• 한국수소및신에너지학회논문집
• /
• 제27권5호
• /
• pp.604-611
• /
• 2016

This paper describes the characteristics of n-Butane fuel for the homogeneous charge compression ignition (HCCI) engine for a new concept. HCCI engines are being considered as a future alternative for diesel and gasoline engines. From the experimental observations, the effect of n-Butane fuel in HCCI engine on CO, HC and NOx are analysed. The objective of this paper is to clear the effects of equivalence ratio and inlet temperature with n-Butane on the HCCI. For this purpose, a 4-cylinder, compression ignition engine was converted into a HCCI engine This work has been run with n-butane fuel at a constant speed.

• 한국수소및신에너지학회논문집
• /
• 제27권5호
• /
• pp.503-509
• /
• 2016

Fuel cell is a device for producing electricity by using the hydrogen produced by the fuel processor. At this time, CO is also created by the fuel processor. The resulting CO enters the stack where is produce electricity and leads to the adsorption of anode catalyst, finally the CO poisoning occurs. Stack which occurred CO poisoning has a reduction in performance and shelf life are gradually fall because they do not respond to hydrogen. In this paper, experiments that using a PROX reactor to prevent CO poisoning were carried out for removing the CO concentration to less than 10ppm range available in the fuel cell. Furthermore experiments by the PROX reaction was designed and manufactured with a water-cooling heat exchange reactor to maintain a suitable temperature control due to the strong exothermic reaction.

• 한국수소및신에너지학회논문집
• /
• 제27권5호
• /
• pp.471-477
• /
• 2016

In this research, the Ir supported $TiO_2$ (P25) catalyst was prepared by precipitation method for oxygen evolution reaction. The $Ir/TiO_2$ catalyst was synthesised by reduction reaction using reducing agent. Physiochemical characterizations of synthesized $Ir/TiO_2$ catalyst was studied by means of SEM, EDS mapping, TEM and XRD. The Electrochemical characterizations were tested by using the technique of CV and LSV by RDE and Potentiostat. Physicochemical properties were characterized with XRD where Iridium metal morphology and Ir(111) and Ir(222) peaks were founded. $Ir0.2Ru0.8O_2$ exhibited higher OER activity than $Ir0.5Ru0.5O_2$ followed by $Ir/TiO_2$ and $IrO_2$.

• 한국수소및신에너지학회논문집
• /
• 제27권5호
• /
• pp.526-532
• /
• 2016

In this study, we synthesized a mediator immobilized biocatalyst([FCA/GOx]/PEI/CNT) by surface modification using ferrocene carboxylic acid(FCA), and evaluated its performance as anode catalyst for biofuel cell. Through the application of FCA on glucose oxidase (GOx), the free amine groups on the lysine residue of GOx surface reacted with carboxylic acid of FCA and make amide bond between GOx and FCA. As the result of that, the electron transfer of catalyst was increased up to 1.91 times($0.468mA{\cdot}cm^{-2}$) than the catalyst without surface modification (GOx/PEI/CNT), and high maxium power density of $1.79mA{\cdot}cm^{-2}$ was gained.

• 한국수소및신에너지학회논문집
• /
• 제27권5호
• /
• pp.533-539
• /
• 2016

This study was performed to evaluate the characteristics of start-up of anaerobic digestion from food waste with different inoculum ratios. The hydrogen yield was similar with different inoculum ratios. The hydrogen production rate increased with increasing inoculum ratio. But the specific hydrogen production rate decreased with increasing inoculum ratio. Total volatile fatty acids composition analysis showed that butyrate and acetate were the prevalent products in all reactors, followed by lactate and propionate. The acetate was most prevalent product in reactors at $X_0/S_0=0.080$ and 0.159. But in reactors at $X_0/S_0=0.239$ and 0.318, butyrate accounted for greater than 50% of the total volatile fatty acids.

• 한국수소및신에너지학회논문집
• /
• 제27권5호
• /
• pp.478-484
• /
• 2016

Polyether ether ketone (PEEK) composite membranes have been intensively investigated for polymer electrolyte membrane water electrolysis (PEMWE). Covalently linked (CL) sulfonated polyether ether ketone (SPEEK) and cellulose polymer composite membranes were prepared and characterized. Polyether ether ketone (PEEK) and cellulose were sulfonated and then were covalently linked by 1,4-diiodobutane to produce covalently linked SPEEK and cellulose polymer composite membranes. The composite membranes showed better thermostability and electrochemical properties than SPEEK. The membranes were prepared by sol-gel casting method. CL-SPEEK/Cellulose composite membrane featured 0.2453 S/cm of proton conductivity at $80^{\circ}C$ which was better than that of Nafion.

• 한국수소및신에너지학회논문집
• /
• 제31권2호
• /
• pp.202-209
• /
• 2020

In methanol steam reforming, commercial catalysts in the form of pellets are mainly used, but there are limitations to directly apply them to underwater weapon systems that require shock resistance and heat transfer characteristics. In this study, to overcome this problem, a multi-layer cup structure (MLCS) was applied to support a pellet type catalyst. The characteristics of pellet catalyst supported by MLCS and the pellet catalyst supported by conventional structure (CS) were compared by the reforming experiment. In the case of MLCS, a high methanol conversion rate was shown in the temperature range 200 to 300℃ relative to the CS manufactured with the same catalyst weight as MLCS. CS shown similar characteristics to MLCS when it manufactured in the same volume as MLCS by adding an additional 67% of the catalyst. In conclusions, MLCS can not only reduce catalyst usage by improving heat transfer characteristics, but also support pellet catalyst in multiple layers, thus improving shock resistance characteristics.

• 한국수소및신에너지학회논문집
• /
• 제31권2호
• /
• pp.234-241
• /
• 2020

This paper presents a thermodynamic performance analysis of a combined cycle consisting of regenerative organic Rankine cycle (ORC) and liquefied natural gas (LNG) Rankine cycle to recover low-grade heat source and the cold energy of LNG. The mathematical models are developed and the system performances are analyzed in the aspect of thermodynamics. The effects of the turbine inlet pressure and the working fluid on the system performance such as the mass flow rates, heat transfers at heat exchangers, power productions at turbines, and thermal efficiency are systematically investigated. The results show that the thermodynamic performance of ORC such as net power production and thermal efficiency can be significantly improved by the regenerative ORC and the LNG cold energy.

• 한국수소및신에너지학회논문집
• /
• 제31권2호
• /
• pp.242-249
• /
• 2020

The Kalina cycle (KC) is considered as one of the most efficient systems for recovery of low grade heat. Recently, Kalina based power and cooling cogeneration cycles (KPCCCs) have been suggested and attracted much attention. This paper presents an energy and exergy analysis of a recently suggested KPCCC with flexible loads. The cycle consists of a KC (KCS-11) and an aqua-ammonia absorption refrigeration cycle. By adjusting the splitting ratios, the cycle can be operated with four modes of pure Kalina cycle, pure absorption cooling cycle, Kalina-cooling parallel cycle, and Kalina-cooling series cycle. The effects of system variables and the operating modes on the energetic and exergetic performances of the system are parametrically investigated. Results show that the system has great potential for efficient utilization of low-grade heat source by adjusting loads of power and cooling.

• 한국수소및신에너지학회논문집
• /
• 제31권2호
• /
• pp.184-193
• /
• 2020

One of the technical methods to increase the volumetric energy density of hydrogen is to pressurize the gaseous hydrogen and then contain it in a rigid vessel. Especially for automotive systems, the compressed hydrogen storage can be found in cars as well as at refueling stations. During the charging the pressurized hydrogen into a vessel, the temperature increases with the amount of stored hydrogen in the vessel. The temperature of the vessel should be controlled to be less than a limitation for ensure stability of material. Therefore, the accurate estimation of temperature is of significance for safely storing the hydrogen. In this work, three well-known cubic equations of state (EOSs) were adopted to examine the accuracy in regenerating thermodynamic properties of hydrogen within the temperature and pressure ranges for the compressed hydrogen storage. The formulations representing molar volume, internal energy, enthalpy, and entropy were derived for Redlich-Kwong (RK), Soave-Redlioch-Kwong (SRK), and Peng-Robinson (PR) EOSs. The calculated results using the EOSs were compared with literature data given by NIST. It was revealed that the accuracies of RK and SRK EOSs were satisfactorily compatible and better than the results by PR EOS.