• Journal of The Korean Society of Agricultural Engineers
• /
• v.53 no.2
• /
• pp.67-74
• /
• 2011

This research focused on the investigation of runoff and nonpoint sources (NPS) pollution characteristics from small soil box plots treated by livestock waste composts. An indoor rainfall simulation was performed over the plots for 60 minutes. Simulated rainfall intensities were 32.4, 43.2, 50.3 and 57.1 mm/hr respectively. Slope of soil box plots was $10^{\circ}$ and $20^{\circ}$, respectively. Rainfall simulation replicated 5 times and the experiment was conducted every four days five times. As the slope of soil box increased, NPS pollution loads increased. And as rainfall intensity was increased from 32.4 to 57.1 mm/hr, NPS pollution loads gradually increased, too. Discharge of NPS pollution loads was the largest in the first simulation and thereafter decreased gradually. Discharged BOD load to the total applied load from $10^{\circ}$ plots, ranged 0.2 to 0.7 %, was 8.4 to 50.0 % lower than slope $20^{\circ}$ plots. When the application rate increased twice, the increase of pollution load was between 1.7~5.7 times. Analysis of Pearson's correlation coefficient showed that organic matter content in pig compost and NPS pollution loads were correlated well. While under liquid compost application, the correlation coefficients between them were not good. It was concluded that application of livestock resources need to consider long-term weather forecast and if necessary, NPS reduction measures must be preceded in order to reduce NPS pollution discharge.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.1
• /
• pp.1-7
• /
• 2013

The interference among the rain radars and interference in the adjacent wireless station due to the spurious signals from the rain radar were analyzed in this paper. The rain radar measures the rain intensity using S-band signal. The measured data are utilized in forecasting the rainfall. The interference among the rain radars or in the adjacent wireless stations may be caused by the operation with low elevation angle and the high output power. Based on the propagation analysis of S band signal and the deduced interference protection ratio of rain radar, the interference due to the rain radar are analyzed. Also, the radiation spectrum characteristics of a rain radar are deduced from the caused interference effects by the spurious signals of the rain radar. To minimize the interference effects for adjacent wireless stations, it is required to get the rejection characteristics of spurious signals above 105 dB. In viewpoints of interference for rain radars, it is necessary to operate the rain radar with a different PRF and operation time opposite to adjacent rain radars.

• International Journal of High-Rise Buildings
• /
• v.10 no.4
• /
• pp.323-334
• /
• 2021

Concrete structures may rarely collapse in fire incidents but fire induced damage to structural members is inevitable as a result of material degradation and thermal expansion. This requires certain repairing measures to be applied to restore the performance of post-fire members. A brief review on investigation of post-fire damage of concrete material and concrete structural members is presented in this paper, followed by a review of post-fire repair research regarding various types of repairing techniques (FRP, steel plate, and concrete section enlargement) and different type of structural members including columns, beams, and slabs. Particularly, the fire scenarios adopted in these studies leading to damage are categorized as three levels according to the duration of gas-phase temperature above 600℃ (t₆₀₀). The repair effectiveness in terms of recovered performance of concrete structural members compared to the initial undamaged performance has been summarized and compared regarding the repairing techniques and fire intensity levels. The complied results have shown that recovering the ultimate strength is achievable but the stiffness recovery is difficult. Moreover, the current fire loading scenarios adopted in the post-fire repair research are mostly idealized as constant heating rates or standard fire curves, which may have produced unrealistic fire damage patterns and the associated repairing techniques may be not practical. For future studies, the realistic fire impact and the system-level structural damage investigation are necessary.

• Journal of Radiation Protection and Research
• /
• v.43 no.4
• /
• pp.160-169
• /
• 2018

Background: This study aims to develop an integrated optical system that can simultaneously or selectively measure the signals obtained from radioluminescence (RL), thermoluminescence (TL), and optically stimulated luminescence (OSL), which are luminescence phenomena of materials stimulated by radioactivity, heat, and light, respectively. The luminescence mechanism of various materials could be investigated using the glow curves of the luminescence materials. Materials and Methods: RL/TL/OSL integrated measuring system was equipped with a X-ray tube (50 kV, $200{\mu}A$) as an ionizing radiation source to irradiate the sample. The sample substrate was used as a heating source and was also designed to optically stimulate the sample material using various light sources, such as high luminous blue light emitting diode (LED) or laser. The system measured the luminescence intensity versus the amount of irradiation/stimulation on the sample for the purpose of measuring RL, TL and OSL sequentially or by selectively combining them. Optical filters were combined to minimize the interference of the stimulation light in the OSL signal. A long-pass filter (420 nm) was used for 470 nm LED, an ultraviolet-pass filter (260-390 nm) was used for detecting the luminescence of the sample by PM tube. Results and Discussion: The reliability of the system was evaluated using the RL/OSL characteristics of $Al_2O_3:C$ and the RL/TL characteristics of LiF:Mg,Cu,Si, which were used as dosimetry materials. The RL/OSL characteristics of $Al_2O_3:C$ showed relatively linear dose-response characteristics. The glow curve of LiF:Mg,Cu,Si also showed typical RL/OSL characteristics. Conclusion: The reliability of the proposed system was verified by sequentially measuring the RL characteristics of radiation as well as the TL and OSL characteristics by concurrent thermal and optical stimulations. In this study, we developed an integrated measurement system that measures the glow curves of RL/TL/OSL using universal USB-DAQs and the control program.

• Parasites, Hosts and Diseases
• /
• v.56 no.6
• /
• pp.625-632
• /
• 2018

Malaria remains one of the leading health burdens in the developing world, especially in several sub-Saharan Africa countries; and Uganda has some of the highest recorded measures of malaria transmission intensity in the world. It is evident that the prevalence of malaria infection, the incidence of disease, and mortality from severe malaria remain very high in Uganda. Although the recent stable political and economic situation in the last few decades in Uganda supported for a fairly good appreciation of malaria control, the declines in infection, morbidity, and mortality are not sufficient to interrupt transmission and this country is among the top 4 countries with cases of malaria, especially among children under 5 years of age. In fact, Uganda, which is endemic in over 95% of the country, is a representative of challenges facing malaria control in Africa. In this study, we evaluated an active case detection program in 6 randomly selected villages, Uganda. This program covered a potential target population of 5,017 individuals. Our team screened 12,257 samples of malaria by active case detection, every 4 months, from February 2015 to January 2017 in the 6 villages (a total of 6 times). This study assessed the perceptions and practices on malaria control in Kiyuni Parish of Kyankwanzi district, Uganda. Our study presents that the incidence of malaria is sustained high despite efforts to scale-up and improve the use of LLINs and access to ACDs, based on the average incidence confirmed by RDTs.

• Journal of dental hygiene science
• /
• v.19 no.2
• /
• pp.113-121
• /
• 2019

Background: We investigated somatization symptoms experienced by dental hygienists due to stress from emotional labor. Our aim was to provide basic research data that could be useful in the development of efficient stress management schemes for this occupational group. Methods: We analyzed data collected from 208 dental hygienists working in Jeollabuk-do Province, Korea. To measure the level and intensity of emotional labor among research participants, we used the Korean Emotional Labor Questionnaire. We used the Somatization Symptom Checklist-90-Revised (SCL-90-R) to measure the level of somatization symptoms among participants. Results: On analyzing the level of emotional labor and somatization symptoms according to general characteristics, participants aged 23~25 years showed high scores for stress due to emotional labor (p<0.05). Working 5 days per week, subjective health status, and organizational support and protection systems were found to correlate with the level of stress due to emotional labor (p<0.05). In the analysis of correlations between emotional labor and somatization symptoms, scoring high across all domains of emotional labor was associated with scoring high for somatization symptoms in the subdomains of emotional labor. When emotional labor and demographical variables were used as independent variables, having higher scores for emotional labor and having poor subjective health status were found to be associated with having higher levels of somatization symptoms (p<0.05). Conclusion: Our results showed that working at night and organizational support and protection systems were correlated with emotional labor and somatization symptoms. Measures must be taken at the organizational level to reduce emotional labor and somatization symptoms.

• Journal of Korean Society of Rural Planning
• /
• v.27 no.3
• /
• pp.11-20
• /
• 2021

Recently, natural disasters caused by climate change have become more frequent across the world. Our country is also not exceptional, and it is urgent to come up with appropriate measures in the agricultural sector as the size and intensity of drought are becoming severe. Consequently, the Ministry of Agriculture and Food has continuously raised the need for efficient water management and governance to overcome the periodic drought. Thus, there is a need for water-saving education and water conservation governance for sustainable and efficient use of agricultural water. Governance is a cooperative mechanism involving various stakeholders, such as central, local, civil society, and businesses, to solve regional or social problems, with different definitions and concepts depending on the field or scope. In this study, we aim to present basis of a governance framework for direct water management participation involving the key agricultural water use stakeholders to imbibe the culture of water savings and conservation practices. Based on this, water-saving governance was established and operated in Gyeongju and Yeoju, in South Korea as a 'water conservation practice', while the water management status of local farmers, the reliability and importance of stakeholders, and the need for governance were investigated. The results indicate that the involvement of various stakeholders in the governance of water management yielded water-saving effects. This study provides the directions of making a framework for water-saving governance establishment and operation. It is expected that sustainable agricultural water use can be achieved in response to climate change if the governance builds and operates with agricultural water use stakeholders based on the continuous government supports.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.16 no.4
• /
• pp.105-118
• /
• 2006

The purpose of this research is twofold. The first is to develop the measures for evaluating performance of fingerprint sensor modules quantitatively and objectively. The second is to present the methodology for evaluating compatibilities among disparate fingerprint sensors. This paper focuses on the performance evaluation not of fingerprint authentication algorithm but of fingerprint sensors. Presented in this paper are several indicators and their measuring schemes such as the actual resolution of fingerprint images, the level of distortion by horizontal and vertical resolutions of fingerprint image, the intensity distribution for various illuminating conditions. Nine commercial sensor modules have been tested and the test results are expressed by using 95% confidence interval based on 50 acquired fingerprint images. The experimental results are compared with the manufacturer's sensor specification.

• Physical Therapy Korea
• /
• v.28 no.1
• /
• pp.53-58
• /
• 2021

Background: To evaluate whether extracorporeal shock wave therapy (ESWT) in the pain point is a more effective treatment than the trigger point for myofascial pain syndrome (MPS) of the upper trapezius. Objects: The purpose of this study was to compare the most effective areas when applying extracorporeal shock wave therapy. Methods: A total of 30 patients with MPS were randomly assigned to the trigger point in the ESWT (n = 15) and pain point ESWT (n = 15) groups. Interventions in both groups were performed in one session, i.e., 2,000 shocks with 1.5 bar intensity. Pain and function were assessed using the visual analog scale (VAS) and cervical range of motion (ROM) and based on mechanical muscle properties. Statistical analysis was performed using the repeated measures two-way analysis of variance to determine the significance probability between pre- and post-test. Results: Changes in mechanical muscle properties were not statistically significant between the two groups. However, VAS and cervical ROM showed statistically significant differences at pre- and post-intervention, regardless of the group (p < 0.05). Conclusion: Although no significant difference was observed in the intervention effect, applying an extracorporeal shock wave to the pain point rather than the pain trigger point should be considered in order to save time in effectively and accurately identifying the pain trigger point and site.

• PNF and Movement
• /
• v.19 no.2
• /
• pp.225-231
• /
• 2021

Purpose: This study was conducted to investigate the type of physical therapist response work and its intensity, along with the prolonged prevalence of COVID-19, to determine the impact on physical therapists' occupational stress and occupational burnout. Methods: An online survey was conducted with 118 physiotherapists and collected the participants' gender, final educational background, clinical work experience, workplace type, additional workload, and fatigue associated with COVID-19. After excluding one participant who submitted an incomplete questionnaire, 117 respondents were included in the final data. Results: Additional COVID-19-related workloads and response reliability for fatigue, occupational burnout, and occupational stress were shown to have Cronbach's alpha measures of 0.76, 0.89, and 0.87, respectively. Groups who had experienced a new epidemic in the past showed higher fatigue levels (3.06±0.94) than those groups who had no such experience (2.49±0.84; p < 0.05). Correlation analysis of COVID-19 work fatigue and occupational burnout scales showed a positive correlation (r = 0.19; p < 0.05). The regression of occupational burnout and occupational stress showed a regression model of Y = 20.00+0.43X₁ (X₁: job stress; p< 0.05) and an explanatory power of 24.8% with an adj.R² = 0.25. Conclusion: Based on the results, it is suggested that various institutions, such as medical institutions, educational institutions, and physiotherapists' associations, should seek ways to manage and alleviate physiotherapists' stress.