• The Journal of Engineering Geology
• /
• v.15 no.1
• /
• pp.29-39
• /
• 2005

For detecting a ground contamination survey, soil sampling method have been used a drilling or coring technique in general. However these methods are very difficult to systematically real-time monitoring of variation of contamination degree in field. ]'n this research frequency Domain Reflectometry (FDR) system was suggested and carried out to experimental approaches for determination of oil contamination on surface and underground. Experimental method using FDR method was discussed with feasibility of measurement in the laboratory column test. It is determined to degree of oil contamination due to response of dielectric constant re-lated with volumetric water content(θ/sub w/) and volumetric oil content( θ/sub al/ ) of saturated and unsaturated soil media. And physical properties such as effective porosity and oil residual ratio of saturated soil media were also measured through real-time monitoring works using installed FDR measurement sensors, which are defected characteristics of oil movement in the saturated soil media under the soil column tests. In the results of these experiments, a range of effective porosity was estimated to about 0.35 compared with initial porosity 0.40 of manufactured saturated soil media, which is also calculated to about 87.5% to the ratio of initial porosity to effective porosity. Finally oil residual ratio which is compared with volumetric water content and volumetric oil content was calculated about 62.5%.

• Korean Journal of Agricultural Science
• /
• v.43 no.4
• /
• pp.634-640
• /
• 2016

The objective of this study was to evaluate the effectiveness of using HR-GC/MS for the rapid screening of dieldrin residues in soils. Persistent organic pollutants (POPs) of organochlorine pesticides such as dieldrin, were analyzed in sedimentary rock and granite rock collected from greenhouses, Niigata, Japan. Dieldrin remains in Japanese farming soils, more than 40 years after their use as insecticides was prohibited. The averages in soil moisture ranged from 2.79% to 7.20% in soils derived from sedimentary rock and from 25.59% to 31.40% in soils derived from granite rock. Mean concentrations of dieldrin residues in sedimentary rock and granite rock were $39.7ng\;g^{-1}$ and $40.51ng\;g^{-1}$, respectively. Dieldrin residue was detected at a slightly higher concentration in granite rock than sedimentary rock samples. There was no consistency between the two soils or between surface and subsurface soils. The coefficients of variation of the two soils were 10.6% and 8.7%, respectively. These results suggest that our high-resolution mass spectrometry detector (HR-GC/MS) is effective at analyzing residual organochlorine pesticides in soil. In order to increase the precision and sensitivity for chemical analysis of POPs, high-resolution gas chromatography coupled with a HR-GC/MS is highly recommended.

• Journal of Environmental Science International
• /
• v.15 no.3
• /
• pp.279-286
• /
• 2006

Electrokinetic technique was considered in removing arsenic from the abandoned mining tails. In order to estimate the removal characteristics of arsenic, the sequential extraction analysis and desorption experiment were carried out prior to the application of electrokientic process. The result of sequential extraction analysis indicated that the water soluble and exchangeable fraction, easily leachable to ground water, were very low as much as about 2.5% and the fraction except residual (38.3%), possibly extractable under very acidic or alkalic environment, was about 59%. In the result of desorption test using four different kinds of electrolytes, the mixture of citric acid and sodium dodecyl sulfate (SDS) showed the highest desorption efficiency as much as 77.3%. The removal efficiencies of arsenic from mining tailings by electrokinetic process under the different electrolyte environments were slightly low and resulted in the following order: citric acid + SDS (18.6%) > 0.1 $NHNO_3$ (8.1%) > HAc (7.4%) > Distilled water(6.6%). Also, arsenic in soil matrix was moved favorably in the direction of anodic rather than cathodic region, which is opposite trend with cationic metal ions generally existing in soil, because anionic form of arsenic is dominated in acidic soil caused by the movement of acid front form anode.

• Journal of Wetlands Research
• /
• v.14 no.3
• /
• pp.365-374
• /
• 2012

Due to the wide use of feed additives on pig farms, large content of heavy metals and antibiotics have been found in piggery wastes. More than 90 % of piggery wastes were applied to crop field in Korea. The metals and antibiotics originated from piggery waste in the soil may affect plant growth and human health. To examine the adsorption capacity and residual ratio of heavy metals and antibiotics to the soil, a couple of jar test and leaching tests were conducted. While 86.4 % of zinc and 68% of copper applied were adsorbed to soil particles, while over than 60% of antibiotics in pig manure liquid fertilizer were leaked out to effluent.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.9 no.1
• /
• pp.89-95
• /
• 1989

In this study, it is attempted to examine (1) the residual deformation and elastic deformation induced from the repeated loads (up to the maximum of 100,000 times) on fully compacted soil specimen, the relation between stress and strain by performing the unconfined compressive test, after repeated loads and (2) the effect of water content, dry density, number of cycle, repeated loads, etc. on the effect of the stress-strain relation. The rate of deformation caused by repeated loads greatly depends on to the condition whether the water content is above or below the plastic limit. It is possible to estimate the initial tangent modulus of soil by means of modulus of elastic deformation obtained by putting repeated loads on the clay soil.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2003.11a
• /
• pp.501-503
• /
• 2003

Soil-gas radon level and other atmospheric factors have been measured at residual soil profiles that overlie granite bedrock which consists of major geology in Korea for 6 months from November, 2000 to April, 2001. Seasonal variations of soil-gas radon concentration are generally of greater magnitude than day-to-day fluctuations. The highest radon concentrations of 5,131 pCi/L measured during winter season and the lowest radon concentrations of 107 pCi/L during spring season. Two study areas, Bongcheon-dong(granite bedrock) and Seongnam-Yongin(gneiss bedrock) were investigated to assess the radon potential according to their field survey and emanation tests. The mean values of radon decrease in sequentially from Suji-A(813 pCi/L)>Suji-B(757 pCi/L)>Bundang-B(691 pCi/L)>Bundang-A(643 pCi/L)>Bongcheon-dong(513 pCi/L). Estimated soil-gas radon potential using maximum radon emanation ratios of each study area decreases in the order of Bongcheondong(950 pCi/L)>Suji-B(524 pCi/L)>Bundang-A(437 pCi/)>Bundang-B(259 pCi/L)>Suji-A(230 pCi/L) areas. The values of indoor radon and its daughter product concentrations in Bongcheon-dong area show that indoor basement rooms in poor ventilation condition could be classified as extremely high radon risk location of more than 4 pCi/L Rn and 0.02 WL.

• Journal of Korea Soil Environment Society
• /
• v.3 no.2
• /
• pp.53-60
• /
• 1998

The influence of venting on the leaching characteristics of pure gasoline and gasoline contaminated soil was studied. The change of leaching characteristics by venting of contaminated soil column could be characterized by two distinct trends : 1) the leaching concentration in TPH-GRO rapidly decreased with evaporation until the evaporation loss became 75% of the original volume. Afterwards, it gradually decreased. 2) the leaching concentrations of individual components showed initial increase followed by gradual decrease. In general, the relative increase of leaching concentration and the venting time to reach the maximum increased with the molecular weight of the components. It should be noted that the decrease of gasoline concentration in the vented air occurs faster than that in the leaching solution. This indicates that, after removing most of the gasoline by evaporation, the focus of the risk assessment for the residual contaminants should be on the groundwater contamination rather than air pollution.

• Applied Biological Chemistry
• /
• v.31 no.2
• /
• pp.200-204
• /
• 1988

This study was conducted to evaluate effect of soil texture, organic matter, temperature and water regime on degradation of pretilachlor (2-chloro-2',6'-diethyl-N-(n-propoxyethyl) acetanilide) in the soils. The period of residual activity in soil treated with pretilachlor at rate of 60g a.i./10a was about 50 days. Also, period of reaching GR 50 value on the barnyard grass was about $25{\sim}27$ days. Degradation rate of pretilachlor in the sandy clay loam soil which has higher contents of organic matter and clay was faster than in the sandy loam soil. When organic matter was added to the soil, the rate of decomposition was accelerated. The faster degradation occurred under the $30^{\circ}C$ soil temperature by comparison under the $20^{\circ}C$. The rate of degradation in the soil was faster under the flooded conditions than under the wetted conditions.

• Journal of Soil and Groundwater Environment
• /
• v.13 no.3
• /
• pp.59-66
• /
• 2008

A biological study was conducted to evaluate the enhancement of landfarming of soil contaminated with petroleum hydrocarbon (TPH) applying organic composite nutrients and a chemical oxidation during bioremediation. The target value of soil TPH after treatment was 500 mg/kg TPH. Addition of an organic compost and liquid swine manure for the removal of soil THP showed higher efficiency as 84.4% and 92.2% respectively than inorganic nutrients of 80.2%. In addition to the removal of non-biodegradable portion of residual hydrocarbons in soil, a chemical oxidation was applied during tailing period of the biological remediation, which showed high remediation efficiency as 98.1% compared with single bioremediation efficiency of 84.7%.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.1
• /
• pp.67-73
• /
• 2014

In this study, the residual heavy metals in the mine tailings, primarily treated by soil washing, were stabilized using phosphate salts. The concentrations of residual contaminants in the washed mine tailings were As (1,861 mg/kg), Cd (20 mg/kg), Cu (56 mg/kg), Pb (2,149 mg/kg), and Zn (633 mg/kg). They were stabilized with $CaHPO_4$, $Ca(H_2PO_4)_2{\cdot}H_2O$, and hydroxyapatite at 0.1 wt%, 1 wt%, and 10 wt% for 1, 3, 5, 7, and 14 days. It was found that 1 wt% $Ca(H_2PO_4)_2{\cdot}H_2O$ was optimum in our experiments, but the stabilization duration did not affect the efficiency. After stabilization with 1 wt% $Ca(H_2PO_4)_2{\cdot}H_2O$ for 1 day, the concentrations of arsenic and heavy metals, As (0.328 mg/L), Cd (0.250 mg/L), Cu (0.143 mg/L), Pb (0.359 mg/L), and Zn (2.622 mg/L), in TCLP leachate were below the RCRA-TCLP limits, which meant the contaminants in the treated mine tailings were stably immobilized.