• Journal of Communications and Networks
• /
• v.14 no.4
• /
• pp.410-417
• /
• 2012

One of the premier mechanisms used in extracting unobserved signals from observed mixtures in signal processing is employing a blind source separation (BSS) algorithm. Orthogonal frequency division multiplexing (OFDM) techniques are playing a prominent role in the sphere of multicarrier communication. A set of remedial solutions taken to mitigate deteriorative effects caused within the air interface of OFDM transmission with aid of BSS schemes is presented. Four energy functions are used in deriving the filter coefficients. Energy criterion functions to be optimized and the performance is justified. These functions together with iterative fixed point rule for receive signal are used in determining the filter coefficients. Time correlation properties of the channel are taken advantage for BSS. It is tried to remove colored noise and jamming components from themixture at the receiver. Themethod is tested in a slow fading channel with a receiver containing equal gain combining to treat the channel state information values. The importance is that, these are quite low computational complexity mechanisms.

• Journal of Advanced Information Technology and Convergence
• /
• v.10 no.1
• /
• pp.1-14
• /
• 2020

Antenna selection is a method to enhance the performance of spatial multiplexing multiple-input multiple-output (MIMO) systems, which can achieve the diversity order of the full MIMO systems. Although various selection criteria have been studied in the literature, they should be adjusted to the detection operation implemented at the receiver. In this paper, antenna selection methods that optimize the post-processing signal-to-noise ratio (SNR) and eigenvalue are considered for the lattice reduction (LR)-based receiver. To develop a complexity-efficient antenna selection algorithm, the incremental selection strategy is adopted. Moreover, for improvement of performance, an additional iterative selection method is presented in combination with an incremental strategy.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.75-78
• /
• 1999

The iterative usage of soft outputs increases the performance of digital radio receiver. The feedback of reliability information reduces the channel estimation errors and increases the performance of equalization. This paper investigates the turbo equalization techniques for wireless cellular systems over continuous time varying channel. Simulation results over a GSM channel were presented.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.7 s.337
• /
• pp.27-34
• /
• 2005

Iterative detection (ID) has proven to be a near-optimal solution for concatenated Finite State Machines (FSMs) with interleavers over an additive white Gaussian noise (AWGN) channel. When perfect channel state information (CSI) is not available at the receiver, an adaptive ID (AID) scheme is required to deal with the unknown, and possibly time-varying parameters. The basic building block for ID or AID is the soft-input soft-output (SISO) or adaptive SISO (A-SISO) module. In this paper, Reduced State SISO (RS-SISO) algorithms have been applied for complexity reduction of the A-SISO module. We show that serially concatenated CPM (SCCPM) with AID has turbo-like performance over fading ISI channels and also RS-A-SISO systems have large iteration gains. Various design options for RS-A-SISO algorithms are evaluated. Recently developed density evolution technique is used to analyze RS-A-SISO algorithms. We show that density evolution technique that is usually used for AWGN systems is also a good analysis tool for RS-A-SISO systems over frequency-selective fading channels.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.2
• /
• pp.702-721
• /
• 2012

In the DVB-T2 system with a multiple-input single-output (MISO) transmission mode, Alamouti coded orthogonal frequency division multiplexing (OFDM) signals are transmitted simultaneously from two spatially separated transmitters in a single frequency network (SFN). In such systems, each transmit-receive link may have a distinct carrier frequency offset (CFO) due to the Doppler shift and/or frequency mismatch between the local oscillators. Thus, the received signal experiences dual CFOs. This not only causes dual phase errors in desired data but also introduces inter-carrier interference (ICI), which cannot be removed completely by simply performing a CFO compensation. To overcome this problem, this paper proposes an iterative detection with dual phase errors compensation technique. In addition, we propose a successive-iterative ICI cancellation technique. This technique successively eliminates ICI in the initial iteration by exploiting pre-detected data pairs. Then, in subsequent iterations, it performs a fine interference cancellation using a priori information, iteratively fed back from the channel decoder. In contrast to previous works, the proposed techniques do not require estimates of dual CFOs. Their performances are evaluated via a full DVB-T2 simulator. Simulation results show that the DVB-T2 receiver equipped with the proposed dual phase errors compensation and the successive-iterative ICI cancellation techniques achieves almost the same performance as ideal dual CFOs-free systems, even for large dual CFOs.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.6A
• /
• pp.519-536
• /
• 2007

In this paper, we combine the Hybrid-Automatic Repeat reQuest (HARQ) algorithm with joint Tx and Rx antenna selection based on the reliability of the individual antennas links. The cyclic redundancy check (CRC) is applied on the data before being encoded using the Turbo encoder. In the receiver the CRC is used to detect errors of each antenna stream and to decide whether a retransmission is required or not. The receiver feeds back the transmitter with the Tx antennas ordering and the acknowledgement of each antenna (ACK or NACK). If the number of ACK antennas is higher than the NACK antennas, then the retransmission takes place from the ACK antennas using the Chase Combining (CC). If the number of the NACK antennas is higher than the ACK antennas then the ACK antennas are used to retransmit the data streams using the CC algorithm and additional NACK antennas are used to retransmit the remaining streams using Incremental Redundancy (IR, i.e. the encoder rate is reduced). Furthermore, the HARQ is used with the I-BLAST (Iterative-BLAST) which grantees a high transmission rate.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.1
• /
• pp.45-51
• /
• 2016

In this paper, we develop an iterative maximum likelihood (ML) receiver for generalized spatial modulation systems. In the proposed ML receiver, to mitigate the deleterious effect of channel information errors on symbol detection, the instantaneous covariance matrix of effective noise is estimated, which is then used to obtain improved ML solutions. The estimated covariance matrix is updated through multiple iterations to enhance the estimation accuracy. The simulation results show that the proposed ML receiver outperforms the conventional ML detection scheme, which does not take the effect of channel information errors into account.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.2A
• /
• pp.172-178
• /
• 2011

In this paper, the performance of bit interleaved of coded and modulation(BICM) module of the second generation of digital terrestrial television broadcasting system(DVB-T2) is evaluated with the help of computer simulation. The frame error rate performance is studied in AWGN, Rayleigh fading and 15% erasure channels. In addition, iterative receiver is considered that exchanges extrinsic information between the rotated demapper and the LDPC decoder. Through the simulation it is observed that under the flat fading Rayleigh channel, about 1.2dB gain at FER of $10^{-4}$ is introduced when rotated constellation and iterative demapping and decoding are employed. Under the 15% earasure channel, rotated constellation gives performance gain of about 5dB at BER of $10^{-4}$ and when IDD is applied, additional performance gain of about 3dB can be achieved.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.7C
• /
• pp.587-593
• /
• 2010

In this paper we design an irregular low-density parity-check (LDPC) code for multiple-input multiple-output (MIMO) system, using a simple extrinsic information transfer (EXIT) chart method. The MIMO systems considered are optimal maximum a posteriori probability (MAP) detector. The MIMO detector and the LDPC decoder exchange soft information and form a turbo iterative receiver. The EXIT charts are used to obtain the edge degree distribution of the irregular LDPC code which is optimized for the MIMO detector. It is shown that the performance of the designed LDPC code is better than that of conventional LDPC code which was optimized for either the Additive White Gaussian Noise (AWGN) channel or the MIMO channel.

• ETRI Journal
• /
• v.40 no.3
• /
• pp.309-317
• /
• 2018

Single carrier-frequency-division multiple access (SC-FDMA) has been adopted as the uplink transmission standard in fourth-generation cellular networks to facilitate power efficiency transmission in mobile stations. Because multiuser multiple-input multiple-output (MU-MIMO) is a promising technology employed to fully exploit the channel capacity in mobile radio networks, this study investigates the uplink transmission of MU-MIMO SC-FDMA systems with orthogonal space-frequency block codes (SFBCs). It is preferable to minimize the length of the cyclic prefix (CP). In this study, the chained turbo equalization technique with chained turbo estimation is employed in the designed receiver. Chained turbo estimation employs a short training sequence to improve the spectrum efficiency without compromising the estimation accuracy. In this paper, we propose a novel and spectrally efficient iterative joint-channel estimation, multiuser detection, and turbo equalization for an MU-MIMO SC-FDMA system without CP-insertion and with short TR. Some simulation examples are presented for the uplink scenario to demonstrate the effectiveness of the proposed scheme.