• BMB Reports
• /
• v.39 no.3
• /
• pp.247-252
• /
• 2006

A rapid method for the detection of Hepatitis E Virus (HEV) was developed by utilizing nano-gold labeled oligonucleotide probes, silver stain enhancement and the microarray technique. The 5'-end -$NH_2$ modified oligonucleotide probes were immobilized on the surface of the chip base as the capture probe. The detection probe was made of the 3'-end -SH modified oligonucleotide probe and nano-gold colloid. The optimal concentrations of these two probes were determined. To test the detection sensitivity and specificity of this technique, a conservative fragment of the virus RNA was amplified by the RT-PCR/PCR one step amplification. The cDNA was hybridized with the capture probes and the detection probes on microarray. The detection signal was amplified by silver stain enhancement and could be identified by naked eyes. 100 fM of amplicon could be detected out on the microarray. As the results, preparation of nano-gold was improved and faster. Development time also was shortened to 2 min. Thus, considering high efficiency, low cost, good specificity and high sensitivity, this technique is alternative for the detection of HEV.

• Journal of Korea Foundry Society
• /
• v.17 no.3
• /
• pp.252-257
• /
• 1997

The 8 mm dia: Sn-38%Pb eutectic alloy rods were produced by use of the horizontal continuous casting process with the heated mold and chill cast process. The cast rods were rolled into 2.0${\sim}$0.5 mm thick plates and structural and mechanical properties were examined. The results revealed that the plates produced by the continuous casting process with the heated mold show much higher superplasticity at ambient temperature (1550% elongation at 0.5mm thick plate and 0.5mm/min strain rate) than the plates procuced by chill cast process (630% elongation). Such a high superplasticity of the continuous cast plates is due to the high-quality plates free from any inside and surface defects with fine and uniform distribution of eutectic phases.

• Preventive Nutrition and Food Science
• /
• v.13 no.3
• /
• pp.249-252
• /
• 2008

Flow behaviors of sweet potato starch (SPS) pastes (5% w/w) were studied in the presence of various sugars (xylose, glucose, fructose and sucrose) and sugar alcohols (xylitol and sorbitol). The flow properties of SPS-sugar mixtures were determined from the rheological parameters of power law model. The vane method was also employed for determining yield stresses of SPS-sugar mixtures directly under a controlled low shear rate. At $25^{\circ}C$ all the samples showed shear-thinning behaviors ($n=0.35{\sim}0.44$) with yield stress. The consistency index (K) values of SPS-sugar mixtures increased in the following order: sorbitol> xylitol> control (no sugar)> sucrose> fructose> glucose> xylose, showing that the addition of sugar alcohols enhanced the K values. The yield stress values were reduced in the presence of ugars and sugar alcohols and they also increased with an increase in swelling power of starch granules in the SPS-sugar mixture systems.

• Korean Journal of Veterinary Service
• /
• v.37 no.4
• /
• pp.247-252
• /
• 2014

The economic impact of swine mycoplasma infection is high. An accurate diagnosis is often difficult and time consuming. We report the development and validation of an effective multiplex polymerase chain reaction (PCR) assay that detects Mycoplasma (M.) hyopneumoniae and M. hyorhinis. The multi detection of M. hyopneumoniae and M. hyorhinis primer set were employed to detect mycoplasma species and typing of the species was performed on the basis of sequence analysis of the PCR product. The target nucleic acid fragments were specifically amplified by M. hyopneumoniae and M. hyorhinis PCR with 16S ribosomal DNA primers. Single and mixed Mycoplasma species DNA templates were used to evaluate the specificity of the multiplex assay. The corresponding specific DNA products were amplified for each pathogen. The multiplex PCR assay provides a novel tool for simultaneous detection and differentiation of M. hyopneumoniae and M. hyorhinis.

• KEPCO Journal on Electric Power and Energy
• /
• v.6 no.3
• /
• pp.245-252
• /
• 2020

It is very important to evaluate on/off-line stability to operate the power system stably and economically. Until now, we have continuously secured the operation reliability of the power system through the evaluation of transient, voltage and small signal stability. This paper proposes that it is possible to operate in KWAMS by applying the multi-section analysis and subspace methods and verifying the reliability of the algorithms to directly estimate the dominant oscillation mode of the power system from the signal waveform acquired from the phasor measurement units. In addition, this paper shows that the dominant oscillation mode can be detected from real-time measurement data in power systems. Therefore, if we can monitor the state of the power system in real time, it is possible to avoid a large-scale power outage by knowing the possibility of the power system accident in advance.

• The Journal of Korean Obstetrics and Gynecology
• /
• v.18 no.1
• /
• pp.242-252
• /
• 2005

Purpose : This study carried out to develop the questionnaires that can measure objectively menstrual quantity and determine quantity index. Method : First, we made questionnaires to measure menstrual quantity by six question. Then we investigated 1309 women's questionnaires who has the menses. Conclusion : 1. the questionnaires that can measure objectively menstrual quantity and determine quantity index was high a correlation coefficient therefore those were used Method of Menstrual Quantity(here after MMQ) calculation. Those were added and averaged. 2. We examined correlation of calculated MMQ and women's questionnaires who has the menses therefore we got 0.30~0.47 correlation. 3. MMQ 1~3(hypomenorrhea) was 39 persons 3.19%, MMQ 4~6(normal menorrhea) was 1050 persons 85.85% and MMQ 7~10(hypermenorrhea) was 134 persons 10.96%. MMQ 4 tended to be little and MMQ 6 tended to be much. 4. MMQ confidence was high as 82% comparatively so we thought MMQ was appropriate as the measured method of menstrual quantity.

• Journal of the Korean earth science society
• /
• v.37 no.2
• /
• pp.89-106
• /
• 2016

The Gochang open-coast intertidal flat is located in the southwestern coast of Korea (the eastern part of the Yellow Sea), characterized by macro-tidal range, an open-coast type, and sand substrates. This study has investigated seasonal variation in sedimentary facies of surface sediments in the Gochang intertidal flat. In the four seasons of February, May, August, and November, 2014, surface sediments of 252 sites in total were sampled and analyzed along three survey lines. The surface sediments of the Gochang intertidal flat in 2014 consisted mainly of fine-grained sand sediments showing a trend in grain size to be coarser in winter and finer in summer. Based on seasonal wave and tidal level data recorded near the study area, it was interpreted that the seasonal effects of wave were stronger than those of tide as a factor controlling surface sedimentation. High waves in winter resulted in the coarsening trend of grain size in surface sediments, whereas, during summer time, the sediments became finer by relatively low waves. Spatial sedimentary facies of the Gochang intertidal flat in 2014 represented that seasonal deviation of the upper tidal zone was larger than that of the lower tidal zone, hence sediments getting coarser in grain size and poorly sorted in the upper tidal zone. From upper to lower tidal zone, the grain size became finer and sediments were better-sorted, showing smaller seasonal deviations.

• Journal of dental hygiene science
• /
• v.15 no.4
• /
• pp.480-487
• /
• 2015

The purpose of this study was to examine the association between oral health status and health related quality of life (HRQoL). The study used a nationally representative sample of Koreans (2013 Korea National Health and Nutrition Examination Survey) aged 19~64 years (n=3,252). Dependent variable was HRQoL, which was assessed with each component of EuroQol-5 dimension (EQ5D). Independent variable was oral health status (oral pain, chewing problem, speaking problem, and perceived oral health). After adjustment for confounders (socio-demographic factors, oral health behaviors, health behaviors, and physical conditions), the risk of having poor HRQoL was greater in adults with poor oral health status. The odds ratio (OR) of having pain/discomfort were 1.50 (95% confidence interval [CI], 1.22~1.86) for respondents with oral pain, 1.72 (95% CI, 1.33~ 2.22) for respondents with chewing problem, 1.79 (95% CI, 1.22~2.62) for respondents with speaking problem, and 1.36 (95% CI, 1.09~1.70) for respondents with poor perceived oral health. The OR of having anxiety/depression were 1.74 (95% CI, 1.28~2.38) when having a chewing problem, 1.72 (95% CI, 1.12~2.64) when having a speaking problem, and 1.54 (95% CI, 1.14~2.08) when rating his/her oral health poor. Among Korean adults, two of the EQ5D components were associated with oral health status. Future study is needed to examine the detailed causal relations between oral health status and HRQoL longitudinally.

• Journal of Environmental Impact Assessment
• /
• v.29 no.4
• /
• pp.252-271
• /
• 2020

In this study, we investigated physical and chemical properties such as grain size, heavy metal pollution, magnetic properties, and their environmental impacts of road dusts (RD) collected from 14 sampling points in Daebul industrial Complex. Heavy metal concentrations in RD were in the order of Fe>Zn>Cu>Pb>Cr>Ni>As>Cd>Hg, and this pollution pattern was related to major industries and traffic activities in this area. The results of the correlation analysis between heavy metal elements and particle size in RD showed that Fe and all of analyzed heavy metals had a significant correlation with each other and metal concentrations had a significantly negative correlation (p<0.05). However, due to the input of large metal particles some heavy metal concentrations in the particle fraction of >1000 ㎛ were highest. Pollution load per unit area of this fraction was the highest among the grain size fractions. Cr, Ni, Cu, Zn, Cd, Pb levels in RD decreased and the levels of Cr, Ni, Cu, Zn, Cd, and Pb were reduced to 85 (As) -22 (Ni)% of the whole after removal of MFs fraction from RD. The mean heavy metal levels in the study area did not exceed the soil contamination guide value of Korea, indicating that heavy metal levels in RD were not a concern. However, at some sampling points, Zn concentrations were exceeded the soil contamination guide value for the 3rd areas of Korea and this result indicated that further studies of the impact of RD on the surrounding environment through re-suspension or non-point pollution, and of effective management methods are required.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.252.2-252.2
• /
• 2010

Biomass is considered to be a major potential fuel and renewable resource for the future. In fact, there is high potential to produce the large amount of energy from biomass around the world. In this study, to obtain basic data for practical application of wood pellet and wood pellet boiler system as heating system in agriculture, agricultural biomass resources were surveyed, pellet was made of agricultural by-product such as stem of rape, oat and rice, ricehusk and sawdust and wood pellet boiler system with capacity of 116 kW was manufactured and installed in greenhouse of $38.5m{\times}32m$. High heating value, bulk density and ash content of pellet made of agricultural by-product and efficiency and heating performance of this system was estimated. Rice straw was the largest agricultural biomass in 2005 and the total amount of rice straw converted into energy of $131.71{\times}10^{11}$ kJ. And in 2005, total amount of forest' by-product converted into energy of $29,277.05{\times}10^{11}$ kJ. High heating values of pellets made of agricultural by-products of stem and seed of rape, stem of oat, rice straw and rice husk were 16,034, 16,026, 16,089, 15,650, 15,044 kJ/kg respectively. High heating values of pellets made of agricultural by-products were 83.6% compared to that of wood pellet. Average bulk density of pellets made of agricultural by-products of stem and seed of rape, stem of oat, rice straw and rice husk was 1,400 $kg/m^3$. Ash contents of the pellets were 6.6, 7.0, 6.2, 5.5, 33% respectively. Ash content of rice husk pellet was the largest compared to other kind of pellets. To increase efficiency of agricultural pellet boiler, the boiler adopted secondary heat exchanger. The agricultural pellet boiler designed and manufactured in this study had high efficiency of 84.2% compared to the conventional agricultural pellet boiler, when water flow rate, exhaust gas temperature and average combustion furnace temperature were 39L/min, $180^{\circ}C$, $680^{\circ}C$ respectively. And pellet supplying and pausing time were 13, 43 seconds respectively. In March of 2010, prices of wood pellet, agricultural tax free diesel, diesel, kerosene were 350 won/kg, 811 won/L, 1,422 won/L, 976 Won/L respectively. Also in terms of energy, prices per same heating value were 77.8, 90.1, 158, 108.4 Won/Mcal. Energy saving rate of wood pellet was 16, 50, 39% compared to agricultural tax free diesel, diesel and kerosene respectively.