• Membrane Journal
• /
• v.5 no.1
• /
• pp.35-43
• /
• 1995

For several years lots of attempts have been made to establish the liquid membrane-based techniques for separations of gas mixtures especially containing carbon dioxide. A more effective system to separate $CO_{2}$ from flue gases, a circulatory hollow-fiber membrane absorber(HFMA) consisting of absorption and desorption modules with vacuum mode, has been considered in this study. Gas-liquid mass transfer has been modeled on a membrane module with non-wetted hollow-fibers in the laminar flow regime. The influence of an absorbent flow rate on the separation performance of the circulatory HFMA can be predicted quantitatively by obtaining the $CO_{2}$ concentration profile in a tube side. The system of $CO_{2}/N_{2}$ binary gas mixture has been studied using pure water as an(inert) absorbent. As the absorbent flow rate is increased, the permeation flux(i.e., defined as permeation rate/membrane contact area) also increases. The enhanced selectivity compared to the previous results, on the other hand, shows the decreasing behavior. It has been found obviously that the permeation flux depends on the variations of pressure in gas phase of desorption module. From an accurate comparison with the results of conventional flat sheet membrane module, the advantageous permeability of this circulatory HFMA can be clearly ascertained as expected. Our efforts to the theoretical model will provide the basic analysis on the circulatory HFMA technique for a better design and process.

• Journal of Practical Engineering Education
• /
• v.12 no.1
• /
• pp.163-176
• /
• 2020

Promoting job growth and quality has been central to developing countries to reduce poverty for decades. In this regard, Nepal is not unique in its need to develop effective TVET programme as it is considered showing positive association with workforce development and productivity. While the copious academic literature has highlighted upon staff training programme in general education, it encounters lack of adequate attention in the field of TVET education. The purpose of the study is to identity and prioritise the professional development needs for the teachers of TVET sector in Nepal. A sample(N=317) of Nepalese teachers from seven provinces were asked to answer the scale. The Borich needs assessment model was employed to assess the perceived level of importance and present preferred training modules among 29 teaching subjects. Moreover, a quadrant analysis using 2×2 matrix was used as a diagnostic tool to denote overriding training topics. The result shows that following competence skills constructs were perceived to be in high need of enhancement as well as in existence of discrepancies: 'occupational characteristics of TVET trainer', 'training needs analysis and curriculum development', 'curriculum development based on national competence standard(NCS)', and 'Institution management evaluation'.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.3
• /
• pp.17-23
• /
• 2020

This paper proposes a simulation model using an equivalent circuit for the development of an MMC system. The MMC has been chosen as the most suitable topology for high voltage power transmission, such as a voltage-type HVDC, and it has dozens to hundreds of sub-modules in the form of a half-bridge or full-bridge connected in series. A simulation study is essential for the development of an MMC algorithm. On the other hand, it is virtually impossible to construct and implement MMC simulation models, including hundreds or thousands of switching devices. Therefore, this paper presents an MMC equivalent model, which is easily expandable and implemented by modeling the dynamic characteristics. The voltage and current equation of the equivalent circuit was calculated using the direction of the arm current and switching signal. The model was implemented on Matlab/Simulink. In this paper, to show the validity of the model developed using Matlab/Simulink, the simulation results of a five-level MMC using the real switching element and the proposed equivalent model are shown. The validity of the proposed model was verified by showing that the current and voltage waveform in the two models match each other.

• Korean Journal of Cognitive Science
• /
• v.21 no.4
• /
• pp.559-602
• /
• 2010

This study examines the concepts and functional characteristics of consciousness in comparison of memory and attention from the perspective of information processing. It also provides an understanding of the relationships between the three as hypothetical constructs. Consciousness is regarded as too ambiguous a concept to be understood and accepted as a mental construct without the inclusion of memory and attention in any conceptualization. We need one criterion to count satisfactorily as an explanation of consciousness in information processing. Consciousness would be a subjective awareness of momentary experience and also have the characteristic of an operating system performing control and consolidation in information processing. This could be called cognitive consciousness which refers to a subjective awareness and an executive control system, even though those are not equivalent concepts. Consciousness, memory and attention, three mental constructs could operate dependently or independently depending on the specific tasks conditioned in many information processing levels whose modules with three mental constructs could operate in hierarchy. In this premise, working memory could not be a unitary system, contrary to those of Baddeley and Hitch(1974) and Baddeley(1992, 2000), just being a mental workplace consisting of two components: the phonological loop, and the visual-spatial sketchpad without the episodic buffer and a central executive which are the characteristics of consciousness. In the continuum of information processing, the conscious processes and the unconscious processes seem not to be totally different and contrasting processes.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.11 no.4
• /
• pp.22-31
• /
• 2008

Recently, with the develop of the location tracking technology using GPS and mobile device such as PDA and UMPC, it is used in various application fields that is coordinate transformation and compensation using GPS, is client development for Mobile GIS using GIS and is development of surface survey system for archaeological site based on mobile. In this paper, we develop the system that can investigate the growth information and production information of rice in crop of the field using mobile device, show position information of user and rice in digital map using GIS and save the investigated crop information and position information in database in server. The system which is developed in this paper consists of modules that the user management module is able to restrict database approaches in authority by of the user, the crops management module is able to save and search crop information in database in server, the map module is able to show position information of user and crops in digital map, the location information module is able to convert received location information from GPS and the communication module is able to send and receive data between GPS and mobile device and between mobile device and database. Finally, this paper shall contribute to efficient management and investigation of birth information of crop in field.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.13 no.1
• /
• pp.28-34
• /
• 2011

This study was carried out to estimate monthly mean of daily maximum and minimum temperature across North Korea at a 30 m grid spacing for a climatological normal year (1971-2000) and the 4 decadal averages (1971-1980, 1981-1990, 1991-2000, and 2001-2010). A geospatial climate interpolation method, which has been successfully used to produce the so-called 'High-Definition Digital Climate Maps' (HD-DCM), was used in conjunction with the 27 North Korean and 17 South Korean synoptic data. Correction modules including local effects of cold air drainage, thermal belt, ocean, solar irradiance and urban heat island were applied to adjust the synoptic temperature data in addition to the lapse rate correction. According to the final temperature estimates for a normal year, North Korean winter is expected colder than South Korean winter by $7^{\circ}C$ in average, while the spatial mean summer temperature is lower by $3^{\circ}C$ than that for South Korea. Warming trend in North Korea for the recent 40 years (1971-2010) was most remarkable in spring and fall, showing a 7.4% increase in the land area with 15 or higher daily maximum temperature for April.

• The Journal of the Acoustical Society of Korea
• /
• v.24 no.8
• /
• pp.498-504
• /
• 2005

We introduce a Korean speech recognition platform (ECHOS) developed for education and research Purposes. ECHOS lowers the entry barrier to speech recognition research and can be used as a reference engine by providing elementary speech recognition modules. It has an easy simple object-oriented architecture, implemented in the C++ language with the standard template library. The input of the ECHOS is digital speech data sampled at 8 or 16 kHz. Its output is the 1-best recognition result. N-best recognition results, and a word graph. The recognition engine is composed of MFCC/PLP feature extraction, HMM-based acoustic modeling, n-gram language modeling, finite state network (FSN)- and lexical tree-based search algorithms. It can handle various tasks from isolated word recognition to large vocabulary continuous speech recognition. We compare the performance of ECHOS and hidden Markov model toolkit (HTK) for validation. In an FSN-based task. ECHOS shows similar word accuracy while the recognition time is doubled because of object-oriented implementation. For a 8000-word continuous speech recognition task, using the lexical tree search algorithm different from the algorithm used in HTK, it increases the word error rate by $40\%$ relatively but reduces the recognition time to half.

• Journal of KIISE:Computing Practices and Letters
• /
• v.7 no.2
• /
• pp.165-182
• /
• 2001

In this paper, we describe a design and implementation of the Wireless Markup Language(WML) compiler to deploy wireless Internet services effectively. The WML compiler translates textual WML decks into binary ones in order to reduce the traffic on wireless links that have relatively low bandwidth to wireline links and mitigate the processing overhead of WML decks on, wireless terminals that have relatively low processing power to fixed workstations. In addition, it takes over the overhead of eXtensible Markup Language(XML) well-formedness and validation processes. The WML compiler consists of the lexical analyzer and parser modules. The granunar for the WML parser module is LALR(1) context-free grammar that is designed based on XML 1.0 and WML 1.2 DTD(Document Type Definition) with the consideration of the Wireless Application Protocol Binary XML grammar. The grammar description is converted into a C program to parse that grammar by using parser generator. Even though the tags in WML will be extended or WML DTD will be upgraded, this approach has the advantage of flexibility because the program is generated by modifying just the changed parts. We have verified the functionality of the WML compiler by using a WML decompiler in the public domain and by using the Nokia WAP Toolkit as a WAP client. To measurethe compressibility gain of the WML compiler, we have tested a large number of textual WML decks and obtained a maximum 85 %. As the effect of compression is reduced when the portion of general textual strings increases relative to one of the tags and attributes in a WML deck, an extended encoding method might be needed for specific applications such as compiling of the WML decks to which the Hyper Text Markup Language document is translated dynamically.

• Journal of Digital Convergence
• /
• v.14 no.12
• /
• pp.73-84
• /
• 2016

The purpose of this study is to examine the global value chain of the global automotive industry to investigate the success factors through the example of the value chain of Hyundai Motor. It looks at the value chain of the well-known Korean automaker, Hyundai Motor, to find success factors with cases. It examines the process to build the supply chain of Hyundai Motor to analyze what impact it has on the growth of Hyundai Motor to look closely at the vertical division of labor of vehicle parts manufacturers. Korea's automobile industry has been expanding cooperation between two sectors as a multifunctional promotion focusing on electronic communications technology in machinery and technology center. Through introducing the nation's first vertical integration in the sector, Hyundai Motor has secured competitiveness of cost reduction and prestige car production. Hyundai Motor has operated and established factories in the United States, India, Turkey, the Czech Republic, Russia, and Brazil. Hyundai Motor operates 51 affiliates, such as Hyundai Mobis, by restructuring, mergers and acquisitions, and building their own vertical division of labor around it. Hyundai Motor has been overcoming dependence on foreign modules businesses and maintaining the supply value chain around Hyundai Mobis.

• Journal of Korean Society of Forest Science
• /
• v.89 no.3
• /
• pp.405-413
• /
• 2000

This study was conducted to develop an on-line monitoring system for a forest hydrological environment and its meteorological condition, such as temperature, wind direction and speed, rainfall and water level on V-notch, electrical conductivity(EC), potential of hydrogen(PH) by the motor drive sensor unit and measurement with a single-chip microprocessor as controller. These results are summarized as follows ; 1. The monitoring system consists of a signal process unit, motor drive sensor unit, radio modem unit and power supply. 2. The motor drive sensor unit protects the sensor from swift current or freezing and can constantly maintain fixed water level during measurements. 3. This monitoring system can transfer the data by radio modem. Additionally, this system can monitor hydrological conditions in real time. 4. The hardware was made of several modules with an independent CPU. They can be mounted, removed, repaired and added to. Their function can be changed and expanded. 5. These are the result of an accuracy test, the values of temperature, EC and pH measured within an error range of ${\pm}0.2^{\circ}C$, ${\pm}1{\mu}S$ and ${\pm}0.1pH$ respectively. 6. This monitoring system proved to be able to measure various factors for a forest hydrological environment in various experimental stations.