• Journal of the Korean Society of Clothing and Textiles
• /
• v.26 no.7
• /
• pp.1078-1084
• /
• 2002

Cotton fabrics were treated with 1,2,3,4-butanetetracarboxylic acid(BTCA) to impart durable press performance, which is formaldehyde-free DP finishing reagent. The pore structures of BTCA treated cottons were compared using a reverse gel permeation chromatographic technique(reverse GPC). A series consisting 4 kinds of water soluble sugars was used to study the elution characteristics of columns prepared from cotton fibers. From these data, differences in pore size distribution in the control and BTCA treated cottons were distinguished. BTCA crosslinks cellulose molecules provided wrinkle resistance to the treated cotton fabrics through ester linkages. Although crosslinking of cotton with BTCA reduced accessible internal volume across the entire range of pore size, differences in line pores were larger than in small pores. BTCA treated cotton exhibited reductions over 40% in large pore sizes.

• Textile Coloration and Finishing
• /
• v.13 no.4
• /
• pp.227-233
• /
• 2001

Wool fabrics were pre-treated with corona prior to treating with enzyme for shrinkage resistance. Commercial protease and cellulase were used for degradation of wool and the treatment conditions such as enzyme amount, treating time, and assistant chemicals. Friction coefficient and zeta-potential were measured to certificate an effect of treatment condition on the handle of wool fabric. Corona pretreatment make the wool fabric soft, which result in the decrease of friction coefficient and zeta-potential. Scale removal of wool surface was observed by scanning electron microscope. Amino acid analysis shows the effectiveness of enzyme, and corona pretreatment does not cause severe internal damage.

• Textile Coloration and Finishing
• /
• v.2 no.2
• /
• pp.33-38
• /
• 1990

Nitrocellulose [NC]-Poly(vinylamine) [PVAm] blended membranes with the change of amino group contents were prepared. The sorption and permeation of a mono-sulfonic acid dye, Orange II, in the membranes were investigated by the steady-state permeation method at $50^{\circ}C$ and pH 2.2. The results were discussed in the framework of dual sorption and diffusion theory. It was found that thesorption isotherms comprise a partition and two Langmuir type adsorption having similar binding constants. One of the latter sorption modes is due to unknown adsorption sites in NC and the other is due to the amino groups in PVAm. Apparent diffusion coefficients for collective P and L dye species, $D_P\; and D_L$, were obtained. Interpretation of $D_P$ values leads to two modes of partitions; one is such that dye is immobilized in NC and the other is the dissolution of the dye into the internal water phase.

• Textile Coloration and Finishing
• /
• v.2 no.3
• /
• pp.8-13
• /
• 1990

In order to study the modification of wettability, tactility, and bathochromicity of the poly (ethylene Terephthalate) (PET) fabrics, low-temperature plasma$(O_2)$ has been irradiated on the PET fabrics in various conditions. The results obtained from this study were as follows; 1) The weight loss rate of plasma-treated PET fabrics is proportional to irradiation time and internal gas temperature of treating chamber. Also, the effect of weight loss is remarkable at gas pressure ranging from 3 torr to 5 torr. 2) The bathochromic effect of PET fabrics treated with low-temperature plasma$(O_2)$ was improved.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.22 no.4
• /
• pp.68-75
• /
• 2018

The introduction of advanced water treatment facilities has increased as the conventional purification method cannot remove the substance clearly. However, the internal waterproofing and Anticorrosion materials of the advanced water treatment facility using ozone deteriorate due to the oxidation power of ozone and affects the concrete, which causes a decrease in durability. This study is to evaluate the ozone resistance according to the type of spray metal and the surface treatment method of the coating, and the bond strength after ozone treatment in order to develope a finishing method to prevent deterioration of concrete structure of water treatment facility using metal spraying method as a way to construct metal panel with excellent ozone resistance and chemical resistance by an easier way than the previous. The Experimental results show that spray metal Ti has superior ozone resistance even after spraying. It is considered to be the most suitable method for ozone resistance and bond performance by finishing using Teflon sealing as surface treatment method.

• International conference on construction engineering and project management
• /
• 2017.10a
• /
• pp.89-98
• /
• 2017

The floor heating method generally uses a wet construction method including the installation of resilient material, lightweight foam concrete, heating piping, and finishing mortar. Such a wet construction method not only delays other internal finishing processes during curing period for two mortar pouring process, but also has a disadvantage that it is difficult to replace the floor heating layer when it deteriorated because it is integrated with the frame. Dry floor heating construction method can be a good alternative in that it can solve these defects. Conversely, when it applied to the wall structure that is vulnerable to the interlayer noise compared with the column-beam structure, the question about the heavy-impact sound(HIS) insulation performance is raised. Therefore, conventional dry floor heating method is hard to apply to the wall structure apartments. Therefore, for the purpose to improve the applicability of dry floor heating method in wall structure apartments, this study investigated the change of floor impact sound, especially HIS insulation performance which is one of the required performance for the floor structure. This study tried to examine whether the change of heavy-impact sound pressure level(SPL) shows a tendency at the significant level according to the shape and mass of the floor structure. Through filed experiments on wall structure apartment, this study confirmed that the form of the raised floor shows better HIS insulation performance than the fully-supported form. In addition, it was also confirmed that the HIS insulation performance increases with the mass on the upper part. Moreover, this study found the fact that a mass of about 30 kg/m² or more should be placed on the upper structure to reduce the heavy-impact SPL according to the bang machine measuring method. Although this study has a limit due to insufficient experiment samples, if the accuracy of this study is increased, it will contribute to the diffusion of dry floor heating by setting the HIS insulation performance target and designing the dry floor heating structure that meets the target.

• Journal of Conservation Science
• /
• v.34 no.2
• /
• pp.107-118
• /
• 2018

This report does studied for making the method of conserving bracket murals in Daeungjeon of Jikjisa Temple, through the scientific way. Results of evaluated the conservation status at the braket mural paintings, most serious damage is structural damage like cracks, breakage, and delamination. After optical investigation, a characteristic point wasn't found such as underdrawing or traces of a coat of paint. The ultrasonic examination speed by each wall painting was measured from about 195.8 m/s to 392.7 m/s, according to the location of the surface, and it was able to compare the surface properties according to the location. In Infrared-thermal image measurement shows that wall layer separation and paint layer delamination are closely detected, therefore it was able to judge of damage on the objective way. Material analysis revealed that the walls were made by sand and weathering soil. The wall layer combined sand with less than fine sand size by nearly 5:5, and the finishing layer was found to have mixed medium sand and fine sand at approximately 6:4 rates. However, In case of finishing layer, mixing ratios of sizes less than very fine sand were found to be significantly lower than wall. Therefore, it is estimated that the plysical damage such as the separation between the layers of the walls created in the braket mural paintings, is continuously caused by changes in the internal stresses and volume ratio caused by the density differences between the wall and the finishing layers.

• Journal of the Korean housing association
• /
• v.14 no.4
• /
• pp.109-119
• /
• 2003

This paper has examined a resident's feeling of satisfaction on residential environment. It has searched a policy direction to improve the quality of residential environment with three models in which what factors have an influence on the resident's feeling of satisfaction is evaluated. First, when the residents were asked why they chose lease APT, Low price was answered the most between two populations. Second, with regard to the feeling of satisfaction by categories, both populations showed similar results. The social prejudice on lease APT such as disadvantage on their children and unfavorable surroundings that has been engraved in people's mind about lease APT for a long time was never an issue any more. Third, when the two populations were examined by regression analysis with three models in terms of what factors had an effect on the feeling of satisfaction, there was no big difference in each effect of variables. Internal environment was a key variable for lease APT while external environment was a core variable for the APT that is converted into installment sale. In order to enhance the feeling of satisfaction on residential environment for lease APT residents, high quality turned out the most important factor between both populations, and then a loan with low interest rate and high average standard of APT followed. As unsatisfactory items, low cultural level, slowness in repairing works, and unsatisfactory finishing work were pointed out with regard to the low quality of internal facilities. In general, it turned out that the APT that was converted into installment sale was more preferable than lease APT. As known in this analysis, housing supply policy needs to be focused on quality and high average standard of APT should be achieved for the working classes.

• Fire Science and Engineering
• /
• v.20 no.4 s.64
• /
• pp.33-41
• /
• 2006

Nowadays in Korea, KS F 2271(Testing method for incombustibility of internal finish material and element of buildings) has been using for the evaluation of fire safety performance of sandwich panels. The test method in Japan and in Korea was based on the same way. When the Japanese standard building code was revised in 2000, the test method in the ISO 5660-1 was adopted for the test method for combustion performance of internal finishing materials and elements of buildings. According to this, the revision version of draft substituting the test method in the KS F 2271 for one in the ISO 5660-1(Cone Calorimeter method) is informed in Korea. In this study, combustion properties of sandwich panels were tested using the cone calorimeter method. Ignition time, peak heat release rate and total heat released of four sandwich panels and four core materials (thermal insulation material), which are widely used in Korea, were tested. Test results were analyzed for each specimen. Finally, test results were classified by Japanese standard building code and Canadian NBC revised.

• THE JOURNAL OF KOREAN ORIENTAL ONCOLOGY
• /
• v.4 no.1
• /
• pp.89-110
• /
• 1998

Yookmijihwangtang has been widely used oriental herb prescriptions, which is healing some discuss that come from insufficiency of innate essence and deficiency of kidney Ki. The meaning of healing discusses tonification of insufficient innate essence and insufficient kidney Ki can be regarded as reinforcement of wholely power of keeping homeostasis, that is correlated with immuno-responsibility which protects subject from outer antigen to keep normal vital condition. This study was aimed to investigate correlative effects of Yookmijihwangtang water abstract on the RBC, WBC, blood CD4+ T helper cell count, blood testosterone, blood cAMP and blood cortisol. 40 Sprague-Dawley male rats were divided into 5 groups(Normal, Control, Sample I, Sample II, Sample III), 6 animals in every group. Normal group was not treated anything, control group was administrated normal saline in the same dosage of Sample I. 3 Sample groups were received some of Yookmijihwangtang water abstract at one time per 24 hours during 5 days in different dosage. Sample I(1/310pack/ml), Sample II(1/62pack/ml), Sample III(1/2.4pack/ml). After finishing treatment, all experimental subjects were killed for blood sample on RBC, WBC, blood CD4+ T helper cell count, spleen CD4+ T helper cell count, axillary lymph node CD4+ T helper cell count. blood cAMP, blood testosterone and blood cortisol. The results were as follows; RBC and WBC were increased in all sample groups. Blood CD4+ T helper cell count(CD4+ T cell count in the blood/whole lymphocyte count in the blood ${\times}100%$) was Normal $46.17{\pm}5.88$, Control $44.50{\pm}4.37$, Sample I $53.00{\pm}2.28$, Sample II $53.83{\pm}3.87$, Sample III $52.17{\pm}2.93$. By the 95% Duncan ANOVA all experimental groups(sample I, Sample II, Sample III) showed slight significant difference from Normal and Control. Blood cAMP(nmol/l) were Normal $1.12{\pm}0.17$, Control $1.16{\pm}0.32$, Sample I $0.46{\pm}0.07$, Sample II $0.44{\pm}0.04$, Sample III $0.54{\pm}0.04$. All experimental groups were singificantly different from both Normal and Control groups(p<0.05). Blood cortisol(nl/ml) were Normal $100.00{\pm}2.00$ Control $90.00{\pm}4.00$, Sample I $440.00{\pm}5.00$, Sample II $520.00{\pm}40.00$, Sample III $470.00{\pm}7.00$. Blood cortisol of all experimental groups were significantly increased(p<0.05). The results suggest that Yookmijihwangtang water abstract could be administrated to patients who have some diseases insufficient essence.