• Proceedings of the Korean Magnestics Society Conference
• /
• 1992.03a
• /
• pp.56-57
• /
• 1992

• Journal of Environmental Science International
• /
• v.12 no.1
• /
• pp.41-45
• /
• 2003

Magnetite powder for kerosene-based ferrofluid was synthesized by air oxidation of waste acid containing $Fe^{2+}$ and $Fe^{3+}$ ions in the pH=11 at $60^{\circ}C$. Stable kerosen-based ferrofluid was prepared by addition of polyoxyethylene nonylphenyl ether(POENPE) to the magnetite containing water. Dispersion mechanism of an addition POENPE to the magnetite was examined by means of the fraction of solid dispersed FT-IR spectrum. And magnetic properties of kerosen-based ferrofluid were examined by method of Vibrating Sample Magnetometer. In order to remove oil on the water surface by an addition of kerosen-based ferrofluid, the optimum conditions were examined.

• Journal of the Korean Ceramic Society
• /
• v.53 no.2
• /
• pp.241-245
• /
• 2016

The purpose of this study was to investigate the bloating mechanism of artificial lightweight aggregates with different sizes (ESA, effective surface area). Aggregates were produced using hard clay, stone sludge, and a bloating agent in order to observe the effect of the gradation of the artificial lightweight aggregates. Kerosene and amorphous carbon were used as bloating agent. The particle size of the produced aggregate ranged from 3 mm to 9 mm. With regard to the amount of bloating agent to be used, 2 ~ 6 parts by weight were used. The specific gravity, absorption rate, and the type of aggregates produced by rapid sintering at $1075{\sim}1200^{\circ}C$ were determined. Microstructures were observed. When ESA had a value of 1 or below, kerosene, which has a high burning rate, was found to be advantageous for use as a bloating agent. When ESA had a value of 1 or above, carbon, which has a relatively low burning rate was found to be an advantageous bloating agent. It is thought that kerosene is more advantageous, as ESA decreases, for the production of aggregates having low water absorption rate.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.31 no.3
• /
• pp.65-71
• /
• 2003

In this research, we make the thin wall chamber to the measurement of heat flux of using a Kerosene/LOx liquid rocket engine's thrust chamber. The wall thickness is one millimeter. We measured outside wall temperature of thrust chamber by nine thermocouple. We suppose the system to the one-dimension unsteady state, and so the heat flux and heat transfer coefficient of thurst chamber are calculated using one-dimensional the transient energy equation by outside wall temperature. In this case, O/F ratio is 2.0, experimental variation is chamber pressure and we got the heat transfer coefficient of the proportion relation of 0.88 times for the chamber pressure.

• Korean Chemical Engineering Research
• /
• v.49 no.4
• /
• pp.417-422
• /
• 2011

The low temperature pyrolysis of ABS resin has been carried out in a batch reactor under the atmospheric pressure. The effect of the reaction temperature on the yield of pyrolytic oils has been determined in the present study. The oil products formed during pyrolysis were classified into gas, gasoline, kerosene, gas oil and heavy oil according to the petroleum product quality standard of Ministry of Knowledge Economy. The conversion reaches 80% after 60 min at $500^{\circ}C$ in the pyrolysis of ABS resin. The amount of the final product was ranked as gas heavy oil > gasoline > gas oil > kerosen based on the yield. The yields of heavy oil and gas oil increase with an increase in the reaction time and temperature.