• Korean Journal of Applied Biomechanics
• /
• v.13 no.2
• /
• pp.161-173
• /
• 2003

This study was performed to investigate the kinematic and kinetic differences between functional walking shoe(FWS) and general sports shoe(GSS). The subjects for this study were 4 male adults who had the walking pattern of rearfoot strike with normal feet. The movement of one lower leg was measured using force platform and 3 video cameras while the subjects walked at the velocity of 2/1.5 m/s. The findings of this study were as follows 1. The angle of lower leg-ground and angle of knee with FWS was greater than with GSS at the moment of strike the floor and the moment of second peak ground reaction force. The decreasing rate of angle of ankle was smaller in FWS from the strike phase to the second peak ground reaction force. These mean upright walking and round walking along the shoe surface. 2. The maximal Increased angle of Achilles tendon and the minimal decreased angle of rearfoot were smaller in FWS very significantly(p<0.001). Thus FWS prevent the excessive pronation of ankle and have good of rear-foot control. 3. The vortical ground reaction force and the rate of it to the BW were smaller in FWS statistically(p<0.001). The loading rate was smaller in FWS, too, and thess represent the reduction of load on ankle joint and prevention of injuries on it.

• Korean Journal of Applied Biomechanics
• /
• v.24 no.2
• /
• pp.181-187
• /
• 2014

In this study, a real-time evaluation system for quantitative dynamic fitting during pedaling was developed. The system is consisted of LED markers, a digital camera connected to a computer and a marker detecting program. LED markers are attached to hip, knee, ankle joint and fifth metatarsal in the sagittal plane. Playstation3 eye which is selected as a main digital camera in this paper has many merits for using motion capture, such as high FPS (Frame per second) about 180FPS, $320{\times}240$ resolution, and low-cost with easy to use. The maker detecting program was made by using Labview2010 with Vision builder. The program was made up of three parts, image acquisition & processing, marker detection & joint angle calculation, and output section. The digital camera's image was acquired in 95FPS, and the program was set-up to measure the lower-joint angle in real-time, providing the user as a graph, and allowing to save it as a test file. The system was verified by pedalling at three saddle heights (knee angle: 25, 35, $45^{\circ}$) and three cadences (30, 60, 90 rpm) at each saddle heights by using Holmes method, a method of measuring lower limbs angle, to determine the saddle height. The result has shown low average error and strong correlation of the system, respectively, $1.18{\pm}0.44^{\circ}$, $0.99{\pm}0.01^{\circ}$. There was little error due to the changes in the saddle height but absolute error occurred by cadence. Considering the average error is approximately $1^{\circ}$, it is a suitable system for quantitative dynamic fitting evaluation. It is necessary to decrease error by using two digital camera with frontal and sagittal plane in future study.

• Korean Journal of Applied Biomechanics
• /
• v.21 no.5
• /
• pp.585-593
• /
• 2011

The purpose of this study was to analyze, from a kinematical point of view, the high jump techniques of three women's high jump winners at the IAAF World Championships, Daegu 2011. The trends for the techniques of the world's top high jumpers were examined, with a view toward adapting these techniques to the physical characteristics of Korean women's high jumpers. It was valuable that Di Martino, who was the shortest in height, was able to win a medal by using a single arm swing take-off technique, along with a half flexed leading leg swing to attain a deep arch and clear the bar. This showed that the world's top athletes used jumping techniques with no decrease in the run-up velocity at the take-off. Furthermore, It appeared that the knee joint angle at take-off had a direct effect on the body position at take-off (H1).

• The Journal of Korean Academy of Orthopedic Manual Physical Therapy
• /
• v.19 no.2
• /
• pp.55-60
• /
• 2013

Background: The purpose of this study was to determine if there is a difference in activation of the rectus femoris, vastus medialis oblique, vastus lateralis, semitendinosus, and biceps femoris when performing normal free squat with standinding position and free squat with $30^{\circ}$ flexed hip joint. Methods: Electromyograph surface electrodes were placed on the rectus femoris, vastus medialis oblique, vastus lateralis, semitendinosus, and biceps femoris of 19 healthy college students. The participants performed standing bilateral squats and standing bilateral squats with $30^{\circ}$ flexed hip joint with EMG measures taken upon initiation of muscle activity as confirmed by an electronic goniometer. Participants completed one trial with the EMG time measurements on each type. Results: There was a significant difference between normal squats(standing squats) and normal squats with $30^{\circ}$ flexed hip joint. The normal squat exercise was statistically higer than normal squat exercise with $30^{\circ}$ flexed trunk except for semitendinosus and biceps femoris that shown slightly high. Conclusions: As a result of this study, there were increases of muscle activity in both ways. In particular, it may be more beneficial for knee joint stabilization to perform normal squat exercise with standing position relatively.

• Journal of the Korea Safety Management & Science
• /
• v.14 no.4
• /
• pp.93-105
• /
• 2012

The purpose of this study was to investigate drivers' postures in different car pedal systems and skilled levels under fatigue. Twenty four subjects participated in this experiment. For three-dimensional analyses, six cameras (Proreflex MCU-240, Qualisys) were used to acquire raw data. The parameters were calculated and analyzed with Visual-3D. In conclusion, ROAs of two leg-pedal system were less than one leg pedal system by pattern analysis. Through statistical tests, skilled levels have effects on ROAs(X, Y, Z) of ankle joint at breaking a pedal and ROAs(Y, Z) of ankle joint at accelerating a pedal. Also, car pedal systems have effects on ROAs(Y, Z) of ankle joint, and ROA(Z) of knee joint at accelerating a pedal. In addition, skilled levels and car pedal systems (cross effects) have an effect on ROA(Z) of ankle joint. These findings suggested that we should improve a present single pedal system.

• Korean Journal of Applied Biomechanics
• /
• v.22 no.2
• /
• pp.201-208
• /
• 2012

The purpose of this study was to investigate the effect of leg extension exercises performed on outdoor resistance exercise machines on knee extension muscle strength and quadriceps muscle group cross sectional area (CSA) in elderly women. Two groups were recruited for this study, including an exercise group (EG: n=13, $71.38{\pm}2.79$ yrs) and a control group (CG: n=5, $73.4{\pm}5.94$), In all subjects, maximum isometric and isokinetic muscle strength of knee flexion and extension were measured using an isokinetic dynamometer (Cybex(R) Humac Norm Testing & Rehabilitation System, USA). Quadriceps muscle group CSA were measured using MRI (Philps, Intera 1.5 T, NE Netherlands). The results of this study showed that post-intervention isometric knee extension peak torque value were higher than pre-intervention measures in the EG. However, the EG did not show improvement in quadriceps muscle group CSA, Also, no differences in the shift of optimal knee joint angle were observed between pre and post-intervention exercise. Outdoor leg extension exercise showed small increases in muscle strength in comparison to other resistance training exercises. The results of this study suggest that because outdoor leg extension exercise machines lack a progressive loading mechanism, significant increases in muscle strength may not be obtained.

• Journal of the Korean Society of Physical Medicine
• /
• v.10 no.3
• /
• pp.95-100
• /
• 2015

PURPOSE: The purpose of this study is to investigate the effects of the angles of the knee and heel-off on the muscle activity during a bridge exercise. METHODS: 15 healthy adult men and women with the balance ability and joint working range required for performing a bridge exercise participated in this study, in which $120^{\circ}$, $90^{\circ}$ and $60^{\circ}$ angles of the knee-flexion and heel-off were applied during the bridge exercise. RESULTS: Our data showed that there were significant differences in muscle activities of elector spinae and rectus abdominis when $120^{\circ}$ and $60^{\circ}$ angles of the knee were applied, of internal oblique when $120^{\circ}$ and $60^{\circ}$ were applied, and external oblique when $90^{\circ}$ and $60^{\circ}$ were applied. When heel-off was applied, there were significant differences in muscle activities of elector spinae and rectus abdominis when $120^{\circ}$ and $60^{\circ}$ were applied, of internal oblique when $120^{\circ}$ and $60^{\circ}$ were applied, and external oblique when $90^{\circ}$ and $60^{\circ}$ were applied. CONCLUSION: In this study on an application of heel-off to the bridge exercise, we showed that the effect of the angles of the knee on the muscle activities of elector spinae, rectus abdominis, internal oblique and external oblique were all similar to the regular bridge exercise, but overall muscle activities were increased with heel-off when compared with the regular bridge exercise.

• Safety and Health at Work
• /
• v.13 no.3
• /
• pp.315-325
• /
• 2022

Background: Firefighters are required to carry self-contained breathing apparatus (SCBA), which increases the risk of musculoskeletal disorders. This study assessed the newly recruited firefighters' internal forces and potential musculoskeletal disorders when carrying SCBA. The effects of SCBA strap lengths were also evaluated. Methods: Kinematic parameters of twelve male subjects running in a control condition with no SCBA equipped and three varying-strapped SCBAs were measured using 3D inertial motion capture. Subsequently, motion data and predicted ground reaction force were inputted for subject-specific musculoskeletal modeling to estimate joint and muscle forces. Results: The knee was exposed to the highest internal force when carrying SCBA, followed by the rectus femoris and hip, while the shoulder had the lowest force compared to the no-SCBA condition. Our model also revealed that adjusting SCBA straps length was an efficient strategy to influence the force that occurred at the lumbar spine, hip, and knee regions. Grey relation analysis indicated that the deviation of the center of mass, step length, and knee flexion-extension angle could be used as the predictor of musculoskeletal disorders. Conclusion: The finding suggested that the training of the newly recruits focuses on the coordinated movement of muscle and joints in the lower limb. The strap lengths around 98-105 cm were also recommended. The findings are expected to provide injury interventions to enhance the occupational health and safety of the newly recruited firefighters.

• The Journal of Churna Manual Medicine for Spine and Nerves
• /
• v.17 no.2
• /
• pp.51-62
• /
• 2022

Objectives This case study aimed to investigate the effect of complex Korean medicine therapy and fascia Chuna therapy on Osgood-Schlatter disease. Methods Hospitalization treatment was performed on a 13-year-old Osgood-Schlatter patient who visited Woosuk University Korean Medicine Hospital. The patient complained of pain in both the tibial tuberosity and restriction on the range of knee joint movement. The results were evaluated using the visual analogue scale, knee injury and osteoarthritis outcome score, and range of motion. Results After treatment, knee pain decreased and range of movement angle improved. Conclusions This study suggests that complex Korean medicine therapy, including myofascial Chuna therapy, are effective in improving the range of motion and improving pain in early Osgood-Schlatter disease. The limitation of this study is that the subject of the study was limited to one case. Further clinical studies are required.

• Korean Journal of Applied Biomechanics
• /
• v.25 no.3
• /
• pp.363-370
• /
• 2015

Objective : The purpose of this study was to give the basic data for the cutting movement with the various angels on the poly urethane. Method : Ten healthy men voluntarily participated in this study. A three-dimensional motion analysis system (VICON) and force plates were used to analyze the movements of the joints for the lower extremities. For the statistical analysis the IBM SPSS 21.0 was used to perform repeated measured ANOVA and post-hoc comparison result was used to perform the Scheffe and the level of significance was set up at ${\alpha}=.05$. Results : There were significant differences for the time required for the increasing angles of the cutting movement(p<.05). In addition, there were significant differences for the maximum dorsiflexion, plantarflexion of ankle joint, maximum flexion of knee joint and hip joint with the increasing the angles of cutting movement(p<.05). Also, there were significant differences for the maximum adduction and abduction angle of the hip joint with the increasing of the angles of cutting movement. There was signigicant difference for the resultant utilized coefficient of friction(RuCOF) for the increasing angles of cutting movement(p<.05). Conclusion : There was a pattern to increase the coefficient friction with the angle of cutting direction. Also, it would be possible to use the poly urethane for the outdoor floor with the results of this study.