• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.1
• /
• pp.109-113
• /
• 2011

This paper analyzes the noise sources of an LED lighting module with TRIAC dimming control and proposes an improved EMI filter design for the reduction of conducted noise emission. TRIAC dimming invokes problems of input oscillation and capacitor overvoltage at the lighting module. The proposed double LC filter reduces high noise level from the circuit. The experimental and simulation results show that this approach can make significant contributions to the reduction of conducted noise emission from an LED lighting module with TRIAC dimming control.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.2 no.4
• /
• pp.59-64
• /
• 2009

In this paper, we represent characteristics and equivalent circuit of donut type resonator of defected ground structure (DGS), and can control resonant frequency with chip capacitor. In General, DGS operates like with parallel LC resonator. We found out variation of resonance frequency when capacitor is placed on slot of DGS. If the chip capacitor replace with varactor diode, the resonance frequencies can be controlled by voltage. This tualable resonator can apply to voltage controlled oscillator and tunable bandpass filter.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.2
• /
• pp.150-159
• /
• 2016

This paper presents a study on the design optimization of a 5 kW plasma discharger for driving plasma reactor. The proposed study is composed of a high-frequency inverter based on the full-bridge circuit using soft switching techniques for high-frequency switching. The switching frequency in the operating region is the area of 130-200 kHz. By applying the LC resonance technique and a variable switching frequency, control technique is designed to be stable under changes in the load characteristics of the plasma reactor. This paper presents a quantitative analysis technique for design optimization. Experiments are performed according to load characteristic variations depending on the vacuum of the plasma reactor. This paper has verified the topology and design method for the 5 kW plasma discharger design.

• 전기의세계
• /
• v.27 no.3
• /
• pp.43-46
• /
• 1978

The prezoelectric ceramic specimen compoxed of PbO, ZrO$_{2}$, TiO$_{2}$ were prepared in this Lab, and showed properties of dielectric constant .epsilon.$^{33}$ /.epsilon.$_{0}$ 487 at 1kHz, electromechanical coefficient Kr 0.524. As the characteristics of piezoelectric HF filter used these piezoelectric specimen were the resonant point 6.7 MHz, effective bandwidth 690KHz, it was exellant. Since a LC resonant filter can be replaced bt this piezoelectric HG filter, it will greatly contribute to compose a compact circuit. If the resont point can be controlled, this piezoelectric HF filter practically.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.11 no.1
• /
• pp.59-64
• /
• 2011

A low noise and low power RF front-end for 5.8 GHz DSRC (Dedicated Short Range Communication) receiver is presented. The RF front-end is composed of a single-to-differential two-stage LNA and a Gilbert down-conversion mixer. In order to remove an external balun and 5.8 GHz LC load tuning circuit, a single-to-differential LNA with capacitive cross coupled pair is proposed. The RF front-end is fabricated in a 0.13 ${\mu}m$ CMOS process and draws 7.3 mA from a 1.2 V supply voltage. It shows a voltage gain of 40 dB and a noise figure (NF) lower than 4.5 dB over the entire DSRC band.

• Journal of IKEEE
• /
• v.19 no.4
• /
• pp.465-471
• /
• 2015

An LC-tuned sinusoidal voltage-controlled oscillator (VCO) using temperature-stable linear operational transconductance amplifiers (OTAs) is presented. Its architecture is based on Hartley oscillator configuration, where the inductor is active one realized with two OTAs and a grounded capacitor. Two diode limiters are used for limiting amplitude. A prototype oscillator built with discrete components exhibits less than 3.1% nonlinearity in its current-to-frequency transfer characteristic from 1.99 MHz to 39.14 MHz and $220ppm/^{\circ}C$ frequency stability to the temperature drift over 0 to $75^{\circ}C$. The total harmonic distortion (THD) is as low as 4.4 % for a specified frequency-tuning range. The simulated phase noise of the VCO is about -108.9 dBc/Hz at 1 MHz offset frequency in frequency range of 0.4 - 46.97 MHz and property of phase noise of VCO is better than colpitts-VCO.

• Proceedings of the KIPE Conference
• /
• 2017.07a
• /
• pp.264-265
• /
• 2017

본 논문에서는 3상 220V/5kVA 소프트스위칭 인버터의 새로운 회로구성을 제안하고 그 동작과 성능을 분석한 내용을 기술하고 있다. 제안하는 소프트스위칭 인버터는 ARCP(Auxiliary Resonant Commutated Pole) 인버터의 회로구성과 유사한 구조이나 이와 달리 LC 공진회로와 Diode 클램프 회로로 구성되어 있다. 이론적인 분석과 실험을 통해 제안하는 인버터의 효율을 분석하고 이를 하드스위칭 인버터와 비교하여 약 1% 정도의 효율 개선이 가능함을 알 수 있었다. 제안하는 인버터는 소프트 스위칭을 위해 소프트스위칭 보조회로와 게이트 드라이버가 추가로 장착되는 점에서 비용적인 경쟁력이 떨어질 수 있다. 그러나 최근 수요가 급증하고 있는 인버터에서 1% 효율 차이는 전력수급의 효율화를 통해 비용 측면에서 경쟁력을 갖을 것으로 판단된다. 또한 소프트스위칭 회로의 컴팩트화와 하드웨어의 최적화된 물리적 배치를 통해 추가의 효율증대가 가능할 것으로 보인다.

• Proceedings of the KIPE Conference
• /
• 2001.07a
• /
• pp.589-593
• /
• 2001

This paper presents a high frequency modulation electronic ballast for the metal halide lamp. As the proposed ballast operates in high frequency ranges (20kHz - 100kHz) and it can start up the lamp using the LC resonant circuit without external igniter, the proposed ballast is very compact. The proposed ballast is controlled with the modulated frequency in the range of 20kHz to 100kHz, and it has variable modulating frequencies between 200Hz and 2kHz in order to avoid the acoustic resonance phenomenon. In this paper, a new realtime acoustic resonance detection method is described and the experimental results with the proto-type ballast of 150W metal halide lamp with the dimming function are discussed.

• Proceedings of the KIPE Conference
• /
• 2001.07a
• /
• pp.576-579
• /
• 2001

In this paper, the development of the LF power supply for dry scrubber is discussed. 1500kW, 100kHz LF power supply is designed and tested. The main power stage is used for the FB PWM inverter with an LC filter in the secondary circuit. The operation characteristics of LF power supply are verified by simulation and experimental results.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.6 no.5
• /
• pp.394-399
• /
• 2001

In this Paper, the development of the power supply for dry scrubber is discussed. 1500w, 100kHz power supply Is designed and tested. The main power stage is used for the FB PWM inverter with an LC filter in the secondary circuit. The operation characteristics of power supply are verified by simulation and experimental results.