• Journal of Electrochemical Science and Technology
• /
• v.10 no.2
• /
• pp.177-184
• /
• 2019

An electrochemical detection method for capsaicin has been developed using ionic liquid (IL) doped graphene-titania-Nafion composite-modified electrode. The combination of IL (1-hexyl-3-methylimidazolium with hexafluorophosphate counter ion) in the composite-modified electrode resulted in a significantly increased electrochemical response for capsaicin compared to that obtained at the corresponding electrode without IL. The increased electrochemical signal could be ascribed to the decreased electron transfer resistance through the composite film and also to the effective accumulation of capsaicin on the electrode surface due to ${\pi}-{\pi}$ interaction of the imidazole groups of IL with the aromatic rings of capsaicin. The present IL composite-modified electrode can detect capsaicin with a concentration range from $3.0{\times}10^{-8}M$ to $1.0{\times}10^{-5}M$ with a detection limit of $3.17{\times}10^{-9}M$ (S/N = 3). The present sensor showed good reproducibility (RSD = 3.2%).

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.18 no.4
• /
• pp.457-464
• /
• 2020

In this study, extraction of uranium(VI) from an aqueous nitric acid solution was investigated using tri-n-butyl phosphate (TBP) as an extractant in an ionic liquid, 1-alkyl-3-methylimidazolium bis (trifluoromethylsulfonyl)imide ([Cnmim][Tf2N]). The distribution ratio of U(VI) in 1.1 M TBP/[Cnmim][Tf2N] was significantly high when the concentration of nitric acid was low. The value of the distribution ratio decreased as the concentration of the nitric acid increased at lower acidities, and then increased with a nitric acid concentration of up to 8 M. This can be attributed to the different extraction mechanisms of U(VI) based on nitric acid concentrations. Thus, a cation exchange at low acidity levels and an ion-pair extraction at high acidity levels were suggested as the extraction mechanism of U(VI) in the TBP/[Cnmim][Tf2N] system.

• Korean Chemical Engineering Research
• /
• v.54 no.4
• /
• pp.543-547
• /
• 2016

Bubble properties such as size (chord length) and rising velocity were investigated in a bubble column with electrolyte solutions, of which diameter was 0.152m and 2.5m in height, respectively. The size and rising velocity of bubbles were measured by using the dual electrical resistivity probe method. Effects of gas and liquid velocities and ionic strength of liquid phase on the size and rising velocity of bubbles were determined. The bubble size increased with increasing gas velocity but decreased with increasing liquid velocity or ionic strength of liquid phase. The rising velocity of bubbles increased with increasing gas velocity and decreased with increasing ionic strength of liquid phase, however, it showed a slight maximum value with varying liquid velocity. The size and rising velocity of bubbles were well correlated with operating variables.

• KSBB Journal
• /
• v.20 no.3
• /
• pp.183-191
• /
• 2005

Ionic liquids, composed of organic cations and either organic or inorganic anions remain liquid over a wide range of temperature. ionic liquids are a new group of solvents or extractants of great interest as a potential 'green solvent'. Ionic liquids are gaining wide recognition as novel solvents in many research fields, such as chemistry, chemical engineering, electrochemitry, etc. However, not much researches have been done related to biotechnology using ionic liquids, while a lot of researches have been performed in chemistry. The merits of ionic liquids in bioseparation technology are originated from some unique properties of ionic liquids, such as negligible vapor pressure, good thermal stability, controllable viscosity and miscibility with water and organic solvents. An appropriate selection of ionic liquid for bioprocesses requires basic knowledge on physicochemical properties of ionic liquids. This review gives a brief overview on the application of ionic liquids in biotechnology, including bioconversion and bioseparation.

• Tribology and Lubricants
• /
• v.30 no.6
• /
• pp.323-329
• /
• 2014

The friction-reducing properties of lubricants containing ionic liquids based on ammonium dithiocarbamate are studied. The ionic liquids are produced through the following two steps: the synthesis of sodium alkyl dithiocarbamates via the substitution reaction of dialkylamine and carbon disulfide and their subsequent conversion into ammonium dithiocarbamate-based ionic liquids through an ion-exchange reaction with a quaternary alkyl ammonium halide salt. The structures of the ionic liquids are characterized by NMR spectroscopy and Fourier transform infrared spectroscopy. The isolated yields of the ionic liquids, which are viscous and pale yellow, are approximately 92%. The Brookfield viscosities and pour points of the ionic liquids are determined. Further, their wear resistances are measured through the four-ball wear test and the Schwingung Reibung Ver-schleiss (oscillation, friction, wear) test. The wear scar diameter of the lubricants containing 1 wt of the quaternary alkyl ammonium dithiocarbamate-based ionic liquids (0.475-0.631 mm) is significantly lower than that of the base oil (0.825 mm), proving that the ammonium dithiocarbamate-based ionic liquids have good friction-reducing characteristics. However, these friction-reducing characteristics fade significantly after long-term storage, owing to the degradation of the ionic liquids.

• Korean Chemical Engineering Research
• /
• v.54 no.1
• /
• pp.52-56
• /
• 2016

As an effective method for extraction of succinic acid, aqueous two-phase systems based on piperidinium ionic liquids were used in this study. Effects of the alkyl chain length of cation in piperinidium ionic liquids on phase diagram and extraction efficiencies were investigated. Experimental results show that aqueous two phase systems can be formed by adding appropriate amount of piperidinium ionic liquids to aqueous $K_2HPO_4$ solutions. It can be found that the ability of piperidinium ionic liquids for phase separation followed the order [OMPip][Br]>[HMPip][Br]>[BMPip][Br]>[EMPip][Br]. The biphase-forming ability of piperidinium ionic liquids was higher than that of imidazolium and pyrrolidinium ionic liquids in the presence of $K_2HPO_4$. 75~95% of the succinic acid could be extracted into the ionic liquid-rich phase in a single-step extraction. There was little difference in the extraction efficiency of succinic acid by piperidinium ionic liquids comparing to other ionic liquids such as imidazolium and pyrrolonidium ionic liquids. This aqueous two phase system by piperidinium ionic liquid is suggested to have effective application for the separation of succinic acid.

• KSBB Journal
• /
• v.28 no.4
• /
• pp.238-243
• /
• 2013

Astaxanthin is one of the carotenoid with strong antioxidant. The conditions of extraction of astaxanthin from Portunus trituberculatus were optimized in this work. Six factors of conditions such as, extraction method, extraction solvent, ratio of solvent to raw material, temperature, and time, were investigated. For the increase of the extraction yield, ionic liquids were used as additives in the extraction solvent. The optimum extraction conditions were found: heat reflux extraction, Dichloromethane/methanol (25:75, v/v) as solvent, 1:30 of the ratio of solvent raw material, $80^{\circ}C$, 90 min, and ionic liquid as additive. As a result, 45.81 ${\mu}g/g$ of astaxanthin was extracted from waste.

• Journal of the Korean Electrochemical Society
• /
• v.5 no.4
• /
• pp.192-196
• /
• 2002

Ionic liquids based on l-ethyl-3-methylimidazolium cation $(EMI^+)$ and inorganic or organic anions containing fluorine atoms were applied to electrolyte materials for double-layer capacitors. The double-layer capacitors composed of a pair of activated carbon electrodes and an ionic liquid selected from $EMIBF_4,\; EMINbF_6,\;EMITaF_6,\;EMICF_3SO_3,\;EMI(CF_3SO_2)_2N,\;and\;EMI(C_2F_5SO_2)_2N$ showed inferior low-temperature characteristics to those of a conventional nonaqueous electrolyte based on propylene carbonate (PC) solvent. On the other hand, the capacitor using $EMIF{\cdot}2.3HF$ showed excellent low-temperature characteristics due to its high conductivity at low temperatures, however, it had a lower working voltage $(\~2V)$ than the conventional nonaqueous counterpart $(\~3V)$.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.6
• /
• pp.1829-1833
• /
• 2012

Titania spheres were synthesized using binary ionic liquids to examine the electrocatalytic activity in acid solution. The morphology of $TiO_2$ particles was significantly different with the composition of ionic liquids. Among the binary ionic liquids, four set of mixtures led to the formation of $TiO_2$ sphere with various sizes. The morphology and structure of $TiO_2$ particles were characterized by XRD, $N_2$ physisoption and SEM analysis. All samples possessed an anatase phase after calcinations at $500^{\circ}C$. The structural properties of the samples were varied significantly with the morphology. In cyclic voltammograms, the morphology of $TiO_2$ spheres affected the electrocatalytic activity in water electrolysis. Among the samples, [Omim][$BF_4$]+[Hmim][$BF_4$] was the most effective ionic liquid to synthesize $TiO_2$ sphere with optimum morphology showing the highest electocatalytic performance.

• Polymer(Korea)
• /
• v.29 no.2
• /
• pp.216-220
• /
• 2005

A new type of polymer gel electrolyte was prepared from poly(ethylene glycol) diacrylate(PEGDA) and 1-butyl-3-methylimidazolium bis((trifluorornethyl) sulfonyl) amide$(BuMeIm^+Tf_2N^-)$ ionic liquid. The effect of the ionic liquid on ionic conductivity of the gel polymer electrolyte was investigated. It was observed that the gel polymer electrolyte having the ionic liquid exhibited higher ionic conductivity $(ca.\;10^{-3}S/cm)$ as well as electrochemical stability than that using organic solvent.