• Journal of the Korean Ceramic Society
• /
• v.44 no.12
• /
• pp.696-702
• /
• 2007

The family of (Sr,Mg)-doped $LaGaO_3$ compounds, which exhibit high ionic conductivity at $600-800^{\circ}C$ over a wide range of oxygen partial pressure, appears to be promising as the electrolyte for intermediate temperature solid oxide fuel cells. Conventional synthesis routes of (Sr,Mg)-doped $LaGaO_3$ compounds based on solid state reaction have some problems such as the formation of impurity phases, long sintering time and Ga loss during high temperature sintering. Phase stability problem especially, the formation of additional phases at the grain boundary is detrimental to the electrical properties of the electrolyte. From this point of view, we focused to synthesize single phase (Sr,Mg)-doped $LaGaO_3$ electrolyte at the stage of powder synthesis and to apply relatively low heat-treatment temperature using novel synthesis route based on combustion method. The synthesized powder and sintered bulk electrolytes were characterized by XRD, TG-DTA, FT-IR and SEM. AC impedance spectroscopy was used to characterize the electrical transport properties of the electrolyte with the consideration of the contribution of the bulk lattice and grain boundary to the total conductivity. Finally, relationship between synthesis condition and electrical properties of the (Sr, Mg)-doped $LaGaO_3$ electrolytes was discussed with the consideration of phase analysis results.

• Proceedings of the Korean Ceranic Society Conference
• /
• 2000.04a
• /
• pp.117.2-117.2
• /
• 2000

• Proceedings of the Korean Ceranic Society Conference
• /
• 2002.10a
• /
• pp.121.2-121
• /
• 2002

• Journal of the Korean Ceramic Society
• /
• v.42 no.9 s.280
• /
• pp.637-644
• /
• 2005

In order to find a proper buffering material which can prohibit an unwanted interfacial reaction between anode and electrolyte of LSGM-based SOFC, we examined a gadolinium doped ceria and scandium doped zirconia as a candidate. For this examination, we investigated the microstructural and phase stability of the interface under different buffering layer conditions. According to the investigation, ceria based material induced a serious La diffusion out of the LSGM electrolyte resulted in the formation of very resistive $LaSrGa_3O_7$ phase at the interface. On the other hand zirconia based material was directly reacted with LSGM electrolyte and thus produced very resistive reaction products such as $La_2Zr_2O_7,\;Sr_2ZrO_4,\;LaSrGaO_4\;and\;LaSrGa_3O_7$. From this study we found that an improper buffering material induced the higher internal cell resistance rather than an interfacial stability.

• Journal of the Korean Ceramic Society
• /
• v.48 no.5
• /
• pp.479-484
• /
• 2011

In this paper, investigations of thick film $La_{0.75}Sr_{0.25}Ga_{0.8}Mg_{0.16}Fe_{0.04}O_{3-{\delta}}$ (LSGMF) cells fabricated via spin coating on either NiO-YSZ anode or $La_{0.7}Sr_{0.3}Ga_{0.6}Fe_{0.4}O_3$ (LSGF) cathode substrates are presented. A La-doped $CeO_2$ (LDC) layer is inserted between NiO-YSZ and LSGMF in order to prevent reactions from occurring during co-firing. For the LSGF cathode-supported cell, no interlayer was required because the components of the cathode are the same as those of LSGMF with the exception of Mg. An LSGMF electrolyte slurry was deposited homogeneously on the porous supports via spin coating. The current-voltage characteristics of the anode and cathode supported LSGMF cells at temperatures between $700^{\circ}C$ and $850^{\circ}C$ are described. The LSGF cathode supported cell demonstrates a theoretical OCV and a power density of ~420 mW $cm^2$ at $800^{\circ}C$, whereas the NiO-YSZ anode supported cell with the LDC interlayer demonstrates a maximum power density of ~350 mW $cm^2$ at $800^{\circ}C$, which decreased more rapidly than the cathode supported cell despite the presence of the LDC interlayer. Potential causes of the degradation at temperatures over $700^{\circ}C$ are also discussed.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.23 no.1
• /
• pp.37-43
• /
• 2013

Conductivity of LSGMC materials were affected by secondary phase segregation, composition and synthetic route. $La_{0.8}Sr_{0.2}Ga_{0.8}Mg_{0.1}Co_{0.1}O_{3-{\delta}}$ (LSGMC) powders were prepared using the glycine nitrate process to produce high surface area and compositionally homogeneous powders. The powders were synthesized with different 0.5, 1, 1.5, 2, 2.5 of glycine/cation molar ratios. A single perovskite phase from the synthesized powders was characterized with X-ray diffraction patterns. The obtained sintered pellets showed the dense grain microstructure. In case of 1.5 molar ratio, its density was higher than the others. The electrical conductivity measured at $800^{\circ}C$ was observed to be 0.131 $Scm^{-1}$. In addition, the linear thermal expansion behavior was indicated between $25^{\circ}C$ and $800^{\circ}C$.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1997.06a
• /
• pp.145-145
• /
• 1997

Recent progress of electric technology requires new piezoelectric crystals having superior properties such as zero temperature coefficients and large electromechanical coupling factors. We have developed a series of new leading chandidates, La$_3$Ga5SiO14(langasite, LGS), La3Nb0.5Ga5.5O14(LNG), La3Ta0.5O14(LTG), to satisfy those requirements. High quality LGS, LNG and LTG single crystals, with dimensions of 2 inches in diameter, were successfully grown by the Czochralski method at a pulling rate of 1mm/h. Since no variation of chemical composition was observed when whole melt in a crucible was crystallized, congruency of these compositions was confirmed. Physical constants such as elastic constants, dielectric constants and piezoelectric constants were measured. Filters and oscillators made of grown LGS, LNG and LTG single crystals showed superior properties such as three times wider passband than that of quartz, low insertion loss and easy processing, Langasite family crystals were shown to be superior materials to other known materials such as quartz, LiTaO$_3$, $\alpha$-AlPO$_4$ and Li$_2$B$_4$O7.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.5
• /
• pp.470-474
• /
• 1999

We have successfully grown <111>-oriented $(La,Sr)(Al,Ta)O_{3}\;(LSAT)$ mixed-perovskite single crystals and <0001>-oriented ${Ca_{8}La_{2}(PO_{4})}_{6}O_2$ (CLPA) single crystals with the apatite structure by the Czochralski method. The compositional and lattice parameter uniformity of the crystals are discussed in relation to the growth conditions. Since LSAT and CLPA single crystals have excellent lattice matching with GaN, they are promising as new substrates for the growth of high quality GaN epitaxial layers.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1998.09a
• /
• pp.73-77
• /
• 1998

Langasite(La3Ga5SiO14) is a new piezoelectric material which is similar to quartz, LN(LiNbO3) and LT(LiTaO3) in its acoustic behavior. In this study, pure Langasite and Langasite family groups were synthesized by the solid state reactions in air. For the synthesis process, diffusion species were investigated and sintered body of synthesized powders were studied on dielectric property according to surface microstructures.

• Proceedings of the Korean Ceranic Society Conference
• /
• 2000.04a
• /
• pp.72.2-72.2
• /
• 2000