• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.4C
• /
• pp.139-147
• /
• 2012

In this study, various laboratory tests using bottom ash, which has similar engineering properties with sand, were conducted in order to solve the problem of clogging in granular compaction pile and to address sand supply and demand. In particular, testing was performed to help reduce clogging and minimize voids in a crushed stone compaction pile constructed in soft ground. Based on compaction tests and large diameter direct shear tests, an optimum mixing ratio was determined to be 80:20 (crushed stone to bottom ash) because an 80:20 mixing ratio showed the highest shear strength. Test results showed that as the bottom ash content increased above 20%, internal friction angle decreased. Another test method showed freezing and thawing had little effect when the replacement ratio was over 40%. Therefore, bottom ash mixed compaction piles in soft ground are most economical at a 40% replacement ratio.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09b
• /
• pp.61-67
• /
• 2010

Thick soft clay deposits which are generally located at the west and south coast of the Korean peninsula have complicated characteristics according to their orientation and formation history. Thus, several geotechnical problems could possibly occur when those soft clay deposits are used as foundations for marine structures. Deep cement mixing (DCM) method is one of the most widely used soft soil improvement method for various marine structures, nowadays. DCM method injects binders such as cement into the soft ground directly and mixes with the in-situ soil to improve the strength and other geotechnical properties sufficiently. However, the natural impacts induced by dynamic motions such as ocean waves, wind, typhoon, and tusnami give significant influences on the stability of marine structures and their underlaying foundations. Thus, the dynamic properties become important design criteria to insure the seismic stability of marine structures. In this study, the dynamic behavior of cemented Busan clay is evaluated. Laboratory unconfined compression test and resonant column test are performed on natural in-situ soil and cement mixed specimens to confirm the strength and strain-dependent dynamic behavior variation induced by cement mixing treatment. Results show that the unconfined compressive strength and shear modulus increase with curing time and cement content increment. Finally, the optimized cement mixing ratio for sufficient dynamic stability is obtained through this study. The results of this study are expected to be widely used to improve the reliability of seismic design for marine structures.

• Journal of the Korean Geotechnical Society
• /
• v.35 no.3
• /
• pp.25-35
• /
• 2019

A laboratory test on uniaxial compressive strength was carried out by making 640 specimens in total, which were divided into two groups by their curing time of 7 and 28 days for 3 water content conditions of a water content at 100% saturation level and 10% and 20% increased water content from the state with clay, sand and gravel mixed grounds of 20 ground conditions of 4 types of stabilizer mixing conditions which were 8%, 10%, 12%, 14%, to understand laboratory strength characteristics for strength design of deep mixing ground. In case of clayey grounds, although the strength increased depending on the increase of stabilizer content, it showed to be analogous regardless of the curing time. And the impact on the strength development of deep mixing specimen according to water content was considered to be comparatively little compared to other grounds. For sandy grounds, the strength increment amount clearly showed to increase as stabilizer content increased, and also the increase of water content was determined to be decreasing the strength increment effect. For gravel mixed grounds, at 14% or over of stabilizer content, the effect on strength development was big making a large increase in strength, but compared to sandy grounds, the strength ratio depending on the curing time showed to be small.

• International Journal of Highway Engineering
• /
• v.15 no.4
• /
• pp.43-51
• /
• 2013

PURPOSES : The main purposes of this study are to examine the influences of polyethylene wax-based WMA additive on the optimum asphalt content of warm-recycled asphalt mixture based on the Marshall mix design and to evaluate performance of warm-recycled asphalt mixture containing 30% RAP with polyethylene wax-based WMA additive. METHODS: Physical and rheological properties of the residual asphalt were evaluated in terms of penetration, softening point, ductility and performance grade (PG) in order to examine the effects of polyethylene wax-based WMA additive on the residual asphalt. Also, To evaluate performance characteristics of the warm-recycled asphalt mixtures using polyethylene wax-based WMA additive along with a control hot-recycled asphalt mixture, indirect tensile strength test, modified Lottman test, dynamic immersion test, wheel tracking test and dynamic modulus test were conduced in the laboratory. RESULTS : Based on the limited laboratory test results, polyethylene wax-based WMA additive is effective to decrease mixing and compacting temperatures without compromising the volumetric characteristics of warm-recycled asphalt mixtures compared to hot-recycled asphalt mixture. Also, it doesn't affect the optimum asphalt content on recycled-asphalt mixture. All performance test results show that the performance of warm-recycled asphalt mixture using polyethylene wax-based WMA additive is similar to that of a control hot-recycled asphalt mixture. CONCLUSIONS: Overall, the performance of warm-recycled asphalt mixture using polyethylene wax-based WMA additive is comparable to hot-recycled asphalt mixture.

• Journal of Soil and Groundwater Environment
• /
• v.7 no.4
• /
• pp.24-30
• /
• 2002

The laboratory adsorption batch tests were performed to investigate the adsorption characteristics of Pb on kaolinite. The characteristics such as adsorption equilibrium time, adsorption capacity, adsorption isotherm were studied, and also the effects of pH and the mixing ratio on the adsorption of Pb on kaolinite were investigated. Test results show that the adsorption equilibrium state was reached within 24 hours, and the adsorbed amount of Pb increased, but the adsorption efficiency over the initial concentration of 198 mg/l decreased, with increasing the initial concentration of Pb. And the adsorption constant, 1/n was obtained 0.9584 by Freundlich isotherm equation. Regardless of the initial concentration of Pb. the adsorbed amount of Pb as well as the adsorption efficiency were increased with increasing pH values and converged to a certain constant value above 8 of pH values. And also the adsorbed amount of Pb increased with the mixing ratio, but its efficiency increased with the mixing ratio up to 8 and then showed the decreasing tendency above that.

• Analytical Science and Technology
• /
• v.17 no.2
• /
• pp.153-162
• /
• 2004

Dioxin CRM for QA/QC was prepared with fly ash collected from municipal waste incinerator. With that CRM inter-laboratory test was carried out. The collected fly ash was conducted several homogeneity steps including sievings and mixing. Homogeneity test and estimation of uncertainty was performed by one-way ANOVA based on ISO guide 35. Compared concentrations of fly ash of participants to CRM values, PCDDs value was lower than that of CRM in almost participants, and showed higher PCDFs concentration than that of CRM. Although there is a small difference in PCDD/Fs concentrations with congeners of extract, the result was close to mean value.

• Journal of Environmental Science International
• /
• v.10 no.4
• /
• pp.311-314
• /
• 2001

The asphalt mixture with CRM(Crumb Rubber Modifier) is known to show a better performance in resisting thermal cracking, fatigue cracking and rutting compared with the conventional mixture. The laboratory tests on the physical characteristics of indirect tensile strength, density, flow and Marshall value of the CRM asphalt were conducted. The test results show that CRM asphalt has better physical characteristics than that of conventional asphalts. And the analysis on the noise reduction effect, penetration capacity from the field test on the national road in Haksan of Chungbuk, and recycling of tire waste were conducted. From this study, the results show that 1% CRM asphalt has higher the noise reduction effect and penetration capacity that those of conventional asphalts. And, optimal contents of crumb rubber modifier in the asphalt binder is one percent. In this case, crumb rubber modifier were used 10 kg to make the asphalt binder of one cubic meter. So it was named as Eco-asphalt.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.43 no.2
• /
• pp.122-131
• /
• 2001

When mixed with lime, sand-bentonite mixture is characterized by considerable hydraulic properties similar to natural pozzolans and may therefore be increased in the strength of sand-bentonite mixture. The present study reports that results obtained in a series of laboratory tests carried out using particular mixing ratio of lime-sand-bentonite with the aim of investigating physical characteristics, permeability and strength. The results were compared and analyzed according to hydration time and lime content. Test results showed that increasing of strength and decreasing of permeability by proper lime content. Curing for longer periods increased unconfined compressive strength of mixture. Based on results of the falling head permeability test, mixtures of lime content 3%, 6% and 9% were satisfied in using as liner after 8-day curing periods.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.1 no.3
• /
• pp.163-172
• /
• 2013

This paper presents a comprehensive review of recent advances in ultra-high performance concrete (UHPC). Fundamental characteristics of UHPC are elaborated with focus on its material constituents, mixing, and formulation procedures. Use of state-of-the-art materials such as carbon nanotubes or nano-silica is discussed as well, whose inclusion may enhance the performance of UHPC. The review evaluates supplementary treatment methods (e.g., pressuring curing) and identifies applicable standard test methods for determining the properties and behavior of UHPC. Site implementation is provided to link laboratory research with full-scale application. Research needs are suggested to further develop UHPC technologies from technical and socio-economical perspectives.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1997.06c
• /
• pp.1.1-16
• /
• 1997

This lecture summarizes the progress of the development of the different ground improvement techniques in Bangkok Plain and is reviewed in relation to the extensive deep wen pumping and the resulting piezometric drawdown at deeper depths. Case records of test embankments with sand drains, sand wicks and PVD are presented to inustrate the effectiveness of different types of vertical drains with surcharge. The use of prefsbicated drain seems more superior than the other types of sand drain. Construction of test embaxlkment, criteria for PVD selection and relevant laboratory testing techniques are discussed for formulating the specif'ication. Alternative teckuuque, such in, the use of deep chemical mixing is reviewed in terms of the efficiency of cement, lime and flyash as additive. Vacuum pre-loading with surcharge and elctro- osmotic consolidation are also explored as possible tectmiques to improve the engineering properties of soft Bangkok clay.