• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.11
• /
• pp.1243-1253
• /
• 2007

Recently UHF RFID system has drawn a great deal of attention because of its potential to revolutionize supply chain management. An important characterization of the performance of a RFID system is 'interrogation range', which is defined as the maximum distance between a reader and a tag. Forward-link interrogation range is defined as the maximum distance from which the tag receives just enough power to turn on and back-scatter, and reverse-tink interrogation range is the maximum distance from which the reader can detect this back-scattered signal. A link balance has to be found between the two interrogation ranges. In this paper, the interrogation range equations are formulated in both forward-link and reverse-link and a trade-off between the two values is investigated in order to maximize the interrogation range. As a result, it is observed that the gain of the reader antenna, the isolation of the circulator, and the phase noise of the local oscillator with range correlation effect mainly determine the reverse-link interrogation range.

• Journal of Sensor Science and Technology
• /
• v.26 no.6
• /
• pp.402-407
• /
• 2017

Characteristics of various material surface plasmon resonance (SPR) chips were investigated in angular interrogation mode and intensity interrogation mode. Among five metals, silver (Ag), gold (Au), copper (Cu), chromium (Cr) and titanium (Ti), three metals, Ag, Au and Cu were paid attention to since their characteristics can be easily analyzed in angular interrogation mode by investigating the change of their reflectance curves according to refractive index change from 1.331 to 1.335. Most of SPR chips with various configurations showed the similar property in angular interrogation mode. The application of the SPR chip made of Ag, Au and Cu or their combinations depends on their reflectance properties. In intensity interrogation mode, the operation range may be limited since the variation of the intensity was not linearly related to refractive index change ranging from 1.331 to 1.335. However, the SPR chip containing high ratio of Ag may be applicable to high sensitive detection due to their sharp reflectance curves in intensity interrogation mode.

• Journal of Korean Medical classics
• /
• v.28 no.1
• /
• pp.21-34
• /
• 2015

Objectives : The treatment starts with physical examination. The four examinations(四診) is a method to examine the disease. The books on history of diagnostics about it contained substantial contents about inspection(望診) and palpation including pulse taking(切診), while they contained little contents about auscultation(聞診) and interrogation or questioning(問診) relatively. For this reason, this study was conducted as on interrogation first of all. Methods : I looked into the contents related to interrogation that were scattered in plenty of books. There were chapters of specialty in interrogation since the Ming dynasty, so I looked into these chapters in chronological order. Results & Conclusions : The level of the contents of interrogation prior to the Ming dynasty were rudimentary and recapitulative. However, there was a turning point by three kinds of books appeared in the Ming dynasty. Yixuerumen Wenzheng dealt with detailed contents. Yixuezhunshengliuyao Wenbingbixiang extended the range of contents. Jingyuequanshu Shiwenpian systematized Eight Principle Pattern Identification(八綱辨證) with increase of contents. Since then, books of the Qing Dynasty were mostly based on three kinds of books ahead. Among these, Yimenfalu Yimingwenbingzhifa(醫門法律 一明問病之法) and Xingsewaizhenjianma wenfa(形色外診簡摩 問法) mentioned the importance of a succinct interrogation that hit the mark and Yibian Yiwenzheng dealt with another detailed contents unlike the previous books based on substantial contents.

• Journal of electromagnetic engineering and science
• /
• v.9 no.1
• /
• pp.39-45
• /
• 2009

In this paper, we discuss hardware design and deployment issues in current passive UHF RFID systems. Using the link budget concept, the methodology to calculate forward- and reverse-link interrogation range is shown. Then, we consider hardware issues: phase diversity, phase noise with range correlation, and TX leakage problems. Finally, three interference problems when deploying RFID systems are presented.

• Journal of Advanced Navigation Technology
• /
• v.21 no.2
• /
• pp.179-186
• /
• 2017

This paper is concerned with an interrogator capable of constructing a interrogation scenario for acquiring active airspace to the intruding aircraft into the surveillance area of the MLAT system. In the MLAT system, the interrogator is an important device used to carry out the interrogation towards the aircraft within the surveillance airspace in the appropriate surveillance scenario. Unlike a conventional SSR's interrogation methods that interrogate for airplanes flying within a certain range, the MLAT system requires a interrogation system that can actively interrogate from remote to near range, or according to operational scenarios, for aircraft intruding into the surveillance range. The interrogator implemented in this paper can be used for interrogating and monitoring aircraft within each surveillance airspace using whisper-shout algorithm according to varying output power based on the actual operation distance.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.975-976
• /
• 2006

The passive type RFID (Radio Frequency Identification) System using Surface Acoustic Wave (SAW) tag at 900 MHz in the range of more than 1 m was fabricated. To improve interrogation range of the system propose a method to increase isolation between transmitter and receiver. This method using a direct conversion architecture achieves a leakage rejection of 10 dB increased compared with conventional system. Measured interrogation range is more than 1 m.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.1169-1172
• /
• 2005

In this paper, we propose an improved anti-collision algorithm for multi tag interrogation in ubiquitous sensor network(USN) and show the result of simulation for multi tag interrogation in RFID systems. We have analyzed an EPC(Electronic Product Code) protocol which specifies the physical and logical requirements for a passive-backscatter Reader-Talk-First(RTF) RFID(Radio Frequency Identification) system operating in the $860MHz{\sim}960MHz$ frequency range. We have also designed and implemented the simulator of the RFID system based on the EPC protocol. Finally, we find that proposed algorithm works better than an existing algorithm.

• Smart Structures and Systems
• /
• v.20 no.3
• /
• pp.343-350
• /
• 2017

An experimental study is presented of the application of fiber Bragg grating (FBG) interrogation method based on optical time-domain reflectometery (OTDR) to monitoring strain in bent reinforced concrete beams. The results obtained with the OTDR-based method are shown to agree well with the direct spectral measurements. Strain sensitivity, resolution and measurement range amounted to $0.0028dB/{\mu}strain$; $30{\mu}strain$; $4000{\mu}strain$, correspondingly. Significant differences are observed in surface and inner deformations of the test beams which can be attributed to different mechanical properties of concrete and steel reinforcement. The prospects of using OTDR-based FBG interrogation technique in real-life applications are discussed.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.20 no.7
• /
• pp.58-65
• /
• 2021

Research on general particle image velocimetry (PIV) has been conducted extensively, but studies on granular PIV are relatively insufficient. In addition, the parameters used for analyzing granular PIV need to be optimized. In this study, we analyzed the error of velocity measurements based on the interrogation area (64-192 pixel), frame per second (30-120 FPS), and video resolution [ultrahigh definition (UHD) and high definition (HD)] within the velocity range typically measured in hoppers. The estimated errors of the granular PIV were below 5%, which is generally acceptable. However, considering the data reliability, the flow velocity in the hopper could be measured with less than 5% error at 120 FPS or higher in the HD resolution and 30 FPS or higher in the UHD resolution.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.7
• /
• pp.17-22
• /
• 2010

We have proposed and experimentally demonstrated a novel fiber Bragg grating (FBG) sensing interrogation method using bidirectional modulation of a Mach-Zehnder electro-optical modulator (MZ-EOM). The proposed structure consists mainly of a broadband light source (BBS), FBG, MZ-EOM, chirped fiber Bragg grating (CFBG), and photodetector (PD). We have obtained the transfer functions of the proposed structure and calculated the time delay from the change in the free spectral range (FSR) for ten wavelengths over the frequency range of 505 MHz to 525 MHz. The results show that the time delay and the wavelength variation have a good linear relationship with a gradient of 12.9 ps/0.2 nm, which can be usefully applied to FBG strain or temperature sensors and other multiplexed sensor applications.