which relates closely with energy consumption and robot operation. This research tried to find optimum specifications in terms of type, number of cell, active area, cooling method, weight, and size. In order to find optimum 500W PEMFC, six options are designed in this paper and studied to reduce total stack weight by applying new materials and design innovations. However, still remaining problems are thermal management, robot space for energy sources, and soon. For a thermal management, design options need to analysis of Computational Fluid Dynamics (CFD) for determining which option has the improved performance and durability.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2012.05a
• /
• pp.541-544
• /
• 2012

Recently, RFID-based mobile robot navigation technology for the study is on the march. Obstacle avoidance using existing RFID tag technology, the target is immediately recognizable through Stored in the tag for obstacle size and shape information. However, this technique is not easy to recognize a moving obstacle. In this paper, in order to this solve problem, mobile robot obstacle avoidance system is proposed using smart RFID tags attached to the ultrasonic sensor. Proposed system used Smart RFID tag is designed to the 900Mhz tags attached ultrasonic sensors. And captured moving obstacles information deliver mobile robot. Mobile robot modify driving information through delivery information. And the system keeps track of the best driving route. Usefulness of the proposed system was confirmed by simulations and experiments.