• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.37 no.1
• /
• pp.101-105
• /
• 2024

4H-SiC power metal-oxide-semiconductor field effect transistors (MOSFETs) have been developed to achieve lower specific-on-resistance (R_on,sp), and the gate oxides have been thermally grown. The poor channel mobility resulting from the high interface trap density (D_it) at the SiO₂/4H-SiC interface significantly affects the higher switching loss of the power device. Therefore, the development of novel fabrication processes to enhance the quality of the SiO₂/4H-SiC interface is required. In this paper, NO post-oxidation annealing (POA) by using the conditions of N₂ diluted NO at a high temperature (1,300℃) is proposed to reduce the high interface trap density resulting from thermal oxidation. The NO POA is carried out in various NO ambient (0, 10, 50, and 100% NO mixed with 100, 90, 50, and 0% of high purity N₂ gas to achieve the optimized condition while maintaining a high temperature (1,300℃). To confirm the optimized condition of the NO POA, measuring capacitance-voltage (C-V) and current-voltage (I-V), and time-of-flight secondary-ion mass spectrometry (ToF-SIMS) are employed. It is confirmed that the POA condition of 50% NO at 1,300℃ facilitates the equilibrium state of both the oxidation and nitridation at the SiO₂/4H-SiC interface, thereby reducing the D_it.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.24 no.4
• /
• pp.625-630
• /
• 1987

Thermal evaporated SiO rf sputtered SiO2 thin films were most widely used to the gate oxide of TFTs. In this paper, the difference of trap density and distribution between SiO2 and SiO2 film were studied. TFTs using SiO and SiO2 thin film for the gate oxide were fabricated. The output characteirstics of TFTs and the time dpendencd of the leakage current were measured. Models of the carrier transport and carrier trapping in TFT were proposed. The trap density was obtained by substituting measured value for the equation derived from the proposed model. It was found that rf sputtered SiO2 had more traps at interface than thermal evaporated SiO.

• 전기의세계
• /
• v.26 no.6
• /
• pp.86-92
• /
• 1977

The phenomenon of non-steady-state current flow through the interface traps during the dielectric relaxation of MOS device is presented. Experimental method is also described for determining the energy distribution of interface traps, which is based on isothermal dielectric relaxation current technique. Actually, the energy distribution of interface traps was obtained by measuring the transient current through the traps at Si-SiO$_{2}$ interface only in lower-half of the bandgap. It is shown that the trap energy distributio has peak value 1.72*10$^{13}$ cm$^{-2}$ eV$^{-1}$ near 0.73eV approximately.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11b
• /
• pp.17-20
• /
• 2001

Nonvolatile semiconductor memory devices with reoxidized nitrided oxide(RONO) gate dielectrics were fabricated, and nitrogen distribution and bonding species which contribute to memory characteristics were analyzed. Also, memory characteristics of devices depending on the anneal temperatures were investigated. The devices were fabricated by retrograde twin well CMOS processes with $0.35{\mu}m$ Nonvolatile semiconductor memory devices with reoxidized nitrided oxide(RONO) gate dielectric were fabricated, and nitrogen distribution and bonding species which contributing memory characteristics were analyzed. Also, memory characteristics of devices according to anneal temperatures were investigated. The devices were fabricated by $0.35{\mu}m$ retrograde twin well CMOS processes. The processes could be simple by in-situ process of nitridation anneal and reoxidation. The nitrogen distribution and bonding state of gate dielectric were investigated by Dynamic Secondary Ion Mass Spectrometry(D-SIMS), Time-of-Flight Secondary Ion Mass Spectrometry(ToF-SIMS), and X-ray Photoelectron Spectroscopy(XPS). Nitrogen concentrations are proportional to nitridation anneal temperatures and the more time was required to form the same reoxidized layer thickness. ToF-SIMS results show that SiON species are detected at the initial oxide interface and $Si_{2}NO$ species near the new $Si-SiO_{2}$ interface that formed after reoxidation. As the anneal temperatures increased, the device showed worse retention and degradation properties. These could be said that nitrogen concentration near initial interface is limited to a certain quantity, so excess nitrogen are redistributed near the $Si-SiO_{2}$ interface and contributed to electron trap generation.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.27 no.9
• /
• pp.547-550
• /
• 2014

In this study, the electrical characteristics of the nickel (Ni)/carbon nanotube (CNT)/$SiO_2$ structures were investigated in order to analyze the mechanism of CNT in MOS device structures. We fabricated 4H-SiC MOS capacitors with or without CNTs. CNT was dispersed by isopropyl alcohol. The capacitance-voltage (C-V) and current-voltage (I-V) are characterized. Both devices were measured by Keithley 4200 SCS. The experimental flatband voltage ($V_{FB}$) shift was positive. Near-interface trap charge density ($N_{it}$) and negative oxide trap charge density ($N_{ox}$) value of CNT embedded MOS capacitors was less than that values of reference samples. Also, the leakage current of CNT embedded MOS capacitors is higher than reference samples. It has been found that its oxide quality is related to charge carriers and/or defect states in the interface of MOS capacitors.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.7
• /
• pp.576-582
• /
• 2002

Nonvolatile semiconductor memory devices with reoxidized nitrided oxide(RONO) gate dielectrics were fabricated, and nitrogen distribution and bonding species which contribute to memory characteristics were analyzed. Also, memory characteristics of devices depending on the anneal temperatures were investigated. The devices were fabricated by retrograde twin well CMOS processes with $0.35\mu m$ design rule. The processes could be simple by in-situ process in growing dielectric. The nitrogen distribution and bonding states of gate dielectrics were investigated by Dynamic Secondary Ion Mass Spectrometry(D-SIMS), Time-of-Flight Secondary Ion Mass Spectrometry(ToF-SIMS), and X-ray Photoelectron Spectroscopy(XPS). As the nitridation temperature increased, nitrogen concentration increased linearly, and more time was required to form the same reoxidized layer thickness. ToF-SIMS results showed that SiON species were detected at the initial oxide interface which had formed after NO annealing and $Si_2NO$ species within the reoxidized layer formed after reoxidation. As the anneal temperatures increased, the device showed worse retention and degradation properties. It could be said that nitrogen concentration near initial interface is limited to a certain quantity, so the excess nitrogen is redistributed within reoxidized layer and contribute to electron trap generation.

• Applied Science and Convergence Technology
• /
• v.26 no.5
• /
• pp.133-138
• /
• 2017

We investigated the interface defect engineering and reaction mechanism of reduced transition layer and nitride layer in the active plasma process on 4H-SiC by the plasma reaction with the rapid processing time at the room temperature. Through the combination of experiment and theoretical studies, we clearly observed that advanced active plasma process on 4H-SiC of oxidation and nitridation have improved electrical properties by the stable bond structure and decrease of the interfacial defects. In the plasma oxidation system, we showed that plasma oxide on SiC has enhanced electrical characteristics than the thermally oxidation and suppressed generation of the interface trap density. The decrease of the defect states in transition layer and stress induced leakage current (SILC) clearly showed that plasma process enhances quality of $SiO_2$ by the reduction of transition layer due to the controlled interstitial C atoms. And in another processes, the Plasma Nitridation (PN) system, we investigated the modification in bond structure in the nitride SiC surface by the rapid PN process. We observed that converted N reacted through spontaneous incorporation the SiC sub-surface, resulting in N atoms converted to C-site by the low bond energy. In particular, electrical properties exhibited that the generated trap states was suppressed with the nitrided layer. The results of active plasma oxidation and nitridation system suggest plasma processes on SiC of rapid and low temperature process, compare with the traditional gas annealing process with high temperature and long process time.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.331-331
• /
• 2012

With the NAND Flash scaling down, it becomes more and more difficult to follow Moore's law to continue the scaling due to physical limitations. Recently, three-dimensional (3D) flash memories have introduced as an ideal solution for ultra-high-density data storage. In 3D flash memory, as the process reason, we need to use poly-Si TFTs instead of conventional transistors. So, after combining charge trap flash (CTF) structure and poly-Si TFTs, the emerging device SONOS-TFTs has also suffered from some reliability problem such as hot carrier degradation, charge-trapping-induced parasitic capacitance and resistance which both create interface traps. Charge pumping method is a useful tool to investigate the degradation phenomenon related to interface trap creation. However, the curves for charge pumping current in SONOS TFTs were far from ideal, which previously due to the fabrication process or some unknown traps. It needs an optimization and the important geometrical effect should be eliminated. In spite of its importance, it is still not deeply studied. In our work, base-level sweep model was applied in SONOS TFTs, and the nonideal charge pumping current was optimized by adjusting the gate pulse transition time. As a result, after the optimizing, an improved charge pumping current curve is obtained.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.257-257
• /
• 2011

The amorphous indium-gallium-zinc-oxide (a-IGZO) materials for use in high performance display research fields are strongly investigated due to its good performance, such as high mobility and better transparency. However, the stability of a-IGZO materials is increasingly becoming one of critical issues due to the sub-gap electron trap sites induced by rough interfaces during deposition processing. It is well-known that the threshold voltage shift is related to interface roughness and oxygen vacancy formed by breaking weak chemical bonds. Here, we report the better properties of transparent oxide transistors by reducing the threshold voltage shift with an external rf plasma supported magnetron sputtering system. Mainly, our sputtering method causes the surface of sample to be sleek, so that it prevents the formation of various defects, such as shallow electron trap sites in the interface. External rf power was applied from 0 to 50W during RF sputtering process to enhance the stability of our oxide transistor without having a large voltage shift. To observe the effects of external rf-plasma source on the properties of our devices, Scanning Electron Microscopy (SEM), Atomic Force Microscopy (AFM), Transmission Electron Microscopy (TEM) are carried out to observe surface roughness and morphology of sputtered thin film. In addition, typical electrical properties, such as I-V characteristics are analyzed.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.95-95
• /
• 2011

비정질 산화물 반도체(Amorphous oxide semiconductors: AOSs)는 대면적화에도 불구하고 높은 이동도를 가지고, 상온에서도 제작할 수 있고, 투명 플렉시블 디스플레이 소자에 사용할 수 있기 때문에 최근 들어 각광받고 있는 연구 분야이다. 본 연구에서는 스퍼터링을 이용하여 활성층을 Amorphous indium gallium zinc oxide(a-IGZO)로 증착할 시에 스퍼터의 파워와 챔버내의 Ar/O2 비율을 다르게 했을 때 소자에 미치는 영향을 MIS구조를 이용하여 분석했다. 또한 같은 조건의 a-IGZO 활성층을 사용한 박막트랜지스터(TFT) 소자의 절연막의 종류를 바꿔가며 제작했을때의 소자의 특성 변화에 대해서도 분석하였다. 먼저 60 nm 두께의 a-IGZO층을 Heavily doped된 N형 실리콘 기판위에 스퍼터링 파워와 가스 분압비를 달리하여 증착하였다. 그 후 30 nm두께의 SiO2, Al2O3, SiNx 절연막을 증착하고, 마지막으로 열 증발 증착장비(Thermal Evaporator)를 이용하여 Al 전극을 150nm 증착하였다. 소자의 전기적 특성 분석은 HP4145와 Boonton 720을 사용하여 I-V와 C-V를 측정하였다. 위의 실험으로부터 스퍼터에서의 증착 rf파워가 증가할수록 a-IGZO 박막 트랜지스터에서의 캐리어 이동도가 감소하는 것을 볼 수 있었고, 챔버내의 가스분압비와 소자의 절연막의 종류가 변하면 a-IGZO 박막 트랜지스터의 전기적 특성이 변하는 것을 볼 수 있었다. 이러한 캐리어 이동도의 감소와 전기적 특성의 변화의 이유는 a-IGZO 활성층의 bulk trap과 절연막, 활성층 사이의 interface trap에 의한 것으로 보여진다.